Seyyed Mohammad Javad Asgari Tabatabaee
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Seyyed Mohammad Javad Asgari Tabatabaee has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Mohammad Towliat
Department of Electrical and Computer Engineering, University of Delaware, Newark, DE, USA
8 shared publications - Morteza Rajabzadeh
Electrical Engineering Department, Quchan University of Technology, Quchan, Iran
7 shared publications Farid Samsami Khodadad
Modern Technologies Engineering Department , Amol University of Spatial of Modern Technologies , Amol , Iran
2 shared publications- Mohsen Abbasi-Jannatabad
Electrical Engineering Department, Khorasan Institute of Higher Education, Mashhad, Iran
2 shared publications A. Maroosi
1 shared publication- Ali Maroosi
Department of Computer Engineering, University of Torbat Heydarieh, Torbat Heydarieh, Iran
1 shared publication
Latest Publications
- 20 February 2026
- Published by Walter de Gruyter GmbH in Frequenz
- Vol. 80 (5-6) , 237-246
Secure transmission with different security requirements based on covert communication and information-theoretic security in the presence of friendly jammer
This paper addresses the power allocation problem in a network where joint information-theoretic secrecy and covert communication are required. In this network, a single transmitter (Alice) sends information to two legitimate users (Bob and Carol). There is also an untrusted user who attempts to detect the content of Bob’s message and a warden (Willie) who wants to detect the existence of communication between Alice and the two users. Thus, Carol requires covert transmission, and Bob requires secure and covert communication. The network utilizes a friendly jammer to address these demands and overcome the low transmission rate of covert communication. To achieve covert communication, Alice sends both users’ data simultaneously in selected time slots to hide it from Willie, while the jammer continuously transmits signals in all time slots. The objective is to maximize the average transmission rate over the allocated powers of Bob, Carol, and the jammer while meeting the two users’ requirements. A novel iterative algorithm is proposed to obtain an effective solution. Simulation results indicate that the proposed method can enhance the network’s average rate while satisfying the users’ demands.
- 20 February 2026
- Published by Walter de Gruyter GmbH in Frequenz
- Vol. 80 (5-6) , 237-246
Secure transmission with different security requirements based on covert communication and information-theoretic security in the presence of friendly jammer
This paper addresses the power allocation problem in a network where joint information-theoretic secrecy and covert communication are required. In this network, a single transmitter (Alice) sends information to two legitimate users (Bob and Carol). There is also an untrusted user who attempts to detect the content of Bob’s message and a warden (Willie) who wants to detect the existence of communication between Alice and the two users. Thus, Carol requires covert transmission, and Bob requires secure and covert communication. The network utilizes a friendly jammer to address these demands and overcome the low transmission rate of covert communication. To achieve covert communication, Alice sends both users’ data simultaneously in selected time slots to hide it from Willie, while the jammer continuously transmits signals in all time slots. The objective is to maximize the average transmission rate over the allocated powers of Bob, Carol, and the jammer while meeting the two users’ requirements. A novel iterative algorithm is proposed to obtain an effective solution. Simulation results indicate that the proposed method can enhance the network’s average rate while satisfying the users’ demands.
- 16 May 2024
- Published by Elsevier in Physical Communication
- Vol. 65
Deep learning-based receiver design for generalized frequency division multiplexing (GFDM)
- 16 May 2024
- Published by Elsevier in Physical Communication
- Vol. 65
Deep learning-based receiver design for generalized frequency division multiplexing (GFDM)
- 16 February 2023
- Published by Walter de Gruyter GmbH in Frequenz
- Vol. 77 (7-8) , 371-383
A novel non-iterative algorithm for the joint design of transceiver beamforming and surface reflection in an IRS-enhanced MIMO system
Intelligent reflecting surface (IRS) is an emerging and low-cost revolutionary technology that can be deployed in future communication systems to enhance data transmission performance. An IRS comprises a lot of small, passive, and low-cost elements that can smartly reflect the incident signal from the transmitter to the receiver. In this paper, an IRS-enhanced multiple-input multiple-output (MIMO) downlink network is considered, in which a cell-edge user receives the data signal from a base station (BS). In this network, the direct path between the BS and the user is blocked by an obstacle, and the user receives only the tunable reflected signal from the IRS. To achieve spatial diversity, beamforming is applied to the antennas at the BS and the user. The goal is to jointly design the transceiver beamforming vectors and the IRS reflection coefficients so that the signal-to-noise ratio (SNR) of the user is maximized. Since the IRS elements are passive, the amplitude of the IRS reflection coefficients must be equal to or smaller than one. The constrained SNR optimization problem is non-convex. We propose a three-step procedure to obtain an effective sub-optimal solution for this problem. Accordingly, an innovative non-iterative algorithm is proposed to design the problem parameters. Simulation results show that the IRS-enhanced MIMO downlink system, in which the proposed non-iterative algorithm is used to develop the network parameters, outperforms the conventional network without IRS in terms of bit error rate (BER).
- 16 February 2023
- Published by Walter de Gruyter GmbH in Frequenz
- Vol. 77 (7-8) , 371-383
A novel non-iterative algorithm for the joint design of transceiver beamforming and surface reflection in an IRS-enhanced MIMO system
Intelligent reflecting surface (IRS) is an emerging and low-cost revolutionary technology that can be deployed in future communication systems to enhance data transmission performance. An IRS comprises a lot of small, passive, and low-cost elements that can smartly reflect the incident signal from the transmitter to the receiver. In this paper, an IRS-enhanced multiple-input multiple-output (MIMO) downlink network is considered, in which a cell-edge user receives the data signal from a base station (BS). In this network, the direct path between the BS and the user is blocked by an obstacle, and the user receives only the tunable reflected signal from the IRS. To achieve spatial diversity, beamforming is applied to the antennas at the BS and the user. The goal is to jointly design the transceiver beamforming vectors and the IRS reflection coefficients so that the signal-to-noise ratio (SNR) of the user is maximized. Since the IRS elements are passive, the amplitude of the IRS reflection coefficients must be equal to or smaller than one. The constrained SNR optimization problem is non-convex. We propose a three-step procedure to obtain an effective sub-optimal solution for this problem. Accordingly, an innovative non-iterative algorithm is proposed to design the problem parameters. Simulation results show that the IRS-enhanced MIMO downlink system, in which the proposed non-iterative algorithm is used to develop the network parameters, outperforms the conventional network without IRS in terms of bit error rate (BER).
- 26 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Systems Journal
- Vol. 17 (2) , 2858-2867
Intelligent-Reflecting-Surface-Assisted GFDM Communication Systems
Demands for higher data rates is an inevitable fact. Therefore, the effect of the frequency selectivity and time variation of communication channels will be more significant. One effective technique to combat the doubly dispersive channels is generalized frequency division multiplexing (GFDM) scheme. Nevertheless, nonorthogonality of the used prototype filter can deteriorate the GFDM performance. On the other hand, intelligent reflecting surface (IRS) is a new revolutionary technology for future wireless networks. IRS can smartly reconfigure the propagation environment in order to improve the efficiency of the communication systems. In this article, IRS is applied in a GFDM communication system to enhance the system's performance. In this way, an IRS-assisted GFDM communication system model is proposed. The goal is to design the reflecting coefficients of the IRS such that the total noise power at a GFDM block is minimized. In order to obtain an effective solution, the optimization problem is converted to a quadratically constrained quadratic program (QCQP). The developed QCQP problem is convex, which can be solved by using an iterative algorithm. An analytical derivation of the maximum achievable rate (MAR) and bit error rate (BER) of the proposed IRS-assisted GFDM system is provided. Also, in simulations, the performance of the proposed method is compared with the conventional GFDM system in terms of MAR and BER. Simulation results confirm that using IRS by employing the proposed method dramatically improves the performance of a GFDM system.
- 26 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Systems Journal
- Vol. 17 (2) , 2858-2867
Intelligent-Reflecting-Surface-Assisted GFDM Communication Systems
Demands for higher data rates is an inevitable fact. Therefore, the effect of the frequency selectivity and time variation of communication channels will be more significant. One effective technique to combat the doubly dispersive channels is generalized frequency division multiplexing (GFDM) scheme. Nevertheless, nonorthogonality of the used prototype filter can deteriorate the GFDM performance. On the other hand, intelligent reflecting surface (IRS) is a new revolutionary technology for future wireless networks. IRS can smartly reconfigure the propagation environment in order to improve the efficiency of the communication systems. In this article, IRS is applied in a GFDM communication system to enhance the system's performance. In this way, an IRS-assisted GFDM communication system model is proposed. The goal is to design the reflecting coefficients of the IRS such that the total noise power at a GFDM block is minimized. In order to obtain an effective solution, the optimization problem is converted to a quadratically constrained quadratic program (QCQP). The developed QCQP problem is convex, which can be solved by using an iterative algorithm. An analytical derivation of the maximum achievable rate (MAR) and bit error rate (BER) of the proposed IRS-assisted GFDM system is provided. Also, in simulations, the performance of the proposed method is compared with the conventional GFDM system in terms of MAR and BER. Simulation results confirm that using IRS by employing the proposed method dramatically improves the performance of a GFDM system.
- 30 August 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Signal Processing
- Vol. 69 (1053587X) , 5147-5158
A Novel Low-Complexity GFDM Relay Communication System: Relay Selection and Filter-and-Forward
In this paper, we develop a low-complexity cooperative relay network based on generalized frequency division multiplexing (GFDM) system. In this network, multiple relay nodes (RNs) are used to relay GFDM symbols from a source node (SN) toward a destination node (DN). We propose three methods to design the RNs based on the minimization of the total power of the noise after symbol estimation at the DN. In the first method, only one node is selected among all RNs to forward the signal from the SN to the DN. In the second and third methods, a filter-and-forward (FF) scheme is used, such that at each RN, the received GFDM signal from the SN is circularly convolved with a finite impulse response (FIR) filter and then, forwarded to the DN. The FIR filter's coefficients are represented as a circulant matrix. Since a circulant matrix is characterized by its eigenvalues, we obtain the eigenvalues of the FIR coefficient matrices for all RNs. The difference between the second and third methods is that in the former, the eigenvalues of the filter matrices are restricted to be one or zero, however, in the later, the eigenvalues are determined with no restrictions. Simulation results are provided to demonstrate the performance of the proposed methods in terms of bit error rate (BER). Moreover, we show that because of using circular convolution, the proposed methods can be implemented with a low complexity.
- 30 August 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Signal Processing
- Vol. 69 (1053587X) , 5147-5158
A Novel Low-Complexity GFDM Relay Communication System: Relay Selection and Filter-and-Forward
In this paper, we develop a low-complexity cooperative relay network based on generalized frequency division multiplexing (GFDM) system. In this network, multiple relay nodes (RNs) are used to relay GFDM symbols from a source node (SN) toward a destination node (DN). We propose three methods to design the RNs based on the minimization of the total power of the noise after symbol estimation at the DN. In the first method, only one node is selected among all RNs to forward the signal from the SN to the DN. In the second and third methods, a filter-and-forward (FF) scheme is used, such that at each RN, the received GFDM signal from the SN is circularly convolved with a finite impulse response (FIR) filter and then, forwarded to the DN. The FIR filter's coefficients are represented as a circulant matrix. Since a circulant matrix is characterized by its eigenvalues, we obtain the eigenvalues of the FIR coefficient matrices for all RNs. The difference between the second and third methods is that in the former, the eigenvalues of the filter matrices are restricted to be one or zero, however, in the later, the eigenvalues are determined with no restrictions. Simulation results are provided to demonstrate the performance of the proposed methods in terms of bit error rate (BER). Moreover, we show that because of using circular convolution, the proposed methods can be implemented with a low complexity.
- 1 August 2021
- Published by Elsevier in Physical Communication
- Vol. 47
Novel transceiver beamforming schemes for a MIMO-GFDM system
- 1 August 2021
- Published by Elsevier in Physical Communication
- Vol. 47
Novel transceiver beamforming schemes for a MIMO-GFDM system
- 12 February 2021
- Published by Springer Nature in Wireless Networks
- Vol. 27 (3) , 2067-2079
Cooperative beamforming in cognitive radio systems without feedback of receiver beamforming vectors to transmitter
- 12 February 2021
- Published by Springer Nature in Wireless Networks
- Vol. 27 (3) , 2067-2079
Cooperative beamforming in cognitive radio systems without feedback of receiver beamforming vectors to transmitter
- 19 August 2020
- Published by Elsevier in Signal Processing
- Vol. 178, 107757
Uplink transceiver design for coded GFDMA systems
- 19 August 2020
- Published by Elsevier in Signal Processing
- Vol. 178, 107757
Uplink transceiver design for coded GFDMA systems
- 1 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Wireless Communications Letters
- Vol. 9 (8) , 1160-1163
On the Noise Enhancement of GFDM
- 1 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Wireless Communications Letters
- Vol. 9 (8) , 1160-1163
On the Noise Enhancement of GFDM