Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Nikolay Khmelevsky has a total of 91 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Restraining SnO2 gas sensor response degradation through heterovalent doping

    by Alina Sagitova, Maria Markelova, Anastasiya Nikolaeva, Sergey Polomoshnov, Sergei Generalov, Nikolay Khmelevskiy, Yuriy Grigoriev, Elisaveta Konstantinova, Valeriy Krivetskiy


  • Open Access

    Distinct Roles of Additives in the Improved Sensitivity to CO of Ag- and Pd-Modified Nanosized LaFeO3

    by Valentina Chumakova, Artem Marikutsa, Vadim Platonov, Nikolay Khmelevsky, Marina Rumyantseva

    Perovskite-type mixed-metal oxides are of particular interest as semiconductor gas sensors due to the variability in the material composition and the stability of sensing parameters. LaFeO3 is a p-type semiconductor with relatively high conductivity and gas sensitivity. However, less is known about the sensitivity and sensing mechanisms of LaFeO3 modified by catalytic noble metals. In this work, we used a microwave-assisted sol–gel method to synthesize perovskite LaFeO3 nanoparticles with an average size of 20–30 nm and a specific surface area of 6–8 m2/g. LaFeO3 was modified by 2–5 wt.% Ag and Pd nanoparticles via the impregnation route. Using X-ray photoelectron spectroscopy, the additives were observed in the partially oxidized states Ag2O/Ag and PdO/Pd, respectively. Electric conduction and sensitivity to noxious gases were characterized by electrophysical measurements. It was shown that LaFeO3 modified by Ag and Pd had improved sensitivity and selectivity to CO, and the sensing behavior persisted in a wide range of relative humidity. Pristine and Ag-modified LaFeO3 had the maximum sensitivity to CO at a temperature of 200 °C, while modification with Pd resulted in a decreased optimal operating temperature of 150 °C. In situ infrared spectroscopy revealed that supported Pd nanoparticles specifically catalyzed CO oxidation at the surface of LaFeO3 at room temperature, which was the likely reason for the improved sensitivity and decreased optimal operating temperature of LaFeO3/Pd sensors. On the other hand, Ag nanoparticles were deduced to activate CO oxidation by lattice oxygen at the surface of LaFeO3, providing enhanced CO sensitivity at a higher temperature.


  • Open Access

    Sensitization of ZnO Photoconductivity in the Visible Range by Colloidal Cesium Lead Halide Nanocrystals

    by Artem Chizhov, Marina Rumyantseva, Nikolay Khmelevsky, Andrey Grunin

    In this work, colloidal perovskite nanocrystals (PNCs) are used to sensitize the photoconductivity of nanocrystalline ZnO films in the visible range. Nanocrystalline ZnO with a crystallite size of 12–16 nm was synthesized by precipitation of a zinc basic carbonate from an aqueous solution, followed by annealing at 300 °C. Perovskite oleic acid- and oleylamine-capped CsPbBr3, CsPb(Cl/Br)3 and CsPb(Br/I)3 PNCs with a size of 6–13 nm were synthesized by a hot injection method at 170 °C in 1-octadecene. Photoconductive nanocomposites were prepared by applying a hexane sol of PNCs to a thick (100 μm) polycrystalline conductive ZnO layer. The spectral dependence of the photoconductivity, the dependence of the photoconductivity on irradiation, and the relaxation of the photoconductivity of the obtained nanocomposites have been studied. Sensitization of ZnO by CsPbBr3 and CsPb(Cl/Br)3 PNCs leads to enhanced photoconductivity in the visible range, the maximum of which is observed at 460 and 500 nm, respectively; close to the absorption maximum of PNCs. Nanocomposites ZnO/CsPb(Br/I)3 turned out to be practically not photosensitive when irradiated with light in the visible range. The data obtained are discussed in terms of the position of the energy levels of ZnO and PNCs and the probable PNCs photodegradation. The structure, morphology, composition, and optical properties of the synthesized nanocrystals have also been studied by XRD, TEM, and XPS. The results can be applied to the creation of artificial neuromorphic systems in the visible optical range.


  • Open Access

    Synergistic Effect of Surface Acidity and PtOx Catalyst on the Sensitivity of Nanosized Metal–Oxide Semiconductors to Benzene

    by Artem Marikutsa, Nikolay Khmelevsky, Marina Rumyantseva

    Benzene is a potentially carcinogenic volatile organic compound (VOC) and its vapor must be strictly monitored in air. Metal–oxide semiconductors (MOS) functionalized by catalytic noble metals are promising materials for sensing VOC, but basic understanding of the relationships of materials composition and sensors behavior should be improved. In this work, the sensitivity to benzene was comparatively studied for nanocrystalline n-type MOS (ZnO, In2O3, SnO2, TiO2, and WO3) in pristine form and modified by catalytic PtOx nanoparticles. Active sites of materials were analyzed by X-ray photoelectron spectroscopy (XPS) and temperature-programmed techniques using probe molecules. The sensing mechanism was studied by in situ diffuse-reflectance infrared (DRIFT) spectroscopy. Distinct trends were observed in the sensitivity to benzene for pristine MOS and nanocomposites MOS/PtOx. The higher sensitivity of pristine SnO2, TiO2, and WO3 was observed. This was attributed to higher total concentrations of oxidation sites and acid sites favoring target molecules’ adsorption and redox conversion at the surface of MOS. The sensitivity of PtOx−modified sensors increased with the surface acidity of MOS and were superior for WO3/PtOx. It was deduced that this was due to stabilization of reduced Pt sites which catalyze deep oxidation of benzene molecules to carbonyl species.


  • Cooperative effect of PdOx and SiO2 in CO detection by SnO2-based gas sensors: Thorough operando DRIFTS analysis

    by Dayana Gulevich, Evgeny Gerasimov, Artem Marikutsa, Nikolay Khmelevsky, Marina Rumyantseva


  • Open Access

    Nanocrystalline SnO2 Functionalized with Ag(I) Organometallic Complexes as Materials for Low Temperature H2S Detection

    by Timofei Goncharov, Abulkosim Nasriddinov, Anastasia Zubenko, Sergey Tokarev, Tatyana Shatalova, Nikolay Khmelevsky, Olga Fedorova, Marina Rumyantseva

    This paper presents a comparative analysis of H2S sensor properties of nanocrystalline SnO2 modified with Ag nanoparticles (AgNPs) as reference sample or Ag organic complexes (AgL1 and AgL2). New hybrid materials based on SnO2 and Ag(I) organometallic complexes were obtained. The microstructure, compositional characteristics and thermal stability of the composites were thoroughly studied by X-ray diffraction (XRD), X-ray fluorescent spectroscopy (XRF), Raman spectroscopy, Fourier transform infrared (FTIR) spectroscopy, X-ray photoelectron spectroscopy (XPS) and Thermogravimetric analysis (TGA). Gas sensor properties to 2 ppm H2S demonstrated high sensitivity, selectivity toward other reducing gases (H2 (20 ppm), NH3 (20 ppm) and CO (20 ppm)) and good reproducibility of the composites in H2S detection at low operating temperatures. The composite materials also showed a linear detection range in the concentration range of 0.12–2.00 ppm H2S even at room temperature. It was concluded that the predominant factors influencing the sensor properties and selectivity toward H2S in low temperature region are the structure of the modifier and the chemical state of silver. Thus, in the case of SnO2/AgNPs reference sample the chemical sensitization mechanism is more possible, while for SnO2/AgL1 and SnO2/AgL2 composites the electronic sensitization mechanism contributes more in gas sensor properties. The obtained results show that composites based on nanocrystalline SnO2 and Ag(I) organic complexes can enhance the selective detection of H2S.


  • Comparison of Au-functionalized semiconductor metal oxides in sensitivity to VOC

    by Artem Marikutsa, Anna Novikova, Marina Rumyantseva, Nikolay Khmelevsky, Alexander Gaskov


  • Open Access

    Electrospun ZnO/Pd Nanofibers: CO Sensing and Humidity Effect

    by Vadim Platonov, Marina Rumyantseva, Nikolay Khmelevsky, Alexander Gaskov

    Variable air humidity affects the characteristics of semiconductor metal oxides, which complicates the reliable and reproducible determination of CO content in ambient air by resistive gas sensors. In this work, we determined the sensor properties of electrospun ZnO and ZnO/Pd nanofibers in the detection of CO in dry and humid air, and investigated the sensing mechanism. The microstructure of the samples, palladium content, and oxidation state, type, and concentration of surface groups were characterized using complementary techniques: X-ray fluorescent spectroscopy, XRD, high-resolution transmission electron microscopy (HRTEM), high angle annular dark field scanning transmission electron microscopy (HAADF-STEM), energy-dispersive X-ray (EDX) mapping, XPS, and FTIR spectroscopy. The sensor properties of ZnO and ZnO/Pd nanofibers were studied at 100–450 °C in the concentration range of 5–15 ppm CO in dry (RH25 = 0%) and humid (RH25 = 60%) air. It was found that under humid conditions, ZnO completely loses its sensitivity to CO, while ZnO/Pd retains a high sensor response. On the basis of in situ diffuse reflectance IR Fourier transform spectroscopy (DRIFTS) results, it was concluded that high sensor response of ZnO/Pd nanofibers in dry and humid air was due to the electronic sensitization effect, which was not influenced by humidity change.


  • Open Access

    Synergy Effect of Au and SiO2 Modification on SnO2 Sensor Properties in VOCs Detection in Humid Air

    by Dayana Gulevich, Marina Rumyantseva, Evgeny Gerasimov, Nikolay Khmelevsky, Elena Tsvetkova, Alexander Gaskov

    Nanocomposites based on Au- and SiO2-modified SnO2 were studied as sensitive materials for ethanol and benzene detection in dry (RH = 1%) and humid (RH = 20%) air. Modification of SnO2 by amorphous SiO2 (13 mol.%) was effectuated by hydrothermal synthesis; modification by Au nanoparticles (1 wt.%) was carried out via impregnation by citrate-stabilized Au sol. The composition of the samples was determined by X-ray fluorescent spectroscopy and energy-dispersive X-ray spectroscopy. The microstructure was characterized by XRD, HRTEM, and low-temperature nitrogen adsorption. The surface groups were investigated by XPS, TPR-H2, and FTIR spectroscopy. DRIFT spectroscopy was performed to investigate the interaction between ethanol and the surface of the synthesized materials. Studies of the sensor properties have shown that in all cases the most sensitive is the SnO2/SiO2-Au nanocomposite. This material retains high sensitivity even in a humid atmosphere. The obtained results are discussed in terms of the synergistic effect of two modifiers (Au and SiO2) in the formation of sensor properties of SnO2/SiO2–Au nanocomposites.


  • Open Access

    Organic-Inorganic Hybrid Materials for Room Temperature Light-Activated Sub-ppm NO Detection

    by Abulkosim Nasriddinov, Marina Rumyantseva, Tatyana Shatalova, Sergey Tokarev, Polina Yaltseva, Olga Fedorova, Nikolay Khmelevsky, Alexander Gaskov

    Nitric oxide (NO) is one of the main environmental pollutants and one of the biomarkers noninvasive diagnosis of respiratory diseases. Organic-inorganic hybrids based on heterocyclic Ru (II) complex and nanocrystalline semiconductor oxides SnO2 and In2O3 were studied as sensitive materials for NO detection at room temperature under periodic blue light (λmax = 470 nm) illumination. The semiconductor matrixes were obtained by chemical precipitation with subsequent thermal annealing and characterized by XRD, Raman spectroscopy, and single-point BET methods. The heterocyclic Ru (II) complex was synthesized for the first time and characterized by 1H NMR, 13C NMR, MALDI-TOF mass spectrometry and elemental analysis. The HOMO and LUMO energies of the Ru (II) complex are calculated from cyclic voltammetry data. The thermal stability of hybrids was investigated by thermogravimetric analysis (TGA)-MS analysis. The optical properties of Ru (II) complex, nanocrystalline oxides and hybrids were studied by UV-Vis spectroscopy in transmission and diffuse reflectance modes. DRIFT spectroscopy was performed to investigate the interaction between NO and the surface of the synthesized materials. Sensor measurements demonstrate that hybrid materials are able to detect NO at room temperature in the concentration range of 0.25–4.0 ppm with the detection limit of 69–88 ppb.