PHPavel Hacek

Pavel Hacek

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Pavel Hacek has a total of 845 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Validation of the GBS code against COMPASS experimental data

    by Petr Mácha, Jakub Seidl, Diego Sales de Oliveira, Davide Galassi, Kyungtak Lim, David Tskhakaya, Jan Horacek, Jiri Adamek, Jordan Cavalier, Petra Bilkova, et al.

    This work presents the first full-size turbulence simulation of the COMPASS tokamak edge with the three-dimensional, self-consistent, flux-driven, two-fluid GBS code. The simulation is validated against experimental data from a standard L-mode COMPASS discharge, covering the SOL from the outer midplane to the divertor region. The dataset combines four diagnostic systems and provides 43 observable profiles, including electron temperature and plasma potential measurements that enable the first direct comparison of their fluctuations and higher-order statistics in COMPASS. The validation results show good agreement between simulation and experiment in profile shape, magnitude, and fluctuation levels for most outer midplane observables. The parallel heat-flux fall-off length is also reproduced. In the divertor, the mean profiles agree reasonably well in magnitude, but the simulated fluctuation levels remain significantly underestimated. Advanced blob analysis shows that both simulation and experiment lie mainly in the sheath-connected regime, with partial presence in the connected ideal-interchange regime. The remaining discrepancies in the COMPASS simulation are probably a consequence of simplified parameters and boundary conditions, reflecting limitations that are common to fluid turbulence models. Overall, the validation demonstrates that GBS captures the dominant upstream SOL turbulence dynamics, while identifying divertor physics as the main target for further improvement.

  • Atomic Beam Probe Synthetic Diagnostic in the COMPASS Tokamak and Its Application in Fusion Plasmas

    by Mátyás Aradi, Dániel I. Réfy, Shimpei Futatani, Ors Asztalos, Miklós Berta, Pavel Háček, Jaroslav Krbec, Sándor Zoletnik, Gergo I. Pokol

  • Final design of outer poloidal field coils for COMPASS Upgrade

    by P. Hacek, P. Junek, J. Krbec, O. Stukavec, M. Balaszova, V. Balner, P. Barton, J. Blocki, O. Bogar, P. Bohm, et al.

  • Open Access

    Quantification of locked mode instability triggered by a change in confinement

    by M. Peterka, J. Seidl, T. Markovic, A. Loarte, N.C. Logan, J.-K. Park, P. Cahyna, J. Havlicek, M. Imrisek, L. Kripner, et al.

    This work presents the first analysis of the disruptive locked mode (LM) triggered by the dynamics of a confinement change. It shows that, under certain conditions, the LM threshold during the transient is significantly lower than expected from steady states. We investigate the sensitivity to a controlled n = 1 error field (EF) activated prior to the L-H transition in the COMPASS tokamak, at q 95 ∼ 3, β N ∼ 1, and using EF coils on the high-field side of the vessel. A threshold for EF penetration subsequent to the L-H transition is identified, which shows no significant trend with density or applied torque, and is an apparent consequence of the reduced intrinsic rotation of the 2/1 mode during this transient phase. This finding challenges the assumption made in theoretical and empirical works that natural mode rotation can be predicted by global plasma parameters and urges against using any parametric EF penetration scaling derived from steady-state experiments to define the EF correction strategy in the entire discharge. Furthermore, even at EFs below the identified penetration threshold, disruptive locking of sawtooth-seeded 2/1 tearing modes is observed after about 30% of L-H transitions without external torque.


  • Open Access

    Overview of the COMPASS results *

    by M. Hron, J. Adámek, J. Cavalier, R. Dejarnac, O. Ficker, O. Grover, J. Horáček, M. Komm, E. Macúšová, E. Matveeva, et al.

    COMPASS addressed several physical processes that may explain the behaviour of important phenomena. This paper presents results related to the main fields of COMPASS research obtained in the recent two years, including studies of turbulence, L–H transition, plasma material interaction, runaway electron, and disruption physics: Tomographic reconstruction of the edge/SOL turbulence observed by a fast visible camera allowed to visualize turbulent structures without perturbing the plasma. Dependence of the power threshold on the X-point height was studied and related role of radial electric field in the edge/SOL plasma was identified. The effect of high-field-side error fields on the L–H transition was investigated in order to assess the influence of the central solenoid misalignment and the possibility to compensate these error fields by low-field-side coils. Results of fast measurements of electron temperature during ELMs show the ELM peak values at the divertor are around 80% of the initial temperature at the pedestal. Liquid metals were used for the first time as plasma facing material in ELMy H-mode in the tokamak divertor. Good power handling capability was observed for heat fluxes up to 12 MW m−2 and no direct droplet ejection was observed. Partial detachment regime was achieved by impurity seeding in the divertor. The evolution of the heat flux footprint at the outer target was studied. Runaway electrons were studied using new unique systems—impact calorimetry, carbon pellet injection technique, wide variety of magnetic perturbations. Radial feedback control was imposed on the beam. Forces during plasma disruptions were monitored by a number of new diagnostics for vacuum vessel (VV) motion in order to contribute to the scaling laws of sideways disruption forces for ITER. Current flows towards the divertor tiles, incl. possible short-circuiting through PFCs, were investigated during the VDE experiments. The results support ATEC model and improve understanding of disruption loads.


  • Open Access

    Preliminary design of the COMPASS upgrade tokamak

    by P. Vondracek, R. Panek, M. Hron, J. Havlicek, V. Weinzettl, T. Todd, D. Tskhakaya, G. Cunningham, P. Hacek, J. Hromadka, et al.


  • Study of secondary instability of precursor magnetic island in COMPASS density limit disruptions

    by F. Salzedas, S. I. W. Shah, J. Havlicek, J. Stöckel, P. Háček, J. Varju, A. Havránek, R. Pánek, C. Silva

    A systematic study of COMPASS density limit disruptions (DLDs) was carried out to analyze the relation between the precursor magnetic island and its secondary instability (SI). In all of these plasmas, the SI was always found present at the onset of energy confinement erosion. The duration of this erosion was shorter for precursor quasi-locked island than for rotating island, and the larger the island amplitude, the shorter the duration. It was also found, at the onset of the erosion of energy confinement, an inverse relation between the magnetic island amplitude and its rotation frequency, showing that erosion can start at different values of precursor island amplitude, depending on what is its rotation frequency. DLDs occur either with smaller precursor island rotating faster or larger island rotating slower (quasi-locked).


  • Micro-Faraday cup matrix detector for ion beam measurements in fusion plasmas

    by D. I. Réfy, S. Zoletnik, D. Dunai, G. Anda, M. Lampert, S. Hegedűs, D. Nagy, M. Palánkai, J. Kádi, B. Leskó, et al.

    Atomic beam probe is an extension of the routinely used beam emission spectroscopy diagnostic for the plasma edge current fluctuation measurement at magnetically confined plasmas. Beam atoms ionized by the plasma are directed to a curved trajectory by the magnetic field and may be detected close to the wall of the device. The arrival location and current distribution of the ions carry information about the plasma current distribution, the density profile, and the electric potential in the plasma edge. This paper describes a micro-Faraday cup matrix detector for the measurement of the few microampere ion current distribution close to the plasma edge. The device implements a shallow Faraday cup matrix, produced by printed-circuit board technology. Secondary electrons induced by the plasma radiation and the ion bombardment are basically confined into the cups by the tokamak magnetic field. Additionally, a double mask is installed in the front face to limit the ion influx into the cups and supplement secondary electron suppression. The setup was tested in detail using a lithium ion beam in the laboratory. Switching time, cross talk, and fluctuation sensitivity test results in the lab setup are presented along with the detector setup to be installed at the COMPASS tokamak.


  • Fast density reconstruction of Li-BES signal on the COMPASS tokamak

    by J. Krbec, P. Háček, M. Berta, J. Seidl, M. Hron, R. Pánek

    This article describes a fast and automatic reconstruction of the edge plasma electron density from the radiation of energetic Li atoms of the diagnostic beam on the COMPASS tokamak. Radiation is detected by using a CCD camera and by using an avalanche photo-diode system with a temporal resolution of 20 ms and 2 μs, respectively. Both systems are equipped with a 670.8 nm optical filter which corresponds to the lithium 1s22s1–1s22p1 transition. A theoretical model and a data processing procedure of a raw signal to obtain the density profile are described. The reconstruction algorithm provides the absolutely calibrated electron density profiles together with the measurement error estimated from relatively calibrated light profiles; the implementation is performed in Python. Time demanding operations of the code were optimized to provide reconstruction of a single profile within less than 10 ms which makes the code applicable for processing of a large amount of data. Thanks to this calculation speed, it is possible to reconstruct electron density profiles between two consecutive shots on the COMPASS tokamak with 2 μs time resolution.


  • Development of an ion beam detector for the atomic beam probe diagnostic

    by P. Hacek, M. Berta, G. Anda, M. Aradi, A. Bencze, D. Dunai, J. Krbec, R. Panek, D. I. Refy, J. Stockel, et al.

    The atomic beam probe diagnostic concept aims at measuring the edge magnetic field and through that edge current distribution in fusion plasmas by observing trajectories of an ion beam stemming from a diagnostic neutral beam. The diagnostic potentially has microsecond scale time resolution and can thus prove to be a powerful option to study fast changes in the edge plasma. A test detector has been installed on the COMPASS tokamak as an extension of the existing lithium beam diagnostic system. It employs a relatively simple concept of an array of conductive detection plates measuring the incident ion current, which is then amplified and converted to a voltage signal. The aim of the test detector is to experimentally examine the idea of the diagnostic and provide background data for design and installation of a final detector. Also, a numerical code based on the CUDA parallel computing platform has been developed for modeling lithium ion trajectories in the given COMPASS plasma discharges. We present the developments of the detector design and test measurements of the diagnostic performed both in a laboratory beam system and on the COMPASS tokamak.