Tobias Egle
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Tobias Egle has a total of 49 co-authors. Here are the top co-authors by number of shared publications:
- Cynthia M. Friend
John A. Paulson School of Engineering and Applied Sciences, Harvard University, Cambridge, Massachusetts 02138, United States
9 shared publications - Christopher R. O'COnnor
Rowland Institute at Harvard, Harvard University, Cambridge, USA
6 shared publications - Robert J. Madix
John A. Paulson School of Engineering and Applied Sciences, Harvard University, Cambridge, MA 02138, USA
4 shared publications - Jason F. Weaver
University of Florida
3 shared publications - Matthijs André Van Spronsen
Diamond Light Source
3 shared publications - Mustafa Karatok
Department of Nanotechnology and Nanomedicine, Hacettepe University, Ankara, Türkiye
3 shared publications
Latest Publications
- 21 November 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (48) , 20332-20342
Creation of Well-Defined Pd Surface Sites on Single Crystal Pd33Ag67: From Ensembles to Single Atoms
- 21 November 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (48) , 20332-20342
Creation of Well-Defined Pd Surface Sites on Single Crystal Pd33Ag67: From Ensembles to Single Atoms
- Open Access
- 5 February 2022
- Published by Elsevier in Surface Science
- Vol. 720, 122048
Comment on “STM study of the (111) and (100) surfaces of PdAg, Surf. Sci. 417 (1998) 292–300″ and references therein
- 5 February 2022
- Published by Elsevier in Surface Science
- Vol. 720, 122048
Open AccessComment on “STM study of the (111) and (100) surfaces of PdAg, Surf. Sci. 417 (1998) 292–300″ and references therein
- 15 July 2021
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry Letters
- Vol. 12 (29) , 6752-6759
Regeneration of Active Surface Alloys during Cyclic Oxidation and Reduction: Oxidation of H2 on Pd/Ag(111)
The surface morphology and composition of a catalyst during excursions between oxidizing and reducing conditions can change substantially, especially in bimetallic alloys. Both thermodynamic and kinetic factors play a role in determining the properties of alloy surfaces where the active phase may be a metastable state. Previously, Ag oxide reduction was shown to be dramatically enhanced when Pd is on the surface; however, Pd is more stable when dissolved in Ag, raising the question as to whether a highly active Pd surface state will persist over multiple reaction cycles, a requirement for catalytic function. Experiments herein demonstrate that the enhanced chemical functionality due to the presence of Pd on the surface is retained, based on the enhanced rate of silver oxide reduction over multiple oxidation/reduction cycles for a Pd/Ag(111) model. Repeated oxidation and reduction promote PdAg alloying, and reversible structural and compositional changes are detected using X-ray photoelectron spectroscopy. This study establishes that metastable phases can persist in reactive processes on surfaces, indicating their potential in heterogeneous catalysis.
- 15 July 2021
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry Letters
- Vol. 12 (29) , 6752-6759
Regeneration of Active Surface Alloys during Cyclic Oxidation and Reduction: Oxidation of H2 on Pd/Ag(111)
The surface morphology and composition of a catalyst during excursions between oxidizing and reducing conditions can change substantially, especially in bimetallic alloys. Both thermodynamic and kinetic factors play a role in determining the properties of alloy surfaces where the active phase may be a metastable state. Previously, Ag oxide reduction was shown to be dramatically enhanced when Pd is on the surface; however, Pd is more stable when dissolved in Ag, raising the question as to whether a highly active Pd surface state will persist over multiple reaction cycles, a requirement for catalytic function. Experiments herein demonstrate that the enhanced chemical functionality due to the presence of Pd on the surface is retained, based on the enhanced rate of silver oxide reduction over multiple oxidation/reduction cycles for a Pd/Ag(111) model. Repeated oxidation and reduction promote PdAg alloying, and reversible structural and compositional changes are detected using X-ray photoelectron spectroscopy. This study establishes that metastable phases can persist in reactive processes on surfaces, indicating their potential in heterogeneous catalysis.
- 16 November 2020
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 10 (23) , 13878-13889
Oxophilicity Drives Oxygen Transfer at a Palladium–Silver Interface for Increased CO Oxidation Activity
- 16 November 2020
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 10 (23) , 13878-13889
Oxophilicity Drives Oxygen Transfer at a Palladium–Silver Interface for Increased CO Oxidation Activity
- 14 August 2020
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 142 (37) , 15907-15916
Evolution of Metastable Structures at Bimetallic Surfaces from Microscopy and Machine-Learning Molecular Dynamics
Restructuring of interfaces plays a crucial role in materials science and heterogeneous catalysis. Bimetallic systems, in particular, often adopt very different composition and morphology at surfaces compared to the bulk. For the first time, we reveal a detailed atomistic picture of long-timescale restructuring of Pd deposited on Ag, using microscopy, spectroscopy, and novel simulation methods. By developing and performing accelerated machine-learning molecular dynamics followed by an automated analysis method, we discover and characterize previously unidentified surface restructuring mechanisms in an unbiased fashion, including Pd-Ag place exchange and Ag pop-out, as well as step ascent and descent. Remarkably, layer-by-layer dissolution of Pd into Ag is always preceded by an encapsulation of Pd islands by Ag, resulting in a significant migration of Ag out of the surface and a formation of extensive vacancy pits within a period of microseconds. These metastable structures are of vital catalytic importance, as Ag-encapsulated Pd remains much more accessible to reactants than bulk-dissolved Pd. Our approach is broadly applicable to complex multimetallic systems and enables the previously intractable mechanistic investigation of restructuring dynamics at atomic resolution.
- 14 August 2020
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 142 (37) , 15907-15916
Evolution of Metastable Structures at Bimetallic Surfaces from Microscopy and Machine-Learning Molecular Dynamics
Restructuring of interfaces plays a crucial role in materials science and heterogeneous catalysis. Bimetallic systems, in particular, often adopt very different composition and morphology at surfaces compared to the bulk. For the first time, we reveal a detailed atomistic picture of long-timescale restructuring of Pd deposited on Ag, using microscopy, spectroscopy, and novel simulation methods. By developing and performing accelerated machine-learning molecular dynamics followed by an automated analysis method, we discover and characterize previously unidentified surface restructuring mechanisms in an unbiased fashion, including Pd-Ag place exchange and Ag pop-out, as well as step ascent and descent. Remarkably, layer-by-layer dissolution of Pd into Ag is always preceded by an encapsulation of Pd islands by Ag, resulting in a significant migration of Ag out of the surface and a formation of extensive vacancy pits within a period of microseconds. These metastable structures are of vital catalytic importance, as Ag-encapsulated Pd remains much more accessible to reactants than bulk-dissolved Pd. Our approach is broadly applicable to complex multimetallic systems and enables the previously intractable mechanistic investigation of restructuring dynamics at atomic resolution.
- 11 August 2020
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 10 (17) , 10117-10124
Reduction of Oxidized Pd/Ag(111) Surfaces by H2: Sensitivity to PdO Island Size and Dispersion
- 11 August 2020
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 10 (17) , 10117-10124
Reduction of Oxidized Pd/Ag(111) Surfaces by H2: Sensitivity to PdO Island Size and Dispersion
- Open Access
- 15 April 2020
- Published by Springer Nature in Nature Communications
- Vol. 11 (1) , 1-6
Hydrogen migration at restructuring palladium–silver oxide boundaries dramatically enhances reduction rate of silver oxide
Heterogeneous catalysts are complex materials with multiple interfaces. A critical proposition in exploiting bifunctionality in alloy catalysts is to achieve surface migration across interfaces separating functionally dissimilar regions. Herein, we demonstrate the enhancement of more than 104 in the rate of molecular hydrogen reduction of a silver surface oxide in the presence of palladium oxide compared to pure silver oxide resulting from the transfer of atomic hydrogen from palladium oxide islands onto the surrounding surface formed from oxidation of a palladium–silver alloy. The palladium–silver interface also dynamically restructures during reduction, resulting in silver–palladium intermixing. This study clearly demonstrates the migration of reaction intermediates and catalyst material across surface interfacial boundaries in alloys with a significant effect on surface reactivity, having broad implications for the catalytic function of bimetallic materials.
- 15 April 2020
- Published by Springer Nature in Nature Communications
- Vol. 11 (1) , 1-6
Open AccessHydrogen migration at restructuring palladium–silver oxide boundaries dramatically enhances reduction rate of silver oxide
Heterogeneous catalysts are complex materials with multiple interfaces. A critical proposition in exploiting bifunctionality in alloy catalysts is to achieve surface migration across interfaces separating functionally dissimilar regions. Herein, we demonstrate the enhancement of more than 104 in the rate of molecular hydrogen reduction of a silver surface oxide in the presence of palladium oxide compared to pure silver oxide resulting from the transfer of atomic hydrogen from palladium oxide islands onto the surrounding surface formed from oxidation of a palladium–silver alloy. The palladium–silver interface also dynamically restructures during reduction, resulting in silver–palladium intermixing. This study clearly demonstrates the migration of reaction intermediates and catalyst material across surface interfacial boundaries in alloys with a significant effect on surface reactivity, having broad implications for the catalytic function of bimetallic materials.
- 25 February 2020
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 22 (11) , 6202-6209
Growth and auto-oxidation of Pd on single-layer AgOx/Ag(111)
Pd is auto-oxidized during deposition onto AgOx and undergoes a transition from single to bi-layer growth at low Pd coverage.
- 25 February 2020
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 22 (11) , 6202-6209
Growth and auto-oxidation of Pd on single-layer AgOx/Ag(111)
Pd is auto-oxidized during deposition onto AgOx and undergoes a transition from single to bi-layer growth at low Pd coverage.
- 19 November 2018
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 123 (13) , 8312-8323
Dynamics of Surface Alloys: Rearrangement of Pd/Ag(111) Induced by CO and O2
- 19 November 2018
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 123 (13) , 8312-8323
Dynamics of Surface Alloys: Rearrangement of Pd/Ag(111) Induced by CO and O2
- 19 July 2017
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 9 (30) , 25615-25622
Multiscale Morphology of Nanoporous Copper Made from Intermetallic Phases
Many application-relevant properties of nanoporous metals critically depend on their multiscale architecture. For example, the intrinsically high step-edge density of curved surfaces at the nanoscale provides highly reactive sites for catalysis, whereas the macroscale pore and grain morphology determines the macroscopic properties, such as mass transport, electrical conductivity, or mechanical properties. In this work, we systematically study the effects of alloy composition and dealloying conditions on the multiscale morphology of nanoporous copper (np-Cu) made from various commercial Zn–Cu precursor alloys. Using a combination of X-ray diffraction, electron backscatter diffraction, and focused ion beam cross-sectional analysis, our results reveal that the macroscopic grain structure of the starting alloy surprisingly survives the dealloying process, despite a change in crystal structure from body-centered cubic (Zn–Cu starting alloy) to face-centered cubic (Cu). The nanoscale structure can be controlled by the acid used for dealloying with HCl leading to a larger and more faceted ligament morphology compared to that of H3PO4. Anhydrous ethanol dehydrogenation was used as a probe reaction to test the effect of the nanoscale ligament morphology on the apparent activation energy of the reaction.
- 19 July 2017
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 9 (30) , 25615-25622
Multiscale Morphology of Nanoporous Copper Made from Intermetallic Phases
Many application-relevant properties of nanoporous metals critically depend on their multiscale architecture. For example, the intrinsically high step-edge density of curved surfaces at the nanoscale provides highly reactive sites for catalysis, whereas the macroscale pore and grain morphology determines the macroscopic properties, such as mass transport, electrical conductivity, or mechanical properties. In this work, we systematically study the effects of alloy composition and dealloying conditions on the multiscale morphology of nanoporous copper (np-Cu) made from various commercial Zn–Cu precursor alloys. Using a combination of X-ray diffraction, electron backscatter diffraction, and focused ion beam cross-sectional analysis, our results reveal that the macroscopic grain structure of the starting alloy surprisingly survives the dealloying process, despite a change in crystal structure from body-centered cubic (Zn–Cu starting alloy) to face-centered cubic (Cu). The nanoscale structure can be controlled by the acid used for dealloying with HCl leading to a larger and more faceted ligament morphology compared to that of H3PO4. Anhydrous ethanol dehydrogenation was used as a probe reaction to test the effect of the nanoscale ligament morphology on the apparent activation energy of the reaction.