Mohammad Alam Saeed
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Mohammad Alam Saeed has a total of 1000 co-authors. Here are the top co-authors by number of shared publications:
- Fernando Martinez Vidal
Instituto de Fisica Corpuscular, Centro Mixto Universidad de Valencia — CSIC
404 shared publications A. Calcaterra
403 shared publicationsA. Jawahery
403 shared publicationsA. Khan
403 shared publicationsA. Lazzaro
403 shared publicationsA. Lusiani
403 shared publications
Latest Publications
- 29 June 2024
- Published by World Scientific Pub Co Pte Ltd in Surface Review and Letters
- Vol. 32 (10)
THE INVESTIGATION OF ALTERNATIVE METALS OF Au, Ag, Al AND Cu FOR BACK CONTACT USED IN FABRICATED ZnS/SnS HETEROJUNCTION FOR SOLAR CELL APPLICATION
In this research, we examined metallic back contacts effects on the electrical characteristics of heterojunctions in the context of solar cells. Gold, silver, aluminum and copper were selected as substitutes for the conventional molybdenum. Heterojunctions with SnS and ZnS as an absorber and buffer layers, respectively, were fabricated using spray pyrolysis. The characterization revealed the formation of SnS in an orthorhombic structure and ZnS in a cubic structure, displaying preferential orientations along (120) and (222) planes, respectively. These structures exhibited excellent crystallinity, evidenced by large crystallite sizes and phase purity, as confirmed by morphological study. Optical measurements indicated the band gap for SnS and ZnS as 1.5 and 3.1[ ]eV, respectively. Additionally, through Hall Effect and Mott–Schottky analysis, it was observed that the SnS and ZnS films displayed p-type and n-type conductivity, with corresponding carrier concentrations of [ ] and [ ][ ]cm[ ], respectively. The electrical characteristics of the n-ZnS/p-SnS heterojunction were explored through forward I–V analysis. Photocurrent measurements revealed that the constructed structures demonstrated rectifying behavior. The resistance series and ideality factor values obtained were observed to be relatively high. The unusual ideality factor can be attributed to the formation of Schottky contact between contacts (Ag, Al, Cu) and SnS film, possibly due to defects at the interface state of ZnS/SnS. This study’s findings indicate that, among the tested FTO/ZnS/SnS heterojunction structures, with Au metal contact exhibited superior performance. It suggests that Au could serve as a viable alternative to Mo as the back metal contact for SnS-based solar cells.
- 29 June 2024
- Published by World Scientific Pub Co Pte Ltd in Surface Review and Letters
- Vol. 32 (10)
THE INVESTIGATION OF ALTERNATIVE METALS OF Au, Ag, Al AND Cu FOR BACK CONTACT USED IN FABRICATED ZnS/SnS HETEROJUNCTION FOR SOLAR CELL APPLICATION
In this research, we examined metallic back contacts effects on the electrical characteristics of heterojunctions in the context of solar cells. Gold, silver, aluminum and copper were selected as substitutes for the conventional molybdenum. Heterojunctions with SnS and ZnS as an absorber and buffer layers, respectively, were fabricated using spray pyrolysis. The characterization revealed the formation of SnS in an orthorhombic structure and ZnS in a cubic structure, displaying preferential orientations along (120) and (222) planes, respectively. These structures exhibited excellent crystallinity, evidenced by large crystallite sizes and phase purity, as confirmed by morphological study. Optical measurements indicated the band gap for SnS and ZnS as 1.5 and 3.1[ ]eV, respectively. Additionally, through Hall Effect and Mott–Schottky analysis, it was observed that the SnS and ZnS films displayed p-type and n-type conductivity, with corresponding carrier concentrations of [ ] and [ ][ ]cm[ ], respectively. The electrical characteristics of the n-ZnS/p-SnS heterojunction were explored through forward I–V analysis. Photocurrent measurements revealed that the constructed structures demonstrated rectifying behavior. The resistance series and ideality factor values obtained were observed to be relatively high. The unusual ideality factor can be attributed to the formation of Schottky contact between contacts (Ag, Al, Cu) and SnS film, possibly due to defects at the interface state of ZnS/SnS. This study’s findings indicate that, among the tested FTO/ZnS/SnS heterojunction structures, with Au metal contact exhibited superior performance. It suggests that Au could serve as a viable alternative to Mo as the back metal contact for SnS-based solar cells.
- Open Access
- 28 August 2020
- Published by MDPI AG in Preprints.org
Analysis of Radioactivity Distributions and Its Lifetime Cancer Risks Along Iju River Sediments, South-West Nigeria
The radioactivity levels were carried out using Super Spec (RS-125) gamma detector and NaI (TI) gamma spectroscopy to evaluate the radiological parameters of lifetime cancer risks from the river sediments utilized by 5 different communities. The results from the analysis indicate that the Iso-dose column with the highest background gamma dose was identified in site 7 with a value of 79 nGy/h, approximately 34 % higher than the world average. The highest values of U-238, Th-232 and K-40 activity levels were found in sites 4, 13and 13, respectively. Significantly, the mean value of 29 x 10-2 for excess lifetime cancer risk (ELCR) is higher than the world average value of 0.29 x 10-3 by a factor of 0.3, approximately 30 %. The multivariate statistical analysis indicates from the regression model revealed that Th-232 has significance effect and is higher than the contributions of U-232 and K-40 respectively
- 28 August 2020
- Published by MDPI AG in Preprints.org
Open AccessAnalysis of Radioactivity Distributions and Its Lifetime Cancer Risks Along Iju River Sediments, South-West Nigeria
The radioactivity levels were carried out using Super Spec (RS-125) gamma detector and NaI (TI) gamma spectroscopy to evaluate the radiological parameters of lifetime cancer risks from the river sediments utilized by 5 different communities. The results from the analysis indicate that the Iso-dose column with the highest background gamma dose was identified in site 7 with a value of 79 nGy/h, approximately 34 % higher than the world average. The highest values of U-238, Th-232 and K-40 activity levels were found in sites 4, 13and 13, respectively. Significantly, the mean value of 29 x 10-2 for excess lifetime cancer risk (ELCR) is higher than the world average value of 0.29 x 10-3 by a factor of 0.3, approximately 30 %. The multivariate statistical analysis indicates from the regression model revealed that Th-232 has significance effect and is higher than the contributions of U-232 and K-40 respectively
- 5 April 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (7) , 075906
Ab initio full-potential study of the fundamental properties of chalcopyrite semiconductors XPN 2 (X = H, Cu)
- 5 April 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (7) , 075906
Ab initio full-potential study of the fundamental properties of chalcopyrite semiconductors XPN 2 (X = H, Cu)
- Open Access
- 28 September 2017
- Published by Penerbit UTM Press in Malaysian Journal of Fundamental and Applied Sciences
- Vol. 13 (3)
Thermoluminescence (TL) response of silica nanoparticles subjected to 50 Gy gamma irradiation.
Thermoluminescence (TL) response of silica nanoparticles synthesized by the sol-gel method is presented here. Transmission electron microscopy (TEM) was used to find out the size and morphology of the pure silica nanoparticles. By using an appropriate amount of tetraethylorthosilicate, ethanol, deionized water and ammonia solution, silica samples were synthesized. To determine the best TL response of silica, samples were irradiated with 50Gy gamma rays. The effect of size dependency towards TL yield indicates that decreasing the particles’ size of silica, increases the TL yield.
- 28 September 2017
- Published by Penerbit UTM Press in Malaysian Journal of Fundamental and Applied Sciences
- Vol. 13 (3)
Open AccessThermoluminescence (TL) response of silica nanoparticles subjected to 50 Gy gamma irradiation.
Thermoluminescence (TL) response of silica nanoparticles synthesized by the sol-gel method is presented here. Transmission electron microscopy (TEM) was used to find out the size and morphology of the pure silica nanoparticles. By using an appropriate amount of tetraethylorthosilicate, ethanol, deionized water and ammonia solution, silica samples were synthesized. To determine the best TL response of silica, samples were irradiated with 50Gy gamma rays. The effect of size dependency towards TL yield indicates that decreasing the particles’ size of silica, increases the TL yield.
- 1 December 2016
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 118, 375-381
Effect of co-doping of sodium on the thermoluminescence dosimetry properties of copper-doped zinc lithium borate glass system
- 1 December 2016
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 118, 375-381
Effect of co-doping of sodium on the thermoluminescence dosimetry properties of copper-doped zinc lithium borate glass system
- RetractedOpen Access
- 27 June 2016
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 11 (6) , e0158084
RETRACTED: Magnetic Properties of Polyvinyl Alcohol and Doxorubicine Loaded Iron Oxide Nanoparticles for Anticancer Drug Delivery Applications
The current study emphasizes the synthesis of iron oxide nanoparticles (IONPs) and impact of hydrophilic polymer polyvinyl alcohol (PVA) coating concentration as well as anticancer drug doxorubicin (DOX) loading on saturation magnetization for target drug delivery applications. Iron oxide nanoparticles particles were synthesized by a reformed version of the co-precipitation method. The coating of polyvinyl alcohol along with doxorubicin loading was carried out by the physical immobilization method. X-ray diffraction confirmed the magnetite (Fe 3 O 4 ) structure of particles that remained unchanged before and after polyvinyl alcohol coating and drug loading. Microstructure and morphological analysis was carried out by transmission electron microscopy revealing the formation of nanoparticles with an average size of 10 nm with slight variation after coating and drug loading. Transmission electron microscopy, energy dispersive, and Fourier transform infrared spectra further confirmed the conjugation of polymer and doxorubicin with iron oxide nanoparticles. The room temperature superparamagnetic behavior of polymer-coated and drug-loaded magnetite nanoparticles were studied by vibrating sample magnetometer. The variation in saturation magnetization after coating evaluated that a sufficient amount of polyvinyl alcohol would be 3 wt. % regarding the externally controlled movement of IONPs in blood under the influence of applied magnetic field for in-vivo target drug delivery.
- 27 June 2016
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 11 (6) , e0158084
RetractedOpen AccessRETRACTED: Magnetic Properties of Polyvinyl Alcohol and Doxorubicine Loaded Iron Oxide Nanoparticles for Anticancer Drug Delivery Applications
The current study emphasizes the synthesis of iron oxide nanoparticles (IONPs) and impact of hydrophilic polymer polyvinyl alcohol (PVA) coating concentration as well as anticancer drug doxorubicin (DOX) loading on saturation magnetization for target drug delivery applications. Iron oxide nanoparticles particles were synthesized by a reformed version of the co-precipitation method. The coating of polyvinyl alcohol along with doxorubicin loading was carried out by the physical immobilization method. X-ray diffraction confirmed the magnetite (Fe 3 O 4 ) structure of particles that remained unchanged before and after polyvinyl alcohol coating and drug loading. Microstructure and morphological analysis was carried out by transmission electron microscopy revealing the formation of nanoparticles with an average size of 10 nm with slight variation after coating and drug loading. Transmission electron microscopy, energy dispersive, and Fourier transform infrared spectra further confirmed the conjugation of polymer and doxorubicin with iron oxide nanoparticles. The room temperature superparamagnetic behavior of polymer-coated and drug-loaded magnetite nanoparticles were studied by vibrating sample magnetometer. The variation in saturation magnetization after coating evaluated that a sufficient amount of polyvinyl alcohol would be 3 wt. % regarding the externally controlled movement of IONPs in blood under the influence of applied magnetic field for in-vivo target drug delivery.
- 1 November 2015
- Published by Elsevier in Journal of Non-Crystalline Solids
- Vol. 427, 83-90
Strontium ion concentration effects on structural and spectral properties of Li4Sr(BO3)3 glass
- 1 November 2015
- Published by Elsevier in Journal of Non-Crystalline Solids
- Vol. 427, 83-90
Strontium ion concentration effects on structural and spectral properties of Li4Sr(BO3)3 glass
- 15 September 2015
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 77 (2) , 396-403
Sol–gel-based single and multilayer nanoparticle thin films on low-temperature substrate poly-methyl methacrylate for optical applications
- 15 September 2015
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 77 (2) , 396-403
Sol–gel-based single and multilayer nanoparticle thin films on low-temperature substrate poly-methyl methacrylate for optical applications