Kirsten van Zuilen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Kirsten van Zuilen has a total of 49 co-authors. Here are the top co-authors by number of shared publications:
- Thomas F. Nägler
Institute of Geological Sciences, University of Bern, Bern, Switzerland
4 shared publications Alan J. Slade
NIBR/Translational Medicine
2 shared publicationsDaniel Kaufmann
Chemical and Analytical Development
2 shared publicationsDietmar G. Schmid
Drug Metabolism & Pharmacokinetics (DMPK)/Integrated Drug Disposition (IDD)
2 shared publications- Friedhelm von Blanckenburg
GFZ German Research Centre for Geosciences Section Earth Surface Geochemistry Potsdam Germany
2 shared publications Frédéric Moynier
Institut de Physique du Globe de Paris, Université Paris Diderot, Université Sorbonne Paris Cité, CNRS UMR 7154, 75238 Paris Cedex 05, France
2 shared publications
Latest Publications
- 28 June 2023
- Published by Elsevier in Earth and Planetary Science Letters
- Vol. 618
Barium isotope (re-)equilibration in the barite-fluid system and its implications for marine barite archives
- 28 June 2023
- Published by Elsevier in Earth and Planetary Science Letters
- Vol. 618
Barium isotope (re-)equilibration in the barite-fluid system and its implications for marine barite archives
- 1 December 2021
- Published by Royal Society of Chemistry (RSC) in Journal of Analytical Atomic Spectrometry
- Vol. 37 (1) , 148-156
“Non-invasive” portable laser ablation sampling for lead isotope analysis of archaeological silver: a comparison with bulk and in situ laser ablation techniques
The main factor restricting lead isotope analysis of metals from museum collections is the requirement for physical material. Hence, there are major incentives for developing minimally invasive methods for lead isotope analysis that are accurate and precise enough to reveal historical information about artefacts and their origin. Portable laser ablation (pLA), collecting microscopic samples on Teflon filters, has four key benefits. It produces no visual impact to the artefacts, does not require transport of artefacts to laboratory facilities, there are no artefact size restrictions, and samples are processed under clean laboratory conditions allowing Pb purification prior to measurement by solution MC-ICPMS. To validate the efficacy of the pLA technique on silver, nine matrixed-matched commercial, in-house and archaeological reference materials were sampled and analysed multiple times (9–10). The pLA mean analyses (±2SD) were all consistent with inter-laboratory bulk analyses. The digestion of sample filters produces precisions that are consistently more than five-times better than in situ nsLA-MC-ICPMS and are the same order of magnitude expected for bulk samples processed in different laboratories.
- 1 December 2021
- Published by Royal Society of Chemistry (RSC) in Journal of Analytical Atomic Spectrometry
- Vol. 37 (1) , 148-156
“Non-invasive” portable laser ablation sampling for lead isotope analysis of archaeological silver: a comparison with bulk and in situ laser ablation techniques
The main factor restricting lead isotope analysis of metals from museum collections is the requirement for physical material. Hence, there are major incentives for developing minimally invasive methods for lead isotope analysis that are accurate and precise enough to reveal historical information about artefacts and their origin. Portable laser ablation (pLA), collecting microscopic samples on Teflon filters, has four key benefits. It produces no visual impact to the artefacts, does not require transport of artefacts to laboratory facilities, there are no artefact size restrictions, and samples are processed under clean laboratory conditions allowing Pb purification prior to measurement by solution MC-ICPMS. To validate the efficacy of the pLA technique on silver, nine matrixed-matched commercial, in-house and archaeological reference materials were sampled and analysed multiple times (9–10). The pLA mean analyses (±2SD) were all consistent with inter-laboratory bulk analyses. The digestion of sample filters produces precisions that are consistently more than five-times better than in situ nsLA-MC-ICPMS and are the same order of magnitude expected for bulk samples processed in different laboratories.
- Open Access
- 8 October 2020
- Published by Copernicus GmbH
Equilibration time of Fe & Zn concentrations and isotopes in metal-silicate partitioning experiments
- 8 October 2020
- Published by Copernicus GmbH
Open AccessEquilibration time of Fe & Zn concentrations and isotopes in metal-silicate partitioning experiments
- 1 January 2020
- Published by Elsevier in Geochimica et Cosmochimica Acta
- Vol. 269, 566-580
Experimental and theoretical modelling of kinetic and equilibrium Ba isotope fractionation during calcite and aragonite precipitation
- 1 January 2020
- Published by Elsevier in Geochimica et Cosmochimica Acta
- Vol. 269, 566-580
Experimental and theoretical modelling of kinetic and equilibrium Ba isotope fractionation during calcite and aragonite precipitation
- Open Access
- 8 October 2018
- Published by National Academy of Sciences in Proceedings of the National Academy of Sciences
- Vol. 115 (43) , 10920-10925
Volatile loss following cooling and accretion of the Moon revealed by chromium isotopes
Terrestrial and lunar rocks share chemical and isotopic similarities in refractory elements, suggestive of a common precursor. By contrast, the marked depletion of volatile elements in lunar rocks together with their enrichment in heavy isotopes compared with Earth’s mantle suggests that the Moon underwent evaporative loss of volatiles. However, whether equilibrium prevailed during evaporation and, if so, at what conditions (temperature, pressure, and oxygen fugacity) remain unconstrained. Chromium may shed light on this question, as it has several thermodynamically stable, oxidized gas species that can distinguish between kinetic and equilibrium regimes. Here, we present high-precision Cr isotope measurements in terrestrial and lunar rocks that reveal an enrichment in the lighter isotopes of Cr in the Moon compared with Earth’s mantle by 100 ± 40 ppm per atomic mass unit. This observation is consistent with Cr partitioning into an oxygen-rich vapor phase in equilibrium with the proto-Moon, thereby stabilizing the CrO2 species that is isotopically heavy compared with CrO in a lunar melt. Temperatures of 1,600–1,800 K and oxygen fugacities near the fayalite–magnetite–quartz buffer are required to explain the elemental and isotopic difference of Cr between Earth’s mantle and the Moon. These temperatures are far lower than modeled in the aftermath of a giant impact, implying that volatile loss did not occur contemporaneously with impact but following cooling and accretion of the Moon. Significance With the exception of volatile elements, which are strongly depleted and isotopically fractionated, the Moon has chemical and isotopic signatures that are indistinguishable from Earth’s mantle. Reconciliation of these properties with Moon formation in a high-energy giant impact invokes evaporative loss of volatile elements, but at conditions that are poorly known. Chromium isotopic fractionation is sensitive to temperature variations and liquid–gas equilibration during evaporation. We measure an isotopic difference between Earth’s mantle and the Moon, consistent with the loss of a Cr-bearing, oxidized vapor phase in equilibrium with the proto-Moon. Temperatures of vapor loss required are much lower than predicted by recent models, implying that volatile elements were removed from the Moon following cooling rather than during a giant impact.
- 8 October 2018
- Published by National Academy of Sciences in Proceedings of the National Academy of Sciences
- Vol. 115 (43) , 10920-10925
Open AccessVolatile loss following cooling and accretion of the Moon revealed by chromium isotopes
Terrestrial and lunar rocks share chemical and isotopic similarities in refractory elements, suggestive of a common precursor. By contrast, the marked depletion of volatile elements in lunar rocks together with their enrichment in heavy isotopes compared with Earth’s mantle suggests that the Moon underwent evaporative loss of volatiles. However, whether equilibrium prevailed during evaporation and, if so, at what conditions (temperature, pressure, and oxygen fugacity) remain unconstrained. Chromium may shed light on this question, as it has several thermodynamically stable, oxidized gas species that can distinguish between kinetic and equilibrium regimes. Here, we present high-precision Cr isotope measurements in terrestrial and lunar rocks that reveal an enrichment in the lighter isotopes of Cr in the Moon compared with Earth’s mantle by 100 ± 40 ppm per atomic mass unit. This observation is consistent with Cr partitioning into an oxygen-rich vapor phase in equilibrium with the proto-Moon, thereby stabilizing the CrO2 species that is isotopically heavy compared with CrO in a lunar melt. Temperatures of 1,600–1,800 K and oxygen fugacities near the fayalite–magnetite–quartz buffer are required to explain the elemental and isotopic difference of Cr between Earth’s mantle and the Moon. These temperatures are far lower than modeled in the aftermath of a giant impact, implying that volatile loss did not occur contemporaneously with impact but following cooling and accretion of the Moon. Significance With the exception of volatile elements, which are strongly depleted and isotopically fractionated, the Moon has chemical and isotopic signatures that are indistinguishable from Earth’s mantle. Reconciliation of these properties with Moon formation in a high-energy giant impact invokes evaporative loss of volatile elements, but at conditions that are poorly known. Chromium isotopic fractionation is sensitive to temperature variations and liquid–gas equilibration during evaporation. We measure an isotopic difference between Earth’s mantle and the Moon, consistent with the loss of a Cr-bearing, oxidized vapor phase in equilibrium with the proto-Moon. Temperatures of vapor loss required are much lower than predicted by recent models, implying that volatile elements were removed from the Moon following cooling rather than during a giant impact.
- 1 October 2018
- Published by Elsevier in Geochimica et Cosmochimica Acta
- Vol. 239, 409-419
Lack of resolvable titanium stable isotopic variations in bulk chondrites
- 1 October 2018
- Published by Elsevier in Geochimica et Cosmochimica Acta
- Vol. 239, 409-419
Lack of resolvable titanium stable isotopic variations in bulk chondrites
- 1 December 2016
- Published by Elsevier in Chemical Geology
- Vol. 443, 111-120
Constraints on the sedimentary input into the Loki's Castle hydrothermal system (AMOR) from B isotope data
- 1 December 2016
- Published by Elsevier in Chemical Geology
- Vol. 443, 111-120
Constraints on the sedimentary input into the Loki's Castle hydrothermal system (AMOR) from B isotope data
- 1 October 2016
- Published by Elsevier in Geochimica et Cosmochimica Acta
- Vol. 190, 72-84
Barium isotope fractionation during witherite (BaCO3) dissolution, precipitation and at equilibrium
- 1 October 2016
- Published by Elsevier in Geochimica et Cosmochimica Acta
- Vol. 190, 72-84
Barium isotope fractionation during witherite (BaCO3) dissolution, precipitation and at equilibrium
- 1 August 2016
- Published by Elsevier in Geochimica et Cosmochimica Acta
- Vol. 186, 226-241
Experimental determination of barium isotope fractionation during diffusion and adsorption processes at low temperatures
- 1 August 2016
- Published by Elsevier in Geochimica et Cosmochimica Acta
- Vol. 186, 226-241
Experimental determination of barium isotope fractionation during diffusion and adsorption processes at low temperatures
- 29 June 2016
- Published by Wiley in Geostandards and Geoanalytical Research
- Vol. 40 (4) , 543-558
Barium Isotopic Compositions of Geological Reference Materials
The interest in variations of barium (Ba) stable isotope amount ratios in low and high temperature environments has increased over the past several years. Characterisation of Ba isotope ratios of widely available reference materials is now required to validate analytical procedures and to allow comparison of data obtained by different laboratories. We present new Ba isotope amount ratio data for twelve geological reference materials with silicate (AGV‐1, G‐2, BHVO‐1, QLO‐1, BIR‐1, JG‐1a, JB‐1a, JR‐1 and JA‐1), carbonate (IAEA‐CO‐9) and sulfate matrices (IAEA‐SO‐5 and IAEA‐SO‐6) relative to NIST SRM 3104a. In addition, two artificially fractionated in‐house reference materials BaBe12 and BaBe27 (δ137/134Ba = −1.161 ± 0.049‰ and −0.616 ± 0.050‰, respectively) are used as quality control solutions for the negative δ‐range. Accuracy of our data was assessed by interlaboratory comparison between the University of Bern and the United States Geological Survey (USGS). Data were measured by MC‐ICP‐MS (Bern) and TIMS (USGS) using two different double spikes for mass bias correction (130Ba–135Ba and 132Ba–136Ba, respectively). MC‐ICP‐MS measurements were further tested for isobaric and non‐spectral matrix effects by a number of common matrix elements. The results are in excellent agreement and suggest data accuracy.
- 29 June 2016
- Published by Wiley in Geostandards and Geoanalytical Research
- Vol. 40 (4) , 543-558
Barium Isotopic Compositions of Geological Reference Materials
The interest in variations of barium (Ba) stable isotope amount ratios in low and high temperature environments has increased over the past several years. Characterisation of Ba isotope ratios of widely available reference materials is now required to validate analytical procedures and to allow comparison of data obtained by different laboratories. We present new Ba isotope amount ratio data for twelve geological reference materials with silicate (AGV‐1, G‐2, BHVO‐1, QLO‐1, BIR‐1, JG‐1a, JB‐1a, JR‐1 and JA‐1), carbonate (IAEA‐CO‐9) and sulfate matrices (IAEA‐SO‐5 and IAEA‐SO‐6) relative to NIST SRM 3104a. In addition, two artificially fractionated in‐house reference materials BaBe12 and BaBe27 (δ137/134Ba = −1.161 ± 0.049‰ and −0.616 ± 0.050‰, respectively) are used as quality control solutions for the negative δ‐range. Accuracy of our data was assessed by interlaboratory comparison between the University of Bern and the United States Geological Survey (USGS). Data were measured by MC‐ICP‐MS (Bern) and TIMS (USGS) using two different double spikes for mass bias correction (130Ba–135Ba and 132Ba–136Ba, respectively). MC‐ICP‐MS measurements were further tested for isobaric and non‐spectral matrix effects by a number of common matrix elements. The results are in excellent agreement and suggest data accuracy.