David H. Solomon

Understanding, and improving, the behavior of thin surface films under exposure to externally applied forces is important for applications such as mimicking biological membranes, water evaporation mitigation, and recovery of oil spills. This paper demonstrates that the incorporation of a water-soluble polymer into the surface film composition, i.e., formation of a three-duolayer system, shows improved performance under an applied dynamic stress, with an evaporation saving of 84% observed after 16 h, compared to 74% for the insoluble three-monolayer alone. Canal viscometry and spreading rate experiments, performed using the same conditions, demonstrated an increased surface viscosity and faster spreading rate for the three-duolayer system, likely contributing to the observed improvement in dynamic performance. Brewster angle microscopy and dye-tagged polymers were used to visualize the system and demonstrated that the duolayer and monolayer system both form a homogeneous film of uniform, single-molecule thickness, with the excess material compacting into small floating reservoirs on the surface. It was also observed that both components have to be applied to the water surface together in order to achieve improved performance under dynamic conditions. These findings have important implications for the use of surface films in various applications where resistance to external disturbance is required.

The novel duolayer system, comprising a monolayer of ethylene glycol monooctadecyl ether (C18E1) and the water-soluble polymer poly(vinylpyrrolidone) (PVP), has been shown to resist forces such as wind stress to a greater degree than the C18E1 monolayer alone. This paper reports all-atom molecular dynamics simulations comparing the monolayer (C18E1 alone) and duolayer systems under an applied force parallel to the air/water interface. The simulations show that, due to the presence of PVP at the interface, the duolayer film exhibits an increase in chain tilt, ordering, and density, as well as a lower lateral velocity compared to the monolayer. These results provide a molecular rationale for the improved performance of the duolayer system under wind conditions, as well as an atomic-level explanation for the observed efficacy of the duolayer system as an evaporation suppressant, which may serve as a useful guide for future development for thin films where resistance to external perturbation is desirable.

All-atom molecular dynamics simulations and experimental characterization have been used to examine the structure and dynamics of novel evaporation-suppressing films where the addition of a water-soluble polymer to an ethylene glycol monooctadecyl ether monolayer leads to improved water evaporation resistance. Simulations and Langmuir trough experiments demonstrate the surface activity of poly(vinyl pyrrolidone) (PVP). Subsequent MD simulations performed on the thin films supported by the PVP sublayer show that, at low surface pressures, the polymer tends to concentrate at the film/water interface. The simulated atomic concentration profiles, hydrogen bonding patterns, and mobility analyses of the water-polymer-monolayer interfaces reveal that the presence of PVP increases the atomic density near the monolayer film, improves the film stability, and reduces the mobility of interfacial waters. These observations explain the molecular basis of the improved efficacy of these monolayer/polymer systems for evaporation protection of water and can be used to guide future development of organic thin films for other applications.

The inclusion of a water-soluble polymer, poly(vinyl pyrrolidone) (PVP), into a surface active film composition before application to the water surface leads to the formation of a dynamic duolayer; a novel surface film system. This duolayer shows improved surface viscosity over the monolayer compound alone, while the addition of polymer maintains other film properties such as evaporation control and equilibrium spreading pressure. Brewster Angle Microscopy shows that the duolayer film undergoes a different formation mechanism upon film compression, and the resultant surface pressure/area isotherm is different at lower surface pressures indicating the PVP is present on the water surface at these pressures and squeezed out to the water subphase at higher pressures. The addition of water-soluble polymers to form a dynamic duolayer provides a unique way to produce defect-free and tightly packed films while polymer is associated with the film. This finding provides new knowledge for the design of surface films with improved properties with potential applications in many areas.

Mixed monolayers of 1-octadecanol (C18OH) and ethylene glycol monooctadecyl ether (C18E1) were studied to assess their evaporation suppressing performance. An unexpected increase in performance and stability was found around the 0.5:0.5 bicomponent mixture and has been ascribed to a synergistic effect of the monolayers. Molecular dynamics simulations have attributed this to an additional hydrogen bonding interaction between the monolayer and water, due to the exposed ether oxygen of C18E1 in the mixed system compared to the same ether oxygen in the pure C18E1 system. This interaction is maximized around the 0.5:0.5 ratio due to the particular interfacial geometry associated with this mixture.

The early experiments on radical polymerization, which were to lead to a study of nitroxide trapping of the initiation step and the interest in defect groups, particularly the macromonomers formed by termination by disproportionation, are discussed. Results from the nitroxide trapping clearly show that the initiation step ranges from simple clean addition to the head of the monomer, to complex addition/abstraction reactions. Careful selection of the monomer/initiation system is emphasized with particular reference to two common monomers, styrene and methyl methacrylate, and two initiating radicals, t-butoxy and benzoyloxy. The discovery of nitroxide mediated polymerization (NMP) from observations made during the nitroxide trapping work is reported and the ability to have a living radical system demonstrated with numerous examples. Similarly, the study of the copolymerization of macromonomers, formed by disproportionation of the propagating chains, is discussed with the discovery of ß-scission and an early form of addition–fragmentation reported. The evolution of reversible addition–fragmentation chain transfer (RAFT) to a highly versatile and commercially attractive radical system is reported and the detailed chemistry behind the discovery of this living radical system discussed. Both NMP and RAFT enable the synthesis of structures not previously possible by radical polymerization and in some cases not possible by any other process.