Krzysztof Dzieciol
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Krzysztof Dzieciol has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Hermann Tempel
Institute of Energy Technologies – Fundamental Electrochemistry (IET‐1) Forschungszentrum Jülich Jülich Germany
3 shared publications - Rüdiger-Albert Eichel
Forschungszentrum Jülich
3 shared publications - Hans Kungl
Institute of Energy Technologies - Fundamental Electrochemistry (IET-1), Forschungszentrum Jülich GmbH, Wilhelm-Johnen-Straße, 52425 Jülich, Germany
2 shared publications - Saul Said Montiel Guerrero
Institute of Energy and Climate Research – Fundamental Electrochemistry (IEK-9) Forschungszentrum Jülich GmbH 52428 Jülich, Germany
2 shared publications - Shibabrata Basak
Forschungszentrum Jülich
2 shared publications - Stefan van Waasen
University of Duisburg-Essen Department of Electrical Engineering and Information Technology 47057 Duisburg Germany
2 shared publications
Latest Publications
- Open Access
- 9 May 2026
- Published by Elsevier in SSRN Electronic Journal
Design and Evaluation of a High-Capacity Li4Ti5O12 (LTO) Reference Electrode for Lithium-Ion Batteries
Reference electrodes (REs) enable the measurement of individual electrode potentials in lithium-ion batteries (LIBs), providing critical insights for state-of-health (SoH) analysis and aging studies. While lithium metal is commonly used as a RE, its high reactivity and cost limit its practical applicability. In this study, lithium titanate oxide (Li4Ti5O12, LTO) is investigated as a high-capacity, stable, and cost-effective RE material. Ultra-thick cylindrical LTO-REs were fabricated via mold casting onto a copper wire, yielding electrodes with a diameter of ~1.6 mm and a length of 15 mm. Following electrochemical formation and activation, the electrodes exhibited a stable voltage plateau at ~1.561 V vs Li/Li+ and delivered an areal capacity of 9.787 mAh cm−2 at C/30, approximately sixfold higher than that of conventional LTO electrodes (1.42 mAh cm−2). For stable operation, the LTO-RE was adjusted to nearly 50 % state-of-charge prior to integration into a three-electrode cell (T-cell). During cell cycling, the LTO-RE enabled continuous monitoring of the anode potential while maintaining a highly stable reference potential, showing only a 3.8 mV shift after more than 500 hours of operation. These results demonstrate that ultra-thick cylindrical LTO-based RE provide stable and reliable performance, indicating their suitability for extended aging studies and capacity-loss analysis in LIB research.
- 9 May 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessDesign and Evaluation of a High-Capacity Li4Ti5O12 (LTO) Reference Electrode for Lithium-Ion Batteries
Reference electrodes (REs) enable the measurement of individual electrode potentials in lithium-ion batteries (LIBs), providing critical insights for state-of-health (SoH) analysis and aging studies. While lithium metal is commonly used as a RE, its high reactivity and cost limit its practical applicability. In this study, lithium titanate oxide (Li4Ti5O12, LTO) is investigated as a high-capacity, stable, and cost-effective RE material. Ultra-thick cylindrical LTO-REs were fabricated via mold casting onto a copper wire, yielding electrodes with a diameter of ~1.6 mm and a length of 15 mm. Following electrochemical formation and activation, the electrodes exhibited a stable voltage plateau at ~1.561 V vs Li/Li+ and delivered an areal capacity of 9.787 mAh cm−2 at C/30, approximately sixfold higher than that of conventional LTO electrodes (1.42 mAh cm−2). For stable operation, the LTO-RE was adjusted to nearly 50 % state-of-charge prior to integration into a three-electrode cell (T-cell). During cell cycling, the LTO-RE enabled continuous monitoring of the anode potential while maintaining a highly stable reference potential, showing only a 3.8 mV shift after more than 500 hours of operation. These results demonstrate that ultra-thick cylindrical LTO-based RE provide stable and reliable performance, indicating their suitability for extended aging studies and capacity-loss analysis in LIB research.
- Open Access
- 17 November 2021
- Published by Wiley in Batteries & Supercaps
- Vol. 4 (12) , 1782
Cover Feature: Improved Electrochemical Performance of Zinc Anodes by EDTA in Near‐Neutral Zinc−Air Batteries (Batteries & Supercaps 12/2021)
- 17 November 2021
- Published by Wiley in Batteries & Supercaps
- Vol. 4 (12) , 1782
Open AccessCover Feature: Improved Electrochemical Performance of Zinc Anodes by EDTA in Near‐Neutral Zinc−Air Batteries (Batteries & Supercaps 12/2021)
- Open Access
- 19 July 2021
- Published by Wiley in Batteries & Supercaps
- Vol. 4 (12) , 1830-1842
Improved Electrochemical Performance of Zinc Anodes by EDTA in Near‐Neutral Zinc−Air Batteries
The influence of ethylenediaminetetraacetic acid (EDTA) electrolyte additive on the performance of Zn−air batteries with near‐neutral chloride‐based electrolytes was examined for primary and secondary batteries. The electrochemical measurements indicated that Zn is not completely active in neat 2 M NaCl, but still could be discharged up to 1 mA cm−2 around −1.0 VAg/AgCl. The characterization of the Zn surfaces revealed the existence of a passive film consisting of Simonkolleite, Zn(OH)2, and/or ZnO. The EDTA additive enhanced the discharge voltages by 200 mV to −1.2 VAg/AgCl indicating an active Zn surface. The effect of EDTA is explained by its chelation abilities with Zn2+ before formation of hydroxide or oxide species. The Zn−air cells with EDTA were operated up to 930 h with specific energies up to 840 Wh kgZn−1. The cells could also be cycled up to 70 cycles while providing enhanced discharge voltages at 1.15 V over 50 cycles. The positive effect of EDTA is dependent on the amount of free EDTA molecules. Nevertheless, the Zn−air cells showed better performance in terms of higher discharge voltage, discharge energies, and lower overpotentials in presence of EDTA.
- 19 July 2021
- Published by Wiley in Batteries & Supercaps
- Vol. 4 (12) , 1830-1842
Open AccessImproved Electrochemical Performance of Zinc Anodes by EDTA in Near‐Neutral Zinc−Air Batteries
The influence of ethylenediaminetetraacetic acid (EDTA) electrolyte additive on the performance of Zn−air batteries with near‐neutral chloride‐based electrolytes was examined for primary and secondary batteries. The electrochemical measurements indicated that Zn is not completely active in neat 2 M NaCl, but still could be discharged up to 1 mA cm−2 around −1.0 VAg/AgCl. The characterization of the Zn surfaces revealed the existence of a passive film consisting of Simonkolleite, Zn(OH)2, and/or ZnO. The EDTA additive enhanced the discharge voltages by 200 mV to −1.2 VAg/AgCl indicating an active Zn surface. The effect of EDTA is explained by its chelation abilities with Zn2+ before formation of hydroxide or oxide species. The Zn−air cells with EDTA were operated up to 930 h with specific energies up to 840 Wh kgZn−1. The cells could also be cycled up to 70 cycles while providing enhanced discharge voltages at 1.15 V over 50 cycles. The positive effect of EDTA is dependent on the amount of free EDTA molecules. Nevertheless, the Zn−air cells showed better performance in terms of higher discharge voltage, discharge energies, and lower overpotentials in presence of EDTA.
- 9 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Medical Imaging
- Vol. 37 (2) , 626-637
Accelerated Parameter Mapping of Multiple-Echo Gradient-Echo Data Using Model-Based Iterative Reconstruction
A new reconstruction method, coined MIRAGE, is presented for accurate, fast, and robust parameter mapping of multiple-echo gradient-echo imaging; the basis sequence of novel quantitative MRI techniques such as water content and susceptibility mapping. Assuming that the temporal signal can be modeled as a sum of damped complex exponentials, MIRAGE performs model-based reconstruction of undersampled data by minimizing the rank of local Hankel matrices. It further incorporates multi-channel information and spatial prior knowledge. Finally, the parameter maps are estimated using nonlinear regression. Simulations and retrospective undersampling of phantom and in vivo data affirm robustness, e.g., to strong inhomogeneity of the static magnetic field and partial volume effects. MIRAGE is compared to a state of the art compressed sensing method, L1-ESPIRiT. Parameter maps estimated from reconstructed data using MIRAGE are shown to be accurate, with the mean absolute error reduced by up to 50 percent for in vivo results. The proposed method has the potential to improve the diagnostic utility of quantitative imaging techniques that rely on multipleecho gradient-echo data.
- 9 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Medical Imaging
- Vol. 37 (2) , 626-637
Accelerated Parameter Mapping of Multiple-Echo Gradient-Echo Data Using Model-Based Iterative Reconstruction
A new reconstruction method, coined MIRAGE, is presented for accurate, fast, and robust parameter mapping of multiple-echo gradient-echo imaging; the basis sequence of novel quantitative MRI techniques such as water content and susceptibility mapping. Assuming that the temporal signal can be modeled as a sum of damped complex exponentials, MIRAGE performs model-based reconstruction of undersampled data by minimizing the rank of local Hankel matrices. It further incorporates multi-channel information and spatial prior knowledge. Finally, the parameter maps are estimated using nonlinear regression. Simulations and retrospective undersampling of phantom and in vivo data affirm robustness, e.g., to strong inhomogeneity of the static magnetic field and partial volume effects. MIRAGE is compared to a state of the art compressed sensing method, L1-ESPIRiT. Parameter maps estimated from reconstructed data using MIRAGE are shown to be accurate, with the mean absolute error reduced by up to 50 percent for in vivo results. The proposed method has the potential to improve the diagnostic utility of quantitative imaging techniques that rely on multipleecho gradient-echo data.