Radoslaw Kot
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Radoslaw Kot has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Mariusz Malinowski
Warsaw University of Technology, Warsaw, Poland
8 shared publications - Sebastian Stynski
Warsaw University of Technology, Institute of Control and Industrial Electronics, Warsaw, Poland
4 shared publications - Adam Milczarek
Institute of Control and Industrial Electronics, Warsaw University of Technology, Koszykowa 75, 00-662 Warsaw, Poland
2 shared publications M. Rolak
2 shared publicationsJ. T. Szuster
Warsaw University of Technology, Faculty of Power and Aeronautical Engineering, Poland
1 shared publicationJan T. Szuster
Warsaw University of Technology, Warszawa, 00-661, Poland
1 shared publication
Latest Publications
- Open Access
- 24 December 2023
- Published by MDPI AG in Electronics
- Vol. 13 (1) , 87
Comparison of Energy Storage Management Techniques for a Grid-Connected PV- and Battery-Supplied Residential System
The use of renewable energy sources (RES) such as wind and solar power is increasing rapidly to meet growing electricity demand. However, the intermittent nature of RES poses a challenge to grid stability. Energy storage (ES) technologies offer a solution by adding flexibility to the system. With the emergence of distributed energy resources (DERs) and the transition to prosumer-based electricity systems, energy management systems (EMSs) have become crucial to coordinate the operation of different devices and optimize system efficiency and functionality. This paper presents an EMS for a residential photovoltaic (PV) and battery system that addresses two different functionalities: energy cost minimization, and self-consumption maximization. The proposed EMS takes into account the operational requirements of the devices and their lower-level controllers. A genetic algorithm (GA) is used to solve the optimization problems, ensuring a desired State of Charge (SOC) at the end of the day based on the next day forecast, without discretizing the SOC transitions allowing a continuous search space. The importance of adhering to the manufacturer’s operating specification to avoid premature battery degradation is highlighted, and a comparative analysis is performed with a simple tariff-driven solution, evaluating total cost, energy exchange, and peak power. Tests are carried out in a detailed model, where Power Electronics Converters (PECs) and their local controllers are considered together with the EMS.
- 24 December 2023
- Published by MDPI AG in Electronics
- Vol. 13 (1) , 87
Open AccessComparison of Energy Storage Management Techniques for a Grid-Connected PV- and Battery-Supplied Residential System
The use of renewable energy sources (RES) such as wind and solar power is increasing rapidly to meet growing electricity demand. However, the intermittent nature of RES poses a challenge to grid stability. Energy storage (ES) technologies offer a solution by adding flexibility to the system. With the emergence of distributed energy resources (DERs) and the transition to prosumer-based electricity systems, energy management systems (EMSs) have become crucial to coordinate the operation of different devices and optimize system efficiency and functionality. This paper presents an EMS for a residential photovoltaic (PV) and battery system that addresses two different functionalities: energy cost minimization, and self-consumption maximization. The proposed EMS takes into account the operational requirements of the devices and their lower-level controllers. A genetic algorithm (GA) is used to solve the optimization problems, ensuring a desired State of Charge (SOC) at the end of the day based on the next day forecast, without discretizing the SOC transitions allowing a continuous search space. The importance of adhering to the manufacturer’s operating specification to avoid premature battery degradation is highlighted, and a comparative analysis is performed with a simple tariff-driven solution, evaluating total cost, energy exchange, and peak power. Tests are carried out in a detailed model, where Power Electronics Converters (PECs) and their local controllers are considered together with the EMS.
- 20 January 2016
- Published by The Korean Institute of Power Electronics in Journal of Power Electronics
- Vol. 16 (1) , 153-162
Simple Technique Reducing Leakage Current for H-Bridge Converter in Transformerless Photovoltaic Generation
- 20 January 2016
- Published by The Korean Institute of Power Electronics in Journal of Power Electronics
- Vol. 16 (1) , 153-162
Simple Technique Reducing Leakage Current for H-Bridge Converter in Transformerless Photovoltaic Generation
- 1 November 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 000076-000081
Experimental evaluation of hardware-based Global Maximum Power Point Searching methods
Operation under partial shading condition (PSC) significantly decreases energy extracted from photovoltaic (PV) power plants. Non-uniform insolation caused by the passing clouds and natural obstacles results in some PV modules to be effectively excluded from operation. Commercially used maximum power point tracking (MPPT) algorithms do not have any information about the global behavior of the PV string or array which they control. This can induce significant error in determining the optimum operating point and in turn affect efficiency of the system. This paper focuses on Global Maximum Power Point Searching (GMPPS) methods based on fast, hardware power-voltage (p-v) sweeping techniques. Two methods based on variable channel resistance of the MOSFET and switched inductor are analyzed and tested for a 3.5 kW PV array in the field conditions. Study shows that both solutions are suitable for accurate p-v sweep independently of the PV array configuration or shading pattern.
- 1 November 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 000076-000081
Experimental evaluation of hardware-based Global Maximum Power Point Searching methods
Operation under partial shading condition (PSC) significantly decreases energy extracted from photovoltaic (PV) power plants. Non-uniform insolation caused by the passing clouds and natural obstacles results in some PV modules to be effectively excluded from operation. Commercially used maximum power point tracking (MPPT) algorithms do not have any information about the global behavior of the PV string or array which they control. This can induce significant error in determining the optimum operating point and in turn affect efficiency of the system. This paper focuses on Global Maximum Power Point Searching (GMPPS) methods based on fast, hardware power-voltage (p-v) sweeping techniques. Two methods based on variable channel resistance of the MOSFET and switched inductor are analyzed and tested for a 3.5 kW PV array in the field conditions. Study shows that both solutions are suitable for accurate p-v sweep independently of the PV array configuration or shading pattern.
- 3 September 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Power Electronics Magazine
- Vol. 2 (3) , 16-30
Optimized Energy-Conversion Systems for Small Wind Turbines: Renewable energy sources in modern distributed power generation systems
Renewable energy sources (RESs) play an increasingly important role in modern distributed power generation systems. Some RES technologies, e.g., photovoltaics and high power wind turbines (WTs), are already reaching a mature stage of development. However, there is another area that still needs further development and requires more attention: low-power small WT (SWT) systems. Many solutions with different features are being proposed with the aim of achieving the best efficiency while minimizing costs and improving performance. The goal of this article is to investigate the status of the SWT sector and its possible expansion. To evaluate future trends, it is essential to review and summarize current technology in the SWT sector, including the design and construction of wind rotors and generators, power electronics converter topologies, and their controls.
- 3 September 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Power Electronics Magazine
- Vol. 2 (3) , 16-30
Optimized Energy-Conversion Systems for Small Wind Turbines: Renewable energy sources in modern distributed power generation systems
Renewable energy sources (RESs) play an increasingly important role in modern distributed power generation systems. Some RES technologies, e.g., photovoltaics and high power wind turbines (WTs), are already reaching a mature stage of development. However, there is another area that still needs further development and requires more attention: low-power small WT (SWT) systems. Many solutions with different features are being proposed with the aim of achieving the best efficiency while minimizing costs and improving performance. The goal of this article is to investigate the status of the SWT sector and its possible expansion. To evaluate future trends, it is essential to review and summarize current technology in the SWT sector, including the design and construction of wind rotors and generators, power electronics converter topologies, and their controls.
- 1 September 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Simple scanning methods for a Global-MPP determination in a PV string
- 1 September 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Simple scanning methods for a Global-MPP determination in a PV string
- 1 March 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2907-2914
Hardware methods for detecting global maximum power point in a PV power plant
Conventional maximum power point tracking (MPPT) algorithms are designed under assumption that all modules are uniformly insulated and therefore can be characterized by a single maximum power point (MPP). At increasing power level PV arrays become larger in area. Moreover, to achieve a reasonable voltage level modules are connected in series, creating strings. These two factors make any array susceptible for any mismatch in their current-voltage characteristics. Under partial shading condition (PSC), when PV modules receive different insulation, multiple maxima occur in power curve of the array. This leads to a tracking error of the MPP and results in significant decrease in efficiency of the system. This paper describes Global Maximum Power Point Searching (GMPPS) methods which are designed specifically for searching global MPP (GMPP). Three hardware methods, which are based on fast sweeping of the characteristics via additional circuitry are described and compared. Three-level boost (TLB) converter is utilized as a DC-DC converter performing GMPPS. Simulation results are provided with 15 kWp PV string model.
- 1 March 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2907-2914
Hardware methods for detecting global maximum power point in a PV power plant
Conventional maximum power point tracking (MPPT) algorithms are designed under assumption that all modules are uniformly insulated and therefore can be characterized by a single maximum power point (MPP). At increasing power level PV arrays become larger in area. Moreover, to achieve a reasonable voltage level modules are connected in series, creating strings. These two factors make any array susceptible for any mismatch in their current-voltage characteristics. Under partial shading condition (PSC), when PV modules receive different insulation, multiple maxima occur in power curve of the array. This leads to a tracking error of the MPP and results in significant decrease in efficiency of the system. This paper describes Global Maximum Power Point Searching (GMPPS) methods which are designed specifically for searching global MPP (GMPP). Three hardware methods, which are based on fast sweeping of the characteristics via additional circuitry are described and compared. Three-level boost (TLB) converter is utilized as a DC-DC converter performing GMPPS. Simulation results are provided with 15 kWp PV string model.
- 1 May 2013
- Published by Elsevier in Mathematics and Computers in Simulation
- Vol. 91, 29-40
Comparison of maximum peak power tracking algorithms for a small wind turbine
- 1 May 2013
- Published by Elsevier in Mathematics and Computers in Simulation
- Vol. 91, 29-40
Comparison of maximum peak power tracking algorithms for a small wind turbine
- 1 June 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21635137,p. 1023-1028
Design of Small Wind Turbine with Maximum Power Point Tracking Algorithm
This paper presents a complex design of Small Wind Turbine with AC/DC converter containing Maximum Power Point Tracking Algorithm. The paper describes a general issues, phenomenon and problems connected with designing particular parts for small wind turbine, such a generator or wind rotor. In addition, it shows short discussion between two different Maximum Power Point Tracking approaches, simulation and experimental results.
- 1 June 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21635137,p. 1023-1028
Design of Small Wind Turbine with Maximum Power Point Tracking Algorithm
This paper presents a complex design of Small Wind Turbine with AC/DC converter containing Maximum Power Point Tracking Algorithm. The paper describes a general issues, phenomenon and problems connected with designing particular parts for small wind turbine, such a generator or wind rotor. In addition, it shows short discussion between two different Maximum Power Point Tracking approaches, simulation and experimental results.