CBChristopher J. Brennan

Christopher J. Brennan

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Christopher J. Brennan has a total of 39 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    An Analysis of the Benefits and Difficulties of Aerial Magnetic Vector Navigation

    by Aaron Joseph Canciani, Christopher J. Brennan

    Recent successful flight tests have demonstrated scalar magnetic anomaly navigation to be a viable GPSalternative navigation system. These flight tests matched magnetic field measurements to maps of the Earth's crustal magnetic field in order to navigate. Scalar magnetic navigation uses only the magnetic field intensity, not direction, in order to navigate. While it appears obvious to extend aerial magnetic navigation to use the full vector field, in practice there are substantial obstacles to doing so. This paper explores the key challenges of magnetic vector navigation including current sensor limitations, lack of high frequency magnetic vector maps of the Earth's crust, and proper integration of the magnetic data with an inertial navigation system. In overcoming these challenges several key benefits of magnetic vector navigation over scalar magnetic navigation become apparent, including modestly improved navigation accuracy and greatly improved platform attitude.


  • Open Access

    Out-of-plane electromechanical coupling in transition metal dichalcogenides

    by Christopher J. Brennan, Kalhan Koul, Nanshu Lu, Edward T. Yu

    Monolayer transition metal dichalcogenides (TMDs) are intrinsically piezoelectric within the plane of their atoms, but out-of-plane piezoelectric response should not occur due to the symmetry of the crystal structure. Recently, however, MoS2 was shown to exhibit out-of-plane electromechanical coupling consistent with the flexoelectric effect. In this study, MoSe2, WS2, and WSe2 are investigated to determine the existence and strength of out-of-plane electromechanical coupling in other monolayer TMD semiconductor materials. Piezoresponse force microscopy measurements show that monolayer MoS2, MoSe2, WS2, and WSe2 all exhibit out-of-plane electromechanical response. The relative magnitudes of their out-of-plane electromechanical couplings are calculated and compared with one another and to predictions made from a simple model of flexoelectricity. This simple model correctly predicts the magnitude of out-of-plane electromechanical response in these materials, and the measured values provide useful guidance for both more detailed understanding of flexoelectric response in monolayer TMDs, and assessment of their consequences in devices incorporating these materials.


  • Improved Performance of Zinc Oxide Thin Film Transistor Pressure Sensors and a Demonstration of a Commercial Chip Compatibility with the New Force Sensing Technology

    by Siarhei Vishniakou, Renjie Chen, Yun Goo Ro, Christopher J. Brennan, Cooper Levy, Edward T. Yu, Shadi A. Dayeh

    A zinc oxide thin film transistor is developed and optimized that simultaneously functions as a transistor and a force sensor, thus allowing for scalable integration of sensors into arrays without the need for additional addressing elements. Through systematic material deposition, microscopy, and piezoelectric characterization, it is determined that an O2 rich deposition condition improves the transistor performance and pressure sensing characteristics. With these optimizations, a sensitivity of 4 nA kPa−1 and a latency of below 1 ms are achieved, exceeding the criteria for successful commercialization of arrayed pressure sensors. The functionality of 16 × 16 pressure sensor arrays on thin bendable glass substrates for integrated low weight and flexible touchscreen displays is fabricated and demonstrated and read‐out electronics to interface with the arrays and to record their response in real‐time are developed. Finally, the application of these sensors for mobile displays via their operation with an existing commercial touch integrated circuit controller is demonstrated.


  • Out-of-Plane Electromechanical Response of Monolayer Molybdenum Disulfide Measured by Piezoresponse Force Microscopy

    by Christopher J. Brennan, Rudresh Ghosh, Kalhan Koul, Sanjay K. Banerjee, Nanshu Lu, Edward T. Yu

    Two-dimensional (2D) materials have recently been theoretically predicted and experimentally confirmed to exhibit electromechanical coupling. Specifically, monolayer and few-layer molybdenum disulfide (MoS2) have been measured to be piezoelectric within the plane of their atoms. This work demonstrates and quantifies a nonzero out-of-plane electromechanical response of monolayer MoS2 and discusses its possible origins. A piezoresponse force microscope was used to measure the out-of-plane deformation of monolayer MoS2 on Au/Si and Al2O3/Si substrates. Using a vectorial background subtraction technique, we estimate the effective out-of-plane piezoelectric coefficient, d33eff, for monolayer MoS2 to be 1.03 ± 0.22 pm/V when measured on the Au/Si substrate and 1.35 ± 0.24 pm/V when measured on Al2O3/Si. This is on the same order as the in-plane coefficient d11 reported for monolayer MoS2. Interpreting the out-of-plane response as a flexoelectric response, the effective flexoelectric coefficient, μeff*, is estimated to be 0.10 nC/m. Analysis has ruled out the possibility of elastic and electrostatic forces contributing to the measured electromechanical response. X-ray photoelectron spectroscopy detected some contaminants on both MoS2 and its substrate, but the background subtraction technique is expected to remove major contributions from the unwanted contaminants. These measurements provide evidence that monolayer MoS2 exhibits an out-of-plane electromechanical response and our analysis offers estimates of the effective piezoelectric and flexoelectric coefficients.


  • Top Cited Papers

    A review on mechanics and mechanical properties of 2D materials—Graphene and beyond

    by Deji Akinwande, Christopher J. Brennan, J. Scott Bunch, Philip Egberts, Jonathan R. Felts, Huajian Gao, Rui Huang, Joon-Seok Kim, Teng Li, Yao Li, et al.


  • Interface Adhesion between 2D Materials and Elastomers Measured by Buckle Delaminations

    by Christopher J. Brennan, Jessica Nguyen, Edward T. Yu, Nanshu Lu

    2D systems have great promise as next generation electronic materials but require intimate knowledge of their interactions with their neighbors for device fabrication and mechanical manipulation. Although adhesion between 2D materials and stiff substrates such as silicon and copper has been measured, adhesion between 2D materials and soft polymer substrates remains difficult to characterize due to the large deformability of the polymer substrates. In this work, a buckling‐based metrology for measuring the adhesion energy between few layer molybdenum disulfide (MoS2) and soft elastomeric substrates is proposed and demonstrated. Due to large elastic mismatch, few layer MoS2 flakes can form spontaneous wrinkles and buckle‐delaminations on elastomer substrates during exfoliation. MoS2‐elastomer interface toughness can therefore be calculated from the buckle delamination profile measured by atomic force microscopy. The thickness of the MoS2 flake is obtained by analyzing coexisting wrinkles on the same flake. Using this approach, adhesion of few layer MoS2 to 10:1 Sylgard 184 polydimethylsiloxane is measured to be 18 ± 2 mJ m−2, which is about an order of magnitude below graphene‐to‐stiff‐substrate adhesion. Finally, this simple methodology can be generalized to obtain adhesion energies between various combinations of 2D materials and deformable substrates.


  • Comparison of gate dielectric plasma damage from plasma-enhanced atomic layer deposited and magnetron sputtered TiN metal gates

    by Christopher J. Brennan, Christopher M. Neumann, Steven A. Vitale

    Fully depleted silicon-on-insulator transistors were fabricated using two different metal gate deposition mechanisms to compare plasma damage effects on gate oxide quality. Devices fabricated with both plasma-enhanced atomic-layer-deposited (PE-ALD) TiN gates and magnetron plasma sputtered TiN gates showed very good electrostatics and short-channel characteristics. However, the gate oxide quality was markedly better for PE-ALD TiN. A significant reduction in interface state density was inferred from capacitance-voltage measurements as well as a 1200× reduction in gate leakage current. A high-power magnetron plasma source produces a much higher energetic ion and vacuum ultra-violet (VUV) photon flux to the wafer compared to a low-power inductively coupled PE-ALD source. The ion and VUV photons produce defect states in the bulk of the gate oxide as well as at the oxide-silicon interface, causing higher leakage and potential reliability degradation.


  • Surface-enhanced Raman spectroscopy with monolithic nanoporous gold disk substrates

    by Ji Qi, Pratik Motwani, Mufaddal Gheewala, Christopher Brennan, John C. Wolfe, Wei-Chuan Shih

    Monolithic hierarchical nanoporous gold disks, 500 nm in diameter, 75 nm in thickness and 3.5 nm in pore radius, have been fabricated by hybrid processes. A surface-enhanced Raman scattering enhancement factor of at least 108 has been obtained on individual disks using benzenethiol self-assembled monolayer with 785 nm laser excitation.