KNKaramtot Krishna Naik

Karamtot Krishna Naik

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Karamtot Krishna Naik has a total of 116 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Next-Generation VLSI-Based Flight Controller Architectures for Unmanned Aerial Vehicles

    by Kothapalli Bannoth Pranaya, G Mamatha, Krishna Naik Karamtot

    The increasing autonomy of unmanned aerial vehicles (UAVs) has created stringent requirements for onboard computing systems that must simultaneously support deterministic flight control and computationally intensive tasks such as perception, localization, and machine-learning-based decision making. Conventional microcontroller- and digital-signal-processor-based flight controllers remain effective for stabilization. Very-large-scale integration (VLSI) provides alternative implementation approaches that enable concurrent and application-specific processing within stringent size, weight, and power constraints. This paper presents a systematic survey of VLSI-based flight-controller architectures reported between 2005 and 2026, covering five major approaches: field-programmable gate arrays (FPGAs), system-on-chip FPGAs (SoC-FPGAs), application-specific integrated circuits (ASICs), RISC-V-based system-on-chips, and neuromorphic architectures. The surveyed designs are analysed using key architectural parameters, including timing determinism, energy efficiency, computational capability, flexibility, silicon area, and implementation cost. Representative fabricated, field-tested, and commercially accessible platforms are further compared to identify the practical trade-offs among different implementation strategies. The analysis indicates that architectural specialization and hardware-level workload partitioning are increasingly important for achieving real-time autonomy within UAV power budgets. In particular, recent designs shift VLSI acceleration from conventional stabilization loops toward perception, state estimation, and learned-control workloads. However, direct comparison remains difficult because existing studies employ heterogeneous workloads, datasets, performance metrics, and validation methodologies. The survey therefore identifies standardized benchmarking, hardware-assisted verification, security, radiation tolerance, and certification-oriented design as important research directions for future VLSI-based UAV flight controllers. The findings provide a consolidated design perspective for researchers and engineers developing energy-efficient, deterministic, and scalable computing architectures for autonomous UAVs.

  • Open Access

    Hybrid quantum classical networks for emerging applications: Comparative perspective

    by Anand Vijaya Kamalanath, Krishna Naik Karamtot

    Quantum Classical Networking integrates quantum information directly with the existing fiber-optic classical communication infrastructures, offering a realistic and scalable approach for developing quantum enabled applications. Unlike quantum-native architecture, it combines data plane functionality with classical control plane intelligence, enabling seamless deployment over current optical and packet-switching networks. The framework incorporates fundamental quantum mechanics constraints like probabilistic entanglement generation, Decoherence, no-cloning process, and finite quantum-memory lifetimes, thereby reflecting realistic operational conditions. A key contribution of this work is its unified cross-layer methodology, which considers architectural design, protocol stack integration, and graph-theoretic modeling when evaluating essential performance metrics like entanglement rate, fidelity, and latency. The manuscript advances the state-of-art through SDN-enabled orchestration, pqNOC-based architecture, quantum-aware routing, and resource allocation for stochastic network environment. Furthermore, it examines emerging technologies Quantum CDMA, Quantum signal processing, Quantum MIMO, and their applicability to 6G Communications, Internet of Drones, Smart Grids, and Metavers/XR eco-systems. Finally, this article presents a simulation based comparative analysis of quantum communication protocols- BB84, BBM92, E91, and QSDC using the NetSquid simulator, quantifying key metrics such as QBER and eavesdropping detection under realistic channel conditions. Results demonstrate protocol-specific trade-offs, with entanglement protocols, BBM92 & E91, achieving non-zero QBER under ideal conditions, while BB84 offers superior resource efficiency for large-scale deployment, and QSDC enables direct secure message transmission suited to mission-critical scenarios.

  • Open Access

    Wavelet Denoising of Inertial Sensor Input Data for Gnss-ins Integration: Simulation Approach

    by Karamtot Krishna Naik

    The Global Navigation Satellite Systems (GNSS) provides autonomous geospatial positioning across the globe, in the name of GPS, GLONASS, GALILEO, Beiduo, and other regional systems like IRNSS, QZSS. The advantage of having access to multiple satellites is accuracy, redundancy, and availability at all times. GPS (Global Positioning System) was the first GNSS in the United States which offers excellent multi-constellation solutions consists of up to 32 medium Earth observation satellites in six different orbital planes of four satellites in each can be used for many purposes like commercial, military, space, agriculture and so many. The Inertial Navigation System (INS) is a self-dependent system that does not depend on external electronic signals. Using the basic laws proposed by Issac Newton, it gives the position based on the time distance relation. The basic need of this navigation system is to know the initial position and the time at which the vehicle starts navigation. It mainly consists of two devices namely accelerometers and gyroscopes which give the amount of acceleration and rotational information of the moving vehicle using inertial sensors. GPS signal is an electromagnetic signal, can be blocked by mountains, dense forests, areas with high buildings, and in bad weather conditions. Therefore, GPS is not continuous all the time where INS is in any situation. Because of this drawback integration of GPS and INS is needed to provide continuous information all the time. The INS will update the GPS measurements whenever it is required and it will also correct GPS phase cycle slips. But most of the errors in the INS are caused by sensor short-term errors that have to be rectified before giving it as an input to the IMU for integration. The wavelet signal processing technique is applied to improve navigation signals. The wavelet will decompose the signal to multiple levels to improve the performance of the inertial sensor signals by separating the signal into lower and higher frequency noise components. However, the wavelet threshold method does not distort the rapidly-changing signal but reduces signal noise. This paper has applied different threshold techniques as part of simulation to improve the navigational performance of the experiment. On performing the wavelet denoising decimated wavelet transform and un-decimated wavelet transform using level-dependent soft threshold technique and also the hybrid un- decimated transform with the least square method as threshold technique results in the reduction of noise.

  • Open Access

    GPS Receiver Simplification for Low cost Applications and Multipath Mitigation Analysis on SDR based Re configurable Software Receiver

    by B. Sathish Nayak, K.KRishna Naik, Odelu Ojjela, Surendra Pal

    Many modern position-based applications rely heavily on the Global Navigation Satellite System (GNSS). Most applications require precise position data obtained through sophisticated hardware with a high computational capacity in the receiver. Some cost-effective applications may not require precise position data and require less complex signal processing. The use of efficient hardware and signal processing techniques to reduce the overall cost of a GNSS receiver is an active research topic. This paper considers Global Positioning System (GPS) constellation and proposes two factors to reduce the receiver complexity: sampling frequency and the number of tracking channels. A Keysight GNSS signal generator to record GPS signals, a Software Defined Radio board and a software-based GPS receiver are used in the experimentation. The sampling frequencies are 40, 20, 10 and 5 MHz considered, and tracking channels are reduced from 12 to 6 and then 4. The increase of error in the receiver position with 6 and 4 satellites is considerably small, but the number of tracking channels and signal processing requirements are reduced considerably. The GPS signals are affected by many errors; one of the significant sources of error is multipath propagation. Three distinct GPS multipath scenarios are generated for four satellite signal combinations with the GNSS simulator for the receiver performance analysis. Three multipath mitigation techniques, namely Early Minus Late (EML), Narrow correlator (NC) and strobe correlator (SC) methods, are considered because of their simple structure and fewer signal processing requirements. The error reductions of three multipath scenarios are compared, and the SC method performs better in all three multipath scenarios.


  • Open Access

    Simulation of Cognitive Electronic Warfare System With Sine and Square Waves

    by Krishna K Naik

    Today’s Electronic Warfare (EW) receivers need advanced technology to achieve real-time surveillance operations. Dynamic and intelligent systems are required for UAVs and other airborne applications. The airborne Electronic Warfare systems must be knowledge-based systems, learning from the threat scenario with highly integrated capabilities to detect, react, and adapt to radar threats in real-time. Artificial intelligence is a machine-dependent process, by adapting certain rules and logic supported by human intelligence, AI can be used for cognitive processing. Cognitive signal processing is required for making the system autonomous and dynamic in nature. Military action on radar signatures requires a set of commands to be executed dynamically with the help of the proposed EW system. It is proposed to design and develop a cognitive EW architecture and simulation of machine learning that combines neural network architecture with the help of sine and square waves as input. This paper presents the Cognitive signal processing for EW systems with Neural Network, Recurrent Neural Network (RNN), Machine learning (ML), and Deep learning (DL) techniques with their simulation with sine and square waves.


  • Open Access

    Multi GNSS IRNSS L5 IRNSS S1 and GPS L1 Hybrid Simulator A Reconfigurable Low cost Solution for Research and Defence Applications

    by B. Sathish Nayak, Sidharth Bhonge, K. Krishna Naik, Odelu Ojjela, Surendra Pal

    Satellite-based positioning field of research is growing rapidly as there is an increase in demand for precise position requirements in various civil and commercial applications. There are many errors that affect the GNSS signals while propagation from satellite to receiver, which eventually induces errors in pseudo-range measurements. In order to assess the receiver characteristics for a specific error condition, the real-time signals may not be appropriate, and it is challenging to perform repeated experiments with the same error condition. The advantage of the GNSS simulator is that users can model the different scenarios for any given location on the globe, which are repeatable at any point of time. The conventional hardware simulators are expensive and have few limitations. In this paper, a reconfigurable hybrid simulator is proposed with some advantages over traditional hardware simulators, such as low cost, reconfigurability, and controllability over fundamental parameters. It can be able to record intermediate stage data, which makes it more suitable for the GNSS research field. The proposed multi-GNSS simulator considered implementing IRNSS-L5, IRNSS-S1, and GPS-L1 band signals. A general-purpose computer can perform the necessary calculations for signal generation. The hybrid simulator can be able to generate the digital I/Q data, which can be stored as I/Q data or can be connected to a general-purpose SDR (Software Defined Radio) for RF signal generation (bladeRF in this case). The I/Q data can be used with the software receiver to analyse the receiver performance concerning the specific error. The generated GNSS signals are validated with software and hardware receivers, and the obtained position is observed as expected.


  • TV white spaces exploration for cognitive radio: taxonomy and research issues

    by Ajit Singh, K. Krishna Naik, C. R. Suthikshn Kumar