GKGennadiy Nikolaevich Kozhemyakin

Gennadiy Nikolaevich Kozhemyakin

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Gennadiy Nikolaevich Kozhemyakin has a total of 43 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Bi nanostructures obtained on Si substrates by thermal evaporation method

    by G. N. Kozhemyakin, S. A. Kiiko, A. V. Kiiko, V. V. Artemov, I. S. Volchkov, Кийко C. А.

    Bi low dimensional structures were obtained on the Si(100) substrates by thermal evaporation method in Ar. Bi nanocrystals and nanowires were condensed on the Si substrates at 10–20 s deposition time. Computer processing of SEM-images was used to determine the sizes of Bi nanocrystals and microcrystals and their distribution densities. The distribution density of nanocrystals was larger than its the microcrystals by a factor of 85–260. The increase of deposition time up to 20 s reduced the nanocrystal density by a factor of 2 with the increase of their sizes. X-ray diffraction analysis revealed oxide layers on the Bi nanocrystals and the Si substrates. The decrease in the sizes of the Bi nanocrystals and the increase in their density on the Si substrates in comparison with those on glassy carbon substrates were observed.

  • Bi Nanostructures Obtained on Si Substrates by Thermal Evaporation

    by G. N. Kozhemyakin, S. A. Kiiko, A. V. Kiiko, V. V. Artemov, I. S. Volchkov

    Low dimension Bi structures were obtained on Si(100) substrates by thermal evaporation in Ar at 10‒20 s deposition time. The sizes and distribution density of Bi nano- and microcrystals were determined by computer processing of electron SEM-images. The nanocrystal density was larger than the microcrystal density by a factor of 260. The decrease of the nanocrystal density by a factor of 2 with the increase of their sizes was observed with the increase up to 20 s deposition time. X-ray diffraction analysis has revealed oxide layers on Bi nanocrystals and the Si substrate surface. The decrease of Bi nanocrystals sizes and the increase of their density on the Si substrates as compared of deposition on glassy carbon substrates was established.


  • Growth of Bi and Bi 1− x Sb x single crystals with specific properties

    by Gennadiy Nikolaevich Kozhemyakin

    The growth of Bi and Bi 1− x Sb x single crystals with different orientations of the (111) plane, defined microstructure and specific properties by the Czochralski technique.


  • Gallium Nanoparticles Obtained on Silicon Substrates by Thermal Evaporation Method

    by G. N. Kozhemyakin, Y. S. Belov, M. K. Trufanova, V. V. Artemov, I. S. Volchkov

    Gallium nanostructures have been obtained on silicon substrates by thermal evaporation in an argon atmosphere. The sizes, density, and shape of Ga particles have been determined by computer processing of electron SEM-images. The condensation of Ga on Si substrates for 10, 15, and 20 s ensured the formation of the particles of several types: spherical, triangular, square, and in the form of rods and polyhedrons. The increase in the Ga condensation time to 20 s led to the increase in the density of spherical nanoparticles by 41%.


  • GALLIUM NANOPARTICLES OBTAINED ON SILICON SUBSTRATES BY THERMAL EVAPORATION METHOD

    by G. N. Kozhemyakin, Yu. S. Belov, M. K. Trufanova, V. V. Artemov, I. S. Volchkov

    GALLIUM NANOPARTICLES OBTAINED ON SILICON SUBSTRATES BY THERMAL EVAPORATION METHOD Получение наночастиц галлия на кремниевых подложках методом термического испарения

  • Photovoltaic effect in metal foils and crystals of topological insulators

    by Gennadiy Nikolaevich Kozhemyakin, Ylii Nikolaevich Bendryshev, Alexei Vyacheslavovich Churilov

    We report that the photovoltaic effect can be produced in metals, semimetals, and semiconductor 3D topological insulators with crystalline and nanostructured states. The behavior of charge carriers in topological insulator crystals and metal foils was investigated under laser illumination. We developed a method for the measurement of electrical potential difference on surfaces of three-dimensional topological insulators: Bi and Sb single crystals, Bi foils, and (Bi1−xSbx)2Te3 and (Bi1−xSex)2Te3 nanostructured crystals, as well as metal foils of Al and Ni alloys. The surface voltage depends on the properties of samples obtained by different methods. The value of the surface potential difference depends on the laser illumination of the top or bottom surfaces of the samples. A negative surface potential difference was observed in most samples, except for Al foils and Ni alloy foils, with top surface illumination. Laser illumination of the bottom surface caused a larger surface potential difference in topological insulators, with the opposite polarity. Surface structure defects and specific band structures in the topological insulators studied provided an increase in the electrical potential difference on their surface due to the photovoltaic effect. The reduction of deposited laser energy from the bottom surface to the top surface by a factor of 1000 due to the low thermal conductivity of topological insulators increased the electrical potential difference by factors of 1.8–3.8. These results promise a new possibility for prospective research and development of energy-efficient photonic devices.


  • Surface Conductivity of Bi, Ga, In, and Sb Nanocrystals Condensed on Glassy Carbon Substrates

    by G. N. Kozhemyakin, Yu. N. Bendryshev, I. S. Volchkov

    The conductivity of Bi, Ga, In, and Sb nanocrystals deposited onto glassy carbon substrates by thermal evaporation at effect of laser irradiation at room temperature has been studied. The high surface conductivity of an array of spherical Bi, Ga, and In nanocrystals, in contrast to pyramidal Sb nanocrystals, has been found. Bi nanocrystals had the maximum conductivity at an average distance of l = 65 nm between them, which is smaller than the laser radiation wavelength by an order of magnitude. The results obtained confirm the hopping mechanism of surface conductivity of nanocrystals of Bi and Sb topological insulators, Ga and In metals.

  • Formation of Gallium Nanoparticles by Thermal Evaporation Method in an Argon Atmosphere

    by G. N. Kozhemyakin, Yu. S. Belov, M. K. Trufanova, O. E. Bryl

    The conditions have been developed to obtain gallium (Ga) nanoparticles by the thermal evaporation method in an argon atmosphere on glassy carbon substrates. Ga particles are studied by the developed intelligent analysis method of SEM images. It is shown that the temperature of the glassy carbon substrate and the condensation time of the melt determine the number of the nanoparticles and microparticles. Ga nanoparticles with 10–100 nm sizes and microparticles with the sizes up to 500 nm are formed on the substrates with the condensation time of 10–20 s. Ga nanoparticles have a shape close to spherical, and their amount increases with the condensation time. Increasing the substrate temperature from 118 to 124°С provided a decrease in the average sizes of most Ga nanoparticles by 20% and an increase in their number by a factor of 7–20.


  • Tellurium Nanostructures Obtained by Thermal Evaporation Method

    by G. N. Kozhemyakin, Y. S. Belov, V. V. Artemov, M. K. Trufanova, I. S. Volchkov

    Tellurium (Te) nanostructures have been obtained on glassy carbon substrates by thermal evaporation in an argon atmosphere. The sizes and shape of Te particles have been determined by computer image processing of electron images. It has been established that the Te condensation on glassy carbon substrates for 10, 20, and 30 s ensures particle formation of two types: spheres and nanowires with the sizes from 10 to 600 nm. The increase in the Te condensation time up to 30 s leads the increase in the nanowires by a factor of 500 and the spherical microparticles by a factor of 5.


  • Opportunities of striation-free crystal growth with ultrasound effect

    by Gennadiy Nikolaevich Kozhemyakin

    The main condition for elimination of growth striations is the formation of standing waves in the melt for damping of convection. The formation of standing waves between the crucible bottom and the solid–liquid interface suppresses convection in the melt and eliminates growth striations in single crystals. Growth striations in InSb and GaAs single crystals were eliminated after the ultrasound was switched on at frequencies of 0.65 MHz and 0.15 MHz in their melts with the Rayleigh numbers 0.18 × 105 and 0.2 × 105, respectively. The ultrasound intensity was determined from a model experiment with similar conditions to crystal growth using a light cut method. The model experiments demonstrated formation of standing waves above the waveguide with a piezo transducer after switching on the ultrasound that attended appearance of a dome on a liquid surface. The dome dimensions on the liquid surface were used for calculation of the ultrasound intensity. The calculated ultrasound intensity was 0.85 W cm−2. It was found that the growth striations disappeared a certain time after switching the ultrasound on, which can be explained by the formation time of standing waves and properties of the melt. The time intervals between switching the ultrasound on and the elimination of striations in grown InSb and GaAs single crystals were measured using the experimental images with the striation elimination, and were 10 s and 22 s, respectively. The controlled formation of ultrasonic standing waves in the melt in crystal growth eliminates growth striations, and this technique can be used for the industrial application.