Jinming Wu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jinming Wu has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Malin Göteman
Department of Engineering Science, Uppsala University, 75121 Uppsala, Sweden
3 shared publications Liang Zhou
School of Mechatronics Engineering, Harbin Institute of Technology, Harbin, Heilongjiang, China
2 shared publications- Liang Zhou
School of Mechatronics Engineering, Harbin Institute of Technology, Harbin 150001, China
2 shared publications Yingxue Yao
Shenzhen Graduate School, Harbin Institute of Technology, Shenzhen, Guangdong, China
2 shared publications- Yingxue Yao
Shenzhen Graduate School, Harbin Institute of Technology, Shenzhen 518055, Guangdong, China
2 shared publications Huifeng Yu
State Key Laboratory of Hydroscience and Engineering, Tsinghua University, Beijing, China
1 shared publication
Latest Publications
- 1 July 2018
- Published by Elsevier in Applied Energy
- Vol. 222, 717-728
Real-time latching control strategies for the solo Duck wave energy converter in irregular waves
- 1 July 2018
- Published by Elsevier in Applied Energy
- Vol. 222, 717-728
Real-time latching control strategies for the solo Duck wave energy converter in irregular waves
- Open Access
Latching and Declutching Control of the Solo Duck Wave-Energy Converter with Different Load Types
The solo duck wave-energy converter (WEC) captures power in a point absorber manner, hence it exhibits high power-capture efficiency within only a narrow bandwidth. Passive control is characterized by a unidirectional power flow, and thus its engineering implementation can be simplified. In this paper, two typical passive control strategies, latching and declutching control, are applied to the solo duck WEC to improve its power-capture performance at wave periods larger and smaller than the natural period of the WEC, respectively. Special attention is paid to the peak value of instantaneous WEC performance parameters, including the peak motion excursion, the peak power take-off (PTO) moment, and the peak-to-average power ratio, when the captured power is maximized. Performance differences between the linear and coulomb loads are also investigated. Results show that both latching and declutching control can effectively improve captured power, but also incidentally increase the peak motion excursion and peak-to-average power ratio. When under latching and declutching control, the coulomb load leads to the same maximum relative capture width and peak motion excursion as the linear load, but presents smaller peak PTO moment and peak-to-average power ratio than the linear load, hence making the coulomb load the better choice for the solo duck WEC.
Open AccessLatching and Declutching Control of the Solo Duck Wave-Energy Converter with Different Load Types
The solo duck wave-energy converter (WEC) captures power in a point absorber manner, hence it exhibits high power-capture efficiency within only a narrow bandwidth. Passive control is characterized by a unidirectional power flow, and thus its engineering implementation can be simplified. In this paper, two typical passive control strategies, latching and declutching control, are applied to the solo duck WEC to improve its power-capture performance at wave periods larger and smaller than the natural period of the WEC, respectively. Special attention is paid to the peak value of instantaneous WEC performance parameters, including the peak motion excursion, the peak power take-off (PTO) moment, and the peak-to-average power ratio, when the captured power is maximized. Performance differences between the linear and coulomb loads are also investigated. Results show that both latching and declutching control can effectively improve captured power, but also incidentally increase the peak motion excursion and peak-to-average power ratio. When under latching and declutching control, the coulomb load leads to the same maximum relative capture width and peak motion excursion as the linear load, but presents smaller peak PTO moment and peak-to-average power ratio than the linear load, hence making the coulomb load the better choice for the solo duck WEC.
- Open Access
Optimizing the Performance of Solo Duck Wave Energy Converter in Tide
The high efficiency performance of the Edinburgh Duck wave energy converter (WEC) in 2D regular wave tests makes it a promising wave energy conversion scheme. A solo Duck WEC will be able to apply the point absorber effect to further enhance its performance. Since released degree of freedom will decrease the efficiency, a Duck WEC with fixed pitching axis will be a better option. However, for fixed supported WECs, tide is a non-ignorable consideration. In this paper, a movable mass method is utilized in the whole tidal range to not only balance the Duck to appropriate beak angles, but also follow the variation of hydrodynamic coefficients to keep cancelling the reactance of the system impedance so that complex conjugate control can be realized to optimize the power capture performance of the Duck WEC in tide. Results show that the beak angle should be adjusted to as large a value as possible so that the response amplitude of the Duck at maximum relative capture width will be reasonable small, and the lowest weight of the movable mass is found when its designed position locates at the center of the Duck profile.
Open AccessOptimizing the Performance of Solo Duck Wave Energy Converter in Tide
The high efficiency performance of the Edinburgh Duck wave energy converter (WEC) in 2D regular wave tests makes it a promising wave energy conversion scheme. A solo Duck WEC will be able to apply the point absorber effect to further enhance its performance. Since released degree of freedom will decrease the efficiency, a Duck WEC with fixed pitching axis will be a better option. However, for fixed supported WECs, tide is a non-ignorable consideration. In this paper, a movable mass method is utilized in the whole tidal range to not only balance the Duck to appropriate beak angles, but also follow the variation of hydrodynamic coefficients to keep cancelling the reactance of the system impedance so that complex conjugate control can be realized to optimize the power capture performance of the Duck WEC in tide. Results show that the beak angle should be adjusted to as large a value as possible so that the response amplitude of the Duck at maximum relative capture width will be reasonable small, and the lowest weight of the movable mass is found when its designed position locates at the center of the Duck profile.