Fan Xiao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Fan Xiao has a total of 56 co-authors. Here are the top co-authors by number of shared publications:
Akiyoshi Osaka
6 shared publicationsFei Gao
Zhejiang University of Technology
5 shared publications- Satoshi Hayakawa
Faculty of Interdisciplinary Science and Engineering in Health Systems, Okayama University
5 shared publications Zhi Xian Zhang
Zhejiang University of Technology
5 shared publicationsKanji Tsuru
Okayama University, Tsushima
4 shared publicationsJia You
3 shared publications
Latest Publications
- 15 July 2025
- Published by Elsevier in Materials Science and Engineering: C
- Vol. 177, 214412
Design and in vitro evaluation of gradient Schwarz Primitive scaffolds with thin-board integration for bone implants
- 15 July 2025
- Published by Elsevier in Materials Science and Engineering: C
- Vol. 177, 214412
Design and in vitro evaluation of gradient Schwarz Primitive scaffolds with thin-board integration for bone implants
- 18 May 2024
- Published by Elsevier in Materials Science and Engineering: C
- Vol. 161, 213899
Gradient gyroid Ti6Al4V scaffolds with TiO2 surface modification: Promising approach for large bone defect repair
- 18 May 2024
- Published by Elsevier in Materials Science and Engineering: C
- Vol. 161, 213899
Gradient gyroid Ti6Al4V scaffolds with TiO2 surface modification: Promising approach for large bone defect repair
- 7 May 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (16) , 27689-27698
In situ fabrication of NIR-II responsive TiO2 bio-metasurface for photothermal antibacterial and enhanced osseointegration
- 7 May 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (16) , 27689-27698
In situ fabrication of NIR-II responsive TiO2 bio-metasurface for photothermal antibacterial and enhanced osseointegration
- Open Access
- 26 February 2022
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 18, 611-628
Mixture optimisation for cement-soil mixtures with embedded GFRP tendons
- 26 February 2022
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 18, 611-628
Open AccessMixture optimisation for cement-soil mixtures with embedded GFRP tendons
- Open Access
- 1 January 2020
- Published by IOP Publishing in Materials Research Express
- Vol. 7 (1) , 015513
Synthesis of novel microencapsulated phase change material with SnO2/CNTs shell for solar energy storage and photo-thermal conversion
In this study, In-situ precipitation reaction was used to prepare paraffin@SnO2/CNTs composite phase change materials. The paraffin@SnO2/CNTs composites material were prepared by using paraffin as a phase change core material, and tin dioxide and carbon nanotubes as composite shell materials. The microstructure, chemical composition and crystal phase structure of the composites were analyzed by Scanning electron microscope (SEM), Fourier infrared spectrum (FT-IR) and X-ray diffraction (XRD). The thermal performance and thermal stability of phase change materials were determined by differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA). The microcapsule has a core–shell structure with a diameter of 2–5 μm. The encapsulation efficiency of the paraffin@SnO2/CNTs composite was calculated to be 42.94%. The slurry is formed by dispersing microcapsules in water, which not only greatly improves the specific heat capacity, thermal conductivity, visible light absorption, but also makes the effective receiving efficiency reach 91.79% at 40 °C, indicating that it is a promising heat transfer working slurry in the field of Direct Absorption Solar Collectors (DASC) system.
- 1 January 2020
- Published by IOP Publishing in Materials Research Express
- Vol. 7 (1) , 015513
Open AccessSynthesis of novel microencapsulated phase change material with SnO2/CNTs shell for solar energy storage and photo-thermal conversion
In this study, In-situ precipitation reaction was used to prepare paraffin@SnO2/CNTs composite phase change materials. The paraffin@SnO2/CNTs composites material were prepared by using paraffin as a phase change core material, and tin dioxide and carbon nanotubes as composite shell materials. The microstructure, chemical composition and crystal phase structure of the composites were analyzed by Scanning electron microscope (SEM), Fourier infrared spectrum (FT-IR) and X-ray diffraction (XRD). The thermal performance and thermal stability of phase change materials were determined by differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA). The microcapsule has a core–shell structure with a diameter of 2–5 μm. The encapsulation efficiency of the paraffin@SnO2/CNTs composite was calculated to be 42.94%. The slurry is formed by dispersing microcapsules in water, which not only greatly improves the specific heat capacity, thermal conductivity, visible light absorption, but also makes the effective receiving efficiency reach 91.79% at 40 °C, indicating that it is a promising heat transfer working slurry in the field of Direct Absorption Solar Collectors (DASC) system.
- 1 June 2019
- Published by Elsevier in Surface and Coatings Technology
- Vol. 367, 91-99
Low-temperature fabrication of titania layer on 3D-printed 316L stainless steel for enhancing biocompatibility
- 1 June 2019
- Published by Elsevier in Surface and Coatings Technology
- Vol. 367, 91-99
Low-temperature fabrication of titania layer on 3D-printed 316L stainless steel for enhancing biocompatibility
- 1 April 2019
- Published by Elsevier in Surface and Coatings Technology
- Vol. 363, 338-343
The fabrication of nanostructured titania polymorphs layer with high crystallinity and its apatite-forming ability
- 1 April 2019
- Published by Elsevier in Surface and Coatings Technology
- Vol. 363, 338-343
The fabrication of nanostructured titania polymorphs layer with high crystallinity and its apatite-forming ability
- 16 July 2018
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 29 (17) , 15241-15248
Synthesis and characterization of microencapsulated paraffin with TiO2 shell as thermal energy storage materials
- 16 July 2018
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 29 (17) , 15241-15248
Synthesis and characterization of microencapsulated paraffin with TiO2 shell as thermal energy storage materials
- 1 January 2017
- Published by Inderscience Publishers in International Journal of Industrial and Systems Engineering
- Vol. 25 (1) , 14
Location and pricing of competitive service providers for post-disaster relief
- 1 January 2017
- Published by Inderscience Publishers in International Journal of Industrial and Systems Engineering
- Vol. 25 (1) , 14
Location and pricing of competitive service providers for post-disaster relief