Wei-Yi Sun
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Wei-Yi Sun has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
Shi-Jun Su
Department of Environmental Science and Engineering, College of Architecture and Environment, Sichuan University, Chengdu, China
6 shared publicationsSang-Lan Ding
Sichuan University
5 shared publicationsSanglan Ding
Department of Environmental Science and Engineering, College of Architecture and Environment, Sichuan University, Chengdu, China
3 shared publications- Bing Liao
State Key Laboratory of Geohazard Prevention and Geoenvironment Protection, Chengdu University of Technology, Chengdu, China
2 shared publications Na Guo
College of Architecture and Environment, Sichuan University, Chengdu, 610065, China
2 shared publicationsShijun Su
College of Architecture and Environment, Sichuan University, Chengdu, Sichuan, People’s Republic of China
2 shared publications
Latest Publications
- 2 July 2020
- Published by Taylor & Francis in Separation Science and Technology
- Vol. 56 (9) , 1612-1621
Leaching characteristics and kinetics of iron and manganese from iron-rich pyrolusite slag in oxalic acid solution
Leaching behaviors of iron-rich pyrolusite slag in oxalic acid solution were explored to investigate the influences of leaching time, temperature, liquid-solid ratio, and concentrations of H+ and oxalic acid on the leaching characteristics of iron (Fe) and manganese (Mn). Leaching rates of Fe and Mn reached 97% and 92% under optimum leaching conditions, respectively. Furthermore, leaching process of Fe was controlled by the chemical reaction between oxalic acid and Fe, and leaching process of Mn was controlled by both the diffusion of oxalic acid across the residual layer as well as the chemical reaction between oxalic acid and Mn.
- 2 July 2020
- Published by Taylor & Francis in Separation Science and Technology
- Vol. 56 (9) , 1612-1621
Leaching characteristics and kinetics of iron and manganese from iron-rich pyrolusite slag in oxalic acid solution
Leaching behaviors of iron-rich pyrolusite slag in oxalic acid solution were explored to investigate the influences of leaching time, temperature, liquid-solid ratio, and concentrations of H+ and oxalic acid on the leaching characteristics of iron (Fe) and manganese (Mn). Leaching rates of Fe and Mn reached 97% and 92% under optimum leaching conditions, respectively. Furthermore, leaching process of Fe was controlled by the chemical reaction between oxalic acid and Fe, and leaching process of Mn was controlled by both the diffusion of oxalic acid across the residual layer as well as the chemical reaction between oxalic acid and Mn.
- 8 May 2019
- Published by Taylor & Francis in Journal of Sulfur Chemistry
- Vol. 40 (5) , 491-502
Thermal and kinetic study of manganese dithionate from absorbing or leaching solution via TG/XRD/IC analysis
Mangano-manganic oxide can be prepared through thermal decomposition of manganese sulfate from the absorption or leaching solution, so desulfurization by pyrolusite or leaching pyrolusite with sulfur dioxide should be fully exploited for the recovery of manganese salt. However, upon preparing MnSO4 using above techniques, manganese dithionate is an inevitable by-product, which lowers the purity of the industrial raw material MnSO4 and exerts negative influences on pyrolysis technology. Information regarding thermal decomposition of solid-state manganese dithionate is scarce. To recycle manganese dithionate efficiently, pyrolysis mechanism and kinetics were systematically investigated by thermal decomposition method. The characteristics of thermal decomposition products were determined by thermogravimetric analysis techniques (TG), X-ray diffraction (XRD), and Ion chromatography (IC). The experimental results revealed that both desulfurization and following dehydration of MnS2O6·H2O were a one-step process, and the desulfurization occurred at about 150°C lower than the dehydration at 230°C. As increasing pyrolysis temperature to 900°C, the manganese sulfate was firstly formed, and to 1100°C, Mangano-manganic oxide was obtained by losing sulfur oxides. Consequently, the kinetic parameters for each decomposition steps of manganese dithionate were determined by the Coasts and Redfern (CR) integral method. The as-obtained experimental and kinetic results may provide theoretical guides for recycling manganese dithionate.
- 8 May 2019
- Published by Taylor & Francis in Journal of Sulfur Chemistry
- Vol. 40 (5) , 491-502
Thermal and kinetic study of manganese dithionate from absorbing or leaching solution via TG/XRD/IC analysis
Mangano-manganic oxide can be prepared through thermal decomposition of manganese sulfate from the absorption or leaching solution, so desulfurization by pyrolusite or leaching pyrolusite with sulfur dioxide should be fully exploited for the recovery of manganese salt. However, upon preparing MnSO4 using above techniques, manganese dithionate is an inevitable by-product, which lowers the purity of the industrial raw material MnSO4 and exerts negative influences on pyrolysis technology. Information regarding thermal decomposition of solid-state manganese dithionate is scarce. To recycle manganese dithionate efficiently, pyrolysis mechanism and kinetics were systematically investigated by thermal decomposition method. The characteristics of thermal decomposition products were determined by thermogravimetric analysis techniques (TG), X-ray diffraction (XRD), and Ion chromatography (IC). The experimental results revealed that both desulfurization and following dehydration of MnS2O6·H2O were a one-step process, and the desulfurization occurred at about 150°C lower than the dehydration at 230°C. As increasing pyrolysis temperature to 900°C, the manganese sulfate was firstly formed, and to 1100°C, Mangano-manganic oxide was obtained by losing sulfur oxides. Consequently, the kinetic parameters for each decomposition steps of manganese dithionate were determined by the Coasts and Redfern (CR) integral method. The as-obtained experimental and kinetic results may provide theoretical guides for recycling manganese dithionate.
- 10 December 2018
- Published by Wiley in ChemistrySelect
- Vol. 3 (46) , 13154-13160
Oxidation of SO 2 by O 2 and Its Effects on Dithionate Formation during Pyrolusite Leaching Process with Mixture Gas Containing SO 2 and O 2
Competitive oxidations of SO 2 oxidized by MnO 2 and O 2 are existed during pyrolusite leaching process with SO 2 and O 2 mixture gases. Generally, SO 2 is oxidized into H 2 SO 4 by O 2 , and manganese sulfate (MnSO 4 ) and manganese dithionate (MnS 2 O 6 ) are formed when oxidized by MnO 2 . Meanwhile, the reaction between SO 2 and O 2 has effect on the amount of aqueous SO 2 oxidized by MnO 2 and solution acidity, resulting in the variations of Mn extraction and MnS 2 O 6 formation. In this paper, the competitive mechanism of SO 2 oxidation by MnO 2 and O 2 was firstly discussed based on theoretical analysis of leaching process, and then concentration ratio of O 2 /SO 2 ( R ) in gas flow was proposed as a determined parameter to characterize the competition, the effects of R on Mn extraction, H 2 SO 4 generation and MnS 2 O 6 formation. The results showed that R was the determined parameter for evaluating the oxidation effect of O 2 on SO 2 , which had a decisive effect on H 2 SO 4 concentration, and eventually affects MnS 2 O 6 formation and Mn extraction under constant gas flow (10 L⋅min −1 ) and others experimental factor. With the increase of R , the H 2 SO 4 concentration increased gradually but the formation of MnS 2 O 6 sharply decreased to negligible amount when R >10, and Mn extraction increased first and then decreased significantly. The most suitable R for obtaining MnSO 4 product was R =10 with 1.4 g⋅L −1 , 96% Mn extraction and 0.07 M H 2 SO 4 .
- 10 December 2018
- Published by Wiley in ChemistrySelect
- Vol. 3 (46) , 13154-13160
Oxidation of SO 2 by O 2 and Its Effects on Dithionate Formation during Pyrolusite Leaching Process with Mixture Gas Containing SO 2 and O 2
Competitive oxidations of SO 2 oxidized by MnO 2 and O 2 are existed during pyrolusite leaching process with SO 2 and O 2 mixture gases. Generally, SO 2 is oxidized into H 2 SO 4 by O 2 , and manganese sulfate (MnSO 4 ) and manganese dithionate (MnS 2 O 6 ) are formed when oxidized by MnO 2 . Meanwhile, the reaction between SO 2 and O 2 has effect on the amount of aqueous SO 2 oxidized by MnO 2 and solution acidity, resulting in the variations of Mn extraction and MnS 2 O 6 formation. In this paper, the competitive mechanism of SO 2 oxidation by MnO 2 and O 2 was firstly discussed based on theoretical analysis of leaching process, and then concentration ratio of O 2 /SO 2 ( R ) in gas flow was proposed as a determined parameter to characterize the competition, the effects of R on Mn extraction, H 2 SO 4 generation and MnS 2 O 6 formation. The results showed that R was the determined parameter for evaluating the oxidation effect of O 2 on SO 2 , which had a decisive effect on H 2 SO 4 concentration, and eventually affects MnS 2 O 6 formation and Mn extraction under constant gas flow (10 L⋅min −1 ) and others experimental factor. With the increase of R , the H 2 SO 4 concentration increased gradually but the formation of MnS 2 O 6 sharply decreased to negligible amount when R >10, and Mn extraction increased first and then decreased significantly. The most suitable R for obtaining MnSO 4 product was R =10 with 1.4 g⋅L −1 , 96% Mn extraction and 0.07 M H 2 SO 4 .
- 12 October 2018
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 44 (6) , 5335-5344
Separation of Manganese from Iron in the $\hbox {SO}_{2}$ SO 2 Reductive Leaching Iron-Rich Pyrolusite Ore: Leaching Mechanism and Kinetics- 12 October 2018
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 44 (6) , 5335-5344
Separation of Manganese from Iron in the $\hbox {SO}_{2}$ SO 2 Reductive Leaching Iron-Rich Pyrolusite Ore: Leaching Mechanism and Kinetics- 11 July 2018
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 47 (10) , 6042-6052
Preparation of Lithium Ion Adsorbent Using Low-Grade Pyrolusite: Preparation Method and Adsorption Performance
- 11 July 2018
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 47 (10) , 6042-6052
Preparation of Lithium Ion Adsorbent Using Low-Grade Pyrolusite: Preparation Method and Adsorption Performance
- 31 January 2018
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 123 (2) , 757-770
Formation characteristics of dithionate and sulfate ions in the pyrolusite leaching process with SO2
- 31 January 2018
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 123 (2) , 757-770
Formation characteristics of dithionate and sulfate ions in the pyrolusite leaching process with SO2
- 1 June 2017
- Published by Elsevier in Carbohydrate Polymers
- Vol. 165, 376-383
Preparation and properties of a novel macro porous Ni 2+ -imprinted chitosan foam adsorbents for adsorption of nickel ions from aqueous solution
- 1 June 2017
- Published by Elsevier in Carbohydrate Polymers
- Vol. 165, 376-383
Preparation and properties of a novel macro porous Ni 2+ -imprinted chitosan foam adsorbents for adsorption of nickel ions from aqueous solution