Delfina Godinho
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Delfina Godinho has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Maria Bernardo
LAQV/REQUIMTE, Departamento de Química (DQ), Faculdade de Ciências e Tecnologia (FCT), Universidade Nova de Lisboa (UNL), 2829-516 Caparica, Portugal
5 shared publications - Isabel Maria Fonseca
LAQV/REQUIMTE, Departamento de Química, Faculdade de Ciências e Tecnologia, Universidade Nova de Lisboa, 2829-516 Caparica, Portugal
4 shared publications - Nuno Lapa
LAQV-REQUIMTE, Departamento de Química, Faculdade de Ciências e Tecnologia, Universidade Nova de Lisboa, 2829-516 Caparica, Portugal
4 shared publications - Diogo Dias
LAQV/REQUIMTE, Faculdade de Ciências e Tecnologia (FCT), Universidade Nova de Lisboa (UNL), 2829-516 Caparica, Portugal
3 shared publications F. Pinto
Unidade de Bioenergia (UB), Laboratório Nacional de Energia e Geologia (LNEG), Estrada do Paço do Lumiar, Ed. J, 1649-038 Lisboa, Portugal
2 shared publicationsFilomena Pinto
Unidade de Bioenergia, Laboratório Nacional de Energia e Geologia, Estrada do Paço do Lumiar, Ed. J, 1649-038, Lisbon, Portugal
2 shared publications
Latest Publications
- Open Access
The behavior of thermally modified wood after exposure in maritime/industrial and urban environments
- Open Access
Thermally Modified Wood Exposed to Different Weathering Conditions: A Review
Outdoor wood applications are exposed to several different biotic and abiotic factors, and for that reason, they require protection to increase their service life. Several technologies of wood protection are already commercialized. One of these technologies is thermal modification, which refers to the structural, mechanical, and chemical transformations occurring in the lignocellulosic material when gradually heated up to specific temperature ranges. In the past few years, several researchers have undertaken weathering resistance evaluations on different wood species. Some cases have considered natural exposure in different countries with different climatic conditions, while others focused on artificial exposure under UV and xenon radiation tests. Most works evaluated the weathering effects on the chemical, mechanical and physical, and anatomical shifts compared to the original characteristics of the material. This review has established a considerable lack of studies in the bibliography focusing on abiotic factors, such as the industrial and maritime environment, or even isolated climatic factors such as salt spray (simulating maritime environments) or pollutant gases (simulating industrial environments). This lack of information can be an opportunity for future work. It could help to understand if thermally modified wood is or is not sensitive to pollutant gases or salinity, or to a combination of both. By knowing the degradation mechanisms caused by these factors, it will be possible to study other forms of protection.
Open AccessThermally Modified Wood Exposed to Different Weathering Conditions: A Review
Outdoor wood applications are exposed to several different biotic and abiotic factors, and for that reason, they require protection to increase their service life. Several technologies of wood protection are already commercialized. One of these technologies is thermal modification, which refers to the structural, mechanical, and chemical transformations occurring in the lignocellulosic material when gradually heated up to specific temperature ranges. In the past few years, several researchers have undertaken weathering resistance evaluations on different wood species. Some cases have considered natural exposure in different countries with different climatic conditions, while others focused on artificial exposure under UV and xenon radiation tests. Most works evaluated the weathering effects on the chemical, mechanical and physical, and anatomical shifts compared to the original characteristics of the material. This review has established a considerable lack of studies in the bibliography focusing on abiotic factors, such as the industrial and maritime environment, or even isolated climatic factors such as salt spray (simulating maritime environments) or pollutant gases (simulating industrial environments). This lack of information can be an opportunity for future work. It could help to understand if thermally modified wood is or is not sensitive to pollutant gases or salinity, or to a combination of both. By knowing the degradation mechanisms caused by these factors, it will be possible to study other forms of protection.
- 6 June 2019
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 26 (22) , 22723-22735
Recovery of Cr(III) by using chars from the co-gasification of agriculture and forestry wastes
The aim of the present work was to assess the efficiency of biochars obtained from the co-gasification of blends of rice husk + corn cob (biochar 50CC) and rice husk + eucalyptus stumps (biochar 50ES), as potential renewable low-cost adsorbents for Cr(III) recovery from wastewaters. The two gasification biochars presented a weak porous structure (ABET = 63–144 m2 g−1), but a strong alkaline character, promoted by a high content of mineral matter (59.8% w/w of ashes for 50CC biochar and 81.9% w/w for 50ES biochar). The biochars were used for Cr(III) recovery from synthetic solutions by varying the initial pH value (3, 4, and 5), liquid/solid (L/S) ratio (100–500 mL g−1), contact time (1–120 h), and initial Cr(III) concentration (10–150 mg L−1). High Cr(III) removal percentages (around 100%) were obtained for both biochars, due to Cr precipitation, at low L/S ratios (100 and 200 mL g−1), for the initial pH 5 and initial Cr concentration of 50 mg L−1. Under the experimental conditions in which other removal mechanisms rather than precipitation occurred, a higher removal percentage (49.9%) and the highest uptake capacity (6.87 mg g−1) were registered for 50CC biochar. In the equilibrium, 50ES biochar presented a Cr(III) removal percentage of 27% with a maximum uptake capacity of 2.58 mg g−1. The better performance on Cr(III) recovery for the biochar 50CC was attributed to its better textural properties, as well as its higher cation exchange capacity.
- 6 June 2019
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 26 (22) , 22723-22735
Recovery of Cr(III) by using chars from the co-gasification of agriculture and forestry wastes
The aim of the present work was to assess the efficiency of biochars obtained from the co-gasification of blends of rice husk + corn cob (biochar 50CC) and rice husk + eucalyptus stumps (biochar 50ES), as potential renewable low-cost adsorbents for Cr(III) recovery from wastewaters. The two gasification biochars presented a weak porous structure (ABET = 63–144 m2 g−1), but a strong alkaline character, promoted by a high content of mineral matter (59.8% w/w of ashes for 50CC biochar and 81.9% w/w for 50ES biochar). The biochars were used for Cr(III) recovery from synthetic solutions by varying the initial pH value (3, 4, and 5), liquid/solid (L/S) ratio (100–500 mL g−1), contact time (1–120 h), and initial Cr(III) concentration (10–150 mg L−1). High Cr(III) removal percentages (around 100%) were obtained for both biochars, due to Cr precipitation, at low L/S ratios (100 and 200 mL g−1), for the initial pH 5 and initial Cr concentration of 50 mg L−1. Under the experimental conditions in which other removal mechanisms rather than precipitation occurred, a higher removal percentage (49.9%) and the highest uptake capacity (6.87 mg g−1) were registered for 50CC biochar. In the equilibrium, 50ES biochar presented a Cr(III) removal percentage of 27% with a maximum uptake capacity of 2.58 mg g−1. The better performance on Cr(III) recovery for the biochar 50CC was attributed to its better textural properties, as well as its higher cation exchange capacity.
- 16 August 2017
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 24 (28) , 22698-22708
Study of the removal mechanism of aquatic emergent pollutants by new bio-based chars
This work is dedicated to study the potential application of char byproducts obtained in the gasification of rice husk (RG char) and rice husk blended with corn cob (RCG char) as removal agents of two emergent aquatic contaminants: tetracycline and caffeine. The chars presented high ash contents (59.5–81.5%), being their mineral content mainly composed of silicon (as silica) and potassium. The samples presented a strong basic character, which was related to its higher mineral oxides content. RCG char presented better textural properties with a higher apparent surface area (144 m2 g−1) and higher micropore content (V micro = 0.05 cm3 g−1). The alkaline character of both chars promoted high ecotoxicity levels on their aqueous eluates; however, the ecotoxic behaviour was eliminated after pH correction. Adsorption experiments showed that RG char presented higher uptake capacity for both tetracycline (12.9 mg g−1) and caffeine (8.0 mg g−1), indicating that textural properties did not play a major role in the adsorption process. For tetracycline, the underlying adsorption mechanism was complexation or ion exchange reactions with the mineral elements of chars. The higher affinity of RG char to caffeine was associated with the higher alkaline character presented by this char.
- 16 August 2017
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 24 (28) , 22698-22708
Study of the removal mechanism of aquatic emergent pollutants by new bio-based chars
This work is dedicated to study the potential application of char byproducts obtained in the gasification of rice husk (RG char) and rice husk blended with corn cob (RCG char) as removal agents of two emergent aquatic contaminants: tetracycline and caffeine. The chars presented high ash contents (59.5–81.5%), being their mineral content mainly composed of silicon (as silica) and potassium. The samples presented a strong basic character, which was related to its higher mineral oxides content. RCG char presented better textural properties with a higher apparent surface area (144 m2 g−1) and higher micropore content (V micro = 0.05 cm3 g−1). The alkaline character of both chars promoted high ecotoxicity levels on their aqueous eluates; however, the ecotoxic behaviour was eliminated after pH correction. Adsorption experiments showed that RG char presented higher uptake capacity for both tetracycline (12.9 mg g−1) and caffeine (8.0 mg g−1), indicating that textural properties did not play a major role in the adsorption process. For tetracycline, the underlying adsorption mechanism was complexation or ion exchange reactions with the mineral elements of chars. The higher affinity of RG char to caffeine was associated with the higher alkaline character presented by this char.
- 1 July 2017
- Published by Elsevier in Waste Management
- Vol. 65, 186-194
Properties of chars from the gasification and pyrolysis of rice waste streams towards their valorisation as adsorbent materials
- 1 July 2017
- Published by Elsevier in Waste Management
- Vol. 65, 186-194
Properties of chars from the gasification and pyrolysis of rice waste streams towards their valorisation as adsorbent materials
- 1 January 2017
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 321, 173-182
Adding value to gasification and co-pyrolysis chars as removal agents of Cr3+
- 1 January 2017
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 321, 173-182
Adding value to gasification and co-pyrolysis chars as removal agents of Cr3+