Haiming Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Haiming Zhang has a total of 88 co-authors. Here are the top co-authors by number of shared publications:
Sinan Liu
School of Physical Science and Technology, Tiangong University, Tianjin, People’s Republic of China
4 shared publicationsYujie Li
School of Physical Science and Technology, Tiangong University, Tianjin, China
4 shared publicationsChanghong Zhou
School of Physical Science and Technology, Tiangong University, Tianjin, People’s Republic of China
3 shared publicationsGuofeng Hu
Tianjin Polytechnic University
3 shared publicationsLijuan Wei
School of Material Science and Engineering, Tianjin Polytechnic University, Tianjin, China
3 shared publicationsQingchen He
School of physical science and technology, Tiangong University, Tianjin 300387, China
3 shared publications
Latest Publications
- 24 September 2026
- Published by Optica Publishing Group in Optics Letters
- Vol. 51 (19) , 5458-5461
Bipolar photoresponse in a BaTiO 3 /ZnO heterojunction photodetector for precise light-wavelength discrimination
Bipolar photoresponse photodetectors enable spectral discrimination and optical logic, but conventional devices often suffer from poor stability and complex fabrication. Here, we report a fully solid-state, chip-scale BaTiO 3 /ZnO heterojunction photodetector with a simple structure, compact size, and precise wavelength discrimination. Under self-powered operation, it selectively detects 330 nm and 395 nm light with positive and negative photocurrents, showing responsivities of 6.7 and −26.1 mA/W, respectively. Fast response and narrow wavelength selectivity (∼67 nm) are achieved via optimized pyroelectric current regulation. The interplay between the photovoltaic effect in the heterojunction and the polarization of the BaTiO 3 is investigated. Finally, a 5 × 5 BaTiO 3 /ZnO array was further demonstrated for encrypted imaging. This work presents a compact, high-performance platform for precise light-wavelength discrimination, optical logic, and secure optical communication.
- 24 September 2026
- Published by Optica Publishing Group in Optics Letters
- Vol. 51 (19) , 5458-5461
Bipolar photoresponse in a BaTiO 3 /ZnO heterojunction photodetector for precise light-wavelength discrimination
Bipolar photoresponse photodetectors enable spectral discrimination and optical logic, but conventional devices often suffer from poor stability and complex fabrication. Here, we report a fully solid-state, chip-scale BaTiO 3 /ZnO heterojunction photodetector with a simple structure, compact size, and precise wavelength discrimination. Under self-powered operation, it selectively detects 330 nm and 395 nm light with positive and negative photocurrents, showing responsivities of 6.7 and −26.1 mA/W, respectively. Fast response and narrow wavelength selectivity (∼67 nm) are achieved via optimized pyroelectric current regulation. The interplay between the photovoltaic effect in the heterojunction and the polarization of the BaTiO 3 is investigated. Finally, a 5 × 5 BaTiO 3 /ZnO array was further demonstrated for encrypted imaging. This work presents a compact, high-performance platform for precise light-wavelength discrimination, optical logic, and secure optical communication.
- 31 August 2026
- Published by Springer Nature in Journal of Materials Science
- Vol. 61 (40) , 30651-30664
Synthesis of Ni-doped MoO3 nanohollow spheres and investigation of gas-sensing performance to acetone
- 31 August 2026
- Published by Springer Nature in Journal of Materials Science
- Vol. 61 (40) , 30651-30664
Synthesis of Ni-doped MoO3 nanohollow spheres and investigation of gas-sensing performance to acetone
- 19 March 2025
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 10 (3) , 2090-2099
Fully Inorganic Metal Halide Perovskite CsGeBr3 Photoferroelectrics for Room-Temperature Photovoltaic Self-Powered Ammonia Detection
Chemiresistive sensing technology plays a significant role in the field of gas monitoring. However, conventional metal oxide gas monitoring devices typically require high operating temperatures and external power supplies to power them. In this paper, we have exploited the property that the photoferroelectric material CsGeBr3 can provide a stable output source through a self-polarization field under light illumination to achieve a good self-powered gas sensing response to NH3 at room temperature, including extremely fast response/recovery time (30 s/40 s), and low concentration sensing (response value of 2.02 at 50 ppm of NH3). This demonstrates significant advantages and a wider range of application scenarios than those of conventional metal oxide gas sensors that require an external power supply. Fourier transform infrared (FTIR) spectroscopic measurements confirmed the high selectivity of CsGeBr3 for NH3, which to our knowledge is the first time that Ge-based all-inorganic photoferroelectric materials of perovskite have been applied to the field of self-powered gas sensing, and the present work provides a new material and direction in the study of self-powered gas sensors.
- 19 March 2025
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 10 (3) , 2090-2099
Fully Inorganic Metal Halide Perovskite CsGeBr3 Photoferroelectrics for Room-Temperature Photovoltaic Self-Powered Ammonia Detection
Chemiresistive sensing technology plays a significant role in the field of gas monitoring. However, conventional metal oxide gas monitoring devices typically require high operating temperatures and external power supplies to power them. In this paper, we have exploited the property that the photoferroelectric material CsGeBr3 can provide a stable output source through a self-polarization field under light illumination to achieve a good self-powered gas sensing response to NH3 at room temperature, including extremely fast response/recovery time (30 s/40 s), and low concentration sensing (response value of 2.02 at 50 ppm of NH3). This demonstrates significant advantages and a wider range of application scenarios than those of conventional metal oxide gas sensors that require an external power supply. Fourier transform infrared (FTIR) spectroscopic measurements confirmed the high selectivity of CsGeBr3 for NH3, which to our knowledge is the first time that Ge-based all-inorganic photoferroelectric materials of perovskite have been applied to the field of self-powered gas sensing, and the present work provides a new material and direction in the study of self-powered gas sensors.
- 10 September 2024
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 9 (9) , 4777-4787
Magnetic Field Assisted Enhanced Sensitivity of Nonferromagnetic Materials Boosting the Carrier Transfer: Mechanistic Studies
The performance of semiconductor sensors is determined by reaction kinetics, conductivity, and electron mobility, which are undoubtedly closely related to the electron motion behavior. Therefore, the effective regulation of electronic states is crucial for improving gas sensing properties. Previous methods of enhancing the gas-sensing performance have induced complex material modifications, and the extent of performance improvement is usually very limited. Further optimization of the gas sensing performance requires continuous efforts to advance new technologies. Toward this issue, a novel magnetic field-induced strategy is adopted to boost the carrier transfer efficiency of nonferromagnetic semiconductors. The gas sensing investigation results manifest that the applied magnetic field can effectively enhance the sensitivity and reduce the baseline resistance. The In2O3 NC-2 (In2O3 nanocubes) with an applied magnetic field have a greatly enhanced response of 161.4 toward 100 ppm formaldehyde, which is 2.5 times higher than that without magnetic field. The enhanced gas sensing properties can be mainly attributed to magnetization of reactive materials, which makes the orientation of electronic magnetic moments consistent, thus greatly contributing to reactivity. This work introduces a practical approach to effectively improve gas sensing performance without further morphology optimization, noble metal catalysis, structural modification, and material cladding. The results of this study provide new insights for designing novel gas sensors to improve the gas sensing performance.
- 10 September 2024
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 9 (9) , 4777-4787
Magnetic Field Assisted Enhanced Sensitivity of Nonferromagnetic Materials Boosting the Carrier Transfer: Mechanistic Studies
The performance of semiconductor sensors is determined by reaction kinetics, conductivity, and electron mobility, which are undoubtedly closely related to the electron motion behavior. Therefore, the effective regulation of electronic states is crucial for improving gas sensing properties. Previous methods of enhancing the gas-sensing performance have induced complex material modifications, and the extent of performance improvement is usually very limited. Further optimization of the gas sensing performance requires continuous efforts to advance new technologies. Toward this issue, a novel magnetic field-induced strategy is adopted to boost the carrier transfer efficiency of nonferromagnetic semiconductors. The gas sensing investigation results manifest that the applied magnetic field can effectively enhance the sensitivity and reduce the baseline resistance. The In2O3 NC-2 (In2O3 nanocubes) with an applied magnetic field have a greatly enhanced response of 161.4 toward 100 ppm formaldehyde, which is 2.5 times higher than that without magnetic field. The enhanced gas sensing properties can be mainly attributed to magnetization of reactive materials, which makes the orientation of electronic magnetic moments consistent, thus greatly contributing to reactivity. This work introduces a practical approach to effectively improve gas sensing performance without further morphology optimization, noble metal catalysis, structural modification, and material cladding. The results of this study provide new insights for designing novel gas sensors to improve the gas sensing performance.
- 7 December 2023
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 6 (24) , 23313-23323
Cs2AgBiBr6 Quantum Dots Supported on Co3O4 Nanocages for Acetone Detection at Room Temperature
- 7 December 2023
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 6 (24) , 23313-23323
Cs2AgBiBr6 Quantum Dots Supported on Co3O4 Nanocages for Acetone Detection at Room Temperature
- 8 August 2023
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 37 (16) , 12345-12352
CsPbIBr2 Quantum Dots as an Interface Layer to Modify Perovskite CsPbIBr2 Films to Improve the Function of Solar Cells
- 8 August 2023
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 37 (16) , 12345-12352
CsPbIBr2 Quantum Dots as an Interface Layer to Modify Perovskite CsPbIBr2 Films to Improve the Function of Solar Cells
- 20 July 2023
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 34 (20) , 1-13
Surfactant modified hexagonal ZnO gas sensor for acetic acid
- 20 July 2023
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 34 (20) , 1-13
Surfactant modified hexagonal ZnO gas sensor for acetic acid
- 14 November 2022
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 5 (11) , 16544-16552
Controlling the Crystal Phase Structure of WO3 Nanosheet-Based Hierarchical Spheres for Enhanced Gas Sensing Performance
- 14 November 2022
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 5 (11) , 16544-16552
Controlling the Crystal Phase Structure of WO3 Nanosheet-Based Hierarchical Spheres for Enhanced Gas Sensing Performance
- 25 October 2022
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 36 (21) , 13179-13186
LiF-Modified SnO2 Electron Transport Layer Improves the Performance of Carbon-Based All-Inorganic CsPbIBr2 Perovskite Solar Cells
- 25 October 2022
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 36 (21) , 13179-13186
LiF-Modified SnO2 Electron Transport Layer Improves the Performance of Carbon-Based All-Inorganic CsPbIBr2 Perovskite Solar Cells
- 20 April 2021
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 45 (20) , 9243-9250
Cadmium doping for improving the efficiency and stability of carbon-based CsPbIBr2 all-inorganic perovskite solar cells
Cadmium ions are doped into perovskite lattice for enhancing the efficiency and stability of carbon-based CsPbIBr2 all-inorganic perovskite solar cells.
- 20 April 2021
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 45 (20) , 9243-9250
Cadmium doping for improving the efficiency and stability of carbon-based CsPbIBr2 all-inorganic perovskite solar cells
Cadmium ions are doped into perovskite lattice for enhancing the efficiency and stability of carbon-based CsPbIBr2 all-inorganic perovskite solar cells.