David F. Davidson
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
David F. Davidson has a total of 158 co-authors. Here are the top co-authors by number of shared publications:
Ronald K. Hanson
48 shared publications- Jiankun Shao
Beijing Institute of Technology
13 shared publications R. K. Hanson
Stanford University
11 shared publications- Rishav Choudhary
Department of Mechanical Engineering, Stanford University, Stanford, USA
10 shared publications - Shengkai Wang
Peking University
10 shared publications - Wesley M. Yu
California Institute of Technology
7 shared publications
Latest Publications
- 4 March 2023
- Published by Elsevier in Combustion and Flame
- Vol. 251
Low-temperature oxidation of n-octane and n-decane in shock tubes: Differences in time histories of key intermediates
- 4 March 2023
- Published by Elsevier in Combustion and Flame
- Vol. 251
Low-temperature oxidation of n-octane and n-decane in shock tubes: Differences in time histories of key intermediates
- 1 October 2022
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 39 (1) , 735-743
Shock tube/laser absorption measurement of the rate constant of the reaction: H2O2 + CO2 2OH + CO2
- 1 October 2022
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 39 (1) , 735-743
Shock tube/laser absorption measurement of the rate constant of the reaction: H2O2 + CO2 2OH + CO2
- 15 September 2022
- Published by Elsevier in Combustion and Flame
- Vol. 245
A mid-IR laser absorption diagnostic for measuring formaldehyde at high pressures and its demonstration in shock tubes
- 15 September 2022
- Published by Elsevier in Combustion and Flame
- Vol. 245
A mid-IR laser absorption diagnostic for measuring formaldehyde at high pressures and its demonstration in shock tubes
- 19 July 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 126 (29) , 4818-4826
Shock Tube/Laser Absorption Measurements of Cyclopentadiene Pyrolysis
High-temperature cyclopentadiene pyrolysis was examined behind reflected shock waves in a heated shock tube using several laser absorption diagnostic schemes. A two-color, online-offline sensor near 3335 cm-1 was used to measure time histories of acetylene, while a three-color scheme of diagnostics at 10.532, 10.675, and 11.345 μm yielded measurements of cyclopentadiene and ethylene. Species time histories of cyclopentadiene decomposition and acetylene formation as well as ethylene yields are reported from 1319 to 1678 K at 1.2-1.5 atm. In addition, the overall decomposition rate of cyclopentadiene is reported, and comparisons are made to a number of kinetic models.
- 19 July 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 126 (29) , 4818-4826
Shock Tube/Laser Absorption Measurements of Cyclopentadiene Pyrolysis
High-temperature cyclopentadiene pyrolysis was examined behind reflected shock waves in a heated shock tube using several laser absorption diagnostic schemes. A two-color, online-offline sensor near 3335 cm-1 was used to measure time histories of acetylene, while a three-color scheme of diagnostics at 10.532, 10.675, and 11.345 μm yielded measurements of cyclopentadiene and ethylene. Species time histories of cyclopentadiene decomposition and acetylene formation as well as ethylene yields are reported from 1319 to 1678 K at 1.2-1.5 atm. In addition, the overall decomposition rate of cyclopentadiene is reported, and comparisons are made to a number of kinetic models.
- 10 January 2022
- Published by Elsevier in Combustion and Flame
- Vol. 238
Shock tube/laser absorption measurements of the isomerization rates of allene and propyne
- 10 January 2022
- Published by Elsevier in Combustion and Flame
- Vol. 238
Shock tube/laser absorption measurements of the isomerization rates of allene and propyne
- 21 June 2021
- Published by American Physical Society (APS) in Physical Review E
- Vol. 103 (6) , 063211
Collisional excitation kinetics for and states using laser absorption spectroscopy in shock-heated weakly ionized -Ar mixtureCollisional excitation kinetics for atomic oxygen is studied behind reflected shock waves in mixtures over 10 000–11 000K using laser absorption spectroscopy of the O() to ) transition at 777 nm and the ) to O() transitions at 926 nm. Four time histories are inferred simultaneously from the absorbance of the two transitions: the population density of level 4 of atomic oxygen, i.e., the O() state, ; the population density of level 6 of atomic oxygen, i.e., the ) state, ; the electron number density, ; and the heavy-particle translational temperature, . Atomic oxygen in the levels 4 and 6 are not in equilibrium with the ground-state atomic oxygen as the measurements of and are generally 3–20 times smaller than the corresponding values under Boltzmann equilibrium at . However, these two states are close to partial equilibrium with each other within the test time, indicating strong heavy-particle cross coupling between levels 4 and 6 of atomic oxygen. A simplified two-temperature collisional-radiative (CR) model is developed to study the thermal and chemical nonequilibrium of atomic oxygen following shock heating. The four measured time histories are used to optimize the 12 collisional rate constants in the CR model using a stochastic gradient descent (SGD) algorithm. The time-history results, diagnostic methods, and collisional-radiative model presented in the current study are potentially useful in studies of high-enthalpy air, plasma processing, or other applications involving weakly ionized oxygen.- 21 June 2021
- Published by American Physical Society (APS) in Physical Review E
- Vol. 103 (6) , 063211
Collisional excitation kinetics for and states using laser absorption spectroscopy in shock-heated weakly ionized -Ar mixtureCollisional excitation kinetics for atomic oxygen is studied behind reflected shock waves in mixtures over 10 000–11 000K using laser absorption spectroscopy of the O() to ) transition at 777 nm and the ) to O() transitions at 926 nm. Four time histories are inferred simultaneously from the absorbance of the two transitions: the population density of level 4 of atomic oxygen, i.e., the O() state, ; the population density of level 6 of atomic oxygen, i.e., the ) state, ; the electron number density, ; and the heavy-particle translational temperature, . Atomic oxygen in the levels 4 and 6 are not in equilibrium with the ground-state atomic oxygen as the measurements of and are generally 3–20 times smaller than the corresponding values under Boltzmann equilibrium at . However, these two states are close to partial equilibrium with each other within the test time, indicating strong heavy-particle cross coupling between levels 4 and 6 of atomic oxygen. A simplified two-temperature collisional-radiative (CR) model is developed to study the thermal and chemical nonequilibrium of atomic oxygen following shock heating. The four measured time histories are used to optimize the 12 collisional rate constants in the CR model using a stochastic gradient descent (SGD) algorithm. The time-history results, diagnostic methods, and collisional-radiative model presented in the current study are potentially useful in studies of high-enthalpy air, plasma processing, or other applications involving weakly ionized oxygen.- 1 January 2021
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 38 (1) , 957-965
Measurement of time histories of stable intermediates during first stage ignition of n-heptane and its two isomers in a shock tube
- 1 January 2021
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 38 (1) , 957-965
Measurement of time histories of stable intermediates during first stage ignition of n-heptane and its two isomers in a shock tube
- 1 January 2021
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 38 (1) , 911-918
High-speed imaging of n-heptane ignition in a high-pressure shock tube
- 1 January 2021
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 38 (1) , 911-918
High-speed imaging of n-heptane ignition in a high-pressure shock tube
- 16 March 2020
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 124 (16) , 3026-3030
Determination of the JP10 + OH → Product Reaction Rate with Measured Fuel Concentrations in Shock Tube Experiments
The overall reaction rate for JP10+OH→products was measured directly via laser absorption of OH in shock tube experiments from 931-1308 K and 0.94-1.44 atm. The JP10 concentration of test gas mixtures was measured in the shock tube for several experiments using a 3.39 µm laser fuel diagnostic. Measured JP10 concentrations indicated fuel losses due to adsorption of 11-31% compared to values calculated manometrically from mixture preparation. OH was generated via rapid thermal decomposition of tert-butyl hydroperoxide behind reflected shock waves, and post-shock OH profiles were measured via laser absorption at 308.6 nm. Measured OH profiles were fit with a chemical kinetic model for JP10 chemistry to determine the overall JP10+OH reaction rate. A recommendation is made for the JP10+OH overall reaction rate over the temperature range explored in this study as k1(931-1308 K) = 1.622x1014 exp(-1826/T[K]) ±12%. To the authors’ knowledge, this provides the first direct measurement of the JP10+OH reaction rate.
- 16 March 2020
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 124 (16) , 3026-3030
Determination of the JP10 + OH → Product Reaction Rate with Measured Fuel Concentrations in Shock Tube Experiments
The overall reaction rate for JP10+OH→products was measured directly via laser absorption of OH in shock tube experiments from 931-1308 K and 0.94-1.44 atm. The JP10 concentration of test gas mixtures was measured in the shock tube for several experiments using a 3.39 µm laser fuel diagnostic. Measured JP10 concentrations indicated fuel losses due to adsorption of 11-31% compared to values calculated manometrically from mixture preparation. OH was generated via rapid thermal decomposition of tert-butyl hydroperoxide behind reflected shock waves, and post-shock OH profiles were measured via laser absorption at 308.6 nm. Measured OH profiles were fit with a chemical kinetic model for JP10 chemistry to determine the overall JP10+OH reaction rate. A recommendation is made for the JP10+OH overall reaction rate over the temperature range explored in this study as k1(931-1308 K) = 1.622x1014 exp(-1826/T[K]) ±12%. To the authors’ knowledge, this provides the first direct measurement of the JP10+OH reaction rate.