Ricardo Póvoa

This paper presents a low-noise inverter-based current-mode instrumentation amplifier with tunable gain and bandwidth for electromyogram (EMG) and electrooculogram (EOG) biopotential signals, targeting low input noise while maintaining low power consumption. The gain tuning method is based on pseudo-resistors, whereas the bandwidth is tunable due to a varactor system that is controlled by the same control voltage that tunes the gain. The circuit was designed and manufactured using the 110 nm UMC CMOS technology node, occupying an area of 0.624 mm². The circuit presents a functioning mode for each biopotential signal with different characteristics, for the EMG a gain of 34.7 dB and a bandwidth of 1412 Hz was measured, with an input referred noise of 1.407 μV which matches a noise efficiency factor of 1.44. The EOG mode achieves a 39.5 dB gain and a 22.4 Hz bandwidth while presenting an input-referred noise of 0.829 μV corresponding to a noise efficiency factor of 6.37. For both modes, the supply voltage is 1.2 V and the circuit consumes 1 μA.