Sven Van Den Berghe
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Sven Van Den Berghe has a total of 259 co-authors. Here are the top co-authors by number of shared publications:
A. Leenaers
15 shared publications- Marc Verwerft
Belgian Nuclear Research Centre (SCK CEN), Institute for Nuclear Materials Science, Mol, Belgium
10 shared publications C. Detavernier
9 shared publicationsW. Van Renterghem
9 shared publications- Ann Leenaers
SCK CEN, MOL, Belgium
8 shared publications E. Koonen
7 shared publications
Latest Publications
- 26 July 2025
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 616
Swelling behavior of high density U3Si2 dispersion fuel
- 26 July 2025
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 616
Swelling behavior of high density U3Si2 dispersion fuel
- 19 October 2023
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 588
Contributions to the mechanistic understanding of the microstructural evolution in irradiated U-Mo dispersion fuel
- 19 October 2023
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 588
Contributions to the mechanistic understanding of the microstructural evolution in irradiated U-Mo dispersion fuel
- Open Access
- 27 July 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (15) , 6905
Microstructural Changes and Chemical Analysis of Fission Products in Irradiated Uranium-7 wt.% Molybdenum Metallic Fuel Using Atom Probe Tomography
Understanding the microstructural and phase changes occurring during irradiation and their impact on metallic fuel behavior is integral to research and development of nuclear fuel programs. This paper reports systematic analysis of as-fabricated and irradiated low-enriched U-Mo (uranium-molybdenum metal alloy) fuel using atom probe tomography (APT). This study is carried out on U-7 wt.% Mo fuel particles coated with a ZrN layer contained within an Al matrix during irradiation. The dispersion fuel plates from which the fuel samples were extracted are irradiated at Belgian Nuclear Research Centre (SCK CEN) with burn-up of 52% and 66% in the framework of the SELENIUM (Surface Engineering of Low ENrIched Uranium-Molybdenum) project. The APT studies on U-Mo particles from as-fabricated fuel plates enriched to 19.8% revealed predominantly γ-phase U-Mo, along with a network of the cell boundary decorated with α-U, γ’-U2Mo, and UC precipitates along the grain boundaries. The corresponding APT characterization of irradiated fuel samples showed formation of fission gas bubbles enriched with solid fission products. The intermediate burnup sample showed a uniform distribution of the typical bubble superlattice with a radius of 2 nm arranged in a regular lattice, while the high burnup sample showed a non-uniform distribution of bubbles in grain-refined regions. There was no evidence of remnant α-U, γ’-U2Mo, and UC phases in the irradiated U-7 wt.% Mo samples.
- 27 July 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (15) , 6905
Open AccessMicrostructural Changes and Chemical Analysis of Fission Products in Irradiated Uranium-7 wt.% Molybdenum Metallic Fuel Using Atom Probe Tomography
Understanding the microstructural and phase changes occurring during irradiation and their impact on metallic fuel behavior is integral to research and development of nuclear fuel programs. This paper reports systematic analysis of as-fabricated and irradiated low-enriched U-Mo (uranium-molybdenum metal alloy) fuel using atom probe tomography (APT). This study is carried out on U-7 wt.% Mo fuel particles coated with a ZrN layer contained within an Al matrix during irradiation. The dispersion fuel plates from which the fuel samples were extracted are irradiated at Belgian Nuclear Research Centre (SCK CEN) with burn-up of 52% and 66% in the framework of the SELENIUM (Surface Engineering of Low ENrIched Uranium-Molybdenum) project. The APT studies on U-Mo particles from as-fabricated fuel plates enriched to 19.8% revealed predominantly γ-phase U-Mo, along with a network of the cell boundary decorated with α-U, γ’-U2Mo, and UC precipitates along the grain boundaries. The corresponding APT characterization of irradiated fuel samples showed formation of fission gas bubbles enriched with solid fission products. The intermediate burnup sample showed a uniform distribution of the typical bubble superlattice with a radius of 2 nm arranged in a regular lattice, while the high burnup sample showed a non-uniform distribution of bubbles in grain-refined regions. There was no evidence of remnant α-U, γ’-U2Mo, and UC phases in the irradiated U-7 wt.% Mo samples.
- 13 March 2020
- Published by Elsevier
- p. 464-484
U-Al Based Fuel System
- 1 May 2019
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 127, 303-318
Feasibility studies for simultaneous irradiation of NBSR & MITR fuel elements in the BR2 reactor
- 1 May 2019
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 127, 303-318
Feasibility studies for simultaneous irradiation of NBSR & MITR fuel elements in the BR2 reactor
- 1 December 2018
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 514, 380-392
Microstructure and calorimetric analysis of the U Mn binary system
- 1 December 2018
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 514, 380-392
Microstructure and calorimetric analysis of the U Mn binary system
- 1 December 2018
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 511, 174-182
STEM-EDS/EELS and APT characterization of ZrN coatings on UMo fuel kernels
- 1 December 2018
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 511, 174-182
STEM-EDS/EELS and APT characterization of ZrN coatings on UMo fuel kernels
- Open Access
- 22 November 2018
- Published by EDP Sciences in EPJ Nuclear Sciences & Technologies
- Vol. 4, 49
Characterization of fresh EMPIrE and SEMPER FIDELIS U(Mo)/Al fuel plates made with PVD-coated U(Mo) particles
The HERACLES group and the US-DOE work jointly to develop dispersed U(Mo)/Al as LEU fuel for conversion of high performance nuclear research reactors. Within this frame, two irradiation programs are in progress. In the first, EMPIrE, mini-plates are tested in the ATR reactor (USA) and in the second, SEMPER FIDELIS, full-size plates are irradiated in BR2 (Belgium). In both experiments, U(Mo)/Al plates with optimized microstructure are tested under high duty conditions. This paper focuses on analyses made at CEA Cadarache on seven fresh plates made of atomized particles, with or without Mo homogenization, and with ZrN coating. Five EMPIrE mini-plates and two SEMPER FIDELIS full-size plates were examined by optical microscopy (OM), scanning electron microscopy (SEM) and energy dispersive X-ray spectroscopy (EDS). A particular attention is paid to the integrity of the ZrN coating (thickness, cracks…) and to the U(Mo) particles microstructure.
- 22 November 2018
- Published by EDP Sciences in EPJ Nuclear Sciences & Technologies
- Vol. 4, 49
Open AccessCharacterization of fresh EMPIrE and SEMPER FIDELIS U(Mo)/Al fuel plates made with PVD-coated U(Mo) particles
The HERACLES group and the US-DOE work jointly to develop dispersed U(Mo)/Al as LEU fuel for conversion of high performance nuclear research reactors. Within this frame, two irradiation programs are in progress. In the first, EMPIrE, mini-plates are tested in the ATR reactor (USA) and in the second, SEMPER FIDELIS, full-size plates are irradiated in BR2 (Belgium). In both experiments, U(Mo)/Al plates with optimized microstructure are tested under high duty conditions. This paper focuses on analyses made at CEA Cadarache on seven fresh plates made of atomized particles, with or without Mo homogenization, and with ZrN coating. Five EMPIrE mini-plates and two SEMPER FIDELIS full-size plates were examined by optical microscopy (OM), scanning electron microscopy (SEM) and energy dispersive X-ray spectroscopy (EDS). A particular attention is paid to the integrity of the ZrN coating (thickness, cracks…) and to the U(Mo) particles microstructure.
- 1 November 2018
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 510, 472-483
Pore pressure estimation in irradiated UMo
- 1 November 2018
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 510, 472-483
Pore pressure estimation in irradiated UMo
- 1 February 2018
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 499, 191-203
A modelling study of the inter-diffusion layer formation in U-Mo/Al dispersion fuel plates at high power
- 1 February 2018
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 499, 191-203
A modelling study of the inter-diffusion layer formation in U-Mo/Al dispersion fuel plates at high power