André Luís de Castro Peixoto
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
André Luís de Castro Peixoto has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
- Ademir Geraldo Cavallari Costalonga
IFSP—Instituto Federal de Educação Ciência e Tecnologia de São Paulo Câmpus Capivari
4 shared publications - Rodrigo Fernando dos Santos Salazar
Universidade de Cruz Alta (UNICRUZ)
4 shared publications - Gustavo Duran Iga
Department of Chemistry Federal University of São Carlos (UFSCar) São Carlos SP 13565–905 Brazil
2 shared publications H. J. Izário Filho
University of São Paulo, Brazil
2 shared publications- Leticia Miranda Estevinho
Centro de Investigação de Montanha (CIMO), Instituto Politécnico de Bragança, Campus de Santa Apolónia, 5300-252 Bragança, Portugal
2 shared publications - Ligia Bicudo de Almeida-Muradian
Universidade de São Paulo, Sao Paulo, Brazil
2 shared publications
Latest Publications
- Open Access
Carotenoid Degradation in Annatto Dye Wastewater Using an O3/H2O2 Advanced Oxidation Process
Urucum, also known as annatto, is a plant native to Brazil. However, there is a notable scarcity of scientific studies focusing on the wastewater generated by the annatto natural dye industry. This study seeks to address the existing knowledge gaps by presenting original and substantive data pertaining to this economic sector. This study investigates the degradation of carotenoids in real annatto dye wastewater through the application of an O3/H2O2 oxidation process. A 23 factorial experimental design was utilized to determine the influence of three key variables—pH (2.5–5.5), O3 mass flow rate (8.0–18.0 mg min−1), and initial H2O2 concentration (between 1.572 and 4.716 g L−1)—on both the degradation efficiency and the associated reaction kinetics. The process demonstrated impressive carotenoid removal, achieving degradation efficiencies between 84% and 97% with pseudo-first-order kinetic constants ranging from 0.0310 to 0.0805 min−1. A statistical analysis revealed that the O3 mass flow rate was the most influential factor on the degradation efficiency, while all the operational parameters played significant roles in determining the degradation kinetics. Notably, the process achieved optimal performance without the need for pH adjustment, presenting a cost-efficient solution for industrial applications. These findings offer critical insights into the treatment of high-strength agro-industrial wastewater, thereby advancing the development and implementation of oxidation processes for wastewater management.
Open AccessCarotenoid Degradation in Annatto Dye Wastewater Using an O3/H2O2 Advanced Oxidation Process
Urucum, also known as annatto, is a plant native to Brazil. However, there is a notable scarcity of scientific studies focusing on the wastewater generated by the annatto natural dye industry. This study seeks to address the existing knowledge gaps by presenting original and substantive data pertaining to this economic sector. This study investigates the degradation of carotenoids in real annatto dye wastewater through the application of an O3/H2O2 oxidation process. A 23 factorial experimental design was utilized to determine the influence of three key variables—pH (2.5–5.5), O3 mass flow rate (8.0–18.0 mg min−1), and initial H2O2 concentration (between 1.572 and 4.716 g L−1)—on both the degradation efficiency and the associated reaction kinetics. The process demonstrated impressive carotenoid removal, achieving degradation efficiencies between 84% and 97% with pseudo-first-order kinetic constants ranging from 0.0310 to 0.0805 min−1. A statistical analysis revealed that the O3 mass flow rate was the most influential factor on the degradation efficiency, while all the operational parameters played significant roles in determining the degradation kinetics. Notably, the process achieved optimal performance without the need for pH adjustment, presenting a cost-efficient solution for industrial applications. These findings offer critical insights into the treatment of high-strength agro-industrial wastewater, thereby advancing the development and implementation of oxidation processes for wastewater management.
- 26 June 2023
- Published by Springer Nature in Brazilian Journal of Chemical Engineering
- Vol. 41 (1) , 149-161
Amoxicillin Degradation by Reactive Oxygen Species on H2O2-Alone Process
- 26 June 2023
- Published by Springer Nature in Brazilian Journal of Chemical Engineering
- Vol. 41 (1) , 149-161
Amoxicillin Degradation by Reactive Oxygen Species on H2O2-Alone Process
- Open Access
Removal of Amoxicillin from Processing Wastewater by Ozonation and UV-Aided Ozonation: Kinetic and Economic Comparative Study
This work presents an empirical and scaling-up study of the degradation and mineralization of amoxicillin (AMX) from expired pharmaceutical formulations by O3-based processes. A set of UV–ozone-based experiments was used to model the kinetics of AMX degradation, considering several chemical/photochemical mechanisms (hydrolysis, direct ozonation, radical reactions, and photolysis). Finally, the modeling data were used for scaling-up purposes, considering CAPEX and OPEX costs on the US Gulf Coast basis. In terms of experimental results, the amoxicillin (AMX) pharmaceutical effluent was successfully degraded by ozone technology at high pH values. The semi-batch ozonation process was effective after 60 min of treatment in all experimental conditions, producing degradation intermediates recalcitrant to O3 oxidative process. From the bench-scale kinetics, scaling-up simulations indicate that the gain provided by adding a UV unit does not compensate for the increase in capital and operational costs of adding irradiation equipment. It suggests ozonation at high pH as the best cost-effective approach to degrade AMX. The figures-of-merit electric energy consumption per order (EEO) corroborates the scaling-up simulations. EEO results indicate no-UV ozonation as the best option to degrade AMX at high pH values. The EEO of the present work showed a lower energy consumption system than previous papers from the literature.
Open AccessRemoval of Amoxicillin from Processing Wastewater by Ozonation and UV-Aided Ozonation: Kinetic and Economic Comparative Study
This work presents an empirical and scaling-up study of the degradation and mineralization of amoxicillin (AMX) from expired pharmaceutical formulations by O3-based processes. A set of UV–ozone-based experiments was used to model the kinetics of AMX degradation, considering several chemical/photochemical mechanisms (hydrolysis, direct ozonation, radical reactions, and photolysis). Finally, the modeling data were used for scaling-up purposes, considering CAPEX and OPEX costs on the US Gulf Coast basis. In terms of experimental results, the amoxicillin (AMX) pharmaceutical effluent was successfully degraded by ozone technology at high pH values. The semi-batch ozonation process was effective after 60 min of treatment in all experimental conditions, producing degradation intermediates recalcitrant to O3 oxidative process. From the bench-scale kinetics, scaling-up simulations indicate that the gain provided by adding a UV unit does not compensate for the increase in capital and operational costs of adding irradiation equipment. It suggests ozonation at high pH as the best cost-effective approach to degrade AMX. The figures-of-merit electric energy consumption per order (EEO) corroborates the scaling-up simulations. EEO results indicate no-UV ozonation as the best option to degrade AMX at high pH values. The EEO of the present work showed a lower energy consumption system than previous papers from the literature.
- 15 June 2021
- Published by Springer Nature
- p. 545-552
Amoxicillin Determination by Colorimetric Methods: An Experience Report Using the DMPD and NCS Methods
- 15 June 2021
- Published by Springer Nature
- p. 545-552
Amoxicillin Determination by Colorimetric Methods: An Experience Report Using the DMPD and NCS Methods
- 16 December 2020
- Published by Springer Nature
- p. 377-381
X-Ray Characterization of TiO2 Obtained by Chemical Route for Photocatalysis
- 16 December 2020
- Published by Springer Nature
- p. 377-381
X-Ray Characterization of TiO2 Obtained by Chemical Route for Photocatalysis
- 18 November 2020
- Published by Taylor & Francis in Journal of Apicultural Research
- Vol. 60 (5) , 775-783
Brazilian bee pollen: phenolic content, antioxidant properties and antimicrobial activity
Bee pollen has been promoted as a dietary supplement for humans due to its nutritional and bioactive properties. Sixty-two samples of Apis mellifera dehydrated bee pollen collected in Brazil (eight states and Federal District) were analyzed for phenolic compounds, flavonoids, antioxidant activity using DPPH, β-carotene and ORAC methods, and antimicrobial activity. The values obtained for total phenolic compounds ranged from 12.60 to 84.22 mg GAE/g bee pollen while total flavonoids oscillated between 1.90 and 36.85 mg quercetin/g bee pollen. The IC50 ranged from 0.35 to 13.42 mg bee pollen/mL of extract. The inhibition percentages ranged from 52.58 to 98.37% of bee pollen extract using the β-carotene method. When measured by the ORAC method, antioxidant activity was between 132.98 and 575.85 μmols eq. Trolox/g bee pollen. Bee pollen efficiently inhibited the growth of all the microorganisms studied. Candida albicans was the most resistant, while Staphylococcus epidermides was the most sensitive.
- 18 November 2020
- Published by Taylor & Francis in Journal of Apicultural Research
- Vol. 60 (5) , 775-783
Brazilian bee pollen: phenolic content, antioxidant properties and antimicrobial activity
Bee pollen has been promoted as a dietary supplement for humans due to its nutritional and bioactive properties. Sixty-two samples of Apis mellifera dehydrated bee pollen collected in Brazil (eight states and Federal District) were analyzed for phenolic compounds, flavonoids, antioxidant activity using DPPH, β-carotene and ORAC methods, and antimicrobial activity. The values obtained for total phenolic compounds ranged from 12.60 to 84.22 mg GAE/g bee pollen while total flavonoids oscillated between 1.90 and 36.85 mg quercetin/g bee pollen. The IC50 ranged from 0.35 to 13.42 mg bee pollen/mL of extract. The inhibition percentages ranged from 52.58 to 98.37% of bee pollen extract using the β-carotene method. When measured by the ORAC method, antioxidant activity was between 132.98 and 575.85 μmols eq. Trolox/g bee pollen. Bee pollen efficiently inhibited the growth of all the microorganisms studied. Candida albicans was the most resistant, while Staphylococcus epidermides was the most sensitive.
- 29 May 2019
- Published by Springer Nature
- p. 313-317
Efficient Optimization of Photocatalytic Process for Azo Dyes
- 29 May 2019
- Published by Springer Nature
- p. 313-317
Efficient Optimization of Photocatalytic Process for Azo Dyes
- 15 August 2018
- Published by Springer Nature
- p. 269-274
Optimization of Photocatalytic Degradation of Methyl Orange Using TiO2
- 15 August 2018
- Published by Springer Nature
- p. 269-274
Optimization of Photocatalytic Degradation of Methyl Orange Using TiO2
- Open Access
- 7 March 2018
- Published by IntechOpen
Design of Experiments Applied to Antibiotics Degradation by Fenton’s Reagent
Advanced oxidation technologies (AOTs) are processes affected by a large number of parameters such as iron (Fe2+) and H2O2 concentrations, pH, temperature, light intensity and chemical composition (organics and inorganics). In addition, for different industrial chemical processes, there are different effluents, which greatly vary in chemical composition from each other, not allowing a unique approach for all of them. Thus, it is necessary to adjust AOT parameters to the specific effluent to be treated. In such context, statistical design of experiments (DoE) and response surface methodology (RSM) emerge as important and widely used tools to determine the effects of multiple variables on wastewater treatment processes such as photo-Fenton. A revision of academic studies based on degradation of antibiotics-containing effluents is presented. The chapter also presents commercial cases of AOT and electrical efficiency considerations.
- 7 March 2018
- Published by IntechOpen
Open AccessDesign of Experiments Applied to Antibiotics Degradation by Fenton’s Reagent
Advanced oxidation technologies (AOTs) are processes affected by a large number of parameters such as iron (Fe2+) and H2O2 concentrations, pH, temperature, light intensity and chemical composition (organics and inorganics). In addition, for different industrial chemical processes, there are different effluents, which greatly vary in chemical composition from each other, not allowing a unique approach for all of them. Thus, it is necessary to adjust AOT parameters to the specific effluent to be treated. In such context, statistical design of experiments (DoE) and response surface methodology (RSM) emerge as important and widely used tools to determine the effects of multiple variables on wastewater treatment processes such as photo-Fenton. A revision of academic studies based on degradation of antibiotics-containing effluents is presented. The chapter also presents commercial cases of AOT and electrical efficiency considerations.
- 30 March 2017
- Published by Taylor & Francis in Journal of Apicultural Research
- Vol. 56 (3) , 231-238
Microbiological quality and physicochemical characterization of Brazilian bee pollen
Sixty-two commercial samples of dehydrated bee pollen (Apis mellifera bees) collected in Brazil (eight states and the Federal District) were analyzed for commercial quality (moisture, ash, lipids, proteins, and carbohydrates), and hygiene (aerobic mesophiles, yeasts and molds, coliforms, Escherichia coli, Staphylococcus aureus and sulfite-reducing Clostridium). The analyzed samples were within the regulatory limits established by the legislation for ash, lipid and protein, except for moisture content. The analyzed hygiene parameters evaluated for bee pollen are not regulated by the Brazilian legislation, and the data discussed can contribute to regulatory agencies. Only moderate and weak correlations were observed between dehydrated pollen samples and the parameters evaluated.
- 30 March 2017
- Published by Taylor & Francis in Journal of Apicultural Research
- Vol. 56 (3) , 231-238
Microbiological quality and physicochemical characterization of Brazilian bee pollen
Sixty-two commercial samples of dehydrated bee pollen (Apis mellifera bees) collected in Brazil (eight states and the Federal District) were analyzed for commercial quality (moisture, ash, lipids, proteins, and carbohydrates), and hygiene (aerobic mesophiles, yeasts and molds, coliforms, Escherichia coli, Staphylococcus aureus and sulfite-reducing Clostridium). The analyzed samples were within the regulatory limits established by the legislation for ash, lipid and protein, except for moisture content. The analyzed hygiene parameters evaluated for bee pollen are not regulated by the Brazilian legislation, and the data discussed can contribute to regulatory agencies. Only moderate and weak correlations were observed between dehydrated pollen samples and the parameters evaluated.