BGBaoming Ge

Baoming Ge

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Baoming Ge has a total of 70 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Common mode voltage reduction of quasi‐Z source indirect matrix converter

    by Xuyang You, Baoming Ge, Shuo Liu, Ning Nie, Xinjian Jiang, Haitham Abu‐Rub

    Summary: Quasi‐Z source indirect matrix converter (IMC) combines both advantages of conventional IMC and quasi‐Z source inverter, for example, no direct current (DC) link capacitor, compact all‐silicon power converter, bidirectional power flow, input power factor controllable, and high voltage gain; moreover, it does not require additional input filter, because continuous quasi‐Z source network integrates LC filter function. However, there is no literature to disclose common mode voltage (CMV) issue of quasi‐Z source IMC. In this paper, for the first time, the CMV issue and reduction of quasi‐Z source IMC are investigated. Firstly, the CMV of quasi‐Z source IMC is analyzed when using current typical modulation method, which follows the brief introduction of topology and modulation method for quasi‐Z source IMC, and the factors that affect the CMV are figured out; Secondly, referring to the CMV reduction methods of conventional IMC, two solutions named as Methods I and II to reduce the CMV for quasi‐Z source IMC are developed, which are achieved in the inverter stage; the third CMV reduction method is proposed in the rectifier stage through redefining the six sectors of the rectifier stage, which can implement zero current commutation. Experimental bench is built to test three approaches for reducing the CMV of quasi‐Z source IMC. Comparative evaluation is carried out between three methods and conventional modulation method. Experimental results verify that three methods can significantly reduce the CMV of quasi‐Z source IMC, with the CMV peak value reduction of 42%, but they present different features in terms of input and output current THDs, switching loss, CMV root mean square (RMS) value, modulation index limitation, and so on. Copyright © 2015 John Wiley & Sons, Ltd.


  • Open Access

    Modelling and controller design of quasi‐Z‐source cascaded multilevel inverter‐based three‐phase grid‐tie photovoltaic power system

    by Yushan Liu, Baoming Ge, Haitham Abu‐Rub

    Quasi‐Z source cascaded multilevel inverter (qZS‐CMI) is an emerging topology applied to photovoltaic (PV) power system. It can overcome disadvantages of conventional CMI‐based PV power system, because of achieving the balanced dc‐link voltage through using its boost ability, and saving one‐third modules. At present, there was not literature to disclose the modelling and controller design for qZS‐CMI‐based three‐phase grid‐tie PV power system. In this study, a control scheme for three‐phase qZS‐CMI‐based grid‐tie PV power system is proposed, where distributed maximum power point tracking (MPPT) and constant dc‐link peak voltage are achieved for all qZS H‐bridge inverter (qZS‐HBI)‐based PV modules, with grid‐injected power in unity power factor. The detailed controller parameter design is demonstrated by using Bode plots and the built models of qZS‐HBI‐based PV module and whole system. A test bench of 7‐level three‐phase qZS‐CMI‐based PV power system is built. Simulation and experimental results validate the proposed control scheme and design method.


  • Simplified quasi‐Z source indirect matrix converter

    by Shuo Liu, Baoming Ge, Xinjian Jiang, Haitham Abu‐Rub, Fang Zheng Peng

    Summary: Conventional matrix converters have a limited voltage gain less than 0.866 and also require many power switches and additional input filter that ensures a low input current harmonics to the grid. Quasi‐Z source (qZS) indirect matrix converter can provide high voltage gain and ensure a sinusoidal input current without additional input filter, which requires 12 power switches in rectifier stage. In this paper, a simplified qZS indirect matrix converter is proposed to overcome aforementioned limitations and achieve (1) higher voltage gain than 0.866, (2) less power switches, and (3) LC‐filter function integrated in qZS network to avoid additional filter. The new converter's operating principle and equivalent circuits are analyzed, and the modulation method is presented. The input current closed‐loop control is employed to implement sinusoidal input current waveform even though the proposed converter has less power switches and without extra input filter. A test bench is used to verify the simplified qZS indirect matrix converter and control methods. Simulation and experimental results identically validate the proposed converter system with wide voltage gain range and low input current harmonics. Copyright © 2014 John Wiley & Sons, Ltd.


  • Open Access

    Modelling and controller design of quasi‐Z‐source inverter with battery‐based photovoltaic power system

    by Yushan Liu, Baoming Ge, Haitham Abu‐Rub, Fang Zheng Peng

    The quasi‐Z‐source inverter (qZSI) with battery can balance the stochastic fluctuations of PV power injected to the grid/load, but there is no literature to disclose its modelling and controller design in detail. This study proposed a dynamic small‐signal model of qZSI with battery and a control strategy for photovoltaic (PV) power generation system. The built model discloses the dynamic relationship of PV panel voltage, battery current, quasi‐Z‐source inductor currents and capacitor voltages. The proposed control method achieves the grid‐tie operation with unity power factor, PV panel's maximum power point tracking and battery management. The novel space vector modulation for the qZSI divides the total shoot‐through time interval into six equal parts per control cycle to be combined into the six switching moments, and lower inductor current ripple and higher inverter efficiency are performed. The experimental and simulation results verify the theoretical analysis and proposed control methods.


  • Open Access

    Phase‐shifted pulse‐width‐amplitude modulation for quasi‐Z‐source cascade multilevel inverter‐based photovoltaic power system

    by Yushan Liu, Baoming Ge, Haitham Abu‐Rub, Fang Zheng Peng

    A phase‐shifted pulse‐width‐amplitude modulation (PS‐PWAM) is proposed for a quasi‐Z‐source cascade multilevel inverter (qZS‐CMI)‐based photovoltaic power system. The switching actions of each power device of the qZS‐CMI in the PS‐PWAM technique are greatly reduced when compared with that in the phase‐shifted sinewave pulsewidth modulation, so the qZS‐CMI's power loss is reduced when using the PS‐PWAM. The PS‐PWAM principle and the qZS‐CMI's loss analysis are presented. The simulation and experimental results verify the proposed PS‐PWAM and the resultant efficiency improvement.


  • A novel quasi‐Z‐source indirect matrix converter

    by Shuo Liu, Baoming Ge, Xuyang You, Xinjian Jiang, Haitham Abu‐Rub, Fang Zheng Peng

    Summary: A new type of three‐phase quasi‐Z‐source indirect matrix converter (QZS‐IMC) is proposed in this paper. It uses a unique impedance network for achieving voltage‐boost capability and making the input current in continuous conduction mode (CCM) to eliminate the input filter. The complete modulation strategy is proposed to operate the QZS‐IMC. Meanwhile, a closed‐loop DC‐link peak voltage control strategy is proposed, and the DC‐link peak voltage is estimated by measuring both the input and capacitor voltages. With this proposed technique, a high‐performance output voltage control can be achieved with an excellent transient performance even if there are input voltage and load current variations. The controller is designed by using the small‐signal model. Vector control scheme of the induction motor is combined with the QZS‐IMC to achieve the motor drive. A QZS‐IMC prototype is built in laboratory, and experimental results verify the operating principle and theoretical analysis of the proposed converter. The simulation tests of QZS‐IMC based inductor motor drive are carried out to validate the proposed converter's application in motor drive. Copyright © 2013 John Wiley & Sons, Ltd.


  • Control System Design of Battery-Assisted Quasi-Z-Source Inverter for Grid-Tie Photovoltaic Power Generation

    by Yushan Liu, Baoming Ge, Haitham Abu-Rub, Fang Zheng Peng

    A control strategy for the quasi-Z-source inverter (qZSI) with a battery-based photovoltaic (PV) power conversion system is proposed. A battery-assisted qZSI can buck/boost PV panel voltage by introducing shoot-through states, and make full use of PV power by the energy-stored battery paralleled to the quasi-Z-source capacitor. A dynamic small-signal model of the battery-assisted qZSI is established to design a closed-loop controller for regulating shoot-through duty ratio and managing the battery's energy storage. A modified space vector modulation (SVM) technique for the qZSI is applied to achieve low harmonics, high voltage utilization, and high efficiency. A P-Q decoupled grid-tie power injection is fulfilled with the maximum power capture from PV panels and the unity power factor. The validity of the proposed PV system is proved by experimental results, showing an efficient method for the energy-stored PV power generation.


  • Novel Energy Stored Single-Stage Photovoltaic Power System With Constant DC-Link Peak Voltage

    by Baoming Ge, Fang Zheng Peng, Haitham Abu-Rub, Fernando J. T. E. Ferreira, Anibal T. de Almeida

    The quasi-Z source inverter (qZSI) with battery can balance the stochastic fluctuations of photovoltaic (PV) power injected to the grid/load, but its existing topology has a power limitation due to the wide range of discontinuous conduction mode during battery discharge. For an energy stored qZSI, traditional control methods cannot ensure a constant dc-link peak voltage because of battery's voltage clamp. This paper proposes a novel energy stored qZSI-based PV power system with constant dc-link peak voltage to overcome the above demerits. The new topology of energy stored qZSI is employed to improve the power compensation ability of existing topology, new constant dc-link peak voltage control and load related maximum power point tracking are proposed, and the whole system is analyzed in detail. Experimental results verify the theoretical analysis and the proposed energy stored qZSI-based PV power system.


  • Overview of Space Vector Modulations for Three-Phase Z-Source/Quasi-Z-Source Inverters

    by Yushan Liu, Baoming Ge, Haitham Abu-Rub, Fang Zheng Peng

    Three existing and one extended space vector modulations (SVMs) for the three-phase Z-source/quasi-Z-source inverter (ZSI/qZSI) are investigated. The different switching control patterns, the available maximum shoot-through duty ratio, the maximum voltage stress across the switch versus voltage gain, and efficiency are compared in detail. A total average switch device power taking into account the shoot-through current stress is proposed to evaluate the total stress of power switches. Simulation and experimental results of the prototyped qZSI verify the theoretical analysis. The six parts of shoot-through time intervals will reduce the inductor current ripples, and improve the qZSI efficiency. Also, the maximum voltage stress and total average switch power will benefit from the shoot-through division. However, the division method impacts these performances of qZSI.


  • Current balancer-based grid-connected parallel inverters for high power wind-power system

    by Baoming Ge, Fang Z. Peng

    Current balancer-based phase leg paralleling provides a preponderant technology for the grid-tie inverter to extend current rating when transporting high wind power to the grid. However, the existing technology used one current balancer per phase output (one core per phase), so that three current balancers (three separate cores) were required for the three-phase system, which caused redundant large size. Also, the low-frequency circulating current components have to be controlled in order to avoid saturation of the current balancer designed for minimizing the switching frequency components of circulating current. This paper contributes in three aspects: (i) two multiphase coupling current balancers are proposed for two parallel configurations, only one single core is employed for the three-phase system, and the compactness and light weight are achieved with a very high permeability magnetic core and no air gap. (ii) The detailed current balancer design methods are proposed for both configurations, and the designed two prototypes compare two current balancers for application to two inverter configurations. (iii) A current closed-loop control is proposed to minimize the circulating current, which is verified by the simulated results. Copyright © 2013 John Wiley & Sons, Ltd.