Yarraguntla Ashok Kumar Reddy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yarraguntla Ashok Kumar Reddy has a total of 56 co-authors. Here are the top co-authors by number of shared publications:
- B. Ajitha
Department of Physics, School of Advanced Sciences, Vellore Institute of Technology (VIT), Vandalur-Kelambakkam Road, Chennai 600127, India
16 shared publications P. Sreedhara Reddy
14 shared publicationsIn-Ku Kang
10 shared publicationsB. Ajitha
9 shared publicationsHee Chul Lee
8 shared publicationsP.V. Karthik Yadav
Department of Physics, Indian Institute of Information Technology, Design and Manufacturing, Kancheepuram, Off Vandalur-Kelambakkam Road, Chennai, 600127, India
7 shared publications
Latest Publications
- 23 October 2026
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 9 (21) , 14688-14698
Effect of Depletion Region Width on Self-Powered UV–Visible Photoresponse of Cu2O-In2O3 Planar p–n Junction Photodetectors
Self-powered photodetectors have garnered significant attention due to their potential applications in optical communication, remote sensing, and imaging. This work presents p-Cu2O/n-In2O3 type-II heterojunction photodetectors via sputtering, achieving self-powered photodetection across the ultraviolet-visible spectrum. Here, Cu2O-In2O3 planar p–n junction thin films are developed with different depletion region widths (DRWs) of 1.5, 3.0, and 4.5 mm. Optical studies confirm that the In2O3 film exhibits strong ultraviolet (UV) absorbance and a wide bandgap of 3.35 eV. In contrast, the Cu2O film exhibits strong UV–visible absorbance with a narrow bandgap of 2.25 eV. Among the devices, the device with a DRW of 3.0 mm achieves higher photodetector performance, attributed to a stronger electric field and reduced charge-carrier recombination in the depletion region. Consequently, the device with a 3.0 mm DRW shows the highest responsivity (Rλ) of 4.8 mA/W, 9.4 mA/W, 13.8 mA/W, and 4.4 mA/W and detectivity (D*) of 2.14 × 1010 Jones, 4.19 × 1010 Jones, 6.15 × 1010 Jones, and 1.98 × 1010 Jones at 380, 460, 530, and 630 nm illuminations, respectively, even at lower incident optical power densities. Although the fabricated Cu2O-In2O3 p–n junction self-powered photodetector devices exhibit relatively modest figures of merit, they offer distinct advantages: self-powered operation, a broad spectral response in the UV–visible region, and stable photoresponse, highlighting their potential for low-power optoelectronic applications.
- 23 October 2026
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 9 (21) , 14688-14698
Effect of Depletion Region Width on Self-Powered UV–Visible Photoresponse of Cu2O-In2O3 Planar p–n Junction Photodetectors
Self-powered photodetectors have garnered significant attention due to their potential applications in optical communication, remote sensing, and imaging. This work presents p-Cu2O/n-In2O3 type-II heterojunction photodetectors via sputtering, achieving self-powered photodetection across the ultraviolet-visible spectrum. Here, Cu2O-In2O3 planar p–n junction thin films are developed with different depletion region widths (DRWs) of 1.5, 3.0, and 4.5 mm. Optical studies confirm that the In2O3 film exhibits strong ultraviolet (UV) absorbance and a wide bandgap of 3.35 eV. In contrast, the Cu2O film exhibits strong UV–visible absorbance with a narrow bandgap of 2.25 eV. Among the devices, the device with a DRW of 3.0 mm achieves higher photodetector performance, attributed to a stronger electric field and reduced charge-carrier recombination in the depletion region. Consequently, the device with a 3.0 mm DRW shows the highest responsivity (Rλ) of 4.8 mA/W, 9.4 mA/W, 13.8 mA/W, and 4.4 mA/W and detectivity (D*) of 2.14 × 1010 Jones, 4.19 × 1010 Jones, 6.15 × 1010 Jones, and 1.98 × 1010 Jones at 380, 460, 530, and 630 nm illuminations, respectively, even at lower incident optical power densities. Although the fabricated Cu2O-In2O3 p–n junction self-powered photodetector devices exhibit relatively modest figures of merit, they offer distinct advantages: self-powered operation, a broad spectral response in the UV–visible region, and stable photoresponse, highlighting their potential for low-power optoelectronic applications.
- 7 August 2026
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
Activation of Forbidden Raman Modes in Black Phosphorus–Metal Oxide Heterostructures for Self-Powered Photodetection
Black phosphorus (BP) is an emerging two-dimensional (2D) material, but few of its vibrational modes remain forbidden under a perfect crystal symmetry. In this work, we investigate the activation of forbidden Raman modes in BP-Cu2O and BP-MoO3 heterostructures via edge-induced symmetry-breaking for self-powered photodetection. These modes are key elements in which symmetry-broken phonon states enable precise control and are leveraged for additional functionalities. Correspondingly, such symmetry-induced interfacial modulation directly influences charge transport characteristics and forms ohmic and Schottky contacts at the electrode and BP-metal oxide heterostructure interface. Importantly, both devices show the photoresponse from the ultraviolet (UV) to near-infrared (NIR) region due to the incorporation of the BP on the surface of the Cu2O and MoO3, which significantly affects the electrical properties because of the BP-Cu2O nanoflakes and BP-MoO3 nanoribbons, resulting in enhanced spectral absorption of the light onto the photoactive layer. Overall, the activation of symmetry-forbidden Raman modes in BP-metal oxide heterostructures reveals strong interfacial coupling and the formation of a built-in electric field, thereby enhancing charge separation efficiency and enabling high-performance self-powered photodetection.
- 7 August 2026
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
Activation of Forbidden Raman Modes in Black Phosphorus–Metal Oxide Heterostructures for Self-Powered Photodetection
Black phosphorus (BP) is an emerging two-dimensional (2D) material, but few of its vibrational modes remain forbidden under a perfect crystal symmetry. In this work, we investigate the activation of forbidden Raman modes in BP-Cu2O and BP-MoO3 heterostructures via edge-induced symmetry-breaking for self-powered photodetection. These modes are key elements in which symmetry-broken phonon states enable precise control and are leveraged for additional functionalities. Correspondingly, such symmetry-induced interfacial modulation directly influences charge transport characteristics and forms ohmic and Schottky contacts at the electrode and BP-metal oxide heterostructure interface. Importantly, both devices show the photoresponse from the ultraviolet (UV) to near-infrared (NIR) region due to the incorporation of the BP on the surface of the Cu2O and MoO3, which significantly affects the electrical properties because of the BP-Cu2O nanoflakes and BP-MoO3 nanoribbons, resulting in enhanced spectral absorption of the light onto the photoactive layer. Overall, the activation of symmetry-forbidden Raman modes in BP-metal oxide heterostructures reveals strong interfacial coupling and the formation of a built-in electric field, thereby enhancing charge separation efficiency and enabling high-performance self-powered photodetection.
- 11 June 2026
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 8 (12) , 5099-5109
Mo-Induced Interfacial Charge Modulation in NiO/In 2 O 3 Vertical p-n Junction Heterostructure for Self-Powered Broadband Photodetector
- 11 June 2026
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 8 (12) , 5099-5109
Mo-Induced Interfacial Charge Modulation in NiO/In 2 O 3 Vertical p-n Junction Heterostructure for Self-Powered Broadband Photodetector
- 28 March 2026
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 8 (7) , 2858-2871
Role of Oxygen Partial Pressure on NO 2 Sensing Properties of Sputter-Grown In 2 O 3– x Thin Films
- 28 March 2026
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 8 (7) , 2858-2871
Role of Oxygen Partial Pressure on NO 2 Sensing Properties of Sputter-Grown In 2 O 3– x Thin Films
- 11 November 2025
- Published by Wiley in Chemphyschem
- Vol. 27 (1) , e202500210
Rapid and Sensitive Ammonia Gas Sensor using Porous Zinc Oxide Nanoflakes and Cholesteric Liquid Crystals
Hybrid material architectures emerge as a transformative approach to enhance the performance of gas sensors. This study reports a novel room‐temperature ammonia (NH 3 ) sensor based on a porous zinc oxide nanoflakes (ZnOP) and polymer‐dispersed cholesteric liquid crystal (PDCLC) composite. The hybrid design integrates the high surface area and mesoporous architecture of ZnO with the functional interfacial properties of PDCLC, yielding a material system that excels in both response and selectivity. The sensor demonstrates exceptional performance metrics, including a broad detection range (1–100 ppm), a low detection limit of 2.61 ppm, and rapid response and recovery times of 5 and 18 s, respectively. Notably, the sensor exhibits superior selectivity toward NH 3 over other volatile organic gases, attributed to the tailored interaction between ammonia molecules and the PDCLC matrix. Moreover, the synergistic interplay between ZnOP and PDCLC enhances electron transfer dynamics, further improving sensing efficiency. This work underscores the potential of porous ZnOP/PDCLC hybrids as advanced materials for ppm‐level NH 3 detection and establishes a robust platform for designing high‐performance gas sensors operable at room temperature.
- 11 November 2025
- Published by Wiley in Chemphyschem
- Vol. 27 (1) , e202500210
Rapid and Sensitive Ammonia Gas Sensor using Porous Zinc Oxide Nanoflakes and Cholesteric Liquid Crystals
Hybrid material architectures emerge as a transformative approach to enhance the performance of gas sensors. This study reports a novel room‐temperature ammonia (NH 3 ) sensor based on a porous zinc oxide nanoflakes (ZnOP) and polymer‐dispersed cholesteric liquid crystal (PDCLC) composite. The hybrid design integrates the high surface area and mesoporous architecture of ZnO with the functional interfacial properties of PDCLC, yielding a material system that excels in both response and selectivity. The sensor demonstrates exceptional performance metrics, including a broad detection range (1–100 ppm), a low detection limit of 2.61 ppm, and rapid response and recovery times of 5 and 18 s, respectively. Notably, the sensor exhibits superior selectivity toward NH 3 over other volatile organic gases, attributed to the tailored interaction between ammonia molecules and the PDCLC matrix. Moreover, the synergistic interplay between ZnOP and PDCLC enhances electron transfer dynamics, further improving sensing efficiency. This work underscores the potential of porous ZnOP/PDCLC hybrids as advanced materials for ppm‐level NH 3 detection and establishes a robust platform for designing high‐performance gas sensors operable at room temperature.
- 26 September 2025
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
Asymmetric Electrode-Driven Self-Powered Photodetector Using Cu2-xS Film
- 26 September 2025
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
Asymmetric Electrode-Driven Self-Powered Photodetector Using Cu2-xS Film
- 30 July 2025
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 8 (15) , 11719-11731
Self-Powered Photodetector Based on p(Cu2O)–n(MoO3) Junction Architecture: Analyzing the Influence of Depletion Region Width on the Photodetector Properties
- 30 July 2025
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 8 (15) , 11719-11731
Self-Powered Photodetector Based on p(Cu2O)–n(MoO3) Junction Architecture: Analyzing the Influence of Depletion Region Width on the Photodetector Properties
- 25 April 2025
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 7 (9) , 4144-4160
Growth Control of Cu2-xS Films for Visible-Near Infrared Photodetectors
- 25 April 2025
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 7 (9) , 4144-4160
Growth Control of Cu2-xS Films for Visible-Near Infrared Photodetectors
- 13 January 2025
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 7 (2) , 838-846
Development of Self-Powered MoS2-x-Based Photodetector with Different Contact Structures
- 13 January 2025
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 7 (2) , 838-846
Development of Self-Powered MoS2-x-Based Photodetector with Different Contact Structures
- 24 June 2024
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 6 (7) , 5151-5162
Surface Morphology Evolution of MoS2–x by Growth Temperature and Its Effect on Photodetector Properties
- 24 June 2024
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 6 (7) , 5151-5162
Surface Morphology Evolution of MoS2–x by Growth Temperature and Its Effect on Photodetector Properties