Ingars Reinholds

Mycotoxins are toxic mold metabolites that can adversely affect human and animal health. More than 400 mycotoxins have been identified so far. Cereals and nuts are the predominant mycotoxin-contaminated foodstuffs. Plant-based drinks produced from cereals, nuts, and legumes have grown in popularity. The mycotoxins accumulated in these crops may transfer to these beverages. A liquid chromatography–tandem mass spectrometry method was developed and optimized for the assessment of 22 mycotoxins in commercially available plant-based drinks in Latvia and Lithuania. A total of 64% of the seventy-two analyzed beverages were positive for one to sixteen mycotoxins, with deoxynivalenol, beauvericin, and enniatins A, B, B1, T-2, and HT-2 toxins detected most frequently. The European Commission has not yet set guidelines for the maximum mycotoxin concentrations in plant-based beverages, nor has the European Food Safety Authority conducted a risk assessment. Therefore, acute exposure studies were provided for the Latvian population based on the assumed replacement of dairy milk with plant-based beverages to ascertain the safety of plant-based milk substitutes. Based on the observed levels of mycotoxin prevalence and contamination levels and assumed exposure, it can be concluded that tested plant-based beverages may be relatively safe. However, exposure to emerging mycotoxins should be considered.

Sulfonated poly(ether ether ketone) (SPEEK) materials are promising candidates for replacing Nafion™ in applications such as proton exchange membrane (PEM) and direct methanol fuel cells. SPEEK membranes have several advantages such as low cost, thermal and radiation stability and controllable physicochemical and mechanical properties, which depend on the degree of sulfonation (DS). Commercial PEEK was homogenously sulfonated up to a DS of 60–90% and the membranes were prepared using a solvent casting method. Part of the samples were irradiated with a 10 MeV electron beam up to a 500 kGy dose to assess the ionizing radiation-induced effects. Both non-irradiated and irradiated membranes were characterized by Fourier Transformation infrared (FT-IR) spectroscopy, thermogravimetric analysis (TGA), proton nuclear magnetic resonance (¹H-NMR) spectroscopy, electrochemical impedance analysis and, for the first time for non-irradiated membranes, by spectrophotometric analysis with Cr(III). The above-mentioned methods for application for DS assessment were compared. The aim of this study is to compare different methods used for the determination of the DS of SPEEK membranes before and after high-dose irradiation. It was observed that irradiated membranes presented a higher value of DS. The appearance of different new signals in ¹H-NMR and FT-IR spectra of irradiated membranes indicated that the effects of radiation induced changes in the structure of SPEEK materials. The good correlation of Cr(III) absorption and SPEEK DS up to 80% indicates that the spectrophotometric method is a comparable tool for the characterization of SPEEK membranes.

The aim of this study is to compare different methods used for determination of the DS for sulfonated membranes before and after high dose irradiation. Commercial PEEK was homogenously sulfonated up to DS of 60-90% and the membranes were prepared using solvent casting method. Part of the samples were irradiated with 10 MeV electron beam up to 500 kGy dose to assess the ionising radiation induced effects. Both non-irradiated and irradiated membranes were characterized by Fourier Transformation infrared (FT-IR) spectrometry, thermogravimetric analysis (TGA), proton nuclear magnetic resonance (1H-NMR), electrochemical impedance analysis and for the first time for non-irradiated membranes by spectrophotometric analysis with Cr(III). Comparison of the above-mentioned methods for application for DS assessment was done. It was observed that irradiated membranes presented a higher value of DS. Appearance of different new signals in 1H-NMR and FT-IR spectra of irradiated membranes indicated the effects of radiation induced changes in the structure of SPEEK materials. It was determined that the novel method with Cr(III) is applicable for the determination of SPEEK DS under 80%.

The potential of aquatic plants to accumulate Cs may be of notable importance in the environmental monitoring of radioactive wastes. This study aimed to evaluate the accumulation of Cs-133 by freshwater macrophytes Bacopa amplexicaulis, Elodea densa, Ceratophyllum submersum, and Limnobium laevigantum after a 10-day incubation period with CsCl (1–1000 μM). The partitioning of Cs and other elements, including 21 metals, such as P, B, and As, was analyzed using inductively coupled plasma mass spectrometry combined with principal component analysis (PCA). The enzymatic activity of plant crude extracts and aquatic microorganisms was characterized. The transfer factor (TF) reached the highest values of 0.13 and 0.10 for C. submersum and L. laevigantum, respectively, at 1000 μM Cs. The TFs in the other sets were below 0.1. In the presence of Cs-133, there was a significant increase in dehydrogenase activity (p < 0.05) and a decrease in the activity of the Folin–Ciocalteu assay. A three-fold decrease in culturable microorganisms was found in plants with 1000 μM Cs. PCA analysis revealed the species-specific elemental distribution in plant biomass and the aquatic phase. A negative correlation between Na, Ca (2.0–2.5, PC1) and Mg, K, and P (−2, PC1) was found. Certain enzyme groups can serve as bioindicators of Cs pollution in aquatic ecosystems.

Twenty-seven mycotoxins in unprocessed cereals (n = 110) and pulses (n = 23) harvested in Latvia were analysed by nanoflow liquid chromatography combined with Orbitrap high-resolution mass spectrometry. One or more mycotoxins were found in 99% of the cereals and 78% of the pulses. Deoxynivalenol, zearalenone and T-2 and HT-2 toxins were prevalent in 9 to 86% of the cereals, mostly below their maximum levels as set by the European regulations. Non-regulated type A and B trichothecenes were prevalent in 5 to 87% of the cereals, at concentrations of 0.27–83 µg kg⁻¹ and 1.7–4,781 µg kg⁻¹, respectively. Quantification of emerging mycotoxins was also provided. Enniatins were detected in 94% of the cereals (3.5–2,073 µg kg⁻¹) and 13% of the pulses (4.4–17 µg kg⁻¹). Alternaria toxins were prevalent in 94% of the cereals at concentrations of 0.72–307 µg kg⁻¹ and in 39% of the pulses at 0.69–10 µg kg⁻¹.

In this paper, a study of fungal and multi-mycotoxin contamination in 140 Camellia sinensis and 26 herbal teas marketed in Latvia is discussed. The analysis was performed using two-dimensional liquid chromatography with time-of-flight mass spectrometry (2D-LC-TOF-MS) and MALDI-TOF-MS. In total, 87% of the tea samples tested positive for 32 fungal species belonging to 17 genera, with the total enumeration of moulds ranging between 1.00 × 10¹ and 9.00 × 10⁴ CFU g⁻¹. Moreover, 42% of the teas (n = 70) were contaminated by 1 to 16 mycotoxins, and 37% of these samples were positive for aflatoxins at concentrations ranging between 0.22 and 41.7 µg kg⁻¹. Deoxynivalenol (DON) and its derivatives co-occurred in 63% of the tea samples, with their summary concentrations reaching 81.1 to 17,360 µg kg⁻¹. Ochratoxin A (OTA), enniatins, and two Alternaria toxins were found in 10–37% of the teas at low concentrations. The dietary exposure assessment based on the assumption of a probable full transfer of determined mycotoxins into infusions indicated that the analysed teas are safe for consumers: the probable maximum daily exposure levels to OTA and the combined DON mycotoxins were only 0.88 to 2.05% and 2.50 to 78.9% of the tolerable daily intake levels.

The occurrence and dietary exposure assessment of 16 mycotoxins, 6 biogenic amines (BAs), and 13 metallic elements in blue-veined cheeses (n = 46) is reported. Co-occurrence of mycophenolic acid (≤599 µg·kg⁻¹) with roquefortine C (≤5454 µg·kg⁻¹) was observed in 63% of the tested cheeses, while BAs were frequently present at concentrations between 0.2 and 717 mg kg⁻¹. The concentrations of heavy metals in cheeses were very low. Chronic/acute exposure assessment based on consumption data from different European populations indicated that the levels of mycotoxins and heavy metals are safe to consumers, whereas, rather high hazard indexes (HI up to 0.77) were determined for BAs according to the worst-case scenario based on high consumption and 95th percentile occurrence. A more detailed acute dietary intake study indicated that histamine and tyramine were predominant among these BAs, reaching 27 and 41% of the acute oral intake reference doses.

The occurrence of 12 mycotoxins has been analysed by liquid chromatography – time of flight mass spectrometry in the batch of 60 herbal teas purchased from drugstores in Latvia. Among the dry tea samples, 90% were positive for one to eight mycotoxins. Enniatin B and deoxynivalenol (DON) were the most frequently detected mycotoxins in 55% and 45% of the samples, respectively. DON reached the highest level, from 129 µg kg⁻¹ in herbal blend to 5,463 µg kg⁻¹ in wormwood tea. Ochratoxin A (OTA) and aflatoxin B₁ (AFB₁) were found in 10% and 20% of the samples at the concentrations ranged between 2.99–30.3 µg kg⁻¹ and 3.40–23.7 µg kg⁻¹. Studies of the tea infusion process indicated that 32–100% of DON and zearalenone present in dry teas were extracted into the infusions. Dietary exposure assessment was performed, using the determined mycotoxin levels and the available consumption data.

In this study, Baytube™ multi‐walled carbon nanotubes (MWCNTs) were in situ modified by graft‐polymerized 2,2′‐bithiophene. The obtained PBT‐g‐MWCNTs were used as fillers for the development of semi‐conductive nanocomposites with ethylene–octene copolymer (EOC, ENGAGE™ 8540). The methods of infrared and Raman spectroscopy, thermogravimetric analysis, and transmission electron microscopy were used to characterize the filler materials. Composite specimens with neat MWCNTs and PBT‐g‐MWCNTs at their contents of 3, 5, and 10 wt% were made by ultra‐sound assisted master batching method and their mechanical and dielectric properties were compared. The strength properties (storage modulus, tensile strength) and the elongation at break of the composites with high contents (> 3 wt%) of PBT‐g‐MWCNTs were notably improved comparing to EOC/MWCNT composites. A notable improvement by more than two orders of magnitude of EOC conductivity was determined at 10 wt% content of PBT‐g‐MWCNT compared to that of pristine MWCNTs used as the composite nanofiller. POLYM. COMPOS., 40:3971–3980, 2019. © 2019 Society of Plastics Engineers