CCCostas Constantinou

Costas Constantinou

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Costas Constantinou has a total of 68 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Interlaboratory mmWave and THz Quasi-Optical Characterization of Commercial Conventional and 3-D Printable Substrates

    by Alperen Sari, Dou Feng, Matthew Brown, Jasper Trilk, Xiaobang Shang, Liam Ausden, Mira Naftaly, Nick M. Ridler, J. Mike F. Gunn, Costas Constantinou, et al.

    The growing interest in terahertz (THz) circuits and devices for next-generation communication and sensing technologies, combined with the increasing need for novel nonplanar designs, necessitates accurate, and broadband characterization of advanced dielectric substrates. This study comprehensively characterizes industrial-grade RadixTM dielectric resins alongside conventional substrates from 50 GHz to 2.5 THz, with measurements conducted at both the National Physical Laboratory and University of Birmingham using quasi-optical systems run by vector network analyzers (VNAs) and time-domain spectrometers (TDSs). Five different collimated beam measurement setups are used, each using in-house developed material extraction algorithms that incorporate the influence of surface roughness into the extraction process, extending proprietary VNA and TDS-based extraction algorithms. The comprehensive interlaboratory measurement campaign demonstrates strong consistency, validating the robustness and reliability of the methodologies. Detailed analysis confirms that the additional surface roughness introduced by 3-D additive manufacturing of RadixTM resins has a negligible impact on electrical parameters.


  • Influence of the Metasurface Local Surface Impedance on the Surface Wave Launcher Efficiency

    by Joshua Barrass, Miguel Navarro-Cía, Costas Constantinou

    Modern metasurfaces have produced new interest in engineering surface wave propagation technologies. One remaining challenge is the efficient coupling of energy into these waves. This paper demonstrates launching efficiencies up to 82% by varying the position of the launcher relative to the unit cell, and provides an equivalent circuit model to guide designers. This is an additional degree of freedom that has not been discussed previously, and arises due to the discontinuity introduced by the launcher and its effect on the local surface impedance.


  • Building a Comprehensive Complex Permittivity Library for THz Radio Planning Using Quasi-Optical Measurements

    by Dou Feng, Alperen Sari, Christopher Sumner, Morgan Dryhurst, Matthew Brown, Vanshika Gupta, Jie Qing, Olcay Altıntaş, Alex Bystrov, Costas Constantinou, et al.

    The lack of an accessible comprehensive reliable dataset of material properties at terahertz (THz) frequencies is a significant roadblock for the development of accurate propagation models for THz wireless systems. To fill this gap, in this article, we extract the complex permittivity of 75 different home and commercial furnishings categorized into fabric, leather, plastic, stone, and wood from quasi-optical measurements. Given that quasi-optical transmission measurement standards are not developed yet, we utilize both vector network analysis and time-domain spectroscopy under collimated and focused beam illumination to highlight the differences and the challenges that precise material extraction faces at THz, and to compute average complex permittivities with confidence intervals.


  • A Liquid-Metal-Enabled Reconfigurable Feed Network for Multipolarization Arrays

    by Yi-Wen Wu, James R. Kelly, Lu Qian, Costas Constantinou, Farhad Ghorbani, Jiafeng Zhou, Yi Huang, Yi Wang

    This article presents a novel reconfigurable feed network that allows the switch of antenna arrays across four different polarization states. Different from most previous multipolarization antennas, the reconfiguration is implemented solely in the feed network without disturbing the radiation element. The key enabler is a reconfigurable coupler that switches between two circuit functions—a branch-line coupler or a crossover—through altering the line widths of its parallel branches. This is only made possible by using liquid metals (LMs). A double-pole-double-throw (DPDT) switch, also enabled by LM, is employed to select the input port of the reconfigurable coupler. The switch and the reconfigurable coupler form the reconfigurable feed network, providing four states of excitation to the antenna. The reconfigurable coupler, the switch, and a 2 $\times$ 2 array have been designed and experimentally verified with the LM actuation. As a branch-line coupler, the reconfigurable coupler shows excellent amplitude and phase balance within 0.04 dB ( $\vert\vert S_{{21}}\vert$ – $\vert S_{{31}}\vert\vert$ $<$ 0.04 dB) and 90 $^{\circ}$ at 3.5 GHz, whereas, as the crossover, it has an isolation over 25 dB. The switch exhibits an isolation of 50 dB. The measured peak gain of the array is 14.7 dBic. At 3.5 GHz, the measured axial ratio (AR) associated with the right-hand circular polarization (CP) state is 1.0 dB. The speed of switching and power handling associated with the LM have been discussed. The use of the LM has enabled a unique way of circuit reconfiguration and a full polarization-reconfigurable multifunctional antenna.


  • Diffuse-Scattering-Informed Geometric Channel Modeling for THz Wireless Communications Systems

    by Leyre Azpilicueta, Alper Schultze, Mikel Celaya-Echarri, Fidel A. Rodríguez-Corbo, Costas Constantinou, Raed M. Shubair, Francisco Falcone, Miguel Navarro-Cía

    Surpassing 100 Gbps data throughput is a key objective and an active area of research for sixth-generation (6G) wireless networks that can only be met by exploiting the TeraHertz (THz) frequency band (0.3 - 10 THz). THz channel modeling faces new challenges given the emerging relevance of scattering and molecular absorption in this frequency range as well as the lack of a reliable library of material properties. In this work, we address these challenges by measuring systematically the dielectric properties of 27 common building and office materials and reporting an in-house three-dimensional ray-launching (3D-RL) algorithm that uses the created material library and accounts for rough surface scattering and atmospheric attenuation. In order to validate the proposed algorithm, a channel sounder measurement campaign has been performed in a typical indoor environment at 300 GHz. Simulations and measurements show good agreement, demonstrating the need for modelling scattering and atmospheric absorption in the THz band. The proposed channel model approach enables scenarios at THz frequencies to be investigated by simulation, providing a relevant knowledge for the development of ultra-high-speed wireless communication systems.


  • Digitally encoded RF to optical data transfer using excited Rb without the use of a local oscillator

    by Marco Menchetti, Liam W. Bussey, Daniel Gilks, Tim Whitley, Costas Constantinou, Kai Bongs

    We present a passive RF to optical data transfer without a local oscillator using an atomic “Rydberg” receiver. We demonstrate the ability to detect a 5G frequency carrier wave (3.5 GHz) and decode digital data from the carrier wave without the use of a local oscillator to detect the modulation of the RF signal. The encoding and decoding of the data are achieved using an intermediate frequency (IF). The rubidium vapor detects the changes in the carrier wave's amplitude, which comes from the mixing of the IF onto the carrier. The rubidium vapor then upconverts the IF into the optical domain for detection. Using this technique for data encoding and extraction, we achieve data rates up to 238 kbps with a variety of encoding schemes.


  • Rain Attenuation at Millimeter Wave and Low-THz Frequencies

    by Fatemeh Norouzian, Emidio Marchetti, Marina Gashinova, Edward Hoare, Costas Constantinou, Peter Gardner, Mikhail Cherniakov

    Wave attenuation through rain with different rainfall rates at millimeter wave (f=77 GHz) and Low-THz (f=300 GHz) frequencies is studied in this paper. Rain has pronounced impacts on electromagnetic wave propagation and one of the well-known effects is attenuation of the transmitted wave. Attenuation at both frequencies and hydrometeor properties (rainfall rate and drop size distribution) are measured simultaneously. The measured drop size distribution is fitted with gamma and Weibull distributions and is also compared to the frequently-used distribution Marshall and Palmer model (MP); Weibull is shown to be a better fit to the measured drop size distributions. Theoretical prediction of attenuation as a function of rainfall rate (up to about 20 mm/hr) is determined using Mie scattering theory, and the fitted gamma and Weibull, and MP distribution models; as well as using the ITU-R recommendation. The calculations are evaluated by comparing them to the experiment. The measured results at 77 GHz best agree with the ITU-R recommendation whereas at 300 GHz, the calculation based on Mie scattering and the Weibull distribution exhibits the best fit to the measured data. The measured data that exceed the theoretical prediction are analyzed and interpreted based on their corresponding observed drop size properties, for the first time.


  • Open Access

    Experimental study on low‐THz automotive radar signal attenuation during snowfall

    by Fatemeh Norouzian, Emidio Marchetti, Edward Hoare, Marina Gashinova, Costas Constantinou, Peter Gardner, Mikhail Cherniakov

    Experimental measurement results of automotive radar signal attenuation during various intensities of snowfall at the current automotive radar frequency (77 GHz) and low‐terahertz (THz) (100–300 GHz) frequencies are presented and compared in this study. The attenuation is characterised by measuring the ratio of the received power from a reference target through snow precipitation of various intensities and through the same path with no precipitation. Statistical analysis of the attenuation is presented. Higher attenuation is measured at a higher frequency, and also attenuation increases as snowfall rate and liquid water content in snowflakes increases. This study is fundamentally important to investigate the effect of adverse weather conditions on low‐THz radar performance in comparison with the current automotive radars operating in the traditional mm‐wave band. In addition, the effects of low‐THz wave attenuation and scattering due to typical contaminants formed on the radome of automotive radars and reflection from common objects on the road are presented.


  • A Practical Access Point Deployment Optimization Strategy in Communication-Based Train Control Systems

    by Tao Wen, Costas Constantinou, Lei Chen, Zhu Li, Clive Roberts

    Communication-based train control (CBTC) systems have been playing a progressively significant role in metro signaling in recent years. As safety-critical systems, CBTC systems have very strict requirements on the wireless communication performance between train and wayside access points (AP), which is highly dependent on the deployment of the APs. In this paper, by customizing and adopting a decomposition-based multiobjective evolutionary algorithm, the proposed AP deployment optimization method has been implemented, verified, and its implementation accuracy has been assessed. A real-world case study is carried out in an integrated simulation platform, in which the optimized AP deployments are verified and show better performance than the original planning.


  • Open Access

    Analysis of the use of complete orders to abstract the internet connectivity at the autonomous system level

    by Pedro David Arjona‐Villicaña, Costas C Constantinou, Alexander S Stepanenko, Jesús Acosta‐Elías

    Complete orders, also called chains, are transitive acyclic digraphs which can be employed as a topological unit to model, abstract and exploit the Internet's path diversity. The main objective behind this work is to demonstrate why complete orders are well suited in abstracting routing information at the interdomain level. In order to abstract a network's topological information, it becomes necessary to introduce another mathematical structure called virtual arc, which allows to define complete orders where these cannot be formed directly. An algorithm, called chain routing, that employs virtual arcs to define chains in a network is described and tested. Further analysis of the chain routing algorithm leads to the conclusion that this is an NP‐complete problem; however, by limiting the size of the complete orders to be used, it is possible to provide an upper bound to the computational task needed to discover these structures in the Internet.