Balaji Birajdar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Balaji Birajdar has a total of 43 co-authors. Here are the top co-authors by number of shared publications:
- Ankit Chahar
Special Center for Nanoscience
5 shared publications - Ram Krishna Ghosh
Department of Electronics and Communication Engineering, Indraprastha Institute of Information Technology Delhi , New Delhi
5 shared publications - Satyabrata Patnaik
Jawaharlal Nehru University
4 shared publications Devender Takhar
3 shared publicationsK. Asokan
3 shared publicationsR. Kumar
3 shared publications
Latest Publications
- 14 March 2026
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 8 (6) , 2285-2294
Optimizing the Ferroelectric Photovoltaic Performance of 0.9[KNbO 3 ]–0.1[BaNi 1/2 Nb 1/2 O 3−δ ] Ceramics via Grain Size Engineering
- 14 March 2026
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 8 (6) , 2285-2294
Optimizing the Ferroelectric Photovoltaic Performance of 0.9[KNbO 3 ]–0.1[BaNi 1/2 Nb 1/2 O 3−δ ] Ceramics via Grain Size Engineering
- Open Access
- 8 January 2026
- Published by Taylor & Francis in Journal of Experimental Nanoscience
- Vol. 21 (1)
Effect of silver incorporation on structural and optical properties of TiO 2 thin films prepared via non-aqueous sol-gel route
- 8 January 2026
- Published by Taylor & Francis in Journal of Experimental Nanoscience
- Vol. 21 (1)
Open AccessEffect of silver incorporation on structural and optical properties of TiO 2 thin films prepared via non-aqueous sol-gel route
- 8 September 2025
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 9 (9)
Competing role of disorder and charge density wave in superconducting- 8 September 2025
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 9 (9)
Competing role of disorder and charge density wave in superconducting- 15 July 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (25) , 44263-44271
Ni2+ mediated enhanced microstructural, optical, and electrical properties of 0.9KNbO3- 0.1BaNi0.5Nb0.5O3-δ electro ceramics for photovoltaic applications
- 15 July 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (25) , 44263-44271
Ni2+ mediated enhanced microstructural, optical, and electrical properties of 0.9KNbO3- 0.1BaNi0.5Nb0.5O3-δ electro ceramics for photovoltaic applications
- Open Access
- 22 August 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (8)
Silver-induced layer exchange and crystallization of a-Si films investigated using in situ scanning transmission electron microscopy
Ag-induced crystallization and layer exchange (AgILE) in a stack of amorphous Si/Ag/quartz substrate has been investigated using optical microscopy, scanning electron microscopy, transmission electron microscopy (TEM), scanning TEM-high angle annular dark field (STEM-HAADF) imaging, and electron tomography, covering length scales from a few tens of micrometers to a few tens of nanometers. The size of Ag grains in the underlying as-deposited Ag film varied from ∼10 to 500 nm. The following processes could be discerned using in situ heating of plan-view samples at 500 °C in STEM: (i) AgILE propagation preferentially along regions of small Ag grains, (ii) formation of pushed-up Ag in the vicinity of AgILE reaction cells, (iii) migration and agglomeration of pushed-up Ag on small and large Ag grains, which tend to inhibit AgILE and promote dendricity, and (iv) dispersion of pushed-up Ag, which tend to reduce dendricity. The resulting dendricity was largely confined to the peripheral regions of the impinging reaction cells and decreased with annealing time. In contrast, dendricity due to AgILE and crystallization at 550 °C is stable and extends right from the center to the periphery of the reaction cells. The microscopic mechanism of AgILE and, in particular, the effect of annealing temperature is investigated. The results are discussed in the light of existing literature and compared with Al-induced layer exchange. Annealing at temperature equal to or slightly less than 500 °C is found to be necessary in the case of AgILE to avoid dendricity and to obtain a continuous Si layer with large Si grains.
- 22 August 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (8)
Open AccessSilver-induced layer exchange and crystallization of a-Si films investigated using in situ scanning transmission electron microscopy
Ag-induced crystallization and layer exchange (AgILE) in a stack of amorphous Si/Ag/quartz substrate has been investigated using optical microscopy, scanning electron microscopy, transmission electron microscopy (TEM), scanning TEM-high angle annular dark field (STEM-HAADF) imaging, and electron tomography, covering length scales from a few tens of micrometers to a few tens of nanometers. The size of Ag grains in the underlying as-deposited Ag film varied from ∼10 to 500 nm. The following processes could be discerned using in situ heating of plan-view samples at 500 °C in STEM: (i) AgILE propagation preferentially along regions of small Ag grains, (ii) formation of pushed-up Ag in the vicinity of AgILE reaction cells, (iii) migration and agglomeration of pushed-up Ag on small and large Ag grains, which tend to inhibit AgILE and promote dendricity, and (iv) dispersion of pushed-up Ag, which tend to reduce dendricity. The resulting dendricity was largely confined to the peripheral regions of the impinging reaction cells and decreased with annealing time. In contrast, dendricity due to AgILE and crystallization at 550 °C is stable and extends right from the center to the periphery of the reaction cells. The microscopic mechanism of AgILE and, in particular, the effect of annealing temperature is investigated. The results are discussed in the light of existing literature and compared with Al-induced layer exchange. Annealing at temperature equal to or slightly less than 500 °C is found to be necessary in the case of AgILE to avoid dendricity and to obtain a continuous Si layer with large Si grains.
- 16 August 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (21) , 44139-44150
Phase evolution and piezoelectric properties of SnO2 doped KNN based piezoceramics
- 16 August 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (21) , 44139-44150
Phase evolution and piezoelectric properties of SnO2 doped KNN based piezoceramics
- 14 May 2024
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 26 (22) , 16261-16272
Dual functionality of the BiN monolayer: unraveling its photocatalytic and piezocatalytic water splitting properties
To achieve scalable and economically viable green hydrogen (H2) production, the photocatalytic and piezocatalytic processes are promising methods. The key to successful overall water splitting (OWS) for H2 production in these processes is using suitable semiconductor catalysts with appropriate band edge potentials, efficient optical absorption, higher mechanical flexibility, and piezoelectric coefficients. Thus, we explore the bismuth nitride (BiN) monolayer using density functional theory simulations, revealing intriguing catalytic properties. The BiN monolayer is a semiconductor with an indirect electronic bandgap (Eg) of 2.08 eV and displays excellent visible light absorption (approximately 105 cm−1). Detailed analyses show that the band edges satisfy the redox potential for photocatalytic OWS via biaxial strain engineering and pH variation. Notably, the solar to hydrogen conversion efficiency (ηSTH) for the BiN monolayer can reach 17.18%, which exceeds the 10% efficiency limit of photocatalysts for economical green H2 production. The obtained in-plane piezoelectric coefficient of e11 = 16.18 Å C m−1 is superior to widely studied 2D materials. Moreover, the generated piezopotential under oscillatory strain stands at 28.34 V, which can initiate the water redox reaction via the piezocatalytic mechanism. This originates from the mechanical flexibility coupled with higher piezoelectric coefficients. The result highlights the BiN monolayer's potential application in photocatalytic, piezocatalytic, and photo-piezo-catalytic OWS.
- 14 May 2024
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 26 (22) , 16261-16272
Dual functionality of the BiN monolayer: unraveling its photocatalytic and piezocatalytic water splitting properties
To achieve scalable and economically viable green hydrogen (H2) production, the photocatalytic and piezocatalytic processes are promising methods. The key to successful overall water splitting (OWS) for H2 production in these processes is using suitable semiconductor catalysts with appropriate band edge potentials, efficient optical absorption, higher mechanical flexibility, and piezoelectric coefficients. Thus, we explore the bismuth nitride (BiN) monolayer using density functional theory simulations, revealing intriguing catalytic properties. The BiN monolayer is a semiconductor with an indirect electronic bandgap (Eg) of 2.08 eV and displays excellent visible light absorption (approximately 105 cm−1). Detailed analyses show that the band edges satisfy the redox potential for photocatalytic OWS via biaxial strain engineering and pH variation. Notably, the solar to hydrogen conversion efficiency (ηSTH) for the BiN monolayer can reach 17.18%, which exceeds the 10% efficiency limit of photocatalysts for economical green H2 production. The obtained in-plane piezoelectric coefficient of e11 = 16.18 Å C m−1 is superior to widely studied 2D materials. Moreover, the generated piezopotential under oscillatory strain stands at 28.34 V, which can initiate the water redox reaction via the piezocatalytic mechanism. This originates from the mechanical flexibility coupled with higher piezoelectric coefficients. The result highlights the BiN monolayer's potential application in photocatalytic, piezocatalytic, and photo-piezo-catalytic OWS.
- 9 February 2023
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 127 (7) , 3408-3416
Photocatalytic and Piezocatalytic Properties of h-NbP and h-NbN Monolayers for Green Hydrogen Production: Insight from Density Functional Theory Calculations
- 9 February 2023
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 127 (7) , 3408-3416
Photocatalytic and Piezocatalytic Properties of h-NbP and h-NbN Monolayers for Green Hydrogen Production: Insight from Density Functional Theory Calculations