Liang Xu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Liang Xu has a total of 83 co-authors. Here are the top co-authors by number of shared publications:
- Weijun Li
Department of Atmospheric Sciences, School of Earth Sciences, Zhejiang University, Hangzhou 310027, China
13 shared publications - Lei Liu
Hangzhou International Innovation Institute, Beihang University, Hangzhou 311115, China
9 shared publications Jian Zhang
School of Environmental and Material Engineering, Yantai University, Yantai, China
8 shared publications- Pingqing Fu
Institute of Surface Earth System Science, School of Earth System Science, Tianjin University, Tianjin, 300072, China
8 shared publications - Daizhou Zhang
Faculty of Environmental and Symbiotic Sciences Prefectural University of Kumamoto Kumamoto Japan
7 shared publications Qi Yuan
Key Laboratory of Geoscience Big Data and Deep Resource of Zhejiang Province, Department of Atmospheric Sciences, School of Earth Sciences, Zhejiang University, Hangzhou, Zhejiang, 310027, China
6 shared publications
Latest Publications
- Open Access
- 28 August 2026
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 12 (35)
Emerging nitrogen-driven urban atmosphere control on aerosol iron dissolution for biogeochemical cycles
Iron (Fe) is a critical micronutrient regulating marine productivity and the global carbon cycle, yet its atmospheric dissolution mechanisms remain debated for biogeochemical cycle. The prevailing “iron-sulfur coupling” paradigm has traditionally explained proton-promoted dissolution. However, disproportionate declines in sulfur dioxide relative to nitrogen oxides emissions have created a “low-sulfur, high-nitrogen” atmosphere over East Asia, raising questions about the role of nitric acid. Here, we develop a data-driven framework to elucidate nitric acid–driven Fe dissolution using the nitrate-to-sulfate acidification capacity ratio ( R N/S ). Results show that nitrate now dominates urban aerosol Fe dissolution, contributing ∼1.5 times more than sulfate, challenging the long-standing paradigm. Global simulations further estimate that nitrate contributes to ∼68% of the enhancement in Fe solubility in PM 2.5 (particulate matter with a diameter of 2.5 μm) dust relative to preindustrial levels. These findings reveal an emerging nitrogen-driven control on Fe mobilization, emphasizing the need to incorporate species-dependent acid chemistry into models to accurately represent global Fe cycling and its climate feedbacks.
- 28 August 2026
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 12 (35)
Open AccessEmerging nitrogen-driven urban atmosphere control on aerosol iron dissolution for biogeochemical cycles
Iron (Fe) is a critical micronutrient regulating marine productivity and the global carbon cycle, yet its atmospheric dissolution mechanisms remain debated for biogeochemical cycle. The prevailing “iron-sulfur coupling” paradigm has traditionally explained proton-promoted dissolution. However, disproportionate declines in sulfur dioxide relative to nitrogen oxides emissions have created a “low-sulfur, high-nitrogen” atmosphere over East Asia, raising questions about the role of nitric acid. Here, we develop a data-driven framework to elucidate nitric acid–driven Fe dissolution using the nitrate-to-sulfate acidification capacity ratio ( R N/S ). Results show that nitrate now dominates urban aerosol Fe dissolution, contributing ∼1.5 times more than sulfate, challenging the long-standing paradigm. Global simulations further estimate that nitrate contributes to ∼68% of the enhancement in Fe solubility in PM 2.5 (particulate matter with a diameter of 2.5 μm) dust relative to preindustrial levels. These findings reveal an emerging nitrogen-driven control on Fe mobilization, emphasizing the need to incorporate species-dependent acid chemistry into models to accurately represent global Fe cycling and its climate feedbacks.
- 24 March 2026
- Published by Elsevier in Environmental Pollution
- Vol. 397, 128001
Ship emissions amplify soluble iron in PM2.5 in a typical coastal port in North China
- 24 March 2026
- Published by Elsevier in Environmental Pollution
- Vol. 397, 128001
Ship emissions amplify soluble iron in PM2.5 in a typical coastal port in North China
- 21 October 2025
- Published by Elsevier in Environmental Pollution
- Vol. 386, 127301
Atmospheric microplastics in rainfalls in the megacity of Hangzhou: Morphology, composition, and deposition flux
- 21 October 2025
- Published by Elsevier in Environmental Pollution
- Vol. 386, 127301
Atmospheric microplastics in rainfalls in the megacity of Hangzhou: Morphology, composition, and deposition flux
- 27 October 2023
- Published by Elsevier in Environmental Pollution
- Vol. 340 (Pt 1) , 122812
Characterizing accumulation and negative effects of aerosol particles on the leaves of urban trees
- 27 October 2023
- Published by Elsevier in Environmental Pollution
- Vol. 340 (Pt 1) , 122812
Characterizing accumulation and negative effects of aerosol particles on the leaves of urban trees
- Open Access
- 17 June 2019
- Published by Copernicus GmbH in EGUsphere
- Vol. 2019, 1-35
Morphology, mixing state, and hygroscopicity of primary biological aerosol particles from a Chinese boreal forest
Biological aerosols play an important role in atmospheric chemistry, clouds, climate, and public health. Here, we studied the morphology and composition of primary biological aerosol particles (PBAPs) collected in the Lesser Khingan Mountain boreal forest of China in summertime using transmission electron microscopy and scanning electron microscopy. Of all detected particles > 100 nm in diameter, 13 % by number were identified as PBAPs. In addition, 57 % of the PBAPs were identified as bacteria, followed by brochosomes (24 %) and fungi (19 %). The dominant size of bacteria was 1–4 μm, fungi was 2–4 μm, and brochosomes was 300–500 nm. The number size distribution of PBAPs coupled with the mass concentrations of PM2.5 and PM10 were used to estimate the total mass concentration of PBAPs, which is approximately 1.9 μg m−3 and accounts for 47 % of the in situ PM2.5–10 mass. C, N, O, P, K, and Si are detected in all PBAP particles, and P represented a major marker to identify PBAPs. Moreover, there is a higher frequency and concentration of PBAPs at night compared with day. Bacterial and fungal particles displayed weak hygroscopicity with a growth factor of ~ 1.09 at RH = 94 %. Electron microscopy shows that approximately 20 % of the bacterial particles were internally mixed with metal, mineral dust, and inorganic salts in the boreal forest air. This work provides a database for both further understanding physicochemical state of individual PBAP particles from natural sources and expanding the scope of atmospheric implications.
- 17 June 2019
- Published by Copernicus GmbH in EGUsphere
- Vol. 2019, 1-35
Open AccessMorphology, mixing state, and hygroscopicity of primary biological aerosol particles from a Chinese boreal forest
Biological aerosols play an important role in atmospheric chemistry, clouds, climate, and public health. Here, we studied the morphology and composition of primary biological aerosol particles (PBAPs) collected in the Lesser Khingan Mountain boreal forest of China in summertime using transmission electron microscopy and scanning electron microscopy. Of all detected particles > 100 nm in diameter, 13 % by number were identified as PBAPs. In addition, 57 % of the PBAPs were identified as bacteria, followed by brochosomes (24 %) and fungi (19 %). The dominant size of bacteria was 1–4 μm, fungi was 2–4 μm, and brochosomes was 300–500 nm. The number size distribution of PBAPs coupled with the mass concentrations of PM2.5 and PM10 were used to estimate the total mass concentration of PBAPs, which is approximately 1.9 μg m−3 and accounts for 47 % of the in situ PM2.5–10 mass. C, N, O, P, K, and Si are detected in all PBAP particles, and P represented a major marker to identify PBAPs. Moreover, there is a higher frequency and concentration of PBAPs at night compared with day. Bacterial and fungal particles displayed weak hygroscopicity with a growth factor of ~ 1.09 at RH = 94 %. Electron microscopy shows that approximately 20 % of the bacterial particles were internally mixed with metal, mineral dust, and inorganic salts in the boreal forest air. This work provides a database for both further understanding physicochemical state of individual PBAP particles from natural sources and expanding the scope of atmospheric implications.
- 1 June 2019
- Published by Elsevier in Science of The Total Environment
- Vol. 669, 948-954
Microscopic comparison of aerosol particles collected at an urban site in North China and a coastal site in Japan
- 1 June 2019
- Published by Elsevier in Science of The Total Environment
- Vol. 669, 948-954
Microscopic comparison of aerosol particles collected at an urban site in North China and a coastal site in Japan
- 1 March 2019
- Published by Elsevier in Journal of Environmental Sciences
- Vol. 77, 354-362
Morphology, composition, and sources of individual aerosol particles at a regional background site of the YRD, China
- 1 March 2019
- Published by Elsevier in Journal of Environmental Sciences
- Vol. 77, 354-362
Morphology, composition, and sources of individual aerosol particles at a regional background site of the YRD, China
- Open Access
- 12 October 2018
- Published by Copernicus GmbH in Atmospheric Chemistry and Physics
- Vol. 18 (19) , 14681-14693
Cloud scavenging of anthropogenic refractory particles at a mountain site in North China
Aerosol–cloud interactions remain a major source of uncertainty in climate forcing estimates. Few studies have been conducted to characterize the aerosol–cloud interactions in heavily polluted conditions worldwide. In this study, cloud residual and cloud interstitial particles were collected during cloud events under different pollution levels from 22 July to 1 August 2014 at Mt. Tai (1532 m above sea level) located in the North China Plain (NCP). A transmission electron microscope was used to investigate the morphology, size, and chemical composition of individual cloud residual and cloud interstitial particles, and to study mixing properties of different aerosol components in individual particles. Our results show that S-rich particles were predominant (78 %) during clean periods (PM 2.5 < 15 µg m −3 ), but a large number of anthropogenic refractory particles (e.g., soot, fly ash, and metal) and their mixtures with S-rich particles (defined as “S-refractory”) were observed during polluted periods. Cloud droplets collected during polluted periods were found to become an extremely complicated mixture by scavenging abundant refractory particles. We found that 76 % of cloud residual particles were S-refractory particles and that 26 % of cloud residual particles contained two or more types of refractory particles. Soot-containing particles (i.e., S-soot and S-fly ash/metal-soot) were the most abundant (62 %) among cloud residual particles, followed by fly ash/metal-containing particles (i.e., S-fly ash/metal and S-fly ash/metal-soot, 37 %). These complicated cloud droplets have not been reported in clean continental or marine air before. Our findings provide an insight into the potential impacts on cloud radiative forcing from black carbon and metal catalyzed reactions of SO 2 in micro-cloud droplets containing soluble metals released from fly ash and metals over polluted air.
- 12 October 2018
- Published by Copernicus GmbH in Atmospheric Chemistry and Physics
- Vol. 18 (19) , 14681-14693
Open AccessCloud scavenging of anthropogenic refractory particles at a mountain site in North China
Aerosol–cloud interactions remain a major source of uncertainty in climate forcing estimates. Few studies have been conducted to characterize the aerosol–cloud interactions in heavily polluted conditions worldwide. In this study, cloud residual and cloud interstitial particles were collected during cloud events under different pollution levels from 22 July to 1 August 2014 at Mt. Tai (1532 m above sea level) located in the North China Plain (NCP). A transmission electron microscope was used to investigate the morphology, size, and chemical composition of individual cloud residual and cloud interstitial particles, and to study mixing properties of different aerosol components in individual particles. Our results show that S-rich particles were predominant (78 %) during clean periods (PM 2.5 < 15 µg m −3 ), but a large number of anthropogenic refractory particles (e.g., soot, fly ash, and metal) and their mixtures with S-rich particles (defined as “S-refractory”) were observed during polluted periods. Cloud droplets collected during polluted periods were found to become an extremely complicated mixture by scavenging abundant refractory particles. We found that 76 % of cloud residual particles were S-refractory particles and that 26 % of cloud residual particles contained two or more types of refractory particles. Soot-containing particles (i.e., S-soot and S-fly ash/metal-soot) were the most abundant (62 %) among cloud residual particles, followed by fly ash/metal-containing particles (i.e., S-fly ash/metal and S-fly ash/metal-soot, 37 %). These complicated cloud droplets have not been reported in clean continental or marine air before. Our findings provide an insight into the potential impacts on cloud radiative forcing from black carbon and metal catalyzed reactions of SO 2 in micro-cloud droplets containing soluble metals released from fly ash and metals over polluted air.