SBStefan Birner

Stefan Birner

*This is an algorithmically generated author record based on publicly available information.

Stefan Birner has a total of 215 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Impact of carrier injector design on the threshold of interband cascade lasers

    by Takuma Sato, Borislav Petrović, Robert Weih, Fabian Hartmann, Sven Höfling, Stefan Birner, Christian Jirauschek, Thomas Grange

    We theoretically investigate how the injector region design of interband cascade lasers (ICLs) impacts the threshold carrier and current densities. The model combines a polarization-sensitive 8-band k⋅p calculation, electrostatics, and a microscopic calculation of Auger recombination rates. The inelastic carrier–carrier scattering is included at the lowest order using quasi-equilibrium Green’s functions. Our approach captures the combined effects of charge-carrier redistribution, parasitic absorption, and bias voltage on the Auger recombination rate. We show that heavily doping the electron injector suppresses the dominant multi-hole Auger recombination by reducing the hole population of the recombination quantum wells. This agrees with the experimental observation that the heavy doping reduces threshold currents. Unlike the measurements, however, they do not increase at high doping concentrations in our model, which does not include scattering-mediated carrier escape and/or light absorption. Furthermore, by introducing indium to the conventional GaSb hole injector wells, we explain the rule of thumb from experiments that raising the hole injector levels does not outperform the doping strategy. Our model provides physical insights for optimizing ICL carrier injectors.


  • 5.0 μm emitting interband cascade lasers with superlattice and bulk AlGaAsSb claddings

    by B. Petrović, A. Bader, J. Nauschütz, T. Sato, S. Birner, R. Weih, F. Hartmann, S. Höfling

    We present a comparison between interband cascade lasers (ICLs) with a six-stage active region emitting at 5 μm with AlSb/InAs superlattice claddings and with bulk Al0.85Ga0.15As0.07Sb0.93 claddings. Utilizing bulk AlGaAsSb claddings with their lower refractive index compared to the more commonly used AlSb/InAs superlattice claddings, the mode-confinement in the active region increases by 14.4% resulting in an improvement of the lasing threshold current density. For broad area laser and under pulsed excitation, the ICL with AlGaAsSb claddings shows a lower threshold current density of Jth=396A/cm2 compared to Jth=521A/cm2 of the ICL with superlattice claddings. Additionally, a higher characteristic temperature was obtained for the ICL with bulk claddings. Emission in pulsed operation is observed up to 65 °C.


  • Optimization of UV LED design using evolutionary algorithms

    by L. Leguay, H. Mączko, A. Schliwa, S. Birner

    We present a computational approach combining evolutionary algorithms with calculation software nextnano++ to optimize the design of a nitride-based ultraviolet light-emitting diode (UV LED). Our findings reveal a significant improvement of the theoretical internal quantum efficiency of the nanostructure at the target wavelength 300 nm.

  • Open Access

    Unveiling the charge distribution of a GaAs-based nanoelectronic device: A large experimental dataset approach

    by Eleni Chatzikyriakou, Junliang Wang, Lucas Mazzella, Antonio Lacerda-Santos, Maria Cecilia da Silva Figueira, Alex Trellakis, Stefan Birner, Thomas Grange, Christopher Bäuerle, Xavier Waintal

    In quantum nanoelectronics, numerical simulations have become a ubiquitous tool. Yet the comparison with experiments is often done at a qualitative level or restricted to a single device with a handful of fitting parameters. In this work, we assess the predictive power of these simulations by comparing the results of a single model with a large experimental dataset of 110 devices with 48 different geometries. The devices are quantum point contacts of various shapes and sizes made with electrostatic gates deposited on top of a high mobility GaAs/AlGaAs two-dimensional electron gas. We study the pinch-off voltages applied on the gates to deplete the two-dimensional electron gas in various spatial positions. We argue that the pinch-off voltages are a very robust signature of the charge distribution in the device. The large experimental dataset allows us to critically review the modeling and arrive at a robust one-parameter model that can be calibrated in situ, a crucial step for making predictive simulations.


  • Increasing the output power of a heavily doped terahertz quantum cascade laser by avoiding the subband misalignment

    by Tsung-Tse Lin, Li Wang, Ke Wang, Thomas Grange, Stefan Birner, Teppei Miyoshi, Hideki Hirayama

    A significant enhancement in the output power of a GaAs-based terahertz quantum cascade laser (THz QCL) was achieved by implementing a relatively high impurity doping concentration. The QC structure was precisely designed using the nonequilibrium green function method by considering the band bending effect caused by a higher doping concentration. This enabled us to avoid the subband misalignment induced by the strong band bending effect, to provide efficient carrier transport even at high doping concentrations, and to improve the output power. The maximum output power of a GaAs/Al0.16Ga0.84As 3.5 THz-band QCL at 10 K was enhanced from 390 to 600 mW by increasing the doping concentration at the depopulation layers from 6 × 1016 to 1.2 × 1017 cm−3. The average power of 21 mW was achieved by implementing the appropriate pulse drive conditions.


  • Open Access

    Semiconductor-based electron flying qubits: review on recent progress accelerated by numerical modelling

    by Hermann Edlbauer, Junliang Wang, Thierry Crozes, Pierre Perrier, Seddik Ouacel, Clément Geffroy, Giorgos Georgiou, Eleni Chatzikyriakou, Antonio Lacerda-Santos, Xavier Waintal, et al.

    The progress of charge manipulation in semiconductor-based nanoscale devices opened up a novel route to realise a flying qubit with a single electron. In the present review, we introduce the concept of these electron flying qubits, discuss their most promising realisations and show how numerical simulations are applicable to accelerate experimental development cycles. Addressing the technological challenges of flying qubits that are currently faced by academia and quantum enterprises, we underline the relevance of interdisciplinary cooperation to move emerging quantum industry forward. The review consists of two main sections:Pathways towards the electron flying qubit:We address three routes of single-electron transport in GaAs-based devices focusing on surface acoustic waves, hot-electron emission from quantum dot pumps and Levitons. For each approach, we discuss latest experimental results and point out how numerical simulations facilitate engineering the electron flying qubit.Numerical modelling of quantum devices:We review the full stack of numerical simulations needed for fabrication of the flying qubits. Choosing appropriate models, examples of basic quantum mechanical simulations are explained in detail. We discuss applications of open-source (KWANT) and the commercial (nextnano) platforms for modelling the flying qubits. The discussion points out the large relevance of software tools to design quantum devices tailored for efficient operation.


  • Open Access

    THz intersubband electroluminescence from n-type Ge/SiGe quantum cascade structures

    by David Stark, Muhammad Mirza, Luca Persichetti, Michele Montanari, Sergej Markmann, Mattias Beck, Thomas Grange, Stefan Birner, Michele Virgilio, Chiara Ciano, et al.

    We report electroluminescence originating from L-valley transitions in n-type Ge/Si0.15Ge0.85 quantum cascade structures centered at 3.4 and 4.9 THz with a line broadening of Δ f / f ≈ 0.2 . Three strain-compensated heterostructures, grown on a Si substrate by ultrahigh vacuum chemical vapor deposition, have been investigated. The design is based on a single quantum well active region employing a vertical optical transition, and the observed spectral features are well described by non-equilibrium Green's function calculations. The presence of two peaks highlights a suboptimal injection in the upper state of the radiative transition. Comparison of the electroluminescence spectra with a similar GaAs/AlGaAs structure yields one order of magnitude lower emission efficiency.


  • Atomic-Scale Insights into Semiconductor Heterostructures: From Experimental Three-Dimensional Analysis of the Interface to a Generalized Theory of Interfacial Roughness Scattering

    by T. Grange, S. Mukherjee, G. Capellini, M. Montanari, L. Persichetti, L. Di Gaspare, S. Birner, A. Attiaoui, O. Moutanabbir, M. Virgilio, et al.

    In this manuscript, we develop a generalized theory for the scattering process produced by interface roughness on charge carriers that is suitable for any semiconductor heterostructure. By exploiting our experimental insights into the three-dimensional atomic landscape of Ge/Ge−Si heterointerfaces obtained by atom probe tomography, we are able to define the full set of interface parameters relevant to the scattering potential, including both the in-plane and axial correlation inside real diffuse interfaces. Our experimental findings indicate a partial coherence of the interface roughness along the growth direction within the interfaces. We show that it is necessary to include this feature, previously neglected by theoretical models, when heterointerfaces characterized by finite interface widths are taken into consideration. To show the relevance of our generalized scattering model in the physics of semiconductor devices, we implement it in a nonequilibrium Green’s function simulation platform to assess the performance of a Ge/Si−Ge-based terahertz quantum cascade laser.


  • Composition analysis and transition energies of ultrathin Sn-rich GeSn quantum wells

    by Inga A. Fischer, Caterina J. Clausen, Daniel Schwarz, Peter Zaumseil, Giovanni Capellini, Michele Virgilio, Maria Cecilia da Silva Figueira, Stefan Birner, Sebastian Koelling, Paul M. Koenraad, et al.

    While GeSn alloys with high Sn content constitute direct group-IV semiconductors, their growth on Si remains challenging. The deposition of a few monolayers of pure Sn on Ge and their overgrowth with Ge using molecular beam epitaxy can be a means of obtaining Sn-rich quantum wells with very high Sn content while maintaining high crystal quality. Here, we provide structural and compositional information on such structures with very high accuracy. Based on our characterization results we theoretically predict transition energies and compare them with experimental results from photoluminescence measurements. Our results constitute the groundwork for tuning the molecular beam epitaxy based growth of Sn-rich quantum wells and dots for applications in electronic and optoelectronic devices.


  • Open Access

    Short-period scattering-assisted terahertz quantum cascade lasers operating at high temperatures

    by Li Wang, Tsung-Tse Lin, Ke Wang, Thomas Grange, Stefan Birner, Hideki Hirayama

    Operating at high temperatures in the range of thermoelectric coolers is essential for terahertz quantum cascade lasers to real applications. The use of scattering-assisted injection scheme enables an increase in operating temperature. This concept, however, has not been implemented in a short-period structure consisting of two quantum wells. In this work, based on non-equilibrium Green’s function calculations, it emphasizes on the current leakage and parasitic absorption via high-energy states as fundamental limitations in this scheme with short-period. A new design concept employing asymmetric wells composition is proposed to suppress these limitations. A peak gain of 40 cm−1 at 230 K is predicted in the GaAs/AlGaAs semiconductor material system with an emission frequency of 3.5 THz.