James D. Kammert
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
James D. Kammert has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
- Robert J. Davis
Department of Chemical Engineering, University of Virginia, Charlottesville, Virginia 22903, United States
5 shared publications Eli Stavitski
National Synchrotron Light Source II, Building 740, Brookhaven National Lab, Upton, New York 11973, United States
2 shared publicationsGordon Brezicki
Department of Chemical Engineering, University of Virginia, 102 Engineer's Way, P.O. Box 400741, Charlottesville, Virginia 22904-4741, USA
2 shared publications- Jiahan Xie
Department of Chemical Engineering, University of Virginia, 102 Engineers’ Way, P.O. Box 400741, Charlottesville, Virginia 22904-4741, United States
2 shared publications Klaus Attenkofer
National Synchrotron Light Source II, Building 740, Brookhaven National Lab, Upton, New York 11973, United States
2 shared publications- Raymond R. Unocic
Oak Ridge National Laboratory
2 shared publications
Latest Publications
- 14 January 2021
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 11 (3) , 1435-1455
Reaction Kinetics and Mechanism for the Catalytic Reduction of Propionic Acid over Supported ReOx Promoted by Pd
- 14 January 2021
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 11 (3) , 1435-1455
Reaction Kinetics and Mechanism for the Catalytic Reduction of Propionic Acid over Supported ReOx Promoted by Pd
- Open Access
- 1 January 2020
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 91 (1) , 013107
High-throughput operando-ready X-ray absorption spectroscopy flow reactor cell for powder samples
A high-throughput, operando-ready X-ray absorption spectroscopy catalytic reaction cell consisting of 4 parallel reactors was designed to collect X-ray absorption near edge structure and extended fine structure spectra under reaction conditions. The cell is capable of operating at temperatures from ambient conditions up to 773 K and pressures from ambient to 2 MPa in a variety of gas environments. The cell design is mechanically simple, and programmable operation at beamline 8-ID (NSLS-II, Brookhaven National Laboratory) makes it straightforward to use. Reactor tube parts were available as-fabricated from commercial sources, while the heating jacket and cell mounting required custom machining.
- 1 January 2020
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 91 (1) , 013107
Open AccessHigh-throughput operando-ready X-ray absorption spectroscopy flow reactor cell for powder samples
A high-throughput, operando-ready X-ray absorption spectroscopy catalytic reaction cell consisting of 4 parallel reactors was designed to collect X-ray absorption near edge structure and extended fine structure spectra under reaction conditions. The cell is capable of operating at temperatures from ambient conditions up to 773 K and pressures from ambient to 2 MPa in a variety of gas environments. The cell design is mechanically simple, and programmable operation at beamline 8-ID (NSLS-II, Brookhaven National Laboratory) makes it straightforward to use. Reactor tube parts were available as-fabricated from commercial sources, while the heating jacket and cell mounting required custom machining.
- 26 April 2019
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 9 (6) , 5308-5319
Insights into the Speciation of Cu in the Cu-H-Mordenite Catalyst for the Oxidation of Methane to Methanol
- 26 April 2019
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 9 (6) , 5308-5319
Insights into the Speciation of Cu in the Cu-H-Mordenite Catalyst for the Oxidation of Methane to Methanol
- 12 July 2018
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 6 (9) , 12353-12366
Reduction of Propionic Acid over a Pd-Promoted ReOx/SiO2 Catalyst Probed by X-ray Absorption Spectroscopy and Transient Kinetic Analysis
A Pd-promoted Re/SiO2 catalyst was prepared by sequential impregnation and compared to monometallic Pd/SiO2 and Re/SiO2. All samples were characterized by electron microscopy, H2 and CO chemisorption, H2 temperature-programmed reduction, and in-situ X-ray absorption spectroscopy at the Re LIII and Pd K-edges. The samples were also tested in the reduction of propionic acid to 1-propanol and propionaldehyde at 433 K in 0.1-0.2 MPa H2. Whereas monometallic Pd was inactive for carboxylic acid reduction, monometallic Re catalyzed aldehyde formation, but only after high-temperature pre-reduction that produced metallic Re. When Pd was present with Re in a bimetallic catalyst, Pd facilitated the reduction of Re in H2 to ~4+ oxidation state at modest temperatures, producing an active catalyst for the conversion of propionic acid to 1-propanol. Under the conditions of this study, the orders of reaction in propionic acid and H2 were approximately zero and one, respectively. Transient kinetic analysis of the carboxylic acid reduction to alcohols revealed that at least 50% of the Re in the bimetallic catalyst participated in the catalytic reaction. The Pd is proposed to enhance the catalytic activity of the bimetallic catalyst by spilling over hydrogen that can partially reduce Re and react with surface intermediates.
- 12 July 2018
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 6 (9) , 12353-12366
Reduction of Propionic Acid over a Pd-Promoted ReOx/SiO2 Catalyst Probed by X-ray Absorption Spectroscopy and Transient Kinetic Analysis
A Pd-promoted Re/SiO2 catalyst was prepared by sequential impregnation and compared to monometallic Pd/SiO2 and Re/SiO2. All samples were characterized by electron microscopy, H2 and CO chemisorption, H2 temperature-programmed reduction, and in-situ X-ray absorption spectroscopy at the Re LIII and Pd K-edges. The samples were also tested in the reduction of propionic acid to 1-propanol and propionaldehyde at 433 K in 0.1-0.2 MPa H2. Whereas monometallic Pd was inactive for carboxylic acid reduction, monometallic Re catalyzed aldehyde formation, but only after high-temperature pre-reduction that produced metallic Re. When Pd was present with Re in a bimetallic catalyst, Pd facilitated the reduction of Re in H2 to ~4+ oxidation state at modest temperatures, producing an active catalyst for the conversion of propionic acid to 1-propanol. Under the conditions of this study, the orders of reaction in propionic acid and H2 were approximately zero and one, respectively. Transient kinetic analysis of the carboxylic acid reduction to alcohols revealed that at least 50% of the Re in the bimetallic catalyst participated in the catalytic reaction. The Pd is proposed to enhance the catalytic activity of the bimetallic catalyst by spilling over hydrogen that can partially reduce Re and react with surface intermediates.
- 22 March 2018
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 8 (5) , 3875-3884
Atomically Dispersed Co and Cu on N-Doped Carbon for Reactions Involving C–H Activation
- 22 March 2018
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 8 (5) , 3875-3884
Atomically Dispersed Co and Cu on N-Doped Carbon for Reactions Involving C–H Activation
- 20 January 2017
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 139 (4) , 1485-1498
Mechanistic Studies of Single-Step Styrene Production Using a Rhodium(I) Catalyst
The direct and single-step conversion of benzene, ethylene, and a Cu(II) oxidant to styrene using the Rh(I) catalyst (FlDAB)Rh(TFA)(η2-C2H4) [FlDAB = N,N′-bis(pentafluorophenyl)-2,3-dimethyl-1,4-diaza-1,3-butadiene; TFA = trifluoroacetate] has been reported to give quantitative yields (with Cu(II) as the limiting reagent) and selectivity combined with turnover numbers >800. This report details mechanistic studies of this catalytic process using a combined experimental and computational approach. Examining catalysis with the complex (FlDAB)Rh(OAc)(η2-C2H4) shows that the reaction rate has a dependence on catalyst concentration between first- and half-order that varies with both temperature and ethylene concentration, a first-order dependence on ethylene concentration with saturation at higher concentrations of ethylene, and a zero-order dependence on the concentration of Cu(II) oxidant. The kinetic isotope effect was found to vary linearly with the order in (FlDAB)Rh(OAc)(η2-C2H4), exhibiting no KIE when [Rh] was in the half-order regime, and a kH/kD value of 6.7(6) when [Rh] was in the first-order regime. From these combined experimental and computational studies, competing pathways, which involve all monomeric Rh intermediates and a binuclear Rh intermediate in the other case, are proposed.
- 20 January 2017
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 139 (4) , 1485-1498
Mechanistic Studies of Single-Step Styrene Production Using a Rhodium(I) Catalyst
The direct and single-step conversion of benzene, ethylene, and a Cu(II) oxidant to styrene using the Rh(I) catalyst (FlDAB)Rh(TFA)(η2-C2H4) [FlDAB = N,N′-bis(pentafluorophenyl)-2,3-dimethyl-1,4-diaza-1,3-butadiene; TFA = trifluoroacetate] has been reported to give quantitative yields (with Cu(II) as the limiting reagent) and selectivity combined with turnover numbers >800. This report details mechanistic studies of this catalytic process using a combined experimental and computational approach. Examining catalysis with the complex (FlDAB)Rh(OAc)(η2-C2H4) shows that the reaction rate has a dependence on catalyst concentration between first- and half-order that varies with both temperature and ethylene concentration, a first-order dependence on ethylene concentration with saturation at higher concentrations of ethylene, and a zero-order dependence on the concentration of Cu(II) oxidant. The kinetic isotope effect was found to vary linearly with the order in (FlDAB)Rh(OAc)(η2-C2H4), exhibiting no KIE when [Rh] was in the half-order regime, and a kH/kD value of 6.7(6) when [Rh] was in the first-order regime. From these combined experimental and computational studies, competing pathways, which involve all monomeric Rh intermediates and a binuclear Rh intermediate in the other case, are proposed.
- 30 May 2013
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 15 (29) , 12187-12196
Single atom alloy surface analogs in Pd0.18Cu15 nanoparticles for selective hydrogenation reactions
We report a novel synthesis of nanoparticle Pd–Cu catalysts, containing only trace amounts of Pd, for selective hydrogenation reactions. Pd–Cu nanoparticles were designed based on model single atom alloy (SAA) surfaces, in which individual, isolated Pd atoms act as sites for hydrogen uptake, dissociation, and spillover onto the surrounding Cu surface. Pd–Cu nanoparticles were prepared by addition of trace amounts of Pd (0.18 atomic (at)%) to Cu nanoparticles supported on Al2O3 by galvanic replacement (GR). The catalytic performance of the resulting materials for the partial hydrogenation of phenylacetylene was investigated at ambient temperature in a batch reactor under a head pressure of hydrogen (6.9 bar). The bimetallic Pd–Cu nanoparticles have over an order of magnitude higher activity for phenylacetylene hydrogenation when compared to their monometallic Cu counterpart, while maintaining a high selectivity to styrene over many hours at high conversion. Greater than 94% selectivity to styrene is observed at all times, which is a marked improvement when compared to monometallic Pd catalysts with the same Pd loading, at the same total conversion. X-ray photoelectron spectroscopy and UV-visible spectroscopy measurements confirm the complete uptake and alloying of Pd with Cu by GR. Scanning tunneling microscopy and thermal desorption spectroscopy of model SAA surfaces confirmed the feasibility of hydrogen spillover onto an otherwise inert Cu surface. These model studies addressed a wide range of Pd concentrations related to the bimetallic nanoparticles.
- 30 May 2013
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 15 (29) , 12187-12196
Single atom alloy surface analogs in Pd0.18Cu15 nanoparticles for selective hydrogenation reactions
We report a novel synthesis of nanoparticle Pd–Cu catalysts, containing only trace amounts of Pd, for selective hydrogenation reactions. Pd–Cu nanoparticles were designed based on model single atom alloy (SAA) surfaces, in which individual, isolated Pd atoms act as sites for hydrogen uptake, dissociation, and spillover onto the surrounding Cu surface. Pd–Cu nanoparticles were prepared by addition of trace amounts of Pd (0.18 atomic (at)%) to Cu nanoparticles supported on Al2O3 by galvanic replacement (GR). The catalytic performance of the resulting materials for the partial hydrogenation of phenylacetylene was investigated at ambient temperature in a batch reactor under a head pressure of hydrogen (6.9 bar). The bimetallic Pd–Cu nanoparticles have over an order of magnitude higher activity for phenylacetylene hydrogenation when compared to their monometallic Cu counterpart, while maintaining a high selectivity to styrene over many hours at high conversion. Greater than 94% selectivity to styrene is observed at all times, which is a marked improvement when compared to monometallic Pd catalysts with the same Pd loading, at the same total conversion. X-ray photoelectron spectroscopy and UV-visible spectroscopy measurements confirm the complete uptake and alloying of Pd with Cu by GR. Scanning tunneling microscopy and thermal desorption spectroscopy of model SAA surfaces confirmed the feasibility of hydrogen spillover onto an otherwise inert Cu surface. These model studies addressed a wide range of Pd concentrations related to the bimetallic nanoparticles.