Jun Yin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jun Yin has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Baolin Deng
Department of Civil & Environmental Engineering, University of Missouri, Columbia, Missouri, USA
5 shared publications Guocheng Zhu
3 shared publications- Huaili Zheng
College of Environment and Ecology, Chongqing University, Chongqing 400044, China
3 shared publications Jianzhong Zheng
State Key Laboratory of Pollution Control and Resource Reuse School of the Environment, Nanjing University, Nanjing 210093, P.R. China
2 shared publicationsLei Ge
State Key Laboratory of Pollution Control and Resource Reuse School of the Environment, Nanjing University, Nanjing 210093, P.R. China
2 shared publicationsPeng Zhang
2 shared publications
Latest Publications
- 23 April 2015
- Published by Taylor & Francis in Separation Science and Technology
Fe (III)/H2O2-like system for removal of azo dye from aqueous solution
Fe(III)/H2O2 system is an effective method for separating the organic compounds from aqueous solution, whereas it is often investigated under lower pH conditions. In order to improve performance of the system, a Fe(III)/H2O2-like system that was composed of iron-based coagulant and H2O2 was developed, which has the combined effect of flocculation and oxidation. The system when used for decolorization of an organic azo dye solution, Procion Red MX-5B, under wider pH range, indicated higher decolorization efficiency. Parameters affecting the decolorization such as coagulant dosage, H2O2 concentration, initial solution pH, temperature, and initial dye concentration were examined in this study. The results indicated that with appropriate coagulant dosage, H2O2 concentration, and pH, it was more effective for the decolorization, especially in a weak alkaline environment (pH = 7-8); the pseudo-first-order kinetics could express the azo dye concentration as a function of the reaction time. This study further illustrated that the azo dye solution was degraded to a degree with 53.22% TOC removal at an initial total TOC concentration of 14.92 mg/L. Overall, the established system in this study was favorable to the decolorization of soluble azo dye.
- 23 April 2015
- Published by Taylor & Francis in Separation Science and Technology
Fe (III)/H2O2-like system for removal of azo dye from aqueous solution
Fe(III)/H2O2 system is an effective method for separating the organic compounds from aqueous solution, whereas it is often investigated under lower pH conditions. In order to improve performance of the system, a Fe(III)/H2O2-like system that was composed of iron-based coagulant and H2O2 was developed, which has the combined effect of flocculation and oxidation. The system when used for decolorization of an organic azo dye solution, Procion Red MX-5B, under wider pH range, indicated higher decolorization efficiency. Parameters affecting the decolorization such as coagulant dosage, H2O2 concentration, initial solution pH, temperature, and initial dye concentration were examined in this study. The results indicated that with appropriate coagulant dosage, H2O2 concentration, and pH, it was more effective for the decolorization, especially in a weak alkaline environment (pH = 7-8); the pseudo-first-order kinetics could express the azo dye concentration as a function of the reaction time. This study further illustrated that the azo dye solution was degraded to a degree with 53.22% TOC removal at an initial total TOC concentration of 14.92 mg/L. Overall, the established system in this study was favorable to the decolorization of soluble azo dye.
- Top Cited Papers
- 1 April 2015
- Published by Elsevier in Journal of Membrane Science
- Vol. 479, 256-275
Polymer-matrix nanocomposite membranes for water treatment
- 1 April 2015
- Published by Elsevier in Journal of Membrane Science
- Vol. 479, 256-275
Top Cited PapersPolymer-matrix nanocomposite membranes for water treatment
- 1 August 2014
- Published by Elsevier in Desalination
- Vol. 346, 38-45
DOM removal by flocculation process: Fluorescence excitation–emission matrix spectroscopy (EEMs) characterization
- 1 August 2014
- Published by Elsevier in Desalination
- Vol. 346, 38-45
DOM removal by flocculation process: Fluorescence excitation–emission matrix spectroscopy (EEMs) characterization
- 1 August 2013
- Published by Elsevier in Journal of Membrane Science
- Vol. 441, 73-82
Attachment of silver nanoparticles (AgNPs) onto thin-film composite (TFC) membranes through covalent bonding to reduce membrane biofouling
- 1 August 2013
- Published by Elsevier in Journal of Membrane Science
- Vol. 441, 73-82
Attachment of silver nanoparticles (AgNPs) onto thin-film composite (TFC) membranes through covalent bonding to reduce membrane biofouling
- 1 June 2013
- Published by Elsevier in Journal of Membrane Science
- Vol. 437, 237-248
Multi-walled carbon nanotubes (MWNTs)/polysulfone (PSU) mixed matrix hollow fiber membranes for enhanced water treatment
- 1 June 2013
- Published by Elsevier in Journal of Membrane Science
- Vol. 437, 237-248
Multi-walled carbon nanotubes (MWNTs)/polysulfone (PSU) mixed matrix hollow fiber membranes for enhanced water treatment
- 1 January 2013
- Published by Taylor & Francis in Environmental Technology
- Vol. 34 (1) , 91-99
Near-infrared spectroscopy as a potential tool with radial basis function for measurement of residual acrylamide in organic polymer
Poly(acrylamide-co-diallyldimethylammonium chloride) (PDA), which is usually prepared by free radical polymerization of acrylamide monomer (AM) onto the cationic monomer dimethyl diallyl ammonium chloride (DMDAAC), has been widely applied to wastewater treatment; however, the free-radical polymerization is always incomplete with residual AM remaining in the PDA. The residual AM affects the PDA's performance while also posing as a potential threat to human health; therefore, during preparation of the PDA, the rapid detection of the residual AM plays an important role in controlling the residual AM while improving the PDA's performance. The objective of this study was to explore the possibilities for applying near-infrared (NIR) spectroscopy as a potential tool for detecting the residual AM in combination with a statistical tool. In this study, the radial basis function (RBF) network model as the statistical tool was combined with NIR spectroscopy for detection of the residual AM. The experimental results showed that five wavelengths in the NIR spectroscopy were the most important characteristic adsorption peaks, particular at 971.95 and 1077 nm. The simulation of the RBF model presented higher performance with R 2-value greater than 0.98, RMSEC and RMSEP less than 7.22×10−5 and coefficient of variation (CV) of the predicted residual AM less than 10%, which demonstrated the feasibility of the NIR spectroscopy being a rapid detection tool for prediction of the residual AM using the RBF model. Wavelet de-nosing was used for removing the interference/noise in the NIR spectroscopy and improved the generalization ability of the RBF model.
- 1 January 2013
- Published by Taylor & Francis in Environmental Technology
- Vol. 34 (1) , 91-99
Near-infrared spectroscopy as a potential tool with radial basis function for measurement of residual acrylamide in organic polymer
Poly(acrylamide-co-diallyldimethylammonium chloride) (PDA), which is usually prepared by free radical polymerization of acrylamide monomer (AM) onto the cationic monomer dimethyl diallyl ammonium chloride (DMDAAC), has been widely applied to wastewater treatment; however, the free-radical polymerization is always incomplete with residual AM remaining in the PDA. The residual AM affects the PDA's performance while also posing as a potential threat to human health; therefore, during preparation of the PDA, the rapid detection of the residual AM plays an important role in controlling the residual AM while improving the PDA's performance. The objective of this study was to explore the possibilities for applying near-infrared (NIR) spectroscopy as a potential tool for detecting the residual AM in combination with a statistical tool. In this study, the radial basis function (RBF) network model as the statistical tool was combined with NIR spectroscopy for detection of the residual AM. The experimental results showed that five wavelengths in the NIR spectroscopy were the most important characteristic adsorption peaks, particular at 971.95 and 1077 nm. The simulation of the RBF model presented higher performance with R 2-value greater than 0.98, RMSEC and RMSEP less than 7.22×10−5 and coefficient of variation (CV) of the predicted residual AM less than 10%, which demonstrated the feasibility of the NIR spectroscopy being a rapid detection tool for prediction of the residual AM using the RBF model. Wavelet de-nosing was used for removing the interference/noise in the NIR spectroscopy and improved the generalization ability of the RBF model.
- Top Cited Papers
- 1 December 2012
- Published by Elsevier in Journal of Membrane Science
- Vol. 423-424, 238-246
Fabrication of a novel thin-film nanocomposite (TFN) membrane containing MCM-41 silica nanoparticles (NPs) for water purification
- 1 December 2012
- Published by Elsevier in Journal of Membrane Science
- Vol. 423-424, 238-246
Top Cited PapersFabrication of a novel thin-film nanocomposite (TFN) membrane containing MCM-41 silica nanoparticles (NPs) for water purification
- 7 January 2010
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 24 (2) , 973-978
Characterization of Oil Sludges from Two Oil Fields in China
- 7 January 2010
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 24 (2) , 973-978
Characterization of Oil Sludges from Two Oil Fields in China
- 1 January 2010
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 136 (1) , 147-151
Using Flotation to Separate Oil Spill Contaminated Beach Sands
Lab flotation in artificial sea water was used to separate sand-oil mixtures prepared by mixing crude oil with quartz-dominated beach sands. Major factors affecting the separation efficiency for three representative oils (light, waxy, and heavy viscous) were examined through lab flotation tests, vortex experiments, and oil viscosity measurements. Results showed that flotation in sea water can effectively separate the tested sand-oil mixtures which had large contrast in physicochemical properties: (1) aging of sand-oil mixtures reduced the separation efficiency; (2) both the viscosity of crude oil and its adhesion to sand surfaces had major impacts on separation efficiency; (3) addition of small amounts of surfactants could substantially improve the separation efficiency; and (4) for heavy viscous oil, hydrocarbon solvents needed to be added to improve separation because of their solvency and capability in reducing oil viscosity.
- 1 January 2010
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 136 (1) , 147-151
Using Flotation to Separate Oil Spill Contaminated Beach Sands
Lab flotation in artificial sea water was used to separate sand-oil mixtures prepared by mixing crude oil with quartz-dominated beach sands. Major factors affecting the separation efficiency for three representative oils (light, waxy, and heavy viscous) were examined through lab flotation tests, vortex experiments, and oil viscosity measurements. Results showed that flotation in sea water can effectively separate the tested sand-oil mixtures which had large contrast in physicochemical properties: (1) aging of sand-oil mixtures reduced the separation efficiency; (2) both the viscosity of crude oil and its adhesion to sand surfaces had major impacts on separation efficiency; (3) addition of small amounts of surfactants could substantially improve the separation efficiency; and (4) for heavy viscous oil, hydrocarbon solvents needed to be added to improve separation because of their solvency and capability in reducing oil viscosity.