Behruz Mirzayi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Behruz Mirzayi has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
- Ali Nematollahzadeh
Chemical Engineering Department, University of Mohaghegh Ardabili, Ardabil, Iran
4 shared publications Hadi Seyyedbagheri
4 shared publicationsAli Nematollahzadeh
2 shared publications- Amir Heydari
Department of Chemical Engineering, University of Mohaghegh Ardabili, Ardabil, Iran
2 shared publications - Mohammad Karimi
Dept. of Chemical Engineering, Faculty of Engineering, University of Mohaghegh Ardabili, Ardabil, Iran
2 shared publications A. Nematollahzadeh
Chemical Engineering Department, University of Mohaghegh Ardabili, P.O. Box 179, Ardabil, Iran
1 shared publication
Latest Publications
- 11 October 2026
- Published by Springer Nature in Journal of Polymers and the Environment
- Vol. 34 (11) , 270
A Developed Filtrate Regression Model for Polymers in Water-based Drilling Fluids: Application in Gas Reservoirs
- 11 October 2026
- Published by Springer Nature in Journal of Polymers and the Environment
- Vol. 34 (11) , 270
A Developed Filtrate Regression Model for Polymers in Water-based Drilling Fluids: Application in Gas Reservoirs
- 21 August 2025
- Published by Elsevier in Journal of the Indian Chemical Society
- Vol. 102 (10)
Chitosan-modified maghemite nanoparticles as an efficient bio-based adsorbent for the removal of lead (II) from aqueous solution
- 21 August 2025
- Published by Elsevier in Journal of the Indian Chemical Society
- Vol. 102 (10)
Chitosan-modified maghemite nanoparticles as an efficient bio-based adsorbent for the removal of lead (II) from aqueous solution
- 1 July 2025
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 65 (7) , 843-852
Viscosity Equations in Oil and Water Wells
The equations of viscosity and acid spending capacity characterize the performance of wellhead solvents and fluids, such as gasoil-water wellhead base fluids, and the types of wettability-altering solvents. This study evaluates the properties and interactions in the reservoir layers by deriving the viscosity equations for both oil and water layers. The results from these equations were then applied for the acid spending capacity and overburden pressure equations to demonstrate their role in the damage calculations (water block type) for different rock types. Focusing on the overburden pressure and water block effects, the study investigates the role of viscous and non-viscous chemicals and fluids in both causing and removing damages in various mineral compositions of the porous media. Finally, introducing these new equations, the study outlines key approaches for analyzing and calculating chemical characteristics and behavior in porous media under high-temperature and high-pressure conditions using field and experimental data as the example.
- 1 July 2025
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 65 (7) , 843-852
Viscosity Equations in Oil and Water Wells
The equations of viscosity and acid spending capacity characterize the performance of wellhead solvents and fluids, such as gasoil-water wellhead base fluids, and the types of wettability-altering solvents. This study evaluates the properties and interactions in the reservoir layers by deriving the viscosity equations for both oil and water layers. The results from these equations were then applied for the acid spending capacity and overburden pressure equations to demonstrate their role in the damage calculations (water block type) for different rock types. Focusing on the overburden pressure and water block effects, the study investigates the role of viscous and non-viscous chemicals and fluids in both causing and removing damages in various mineral compositions of the porous media. Finally, introducing these new equations, the study outlines key approaches for analyzing and calculating chemical characteristics and behavior in porous media under high-temperature and high-pressure conditions using field and experimental data as the example.
- 6 June 2025
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 64 (24) , 11911-11922
Dynamic Performance Analysis of Swellable Monolithic Hydrogel-Based Catalyst in Continuous Reaction Column
- 6 June 2025
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 64 (24) , 11911-11922
Dynamic Performance Analysis of Swellable Monolithic Hydrogel-Based Catalyst in Continuous Reaction Column
- 9 October 2024
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 103 (6) , 2603-2623
Application of MgO based‐nanofluid for controlling the growth of asphaltene flocs under static and micromodel dynamic conditions
In this study, the impact of magnesium oxide (MgO) nanoparticles on the control of asphaltene aggregates growth was examined. The investigation began with static testing, followed by dynamic testing, where nanofluid was injected into a constructed glass micromodel simulating a porous medium. The results obtained from light microscopy and asphaltene dispersant tests demonstrated that the MgO nanoparticles with an average diameter of 50 nm postpone the asphaltene onset point (AOP) and delay the growth of asphaltene aggregates in crude oil. Also, the results obtained from these experiments illustrated the performance of synthesized nanoparticles in various concentrations on inhibition of asphaltene deposit in the crude oil medium, in the order of 750 > 1500 > 100 > 1000 > 500 ppm. The results from both microscopy and ADT experiments strongly validate the effectiveness of MgO nanoparticles across varying concentrations, highlighting the optimal dosage of 750 ppm. Images of nanofluid flooding at the optimal concentration in the glass micromodel demonstrate effective nanoparticle inhibition and enhanced oil recovery from the porous medium. These findings corroborate the results obtained from ADT and microscopy tests. The results of FT‐IR analysis show the adsorption of asphaltene particles on the surfaces of MgO nanoparticles in wavelengths of 2900–3000 cm −1 . Moreover, dynamic light scattering (DLS) analysis results indicated that the average diameter of suspended particles was 3580 nm before adsorption and 6230 nm after adsorption, indicating the controlled adsorption of asphaltene onto the surface of MgO nanoparticles. The findings from this study can be applied to manage asphaltene formation across all stages of oil processing and production.
- 9 October 2024
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 103 (6) , 2603-2623
Application of MgO based‐nanofluid for controlling the growth of asphaltene flocs under static and micromodel dynamic conditions
In this study, the impact of magnesium oxide (MgO) nanoparticles on the control of asphaltene aggregates growth was examined. The investigation began with static testing, followed by dynamic testing, where nanofluid was injected into a constructed glass micromodel simulating a porous medium. The results obtained from light microscopy and asphaltene dispersant tests demonstrated that the MgO nanoparticles with an average diameter of 50 nm postpone the asphaltene onset point (AOP) and delay the growth of asphaltene aggregates in crude oil. Also, the results obtained from these experiments illustrated the performance of synthesized nanoparticles in various concentrations on inhibition of asphaltene deposit in the crude oil medium, in the order of 750 > 1500 > 100 > 1000 > 500 ppm. The results from both microscopy and ADT experiments strongly validate the effectiveness of MgO nanoparticles across varying concentrations, highlighting the optimal dosage of 750 ppm. Images of nanofluid flooding at the optimal concentration in the glass micromodel demonstrate effective nanoparticle inhibition and enhanced oil recovery from the porous medium. These findings corroborate the results obtained from ADT and microscopy tests. The results of FT‐IR analysis show the adsorption of asphaltene particles on the surfaces of MgO nanoparticles in wavelengths of 2900–3000 cm −1 . Moreover, dynamic light scattering (DLS) analysis results indicated that the average diameter of suspended particles was 3580 nm before adsorption and 6230 nm after adsorption, indicating the controlled adsorption of asphaltene onto the surface of MgO nanoparticles. The findings from this study can be applied to manage asphaltene formation across all stages of oil processing and production.
- 4 March 2024
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 399
Modeling and CFD simulation of photocatalytic removal of tetracycline by ZnO/PbBiO2Cl nanocomposite catalyst
- 4 March 2024
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 399
Modeling and CFD simulation of photocatalytic removal of tetracycline by ZnO/PbBiO2Cl nanocomposite catalyst
- 28 February 2024
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 21 (9) , 6553-6566
Highly efficient removal of MTBE using natural nanoporous adsorbents
- 28 February 2024
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 21 (9) , 6553-6566
Highly efficient removal of MTBE using natural nanoporous adsorbents
- 24 December 2021
- Published by Pleiades Publishing Ltd in Петролеомика
- Vol. 1 (1) , 127-136
Удаление асфальтенов из нефти в системе закольцованного потока с использованием наночастиц маггемита
В данной работе был исследован процесс адсорбции асфальтенов наноачастицами маггемита в системе flow-loop, которая воспроизводит реальный процесс. Для синтеза наночастиц магемита (γ-Fe2O3) был применен метод совместного осаждения ионов железа и оксида железа(III). Для адсорбции и удаления асфальтена из проб сырой нефти в системе потока были применены синтезированные наночастицы маггемита. Исследовано влияние времени контакта, концентрации наночастиц и скорости потока, на процесс адсорбции. Показано, что в эксперименте с системой flow-loop, скорость адсорбции асфальтенов наночастицами маггемита увеличивается с увеличением скорости нефти, времени контакта и концентрации наночастиц. Кинетические эксперименты также показали, что адсорбция асфальтена наночастицамми маггемита осуществляется по нелинейной модели Томаса, и равновесие может быть достигнуто менее чем за 4 ч.
- 24 December 2021
- Published by Pleiades Publishing Ltd in Петролеомика
- Vol. 1 (1) , 127-136
Удаление асфальтенов из нефти в системе закольцованного потока с использованием наночастиц маггемита
В данной работе был исследован процесс адсорбции асфальтенов наноачастицами маггемита в системе flow-loop, которая воспроизводит реальный процесс. Для синтеза наночастиц магемита (γ-Fe2O3) был применен метод совместного осаждения ионов железа и оксида железа(III). Для адсорбции и удаления асфальтена из проб сырой нефти в системе потока были применены синтезированные наночастицы маггемита. Исследовано влияние времени контакта, концентрации наночастиц и скорости потока, на процесс адсорбции. Показано, что в эксперименте с системой flow-loop, скорость адсорбции асфальтенов наночастицами маггемита увеличивается с увеличением скорости нефти, времени контакта и концентрации наночастиц. Кинетические эксперименты также показали, что адсорбция асфальтена наночастицамми маггемита осуществляется по нелинейной модели Томаса, и равновесие может быть достигнуто менее чем за 4 ч.