Yu Du
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yu Du has a total of 102 co-authors. Here are the top co-authors by number of shared publications:
- Xiaoqing Tian
College of Physics and Optoelectronic Engineering, Shenzhen University, Shenzhen 518060, China
9 shared publications - Boris I. Yakobson
Department of Materials Science and Nanoengineering, Rice University, Houston, TX 77005, USA
7 shared publications Juan Gu
College of Physics and Energy, Shenzhen University , Shenzhen 518060, Guangdong, P.R. China
6 shared publicationsLin Liu
College of Physics and Energy, Shenzhen University , Shenzhen 518060, Guangdong, P.R. China
6 shared publications- Xuejin Li
Shenzhen Key Laboratory of Sensor Technology, Shenzhen University, Shenzhen, China
6 shared publications - Youfu Geng
College of Physics and Optoelectronic Engineering, Shenzhen Key Laboratory of Sensor Technology, Shenzhen University, Shenzhen, China
6 shared publications
Latest Publications
- 6 May 2025
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 10 (7) , 4938-4944
A Silicon Microring Resonator for Refractive Index Carbon Dioxide Gas Sensing
Silicon microring resonators (MRRs) are promising for on-chip optical gas sensing due to their strong light-matter interaction, compact footprint, and mass-scalable fabrication potential. However, for refractive index sensors, it is essential to consider the cross-sensitivity to temperature induced by the thermal-optic effect in MRRs. To address this challenge, we demonstrate a silicon MRR coated with gas-sensitive polyhexamethylene biguanide hydrochloride as the upper cladding for carbon dioxide sensing. The engineered MRR exhibits distinct temperature and gas sensitivities for TE0 and TE1 modes. With the linear independent responses, a gas sensitivity of -0.90 pm/ppm within a range of 700 ppm is demonstrated in conjunction with the temperature compensation. The response and recovery times of gas sensing are measured as ∼3.5 and 1.5 min. Our study paves the way for on-chip optical gas sensing with temperature compensation.
- 6 May 2025
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 10 (7) , 4938-4944
A Silicon Microring Resonator for Refractive Index Carbon Dioxide Gas Sensing
Silicon microring resonators (MRRs) are promising for on-chip optical gas sensing due to their strong light-matter interaction, compact footprint, and mass-scalable fabrication potential. However, for refractive index sensors, it is essential to consider the cross-sensitivity to temperature induced by the thermal-optic effect in MRRs. To address this challenge, we demonstrate a silicon MRR coated with gas-sensitive polyhexamethylene biguanide hydrochloride as the upper cladding for carbon dioxide sensing. The engineered MRR exhibits distinct temperature and gas sensitivities for TE0 and TE1 modes. With the linear independent responses, a gas sensitivity of -0.90 pm/ppm within a range of 700 ppm is demonstrated in conjunction with the temperature compensation. The response and recovery times of gas sensing are measured as ∼3.5 and 1.5 min. Our study paves the way for on-chip optical gas sensing with temperature compensation.
- 2 April 2024
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 36 (8) , 3976
Correction to “Electronic and Magnetic Diversity of Graphone/Graphene Superlattices”
- 2 April 2024
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 36 (8) , 3976
Correction to “Electronic and Magnetic Diversity of Graphone/Graphene Superlattices”
- 28 April 2023
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 6 (9) , 7855-7863
Au Nanocage/In2O3 Nanoparticle-Based Hybrid Structures for Formaldehyde Sensors
- 28 April 2023
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 6 (9) , 7855-7863
Au Nanocage/In2O3 Nanoparticle-Based Hybrid Structures for Formaldehyde Sensors
- Open Access
- 10 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 14 (4) , 1-5
In-Situ Study of Dynamics of Refractive Index Changes in Silicon Devices Induced by UV-light Irradiation
Silicon photonics has been studied in various areas by providing small-footprint, high-performance, and mass-producible optoelectronic components integrated on a chip. For the photonic packaging, ultraviolet (UV) curing techniques have been widely utilized. Meanwhile, silica cladding absorption to UV light could alter its refractive index (RI), affecting the optical testing of silicon devices during or after the device packaging. Therefore, it is significant to characterize the dynamics of RI changes induced by UV-light irradiation. However, the in-situ characterization of such devices is seldom explored. Here, we studied the influence of UV-light irradiation on silicon photonic devices by probing resonant wavelength shifts of a racetrack microring resonator. Specifically, we studied the temporary variation of the resonant wavelength and its recovery time under different UV-light exposure durations. Experimental results show that with a UV energy of 21 J/cm2, the resonator had a maximum resonant wavelength shift of 0.31 nm, corresponding to an effective RI change of 0.0009 and recovering time of 95 minutes. Based on the experimental results, we compressively analyzed and compared RI changes induced by plasmon dispersion effect, thermal optical effect and photon-induced silica densification effect. Our study is expected to provide useful guidelines for in-situ silicon photonic testing and packaging.
- 10 June 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 14 (4) , 1-5
Open AccessIn-Situ Study of Dynamics of Refractive Index Changes in Silicon Devices Induced by UV-light Irradiation
Silicon photonics has been studied in various areas by providing small-footprint, high-performance, and mass-producible optoelectronic components integrated on a chip. For the photonic packaging, ultraviolet (UV) curing techniques have been widely utilized. Meanwhile, silica cladding absorption to UV light could alter its refractive index (RI), affecting the optical testing of silicon devices during or after the device packaging. Therefore, it is significant to characterize the dynamics of RI changes induced by UV-light irradiation. However, the in-situ characterization of such devices is seldom explored. Here, we studied the influence of UV-light irradiation on silicon photonic devices by probing resonant wavelength shifts of a racetrack microring resonator. Specifically, we studied the temporary variation of the resonant wavelength and its recovery time under different UV-light exposure durations. Experimental results show that with a UV energy of 21 J/cm2, the resonator had a maximum resonant wavelength shift of 0.31 nm, corresponding to an effective RI change of 0.0009 and recovering time of 95 minutes. Based on the experimental results, we compressively analyzed and compared RI changes induced by plasmon dispersion effect, thermal optical effect and photon-induced silica densification effect. Our study is expected to provide useful guidelines for in-situ silicon photonic testing and packaging.
- Open Access
Multiplexed Weak Waist-Enlarged Fiber Taper Curvature Sensor and Its Rapid Inline Fabrication
This study proposes a multiplexed weak waist-enlarged fiber taper (WWFT) curvature sensor and its rapid fabrication method. Compared with other types of fiber taper, the proposed WWFT has no difference in appearance with the single mode fiber and has ultralow insertion loss. The fabrication of WWFT also does not need the repeated cleaving and splicing process, and thereby could be rapidly embedded into the inline sensing fiber without splicing point, which greatly enhances the sensor solidity. Owing to the ultralow insertion loss (as low as 0.15 dB), the WWFT-based interferometer is further used for multiplexed curvature sensing. The results show that the different curvatures can be individually detected by the multiplexed interferometers. Furthermore, it also shows that diverse responses for the curvature changes exist in two orthogonal directions, and the corresponding sensitivities are determined to be 79.1°/m−1 and –48.0°/m−1 respectively. This feature can be potentially applied for vector curvature sensing.
Open AccessMultiplexed Weak Waist-Enlarged Fiber Taper Curvature Sensor and Its Rapid Inline Fabrication
This study proposes a multiplexed weak waist-enlarged fiber taper (WWFT) curvature sensor and its rapid fabrication method. Compared with other types of fiber taper, the proposed WWFT has no difference in appearance with the single mode fiber and has ultralow insertion loss. The fabrication of WWFT also does not need the repeated cleaving and splicing process, and thereby could be rapidly embedded into the inline sensing fiber without splicing point, which greatly enhances the sensor solidity. Owing to the ultralow insertion loss (as low as 0.15 dB), the WWFT-based interferometer is further used for multiplexed curvature sensing. The results show that the different curvatures can be individually detected by the multiplexed interferometers. Furthermore, it also shows that diverse responses for the curvature changes exist in two orthogonal directions, and the corresponding sensitivities are determined to be 79.1°/m−1 and –48.0°/m−1 respectively. This feature can be potentially applied for vector curvature sensing.
- Open Access
- 15 June 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 13 (4) , 1-6
Design of a Graphene-Based Waveguide-Integrated Multimode Phase Modulator
The on-chip mode-division multiplexing (MDM) is an attractive technique to achieve high-capacity optical transmissions by using a single-wavelength carrier. In traditional schemes, multiple channels with a fundamental mode are modulated by parallel arranged electro-optic modulators and then converted to high-order modes. However, the method is usually limited by large device footprints and high energy consumption. In this work, we study a graphene-based waveguide-integrated multimode phase modulator to individually modulate TE0 and TE1 modes in a multimode waveguide device. To be specific, we designed a single layer of graphene narrow strips (GNSs) integrated on the surface of the multimode waveguide device to selectively introduce contrasting phase shifts to different modes. Based on the optimized waveguide structures, a Mach-Zehnder interferometer modulator with different GNS patterns on each arm is designed. Our study is promising to be used in the future high-density on-chip MDM systems for optical interconnects and optical networks.
- 15 June 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 13 (4) , 1-6
Open AccessDesign of a Graphene-Based Waveguide-Integrated Multimode Phase Modulator
The on-chip mode-division multiplexing (MDM) is an attractive technique to achieve high-capacity optical transmissions by using a single-wavelength carrier. In traditional schemes, multiple channels with a fundamental mode are modulated by parallel arranged electro-optic modulators and then converted to high-order modes. However, the method is usually limited by large device footprints and high energy consumption. In this work, we study a graphene-based waveguide-integrated multimode phase modulator to individually modulate TE0 and TE1 modes in a multimode waveguide device. To be specific, we designed a single layer of graphene narrow strips (GNSs) integrated on the surface of the multimode waveguide device to selectively introduce contrasting phase shifts to different modes. Based on the optimized waveguide structures, a Mach-Zehnder interferometer modulator with different GNS patterns on each arm is designed. Our study is promising to be used in the future high-density on-chip MDM systems for optical interconnects and optical networks.
- 12 March 2021
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 33 (6) , 2090-2098
Electronic and Magnetic Diversity of Graphone/Graphene Superlattices
- 12 March 2021
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 33 (6) , 2090-2098
Electronic and Magnetic Diversity of Graphone/Graphene Superlattices
- 30 June 2020
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 8 (32) , 11153-11159
A self-assembled fiber Mach–Zehnder interferometer based on liquid crystals
In this work, we fabricated a self-assembled fiber Mach–Zehnder interferometer (MZI) based on liquid crystals (LCs), which offers a new method for LC/fiber sensing.
- 30 June 2020
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 8 (32) , 11153-11159
A self-assembled fiber Mach–Zehnder interferometer based on liquid crystals
In this work, we fabricated a self-assembled fiber Mach–Zehnder interferometer (MZI) based on liquid crystals (LCs), which offers a new method for LC/fiber sensing.
- 21 May 2020
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 12 (25) , 13450-13459
Hexagonal layered group IV–VI semiconductors and derivatives: fresh blood of the 2D family
New phases of group IV–VI semiconductors in 2D hexagonal structures are predicted and their unusual physical properties are revealed.
- 21 May 2020
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 12 (25) , 13450-13459
Hexagonal layered group IV–VI semiconductors and derivatives: fresh blood of the 2D family
New phases of group IV–VI semiconductors in 2D hexagonal structures are predicted and their unusual physical properties are revealed.
- 1 June 2019
- Published by Elsevier in Materials Letters
- Vol. 244, 182-185
Mesostructure Carbon-Templated synthesis of mesoporous ZnO by a nanocasting route for NO2 sensing
- 1 June 2019
- Published by Elsevier in Materials Letters
- Vol. 244, 182-185
Mesostructure Carbon-Templated synthesis of mesoporous ZnO by a nanocasting route for NO2 sensing