Salvador José Esteves Dias
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Salvador José Esteves Dias has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Joaquim Antonio Oliveira Barros
ISISE, ARISE, Department of Civil Engineering University of Minho Guimarães Portugal
19 shared publications - M. R. Mostakhdemin Hosseini
Department of Civil Engineering, Mahdishahr Branch Islamic Azad University Mahdishahr Iran
4 shared publications - António Ventura-Gouveia
Department of Civil Engineering, Polytechnic Institute of Viseu, Campus Politécnico de Repeses, 3504-510 Viseu, Portugal
2 shared publications Hadi Baghi
2 shared publications- A. Ziaeinia
University of Minho
1 shared publication Adriano S. Fortes
1 shared publication
Latest Publications
- 8 February 2026
- Published by Springer Nature
- p. 379-389
Flexural Strengthening of Reinforced Concrete Cantilever Balconies With New ETS-NSM CFRP Bar
- 8 February 2026
- Published by Springer Nature
- p. 379-389
Flexural Strengthening of Reinforced Concrete Cantilever Balconies With New ETS-NSM CFRP Bar
- Open Access
- 5 September 2024
- Published by MDPI AG in Journal of Composites Science
- Vol. 8 (9) , 348
Numerical Assessment of the Effect of CFRP Anchorages on the Flexural and Shear Strengthening Performance of RC Beams
This study investigates the effectiveness of a hybrid solution that combines carbon fiber-reinforced polymer (CFRP) systems for the flexural and shear strengthening of T-cross section reinforced concrete (RC) beams. The hybrid solution consists of near-surface mounted CFRP laminates for flexural enhancement and externally bonded U-shaped CFRP strips for shear strengthening. Moreover, an innovative CFRP anchorage system is proposed to prevent premature debonding of the U-CFRP strips and to improve their shear contribution. To address the limitations of the experimental program and propose an efficient and design-oriented simulation approach for NSM-EBR strengthening RC beams with the innovative anchorage system, a comprehensive numerical investigation was conducted by considering the key parameters affecting the performance of the strengthened system. This paper presents the results of an experimental program and a nonlinear finite element analysis that simulate the behavior of the materials up to their failure and the bond conditions between CFRP and concrete. This study also includes a numerical parametric study to assess the effectiveness of the proposed strengthening concept with several possible scenarios, as well as the predictive performance of the fib Bulletin 90 and ACI 440.2R-17 formulations.
- 5 September 2024
- Published by MDPI AG in Journal of Composites Science
- Vol. 8 (9) , 348
Open AccessNumerical Assessment of the Effect of CFRP Anchorages on the Flexural and Shear Strengthening Performance of RC Beams
This study investigates the effectiveness of a hybrid solution that combines carbon fiber-reinforced polymer (CFRP) systems for the flexural and shear strengthening of T-cross section reinforced concrete (RC) beams. The hybrid solution consists of near-surface mounted CFRP laminates for flexural enhancement and externally bonded U-shaped CFRP strips for shear strengthening. Moreover, an innovative CFRP anchorage system is proposed to prevent premature debonding of the U-CFRP strips and to improve their shear contribution. To address the limitations of the experimental program and propose an efficient and design-oriented simulation approach for NSM-EBR strengthening RC beams with the innovative anchorage system, a comprehensive numerical investigation was conducted by considering the key parameters affecting the performance of the strengthened system. This paper presents the results of an experimental program and a nonlinear finite element analysis that simulate the behavior of the materials up to their failure and the bond conditions between CFRP and concrete. This study also includes a numerical parametric study to assess the effectiveness of the proposed strengthening concept with several possible scenarios, as well as the predictive performance of the fib Bulletin 90 and ACI 440.2R-17 formulations.
- 29 April 2022
- Published by Wiley in Structural Concrete
- Vol. 23 (3) , 1780-1793
Fatigue behavior of RC slabs flexurally strengthened with prestressed NSM CFRP laminates
- 29 April 2022
- Published by Wiley in Structural Concrete
- Vol. 23 (3) , 1780-1793
Fatigue behavior of RC slabs flexurally strengthened with prestressed NSM CFRP laminates
- 3 July 2021
- Published by SAGE Publications in Advances in Structural Engineering
- Vol. 24 (13) , 2927-2947
Flexural strengthening of pre-cracked RC slabs with prestressed NSM CFRP laminates and evaluation of strain loss
The strengthening intervention of RC structures often involves already cracked concrete. To evaluate the effect of the level of damage prior to the strengthening (pre-cracks) on the behavior of the flexurally strengthened RC slabs with prestressed NSM CFRP laminates, an experimental research was carried out. Two pre-cracking levels of damage were analyzed and, for each one, three levels of prestress were tested (0%, 20% and 40%). The obtained results showed that the strengthening of damaged RC slabs with prestressed NSM CFRP laminates results in a significant increase on the load carrying capacity at serviceability limit states. Pre-cracked RC slabs strengthened with prestressed NSM CFRP laminates presented a load carrying capacity almost similar to the corresponding uncracked strengthened slabs. To determine the effective prestress level in CFRP laminates, the variation of strain over the length of the CFRP and over time was experimentally recorded. The prestress transfer length was also evaluated. The experimental results revealed that the transfer length of CFRP laminates was less than 150 mm, and the maximum value of strain loss out of transfer length (around 14%) was measured close to the cracked section of the damaged RC slabs. Significant part of strain loss in CFRP laminates occurred during 24 h after releasing the prestress load.
- 3 July 2021
- Published by SAGE Publications in Advances in Structural Engineering
- Vol. 24 (13) , 2927-2947
Flexural strengthening of pre-cracked RC slabs with prestressed NSM CFRP laminates and evaluation of strain loss
The strengthening intervention of RC structures often involves already cracked concrete. To evaluate the effect of the level of damage prior to the strengthening (pre-cracks) on the behavior of the flexurally strengthened RC slabs with prestressed NSM CFRP laminates, an experimental research was carried out. Two pre-cracking levels of damage were analyzed and, for each one, three levels of prestress were tested (0%, 20% and 40%). The obtained results showed that the strengthening of damaged RC slabs with prestressed NSM CFRP laminates results in a significant increase on the load carrying capacity at serviceability limit states. Pre-cracked RC slabs strengthened with prestressed NSM CFRP laminates presented a load carrying capacity almost similar to the corresponding uncracked strengthened slabs. To determine the effective prestress level in CFRP laminates, the variation of strain over the length of the CFRP and over time was experimentally recorded. The prestress transfer length was also evaluated. The experimental results revealed that the transfer length of CFRP laminates was less than 150 mm, and the maximum value of strain loss out of transfer length (around 14%) was measured close to the cracked section of the damaged RC slabs. Significant part of strain loss in CFRP laminates occurred during 24 h after releasing the prestress load.
- 1 October 2018
- Published by Elsevier in Composite Structures
- Vol. 201, 363-376
Behavior of RC beams flexurally strengthened with NSM CFRP laminates
- 1 October 2018
- Published by Elsevier in Composite Structures
- Vol. 201, 363-376
Behavior of RC beams flexurally strengthened with NSM CFRP laminates
- 1 April 2017
- Published by Elsevier in Composites Part B: Engineering
- Vol. 114, 256-267
NSM shear strengthening technique with CFRP laminates applied in high T cross section RC beams
- 1 April 2017
- Published by Elsevier in Composites Part B: Engineering
- Vol. 114, 256-267
NSM shear strengthening technique with CFRP laminates applied in high T cross section RC beams
- 1 November 2016
- Published by American Concrete Institute in ACI Structural Journal
- Vol. 113 (6) , 1275-1287
New Shear Strengthening Configurations of Near-Surface-Mounted CFRP Laminates for RC Beams
- 1 November 2016
- Published by American Concrete Institute in ACI Structural Journal
- Vol. 113 (6) , 1275-1287
New Shear Strengthening Configurations of Near-Surface-Mounted CFRP Laminates for RC Beams
- 1 April 2016
- Published by Elsevier in Composites Part B: Engineering
- Vol. 90, 14-29
Flexural strengthening of reinforced low strength concrete slabs using prestressed NSM CFRP laminates
- 1 April 2016
- Published by Elsevier in Composites Part B: Engineering
- Vol. 90, 14-29
Flexural strengthening of reinforced low strength concrete slabs using prestressed NSM CFRP laminates
- 1 May 2014
- Published by Elsevier in Composite Structures
- Vol. 111, 249-258
Effectiveness of prestressed NSM CFRP laminates for the flexural strengthening of RC slabs
- 1 May 2014
- Published by Elsevier in Composite Structures
- Vol. 111, 249-258
Effectiveness of prestressed NSM CFRP laminates for the flexural strengthening of RC slabs
- 1 November 2013
- Published by Elsevier in Engineering Structures
- Vol. 56, 1192-1206
A FEM-based model to predict the behaviour of RC beams shear strengthened according to the NSM technique
- 1 November 2013
- Published by Elsevier in Engineering Structures
- Vol. 56, 1192-1206
A FEM-based model to predict the behaviour of RC beams shear strengthened according to the NSM technique