Gianpaolo Pinelli
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Gianpaolo Pinelli has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Mario Greco
IDS, Pisa, Italy
4 shared publications - Davide Oscar Nitti
GAP S.r.l. (Italy)
2 shared publications - Fabio Bovenga
Istituto per il Rilevamento Elettromagnetico dell’Ambiente, Consiglio Nazionale delle Ricerche (CNR-IREA), Bari, Italy
2 shared publications - Simon Wagner
Cognitive Radar Methods Fraunhofer FHR Wachtberg Germany
2 shared publications - Stefan Brüggenwirth
Cognitive Methods Department, Fraunhofer Institute for High Frequency Physics and Radar Techniques (FHR), Wachtberg, Germany
2 shared publications Tanja Bieker
Fraunhofer FHR, Wachtberg, Germany
2 shared publications
Latest Publications
- 9 March 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Aerospace and Electronic Systems Magazine
- Vol. 36 (3) , 24-35
Results on Super-Resolution and Target Identification Techniques From the SPERI Project
We give an overview of the EDA CAT B R&D project “Signal Processing for Enhanced Radar Imaging” (SPERI). In this project, the benefits of applying two super-resolution methods Super Spatially Variant Apodization (SSVA) and Compressed Sensing (CS) to two-dimensional Inverse Synthetic Aperture Radar (ISAR) images of airborne radar targets were investigated with respect to the improvements in automatic target identification rates. The algorithms have been tested over a database of more than 1200 real radar images.
- 9 March 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Aerospace and Electronic Systems Magazine
- Vol. 36 (3) , 24-35
Results on Super-Resolution and Target Identification Techniques From the SPERI Project
We give an overview of the EDA CAT B R&D project “Signal Processing for Enhanced Radar Imaging” (SPERI). In this project, the benefits of applying two super-resolution methods Super Spatially Variant Apodization (SSVA) and Compressed Sensing (CS) to two-dimensional Inverse Synthetic Aperture Radar (ISAR) images of airborne radar targets were investigated with respect to the improvements in automatic target identification rates. The algorithms have been tested over a database of more than 1200 real radar images.
- 23 November 2019
- Published by Springer Nature
- p. 723-733
Classification of Drones with a Surveillance Radar Signal
- 23 November 2019
- Published by Springer Nature
- p. 723-733
Classification of Drones with a Surveillance Radar Signal
- 31 July 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 15 (11) , 1725-1729
Nonparametric ISAR Autofocusing Via Entropy- Based Doppler Centroid Search
A novel approach to nonparametric entropy-based autofocusing of inverse synthetic aperture radar images is proposed. Kinematics considerations show that the range cell corresponding to the target rotation center has a purely translational Doppler phase. This range cell can be selected by means of entropy criteria, and its phase component used as a measurement of the translational Doppler phase. Concerning the existing techniques, the new one is robust enough to noise and low target reflectivity, whereas provides higher quality output images with low computational load. The quality of the output is further confirmed by resorting to a recently published automatic target recognition algorithm, obtaining a very high success rate on a wide and variegated data set, acquired by the tracking and imaging radar system of the Fraunhofer FHR Institute.
- 31 July 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 15 (11) , 1725-1729
Nonparametric ISAR Autofocusing Via Entropy- Based Doppler Centroid Search
A novel approach to nonparametric entropy-based autofocusing of inverse synthetic aperture radar images is proposed. Kinematics considerations show that the range cell corresponding to the target rotation center has a purely translational Doppler phase. This range cell can be selected by means of entropy criteria, and its phase component used as a measurement of the translational Doppler phase. Concerning the existing techniques, the new one is robust enough to noise and low target reflectivity, whereas provides higher quality output images with low computational load. The quality of the output is further confirmed by resorting to a recently published automatic target recognition algorithm, obtaining a very high success rate on a wide and variegated data set, acquired by the tracking and imaging radar system of the Fraunhofer FHR Institute.
- Open Access
Feasibility of Using Synthetic Aperture Radar to Aid UAV Navigation
This study explores the potential of Synthetic Aperture Radar (SAR) to aid Unmanned Aerial Vehicle (UAV) navigation when Inertial Navigation System (INS) measurements are not accurate enough to eliminate drifts from a planned trajectory. This problem can affect medium-altitude long-endurance (MALE) UAV class, which permits heavy and wide payloads (as required by SAR) and flights for thousands of kilometres accumulating large drifts. The basic idea is to infer position and attitude of an aerial platform by inspecting both amplitude and phase of SAR images acquired onboard. For the amplitude-based approach, the system navigation corrections are obtained by matching the actual coordinates of ground landmarks with those automatically extracted from the SAR image. When the use of SAR amplitude is unfeasible, the phase content can be exploited through SAR interferometry by using a reference Digital Terrain Model (DTM). A feasibility analysis was carried out to derive system requirements by exploring both radiometric and geometric parameters of the acquisition setting. We showed that MALE UAV, specific commercial navigation sensors and SAR systems, typical landmark position accuracy and classes, and available DTMs lead to estimated UAV coordinates with errors bounded within ±12 m, thus making feasible the proposed SAR-based backup system.
Open AccessFeasibility of Using Synthetic Aperture Radar to Aid UAV Navigation
This study explores the potential of Synthetic Aperture Radar (SAR) to aid Unmanned Aerial Vehicle (UAV) navigation when Inertial Navigation System (INS) measurements are not accurate enough to eliminate drifts from a planned trajectory. This problem can affect medium-altitude long-endurance (MALE) UAV class, which permits heavy and wide payloads (as required by SAR) and flights for thousands of kilometres accumulating large drifts. The basic idea is to infer position and attitude of an aerial platform by inspecting both amplitude and phase of SAR images acquired onboard. For the amplitude-based approach, the system navigation corrections are obtained by matching the actual coordinates of ground landmarks with those automatically extracted from the SAR image. When the use of SAR amplitude is unfeasible, the phase content can be exploited through SAR interferometry by using a reference Digital Terrain Model (DTM). A feasibility analysis was carried out to derive system requirements by exploring both radiometric and geometric parameters of the acquisition setting. We showed that MALE UAV, specific commercial navigation sensors and SAR systems, typical landmark position accuracy and classes, and available DTMs lead to estimated UAV coordinates with errors bounded within ±12 m, thus making feasible the proposed SAR-based backup system.
- 13 March 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 11 (1) , 99-103
Improved Edge Enhancing Diffusion Filter for Speckle-Corrupted Images
In the context of automatic image processing, noise is often the hardest problem to cope with. This is, in particular, true for images corrupted by multiplicative speckle noise, such as synthetic aperture radar images. To tackle such an issue, this letter proposes a novel anisotropic diffusion filter that manages to simultaneously fulfill competing requirements: reduce noise on homogeneous regions, preserve weak edges, and keeping hard targets intact. The capabilities of our filter were proved by comparing it with other state-of-the-art filters on a 1-look Cosmo-SkyMed image.
- 13 March 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 11 (1) , 99-103
Improved Edge Enhancing Diffusion Filter for Speckle-Corrupted Images
In the context of automatic image processing, noise is often the hardest problem to cope with. This is, in particular, true for images corrupted by multiplicative speckle noise, such as synthetic aperture radar images. To tackle such an issue, this letter proposes a novel anisotropic diffusion filter that manages to simultaneously fulfill competing requirements: reduce noise on homogeneous regions, preserve weak edges, and keeping hard targets intact. The capabilities of our filter were proved by comparing it with other state-of-the-art filters on a 1-look Cosmo-SkyMed image.
- 19 October 2012
- Published by SPIE-Intl Soc Optical Eng
- Vol. 8532, 853203
On the use of SAR interferometry to aid navigation of UAV
This study is aimed at exploring the potentials of SAR Interferometry (InSAR) to aid Unmanned Aerial Vehicles (UAV) navigation. The basic idea is to infer both position and attitude of an aerial platform by inspecting the InSAR phase derived by a real time SAR interferometer mounted onboard the platform. Thanks to the expected favorable conditions in terms of geometrical sensitivity as well as signal coherence, the InSAR phase field can be used to derive the terrain elevation. By using both approximated position and attitude values of the platform as well as a reference Digital Terrain Model (DTM) from a mission database available onboard, it is possible to generate a synthetic InSAR phase model to be compared w.r.t. that derived by SAR observations. The geometrical transformation needed to match these two terrain models depends on the difference between position and attitude values derived by the instruments available on board and their actual values. Hence, this matching provides a feedback to be used for adjusting position and attitude. In order to assess the reliability of the proposed approach, we evaluated the interferometric sensitivity to changes in position and attitude. This analysis defines the limits of applicability of the InSAR-based approach and provides indications and requirements on geometric and radiometric parameters.
- 19 October 2012
- Published by SPIE-Intl Soc Optical Eng
- Vol. 8532, 853203
On the use of SAR interferometry to aid navigation of UAV
This study is aimed at exploring the potentials of SAR Interferometry (InSAR) to aid Unmanned Aerial Vehicles (UAV) navigation. The basic idea is to infer both position and attitude of an aerial platform by inspecting the InSAR phase derived by a real time SAR interferometer mounted onboard the platform. Thanks to the expected favorable conditions in terms of geometrical sensitivity as well as signal coherence, the InSAR phase field can be used to derive the terrain elevation. By using both approximated position and attitude values of the platform as well as a reference Digital Terrain Model (DTM) from a mission database available onboard, it is possible to generate a synthetic InSAR phase model to be compared w.r.t. that derived by SAR observations. The geometrical transformation needed to match these two terrain models depends on the difference between position and attitude values derived by the instruments available on board and their actual values. Hence, this matching provides a feedback to be used for adjusting position and attitude. In order to assess the reliability of the proposed approach, we evaluated the interferometric sensitivity to changes in position and attitude. This analysis defines the limits of applicability of the InSAR-based approach and provides indications and requirements on geometric and radiometric parameters.