Hui-Jin Tao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hui-Jin Tao has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
Shan Zhou
School of Materials Science and Engineering, Central South University, Changsha, China
2 shared publicationsDongyang Zhang
School of Material Science and Engineering, Central South University, ChangSha, China
1 shared publicationHao Xu
School of Material Science and Engineering Central South University 410083 Changsha China
1 shared publicationJian Yin
State Key Laboratory for Powder Metallurgy Central South University 410083 Changsha China
1 shared publicationKe-Chen Zhang
School of Materials Science and Engineering, Central South University, Changsha, China
1 shared publicationMengyuan Zhang
School of Material Science and Engineering, Central South University, ChangSha, China
1 shared publication
Latest Publications
- 1 July 2019
- Published by Springer Nature in Journal of Central South University
- Vol. 26 (7) , 2011-2018
Influence of Ag on photocatalytic performance of Ag/ZnO nanosheet photocatalysts
- 1 July 2019
- Published by Springer Nature in Journal of Central South University
- Vol. 26 (7) , 2011-2018
Influence of Ag on photocatalytic performance of Ag/ZnO nanosheet photocatalysts
- 8 March 2018
- Published by Taylor & Francis in Materials Research Innovations
- Vol. 23 (5) , 247-252
Effects of different alkali metal ions on morphology and photocatalysis properties of ZnO crystals via hydrothermal method
With the precursor solution prepared by ZnSO4·7H2O and MOH (M = Li, Na or K), ZnO nanocrystals single doped with Li, Na, K and codoped with Na and K were prepared via a simple hydrothermal method. Their morphologies and structures were characterized by SEM, XRD, ICP, XPS and ultraviolet-visible spectrophotometer methods. It is found that the crystal morphology changes from the short bar shape to the long strip shape; Li+ is likely easier than Na+ and K+ to enter into the lattice to replace Zn2+ and inhibits the growth of positive polar plane while promotes the growth of negative one of ZnO in hydrothermal environment, leading to the morphology of short bars; K+ is easier than Li+ and Na+ to promote the two-dimensional nucleation and accelerate the axial growth of ZnO, leading to the morphology of long strips; Na+ and K+ have the obvious synergistic effect to facilitate the access to the lattice of ZnO. Experimental result of photocatalytic degradation of methylene blue shows that the ratio I of intensitiy of X-ray diffraction peak for (002) plane to that of (100) plane can reflect the relative area proportion of plane (002) with strong photocatalytic activity, and the photocatalytic effect may be better if the value of I is larger.
- 8 March 2018
- Published by Taylor & Francis in Materials Research Innovations
- Vol. 23 (5) , 247-252
Effects of different alkali metal ions on morphology and photocatalysis properties of ZnO crystals via hydrothermal method
With the precursor solution prepared by ZnSO4·7H2O and MOH (M = Li, Na or K), ZnO nanocrystals single doped with Li, Na, K and codoped with Na and K were prepared via a simple hydrothermal method. Their morphologies and structures were characterized by SEM, XRD, ICP, XPS and ultraviolet-visible spectrophotometer methods. It is found that the crystal morphology changes from the short bar shape to the long strip shape; Li+ is likely easier than Na+ and K+ to enter into the lattice to replace Zn2+ and inhibits the growth of positive polar plane while promotes the growth of negative one of ZnO in hydrothermal environment, leading to the morphology of short bars; K+ is easier than Li+ and Na+ to promote the two-dimensional nucleation and accelerate the axial growth of ZnO, leading to the morphology of long strips; Na+ and K+ have the obvious synergistic effect to facilitate the access to the lattice of ZnO. Experimental result of photocatalytic degradation of methylene blue shows that the ratio I of intensitiy of X-ray diffraction peak for (002) plane to that of (100) plane can reflect the relative area proportion of plane (002) with strong photocatalytic activity, and the photocatalytic effect may be better if the value of I is larger.
- 4 October 2017
- Published by Wiley in Rare Metals
- Vol. 37 (9) , 750-758
Morphology and photocatalytic performance of nano‐sized TiO 2 prepared by simple hydrothermal method with different pH values
PH value is a key factor in the preparation of nano‐sized TiO 2 with hydrothermal method. Using Ti(SO 4 ) 2 as the titanium source, H 2 O 2 as the complexing agent, NaOH and HCl as the pH value regulator, nano‐sized TiO 2 powder with various morphologies and sizes was synthesized. Changes in morphology, size and phase type with pH values of samples were characterized by X‐ray diffraction (XRD) and transmission electron microscopy (TEM) measurements. Results show that under the present preparation conditions, TiO 2 powder is an anatase phase with pH value less than 11, but is more likely to be a brookite phase with pH value more than 11. With the increase in pH value from 1 to 11 in hydrothermal environment, nano‐sized anatase TiO 2 gradually grows up in all directions. {001}, {101} and {100} groups of crystal plane are the exposed crystal planes of nano‐sized anatase TiO 2 for the (004), (101) and (200) facets found in high‐resolution TEM image. The photocatalytic performance of nano‐sized TiO 2 with different morphologies was compared by measuring their photocatalytic degradation rates for methylene blue under ultraviolet light. Results show that anatase TiO 2 prepared under the alkalescent hydrothermal environment (pH = 9, 11) has a better photocatalytic degrading performance. Different sizes and phases of nanoscaled TiO 2 powders with different photocatalytic performances can be prepared by the control of pH value of hydrothermal solutions.
- 4 October 2017
- Published by Wiley in Rare Metals
- Vol. 37 (9) , 750-758
Morphology and photocatalytic performance of nano‐sized TiO 2 prepared by simple hydrothermal method with different pH values
PH value is a key factor in the preparation of nano‐sized TiO 2 with hydrothermal method. Using Ti(SO 4 ) 2 as the titanium source, H 2 O 2 as the complexing agent, NaOH and HCl as the pH value regulator, nano‐sized TiO 2 powder with various morphologies and sizes was synthesized. Changes in morphology, size and phase type with pH values of samples were characterized by X‐ray diffraction (XRD) and transmission electron microscopy (TEM) measurements. Results show that under the present preparation conditions, TiO 2 powder is an anatase phase with pH value less than 11, but is more likely to be a brookite phase with pH value more than 11. With the increase in pH value from 1 to 11 in hydrothermal environment, nano‐sized anatase TiO 2 gradually grows up in all directions. {001}, {101} and {100} groups of crystal plane are the exposed crystal planes of nano‐sized anatase TiO 2 for the (004), (101) and (200) facets found in high‐resolution TEM image. The photocatalytic performance of nano‐sized TiO 2 with different morphologies was compared by measuring their photocatalytic degradation rates for methylene blue under ultraviolet light. Results show that anatase TiO 2 prepared under the alkalescent hydrothermal environment (pH = 9, 11) has a better photocatalytic degrading performance. Different sizes and phases of nanoscaled TiO 2 powders with different photocatalytic performances can be prepared by the control of pH value of hydrothermal solutions.
- 12 July 2011
- Published by Springer Nature in Journal of Phase Equilibria and Diffusion
- Vol. 32 (5) , 428-434
Research on the Lattice Stability of Elemental Be, Mg, Ca, Sr, Ba and Ra by the Ultra-Soft Pseudo-Potential Method in First Principles
- 12 July 2011
- Published by Springer Nature in Journal of Phase Equilibria and Diffusion
- Vol. 32 (5) , 428-434
Research on the Lattice Stability of Elemental Be, Mg, Ca, Sr, Ba and Ra by the Ultra-Soft Pseudo-Potential Method in First Principles