Anirudh Rao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Anirudh Rao has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Kerry Hourigan
Monash University
14 shared publications M.C. Thompson
6 shared publications- Thomas Leweke
IRPHE, CNRS, Centrale Méditerranée, Aix-Marseille Université
6 shared publications - Mark Christopher Thompson
Monash University
5 shared publications Branislav Basara
4 shared publications- John Sheridan
Fluids Laboratory for Aeronautical and Industrial Research (FLAIR), Department of Mechanical and Aerospace Engineering, Monash University, Melbourne, VIC 3800, Australia
4 shared publications
Latest Publications
- 1 December 2021
- Published by Elsevier in Aerospace Science and Technology
- Vol. 119
Impact of installation on a civil large turbofan exhaust system at idle descent conditions
- 1 December 2021
- Published by Elsevier in Aerospace Science and Technology
- Vol. 119
Impact of installation on a civil large turbofan exhaust system at idle descent conditions
- 1 March 2019
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 186, 241-249
Qualitative assessment of the bi-stable states in the wake of a finite-width double backward facing step
- 1 March 2019
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 186, 241-249
Qualitative assessment of the bi-stable states in the wake of a finite-width double backward facing step
- 1 December 2018
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 183, 243-272
Investigation of the near-wake flow topology of a simplified heavy vehicle using PANS simulations
- 1 December 2018
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 183, 243-272
Investigation of the near-wake flow topology of a simplified heavy vehicle using PANS simulations
- 1 October 2018
- Published by Elsevier in Ocean Engineering
- Vol. 165, 221-236
Comparison of PANS and LES of the flow past a generic ship
- 1 October 2018
- Published by Elsevier in Ocean Engineering
- Vol. 165, 221-236
Comparison of PANS and LES of the flow past a generic ship
- Open Access
- 25 September 2018
- Published by Springer Nature in Flow, Turbulence and Combustion
- Vol. 102 (2) , 389-415
An LES Investigation of the Near-Wake Flow Topology of a Simplified Heavy Vehicle
- 25 September 2018
- Published by Springer Nature in Flow, Turbulence and Combustion
- Vol. 102 (2) , 389-415
Open AccessAn LES Investigation of the Near-Wake Flow Topology of a Simplified Heavy Vehicle
- 1 February 2018
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 173, 262-278
On the two flow states in the wake of a hatchback Ahmed body
- 1 February 2018
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 173, 262-278
On the two flow states in the wake of a hatchback Ahmed body
- Open Access
- 1 January 2018
- Published by Begell House Inc. Publishers
- p. 731-734
Influence of the numerical schemes on the flow states of a simplified heavy vehicle
Recent experiments [1, 2] in the wake of a simplified heavy vehicle (also know as a ground transportation system (GTS)) have shown that the flow topology remains invariant over a large range of Reynolds numbers [3.8 × 104−2.8 × 106]. This allows numerical techniques such as large eddy simulations (LES) to accurately predict the flow topology at low Reynolds numbers, but are computationally expensive. Hybrid RANS/LES turbulence models are an alternative choice where, accurate prediction of the flow is possible on coarser grids ([3, 4]). Numerical simulations are performed using LES and a hybrid turbulence model - partially-averaged Navier−Stokes (PANS) equations at ReH = 3.8 × 104 for a unified tractor-trailer geometry to compare the flow topologies in the near wake. The influence of the numerical schemes on the flow topology in the symmetry plane which is susceptible to bi-stable flow is investigated using PANS, with the results from LES as a baseline for comparison.
- 1 January 2018
- Published by Begell House Inc. Publishers
- p. 731-734
Open AccessInfluence of the numerical schemes on the flow states of a simplified heavy vehicle
Recent experiments [1, 2] in the wake of a simplified heavy vehicle (also know as a ground transportation system (GTS)) have shown that the flow topology remains invariant over a large range of Reynolds numbers [3.8 × 104−2.8 × 106]. This allows numerical techniques such as large eddy simulations (LES) to accurately predict the flow topology at low Reynolds numbers, but are computationally expensive. Hybrid RANS/LES turbulence models are an alternative choice where, accurate prediction of the flow is possible on coarser grids ([3, 4]). Numerical simulations are performed using LES and a hybrid turbulence model - partially-averaged Navier−Stokes (PANS) equations at ReH = 3.8 × 104 for a unified tractor-trailer geometry to compare the flow topologies in the near wake. The influence of the numerical schemes on the flow topology in the symmetry plane which is susceptible to bi-stable flow is investigated using PANS, with the results from LES as a baseline for comparison.
- 20 July 2017
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 825, 245-283
Three-dimensionality of elliptical cylinder wakes at low angles of incidence
The wake of an elliptical cylinder at low incident angles is investigated for different aspect ratio ( $\unicode[STIX]{x1D6E4}=\text{major:minor axis ratio}$ ) cylinders using stability analysis and direct simulations. In particular, two- and three-dimensional transitions are mapped for cylinders of aspect ratios between 1 and 4 using Floquet stability analysis. The transition scenario for near-unity aspect ratio cylinders resembles that for a circular cylinder wake as Reynolds number is increased to $Re\lesssim 400$ ; first, with the transition from steady two-dimensional flow to unsteady two-dimensional flow, followed by the onset of three-dimensional flow via a long-wavelength instability (mode A), then, a short-wavelength instability (mode B) and, finally, an intermediary wavelength instability which is quasi-periodic in nature (mode QP). The effect of the incident angle on this transition scenario for the low-aspect-ratio cylinders is minimal. As the aspect ratio is increased towards 2, two synchronous modes, modes $\widehat{\text{A}}$ and $\widehat{\text{B}}$ , become unstable; these modes have spatio-temporal symmetries similar to their circular cylinder wake counterparts, modes A and mode B, respectively. While mode $\widehat{\text{A}}$ persists for all incident angles investigated here, mode $\widehat{\text{B}}$ is found only to be unstable for incident angles up to $10^{\circ }$ . Surprisingly, for $1.8\lesssim \unicode[STIX]{x1D6E4}\lesssim 2.9$ , the mode A instability observed at zero incident angle emerges as a quasi-periodic mode as the incident angle is increased even slightly. At higher incident angles, this quasi-periodic mode once again transforms to a real mode on increasing the Reynolds number. The parameter space maps for the various aspect ratios are presented in the Reynolds number–incident angle plane, and the three-dimensional modes are discussed in terms of similarities to and differences from existing modes. A key aim of the work is to map the different modes and various transition sequences as a simple body geometry is systematically changed and as the flow symmetry is systematically broken; thus, insight is provided on the overall path towards fully turbulent flow.- 20 July 2017
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 825, 245-283
Three-dimensionality of elliptical cylinder wakes at low angles of incidence
The wake of an elliptical cylinder at low incident angles is investigated for different aspect ratio ( $\unicode[STIX]{x1D6E4}=\text{major:minor axis ratio}$ ) cylinders using stability analysis and direct simulations. In particular, two- and three-dimensional transitions are mapped for cylinders of aspect ratios between 1 and 4 using Floquet stability analysis. The transition scenario for near-unity aspect ratio cylinders resembles that for a circular cylinder wake as Reynolds number is increased to $Re\lesssim 400$ ; first, with the transition from steady two-dimensional flow to unsteady two-dimensional flow, followed by the onset of three-dimensional flow via a long-wavelength instability (mode A), then, a short-wavelength instability (mode B) and, finally, an intermediary wavelength instability which is quasi-periodic in nature (mode QP). The effect of the incident angle on this transition scenario for the low-aspect-ratio cylinders is minimal. As the aspect ratio is increased towards 2, two synchronous modes, modes $\widehat{\text{A}}$ and $\widehat{\text{B}}$ , become unstable; these modes have spatio-temporal symmetries similar to their circular cylinder wake counterparts, modes A and mode B, respectively. While mode $\widehat{\text{A}}$ persists for all incident angles investigated here, mode $\widehat{\text{B}}$ is found only to be unstable for incident angles up to $10^{\circ }$ . Surprisingly, for $1.8\lesssim \unicode[STIX]{x1D6E4}\lesssim 2.9$ , the mode A instability observed at zero incident angle emerges as a quasi-periodic mode as the incident angle is increased even slightly. At higher incident angles, this quasi-periodic mode once again transforms to a real mode on increasing the Reynolds number. The parameter space maps for the various aspect ratios are presented in the Reynolds number–incident angle plane, and the three-dimensional modes are discussed in terms of similarities to and differences from existing modes. A key aim of the work is to map the different modes and various transition sequences as a simple body geometry is systematically changed and as the flow symmetry is systematically broken; thus, insight is provided on the overall path towards fully turbulent flow.- 29 February 2016
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 792, 50-66
A universal three-dimensional instability of the wakes of two-dimensional bluff bodies
Linear stability analysis of a wide range of two-dimensional and axisymmetric bluff-body wakes shows that the first three-dimensional mode to became unstable is always mode E. From the studies presented in this paper, it is speculated to be the universal primary 3D instability, irrespective of the flow configuration. However, since it is a transition from a steady two-dimensional flow, whether this mode can be observed in practice does depend on the nature of the flow set-up. For example, the mode E transition of a circular cylinder wake occurs at a Reynolds number of $\mathit{Re}\simeq 96$ , which is considerably higher than the steady to unsteady Hopf bifurcation at $\mathit{Re}\simeq 46$ leading to Bénard–von-Kármán shedding. On the other hand, if the absolute instability responsible for the latter transition is suppressed, by rotating the cylinder or moving it towards a wall, then mode E may become the first transition of the steady flow. A well-known example is flow over a backward-facing step, where this instability is the first global instability to be manifested on the otherwise two-dimensional steady flow. Many other examples are considered in this paper. Exploring this further, a structural stability analysis (Pralits et al.J. Fluid Mech., vol. 730, 2013, pp. 5–18) was conducted for the subset of flows past a rotating cylinder as the rotation rate was varied. For the non-rotating or slowly rotating case, this indicated that the growth rate of the instability mode was sensitive to forcing between the recirculation lobes, while for the rapidly rotating case, it confirmed sensitivity near the cylinder and towards the hyperbolic point. For the non-rotating case, the perturbation, adjoint and structural stability fields, together with the wavelength selection, show some similarities with those of a Crow instability of a counter-rotating vortex pair, at least within the recirculation zones. On the other hand, at much higher rotation rates, Pralits et al. (J. Fluid Mech., vol. 730, 2013, pp. 5–18) have suggested that hyperbolic instability may play a role. However, both instabilities lie on the same continuous solution branch in Reynolds number/rotation-rate parameter space. The results suggest that this particular flow transition at least, and probably others, may have a number of different physical mechanisms supporting their development.- 29 February 2016
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 792, 50-66
A universal three-dimensional instability of the wakes of two-dimensional bluff bodies
Linear stability analysis of a wide range of two-dimensional and axisymmetric bluff-body wakes shows that the first three-dimensional mode to became unstable is always mode E. From the studies presented in this paper, it is speculated to be the universal primary 3D instability, irrespective of the flow configuration. However, since it is a transition from a steady two-dimensional flow, whether this mode can be observed in practice does depend on the nature of the flow set-up. For example, the mode E transition of a circular cylinder wake occurs at a Reynolds number of $\mathit{Re}\simeq 96$ , which is considerably higher than the steady to unsteady Hopf bifurcation at $\mathit{Re}\simeq 46$ leading to Bénard–von-Kármán shedding. On the other hand, if the absolute instability responsible for the latter transition is suppressed, by rotating the cylinder or moving it towards a wall, then mode E may become the first transition of the steady flow. A well-known example is flow over a backward-facing step, where this instability is the first global instability to be manifested on the otherwise two-dimensional steady flow. Many other examples are considered in this paper. Exploring this further, a structural stability analysis (Pralits et al.J. Fluid Mech., vol. 730, 2013, pp. 5–18) was conducted for the subset of flows past a rotating cylinder as the rotation rate was varied. For the non-rotating or slowly rotating case, this indicated that the growth rate of the instability mode was sensitive to forcing between the recirculation lobes, while for the rapidly rotating case, it confirmed sensitivity near the cylinder and towards the hyperbolic point. For the non-rotating case, the perturbation, adjoint and structural stability fields, together with the wavelength selection, show some similarities with those of a Crow instability of a counter-rotating vortex pair, at least within the recirculation zones. On the other hand, at much higher rotation rates, Pralits et al. (J. Fluid Mech., vol. 730, 2013, pp. 5–18) have suggested that hyperbolic instability may play a role. However, both instabilities lie on the same continuous solution branch in Reynolds number/rotation-rate parameter space. The results suggest that this particular flow transition at least, and probably others, may have a number of different physical mechanisms supporting their development.- 1 August 2015
- Published by Elsevier in Journal of Fluids and Structures
- Vol. 57, 314-330
Flow past a rotating cylinder translating at different gap heights along a wall
- 1 August 2015
- Published by Elsevier in Journal of Fluids and Structures
- Vol. 57, 314-330
Flow past a rotating cylinder translating at different gap heights along a wall