Ting Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ting Li has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Dongyan Ding
Shanghai Jiao Tong University
6 shared publications - Congqin Ning
The Education Ministry Key Lab of Resource Chemistry and Shanghai Frontiers Science Center of Biomimetic Catalysis and Shanghai Engineering Research Center of Green Energy Chemical Engineering, Shanghai Normal University, Shanghai, China
2 shared publications - Zhenbiao Dong
Faculty of Intelligence Technology
2 shared publications - Nan Li
Handan Institute of Innovation, Peking University, Handan 056000, China
1 shared publication
Latest Publications
- 1 August 2020
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 45 (41) , 20983-20992
Photoelectrochemical water splitting with black Ni/Si-doped TiO2 nanostructures
- 1 August 2020
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 45 (41) , 20983-20992
Photoelectrochemical water splitting with black Ni/Si-doped TiO2 nanostructures
- 4 January 2020
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 167 (6) , 066514
Enhanced Photoelectrochemical Water Splitting Performance of Ni/Si-doped TiO 2 Photoanode Fabricated through Electrochemical Reduction in Aqueous Solutions
Ni/Si-doped TiO 2 nanostructures were prepared by anodizing Ti-1Ni-5Si alloy. The electrochemical reduction in the aqueous solutions was a simple and effective method to self-dope Ti 3+ into Ni/Si-doped TiO 2 nanostructures. It was found that electrochemical reduction in neutral aqueous solution (pH 7) was more effective than that in either acidic aqueous solution (pH 3) and basic aqueous solution (pH 13). The stable reduced Ni/Si-doped TiO 2 photoanode obtained in the neutral aqueous solution exhibited an excellent photoelectrochemical water splitting performance due to the increased Ti 3+ and oxygen vacancies species, which not only extended the visible-light absorption range but also promoted the charge transfer and separation process. A remarkable photocurrent density of 2.41 mA cm −2 at 0 V vs Ag/AgCl was achieved, corresponding to a photoconversion efficiency of 1.12%, which was 5.9 times that of the undoped TiO 2 photoanode (0.19%).
- 4 January 2020
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 167 (6) , 066514
Enhanced Photoelectrochemical Water Splitting Performance of Ni/Si-doped TiO 2 Photoanode Fabricated through Electrochemical Reduction in Aqueous Solutions
Ni/Si-doped TiO 2 nanostructures were prepared by anodizing Ti-1Ni-5Si alloy. The electrochemical reduction in the aqueous solutions was a simple and effective method to self-dope Ti 3+ into Ni/Si-doped TiO 2 nanostructures. It was found that electrochemical reduction in neutral aqueous solution (pH 7) was more effective than that in either acidic aqueous solution (pH 3) and basic aqueous solution (pH 13). The stable reduced Ni/Si-doped TiO 2 photoanode obtained in the neutral aqueous solution exhibited an excellent photoelectrochemical water splitting performance due to the increased Ti 3+ and oxygen vacancies species, which not only extended the visible-light absorption range but also promoted the charge transfer and separation process. A remarkable photocurrent density of 2.41 mA cm −2 at 0 V vs Ag/AgCl was achieved, corresponding to a photoconversion efficiency of 1.12%, which was 5.9 times that of the undoped TiO 2 photoanode (0.19%).
- Open Access
Ni/Si-Codoped TiO2 Nanostructure Photoanode for Enhanced Photoelectrochemical Water Splitting
We synthesized Ni/Si-codoped TiO2 nanostructures for photoelectrochemical (PEC) water splitting, by electrochemical anodization of Ti-1Ni-5Si alloy foils in ethylene glycol/glycerol solutions containing a small amount of water. The effects of annealing temperature on PEC properties of Ni/Si-codoped TiO2 photoanode were investigated. We found that the Ni/Si-codoped TiO2 photoanode annealed at 700 °C had an anatase-rutile mixed phase and exhibited the highest photocurrent density of 1.15 mA/cm2 at 0 V (vs. Ag/AgCl), corresponding to a photoconversion efficiency of 0.70%, which was superior to Ni-doped and Si-doped TiO2. This improvement in PEC water splitting could be attributed to the extended light absorption, faster charge transfer, possibly lower charge recombination, and longer lifetime.
Open AccessNi/Si-Codoped TiO2 Nanostructure Photoanode for Enhanced Photoelectrochemical Water Splitting
We synthesized Ni/Si-codoped TiO2 nanostructures for photoelectrochemical (PEC) water splitting, by electrochemical anodization of Ti-1Ni-5Si alloy foils in ethylene glycol/glycerol solutions containing a small amount of water. The effects of annealing temperature on PEC properties of Ni/Si-codoped TiO2 photoanode were investigated. We found that the Ni/Si-codoped TiO2 photoanode annealed at 700 °C had an anatase-rutile mixed phase and exhibited the highest photocurrent density of 1.15 mA/cm2 at 0 V (vs. Ag/AgCl), corresponding to a photoconversion efficiency of 0.70%, which was superior to Ni-doped and Si-doped TiO2. This improvement in PEC water splitting could be attributed to the extended light absorption, faster charge transfer, possibly lower charge recombination, and longer lifetime.
- Open Access
Anodic Fabrication of Ti-Ni-Si-O Nanostructures on Ti10Ni5Si Alloy
Ti-Ni-Si-O nanostructures were synthesized on Ti10Ni5Si alloy through an electrochemical anodization in electrolyte solutions containing ammonium fluoride (NH4F). The anodic oxide structures were affected by the electrochemical anodization parameters, including the electrolyte viscosity, water content, anodization potential and anodization time. Using an anodization potential of 40 V for 90 min in an ethylene glycol/glycerol electrolyte with 3 vol.% deionized water, highly ordered self-organized nanotube arrays were obtained in the α-Ti phase region of the alloy substrate, with an average inner diameter of 70 nm and a wall thickness of about 12 nm. Self-organized nanopore structures with an average pore diameter of 25 nm grew in the Ti5Si3 phase region. Only etching pits were found in the Ti2Ni phase region. The Ti-Ni-Si-O nanostructures were characterized using scanning electron microscopy and energy dispersive spectroscopy. In addition, a formation mechanism of different nanostructures was presented.
Open AccessAnodic Fabrication of Ti-Ni-Si-O Nanostructures on Ti10Ni5Si Alloy
Ti-Ni-Si-O nanostructures were synthesized on Ti10Ni5Si alloy through an electrochemical anodization in electrolyte solutions containing ammonium fluoride (NH4F). The anodic oxide structures were affected by the electrochemical anodization parameters, including the electrolyte viscosity, water content, anodization potential and anodization time. Using an anodization potential of 40 V for 90 min in an ethylene glycol/glycerol electrolyte with 3 vol.% deionized water, highly ordered self-organized nanotube arrays were obtained in the α-Ti phase region of the alloy substrate, with an average inner diameter of 70 nm and a wall thickness of about 12 nm. Self-organized nanopore structures with an average pore diameter of 25 nm grew in the Ti5Si3 phase region. Only etching pits were found in the Ti2Ni phase region. The Ti-Ni-Si-O nanostructures were characterized using scanning electron microscopy and energy dispersive spectroscopy. In addition, a formation mechanism of different nanostructures was presented.
- 1 August 2018
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 43 (31) , 14183-14192
NaBH4 reduction of Ti Si O nanotubes photoanode for high-efficiency photoelectrochemical water splitting
- 1 August 2018
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 43 (31) , 14183-14192
NaBH4 reduction of Ti Si O nanotubes photoanode for high-efficiency photoelectrochemical water splitting
- Open Access
- 31 October 2017
- Published by MDPI AG in Nanomaterials
- Vol. 7 (11) , 359
Photoelectrochemical Water Splitting Properties of Ti-Ni-Si-O Nanostructures on Ti-Ni-Si Alloy
Ti-Ni-Si-O nanostructures were successfully prepared on Ti-1Ni-5Si alloy foils via electrochemical anodization in ethylene glycol/glycerol solutions containing a small amount of water. The Ti-Ni-Si-O nanostructures were characterized by field-emission scanning electron microscopy (FE-SEM), energy dispersive spectroscopy (EDS), X-ray diffraction (XRD), and diffuse reflectance absorption spectra. Furthermore, the photoelectrochemical water splitting properties of the Ti-Ni-Si-O nanostructure films were investigated. It was found that, after anodization, three different kinds of Ti-Ni-Si-O nanostructures formed in the α-Ti phase region, Ti2Ni phase region, and Ti5Si3 phase region of the alloy surface. Both the anatase and rutile phases of Ti-Ni-Si-O oxide appeared after annealing at 500 °C for 2 h. The photocurrent density obtained from the Ti-Ni-Si-O nanostructure photoanodes was 0.45 mA/cm2 at 0 V (vs. Ag/AgCl) in 1 M KOH solution. The above findings make it feasible to further explore excellent photoelectrochemical properties of the nanostructure-modified surface of Ti-Ni-Si ternary alloys.
- 31 October 2017
- Published by MDPI AG in Nanomaterials
- Vol. 7 (11) , 359
Open AccessPhotoelectrochemical Water Splitting Properties of Ti-Ni-Si-O Nanostructures on Ti-Ni-Si Alloy
Ti-Ni-Si-O nanostructures were successfully prepared on Ti-1Ni-5Si alloy foils via electrochemical anodization in ethylene glycol/glycerol solutions containing a small amount of water. The Ti-Ni-Si-O nanostructures were characterized by field-emission scanning electron microscopy (FE-SEM), energy dispersive spectroscopy (EDS), X-ray diffraction (XRD), and diffuse reflectance absorption spectra. Furthermore, the photoelectrochemical water splitting properties of the Ti-Ni-Si-O nanostructure films were investigated. It was found that, after anodization, three different kinds of Ti-Ni-Si-O nanostructures formed in the α-Ti phase region, Ti2Ni phase region, and Ti5Si3 phase region of the alloy surface. Both the anatase and rutile phases of Ti-Ni-Si-O oxide appeared after annealing at 500 °C for 2 h. The photocurrent density obtained from the Ti-Ni-Si-O nanostructure photoanodes was 0.45 mA/cm2 at 0 V (vs. Ag/AgCl) in 1 M KOH solution. The above findings make it feasible to further explore excellent photoelectrochemical properties of the nanostructure-modified surface of Ti-Ni-Si ternary alloys.