Jianlan Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jianlan Li has a total of 57 co-authors. Here are the top co-authors by number of shared publications:
Luyi Lu
8 shared publicationsGuoqiang Hu
4 shared publications- Luyi Lu
School of Energy and Power Engineering, Huazhong University of Science and Technology, 1037 Luoyu Road, Wuhan 430074, China
3 shared publications - Qing Yang
State Key Laboratory of Coal Combustion, Huazhong University of Science and Technology, Wuhan, China
3 shared publications Xiaodong Zhao
School of Energy and Power Engineering, Huazhong University of Science and Technology, Wuhan 430074, China
3 shared publicationsYingxuan Zhang
3 shared publications
Latest Publications
- 30 April 2026
- Published by Elsevier in Energy Conversion and Management
- Vol. 359
Effect of hotspots on the lifetime of photovoltaic modules
- 30 April 2026
- Published by Elsevier in Energy Conversion and Management
- Vol. 359
Effect of hotspots on the lifetime of photovoltaic modules
- 13 April 2026
- Published by Elsevier in Solar Energy
- Vol. 312
Seawater-induced deposition and corrosion of PV glass and their impacts on module performance
- 13 April 2026
- Published by Elsevier in Solar Energy
- Vol. 312
Seawater-induced deposition and corrosion of PV glass and their impacts on module performance
- 1 August 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (8)
Mechanisms of dust agglomeration and self-cleaning on a superhydrophobic surface during condensation
Dust accumulation on a photovoltaic (PV) surface hinders sunlight transmission, reduces photoelectric efficiency, and poses security risks. Although condensation affects dust agglomeration, self-cleaning superhydrophobic surfaces can effectively remove dust accumulated on a PV surface. However, the mechanism of agglomeration and adhesion of dust particles on the superhydrophobic surface remains unclear. The mechanism of particles carried by jumping droplets on a superhydrophobic surface has not been well understood. Therefore, we performed dust particle agglomeration and self-cleaning experiments on a superhydrophobic surface during condensation. The agglomeration process of dust particles on the superhydrophobic surface was observed using a three-dimensional microscope. We analyzed the causes that facilitate dust removal by droplets jumping away from the superhydrophobic surface. The particle agglomeration process primarily entailed four processes: coalescence of two droplets, coalescence of partially wetted particles and droplets, agglomeration of partially wetted particles, and coalescence of droplets wrapped with multiparticles. We analyzed the mechanisms of condensation-induced droplet jumping and particle agglomeration on the superhydrophobic surface. Droplets jumping away from a superhydrophobic surface can induce the formation of stacked spherical agglomerates. These agglomerates exhibited reduced contact areas and adhesion forces between the agglomerates and superhydrophobic surfaces, which facilitated the removal of dust particles from the surface. The smaller the particles, the better the dust cleaning effectiveness of the droplet jumping phenomenon. In addition, outdoor self-cleaning and wind cleaning simulation experiments were performed to confirm the self-cleaning effect of superhydrophobic surfaces. The obtained results provide a theoretical guidance for the optimal design of self-cleaning surfaces.
- 1 August 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (8)
Mechanisms of dust agglomeration and self-cleaning on a superhydrophobic surface during condensation
Dust accumulation on a photovoltaic (PV) surface hinders sunlight transmission, reduces photoelectric efficiency, and poses security risks. Although condensation affects dust agglomeration, self-cleaning superhydrophobic surfaces can effectively remove dust accumulated on a PV surface. However, the mechanism of agglomeration and adhesion of dust particles on the superhydrophobic surface remains unclear. The mechanism of particles carried by jumping droplets on a superhydrophobic surface has not been well understood. Therefore, we performed dust particle agglomeration and self-cleaning experiments on a superhydrophobic surface during condensation. The agglomeration process of dust particles on the superhydrophobic surface was observed using a three-dimensional microscope. We analyzed the causes that facilitate dust removal by droplets jumping away from the superhydrophobic surface. The particle agglomeration process primarily entailed four processes: coalescence of two droplets, coalescence of partially wetted particles and droplets, agglomeration of partially wetted particles, and coalescence of droplets wrapped with multiparticles. We analyzed the mechanisms of condensation-induced droplet jumping and particle agglomeration on the superhydrophobic surface. Droplets jumping away from a superhydrophobic surface can induce the formation of stacked spherical agglomerates. These agglomerates exhibited reduced contact areas and adhesion forces between the agglomerates and superhydrophobic surfaces, which facilitated the removal of dust particles from the surface. The smaller the particles, the better the dust cleaning effectiveness of the droplet jumping phenomenon. In addition, outdoor self-cleaning and wind cleaning simulation experiments were performed to confirm the self-cleaning effect of superhydrophobic surfaces. The obtained results provide a theoretical guidance for the optimal design of self-cleaning surfaces.
- 9 November 2023
- Published by Elsevier in Journal of Cleaner Production
- Vol. 429
Effect of calcium sulphate dihydrate on dust adhesion on photovoltaic panel surfaces under condensation
- 9 November 2023
- Published by Elsevier in Journal of Cleaner Production
- Vol. 429
Effect of calcium sulphate dihydrate on dust adhesion on photovoltaic panel surfaces under condensation
- 1 January 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (1) , 017133
Experimental and mechanical analyses of dust agglomeration on photovoltaic surfaces due to condensation
The dust deposited on a photovoltaic (PV) surface decreases the photoelectric efficiency of a module, leading to potential security risks. A few studies have demonstrated that condensation affects dust accumulation on PV surfaces; however, the mechanism remains unclear. Therefore, this study investigated the effects of dust agglomeration dynamic factors on PV surfaces using micro-experiments and mechanical analysis. An experimental platform for dust particle agglomeration due to condensation was designed and developed, and microscopic experiments were conducted to study the dust particle agglomeration process on the PV panel surface. The particles on the hydrophilic PV surface were confirmed to agglomerate owing to condensation. The particle agglomeration process on the hydrophilic PV surface primarily entails three typical processes that occur sequentially: fusion between droplets, fusion between the semi-submerged particles and droplets, and agglomeration between semi-submerged particles. The particles agglomerated on the hydrophilic PV surfaces have a tiled morphology. An analysis of the particle agglomeration mechanism on the hydrophilic PV surface due to condensation was performed. Water surface tension was identified as the main dynamic factor leading to particle agglomeration during condensation. The results provide theoretical guidance for reducing the dust deposited on PV surfaces.
- 1 January 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (1) , 017133
Experimental and mechanical analyses of dust agglomeration on photovoltaic surfaces due to condensation
The dust deposited on a photovoltaic (PV) surface decreases the photoelectric efficiency of a module, leading to potential security risks. A few studies have demonstrated that condensation affects dust accumulation on PV surfaces; however, the mechanism remains unclear. Therefore, this study investigated the effects of dust agglomeration dynamic factors on PV surfaces using micro-experiments and mechanical analysis. An experimental platform for dust particle agglomeration due to condensation was designed and developed, and microscopic experiments were conducted to study the dust particle agglomeration process on the PV panel surface. The particles on the hydrophilic PV surface were confirmed to agglomerate owing to condensation. The particle agglomeration process on the hydrophilic PV surface primarily entails three typical processes that occur sequentially: fusion between droplets, fusion between the semi-submerged particles and droplets, and agglomeration between semi-submerged particles. The particles agglomerated on the hydrophilic PV surfaces have a tiled morphology. An analysis of the particle agglomeration mechanism on the hydrophilic PV surface due to condensation was performed. Water surface tension was identified as the main dynamic factor leading to particle agglomeration during condensation. The results provide theoretical guidance for reducing the dust deposited on PV surfaces.
- 3 February 2022
- Published by Elsevier in Renewable Energy
- Vol. 187, 774-789
Safety and efficiency assessment of absorber with an initial offset in a parabolic trough collector
- 3 February 2022
- Published by Elsevier in Renewable Energy
- Vol. 187, 774-789
Safety and efficiency assessment of absorber with an initial offset in a parabolic trough collector
- 1 November 2021
- Published by Elsevier in Journal of Cleaner Production
- Vol. 323
Research on low-carbon campus based on ecological footprint evaluation and machine learning: A case study in China
- 1 November 2021
- Published by Elsevier in Journal of Cleaner Production
- Vol. 323
Research on low-carbon campus based on ecological footprint evaluation and machine learning: A case study in China