Thierry Woignier
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Thierry Woignier has a total of 98 co-authors. Here are the top co-authors by number of shared publications:
Florence Clostre
Cirad, UPR HortSys, F-97285, Le Lamentin, France
4 shared publications- Juan Primera
Departamento de Fisica, FEC, LUZ, 4011 Maracaibo, Venezuela
4 shared publications L. Duffours
Montpellier, France Le Lamentin
4 shared publicationsLaurent Duffours
Prime Verre, Montpellier, France
4 shared publications- Annelise Faivre
Laboratoire Charles Coulomb, Université Montpellier 2, Place E. Bataillon, CEDEX 5, 34095 Montpellier, France
3 shared publications J. Phalippou
Laboratoire Charles Coulomb, Montpellier Université
3 shared publications
Latest Publications
- 14 May 2022
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 102 (3) , 589-595
Porous glasses from aerogels: from organic liquid to mineral materials
- 14 May 2022
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 102 (3) , 589-595
Porous glasses from aerogels: from organic liquid to mineral materials
- Open Access
Fractal Structure in Silica and Composites Aerogels
Silica aerogels are known to be materials with exceptional characteristics, such as ultra-low density, high surface area, high porosity, high adsorption, and low-thermal conductivity. In addition, these unique properties are mainly related to their specific processing. Depending on the aerogel synthesis procedure, the aerogels texture can be tailored with meso and/or macroporosity. Fractal geometry has been observed and used to describe silica aerogels at nanoscales in certain conditions. In this review paper, we describe the fractal structure of silica aerogels that can develop depending on the synthesis conditions. X-ray and neutron scattering measurements allow to show that silica aerogels can exhibit a fractal structure over one or even more than two orders of magnitude in length. The fractal dimension does not depend directly on the material density but can vary with the synthesis conditions. It ranges typically between 1.6 and 2.4. The effect of the introduction of silica particles or of further thermal treatment or compression of the silica aerogels on their microstructure and their fractal characteristics is also resumed.
Open AccessFractal Structure in Silica and Composites Aerogels
Silica aerogels are known to be materials with exceptional characteristics, such as ultra-low density, high surface area, high porosity, high adsorption, and low-thermal conductivity. In addition, these unique properties are mainly related to their specific processing. Depending on the aerogel synthesis procedure, the aerogels texture can be tailored with meso and/or macroporosity. Fractal geometry has been observed and used to describe silica aerogels at nanoscales in certain conditions. In this review paper, we describe the fractal structure of silica aerogels that can develop depending on the synthesis conditions. X-ray and neutron scattering measurements allow to show that silica aerogels can exhibit a fractal structure over one or even more than two orders of magnitude in length. The fractal dimension does not depend directly on the material density but can vary with the synthesis conditions. It ranges typically between 1.6 and 2.4. The effect of the introduction of silica particles or of further thermal treatment or compression of the silica aerogels on their microstructure and their fractal characteristics is also resumed.
- 14 November 2019
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 93 (1) , 6-27
Techniques for characterizing the mechanical properties of aerogels
- 14 November 2019
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 93 (1) , 6-27
Techniques for characterizing the mechanical properties of aerogels
- 29 July 2019
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 27 (33) , 40980-40991
Physical limitation of pesticides (chlordecone) decontamination in volcanic soils: fractal approach and numerical simulation
In the French West Indies, the chlordecone (organochloride pesticide) pollution is now diffuse becoming new contamination source for crops and environment (water, trophic chain). Decontamination by bioremediation and chemical degradation are still under development but the physical limitations of these approaches are generally not taken into account. These physical limitations are related to the poor physical accessibility to the pesticides in soils because of the peculiar structural properties of the contaminated clays (pore volume, transport properties, permeability, and diffusion). Some volcanic soils (andosols), which represent the half of the contaminated soils in Martinique, contain nanoclay (allophane) with a unique structure and porous properties. Andosols are characterized by pore size distribution in the mesoporous range, a high specific surface area, a large pore volume, and a fractal structure. Our hypothesis is that the clay microstructure characteristics are crucial physico-chemical factors strongly limiting the remediation of the pesticide. Our results show that allophane microstructure (small pore size, hierarchical microstructure, and tortuosity) favors accumulation of chlordecone, in andosols. Moreover, the clay microporosity limits the accessibility of microorganisms and chemical species able to decontaminate because of poor transport properties (permeability and diffusion). We model the transport properties by two approaches: (1) we use a numerical model to simulate the structure of allophane aggregates. The algorithm is based on a cluster–cluster aggregation model. From the simulated data, we derived the pore volume, specific surface area, tortuosity, permeability, and diffusion. We show that transport properties strongly decrease because of the presence of allophane. (2) The fractal approach. We characterize the fractal features (size of the fractal aggregate, fractal dimension, tortuosity inside allophane aggregates) and we calculate that transport properties decrease of several order ranges inside the clay aggregates. These poor transport properties are important parameters to explain the poor accessibility to pollutants in volcanic soils and should be taken into account by future decontamination process. We conclude that for andosols, this inaccessibility could render inefficient some of the methods proposed in the literature.
- 29 July 2019
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 27 (33) , 40980-40991
Physical limitation of pesticides (chlordecone) decontamination in volcanic soils: fractal approach and numerical simulation
In the French West Indies, the chlordecone (organochloride pesticide) pollution is now diffuse becoming new contamination source for crops and environment (water, trophic chain). Decontamination by bioremediation and chemical degradation are still under development but the physical limitations of these approaches are generally not taken into account. These physical limitations are related to the poor physical accessibility to the pesticides in soils because of the peculiar structural properties of the contaminated clays (pore volume, transport properties, permeability, and diffusion). Some volcanic soils (andosols), which represent the half of the contaminated soils in Martinique, contain nanoclay (allophane) with a unique structure and porous properties. Andosols are characterized by pore size distribution in the mesoporous range, a high specific surface area, a large pore volume, and a fractal structure. Our hypothesis is that the clay microstructure characteristics are crucial physico-chemical factors strongly limiting the remediation of the pesticide. Our results show that allophane microstructure (small pore size, hierarchical microstructure, and tortuosity) favors accumulation of chlordecone, in andosols. Moreover, the clay microporosity limits the accessibility of microorganisms and chemical species able to decontaminate because of poor transport properties (permeability and diffusion). We model the transport properties by two approaches: (1) we use a numerical model to simulate the structure of allophane aggregates. The algorithm is based on a cluster–cluster aggregation model. From the simulated data, we derived the pore volume, specific surface area, tortuosity, permeability, and diffusion. We show that transport properties strongly decrease because of the presence of allophane. (2) The fractal approach. We characterize the fractal features (size of the fractal aggregate, fractal dimension, tortuosity inside allophane aggregates) and we calculate that transport properties decrease of several order ranges inside the clay aggregates. These poor transport properties are important parameters to explain the poor accessibility to pollutants in volcanic soils and should be taken into account by future decontamination process. We conclude that for andosols, this inaccessibility could render inefficient some of the methods proposed in the literature.
- Open Access
- 2 April 2019
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 90 (1) , 1
Preface
- 2 April 2019
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 90 (1) , 1
Open AccessPreface
- Open Access
- 1 January 2019
- Published by The Company of Biologists in Biology Open
- Vol. 8 (12)
Fine scale geographic residence and annual primary production drive body condition of wild immature green turtles (Chelonia mydas) in Martinique Island (Lesser Antilles)
The change of animal biometrics (body mass and body size) can reveal important information about their living environment as well as determine the survival potential and reproductive success of individuals and thus the persistence of populations. However, weighing individuals like marine turtles in the field presents important logistical difficulties. In this context, estimating body mass based on body size is a crucial issue. Furthermore, the determinants of the variability of the parameters for this relationship can provide information about the quality of the environment and the manner in which individuals exploit the available resources. This is of particular importance in young individuals which growth quality might be a determinant of adult fitness. Our study aimed to validate the use of different body measurements to estimate body mass, which can be difficult to obtain in the field, and explore the determinants of the relationship between body mass and size in juvenile green turtles. Juvenile green turtles were caught, measured, and weighed for six years (2011-2012; 2015-2018) at six bays in the west of Martinique Island (Lesser Antilles). Using different datasets from this global database, we were able to show that the body mass of individuals can be predicted from body measurements with an error of less than 2%. We built several dataset including different morphological and time-location information to test the accuracy of the mass prediction. We show a year and north-south pattern for the relationship between body mass and body measurements. The year effect for the relationship of body mass and size is strongly correlated with net primary production but not with sea surface temperature or cyclonic events. We also found that if the bay locations and year effects were removed from the analysis, the mass prediction degraded slightly but was still less than 3% on average. Further investigations of the feeding habitats in Martinique are still needed to better understand these effects and to link them with geographic and oceanographic conditions.
- 1 January 2019
- Published by The Company of Biologists in Biology Open
- Vol. 8 (12)
Open AccessFine scale geographic residence and annual primary production drive body condition of wild immature green turtles (Chelonia mydas) in Martinique Island (Lesser Antilles)
The change of animal biometrics (body mass and body size) can reveal important information about their living environment as well as determine the survival potential and reproductive success of individuals and thus the persistence of populations. However, weighing individuals like marine turtles in the field presents important logistical difficulties. In this context, estimating body mass based on body size is a crucial issue. Furthermore, the determinants of the variability of the parameters for this relationship can provide information about the quality of the environment and the manner in which individuals exploit the available resources. This is of particular importance in young individuals which growth quality might be a determinant of adult fitness. Our study aimed to validate the use of different body measurements to estimate body mass, which can be difficult to obtain in the field, and explore the determinants of the relationship between body mass and size in juvenile green turtles. Juvenile green turtles were caught, measured, and weighed for six years (2011-2012; 2015-2018) at six bays in the west of Martinique Island (Lesser Antilles). Using different datasets from this global database, we were able to show that the body mass of individuals can be predicted from body measurements with an error of less than 2%. We built several dataset including different morphological and time-location information to test the accuracy of the mass prediction. We show a year and north-south pattern for the relationship between body mass and body measurements. The year effect for the relationship of body mass and size is strongly correlated with net primary production but not with sea surface temperature or cyclonic events. We also found that if the bay locations and year effects were removed from the analysis, the mass prediction degraded slightly but was still less than 3% on average. Further investigations of the feeding habitats in Martinique are still needed to better understand these effects and to link them with geographic and oceanographic conditions.
- 26 September 2018
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 90 (1) , 76-86
Sintering of aerogels for glass synthesis
- 26 September 2018
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 90 (1) , 76-86
Sintering of aerogels for glass synthesis
- 1 June 2018
- Published by Springer Nature
- p. 1487-1512
Evolution of the Mechanical Properties During the Gel–Glass Process
- 1 June 2018
- Published by Springer Nature
- p. 1487-1512
Evolution of the Mechanical Properties During the Gel–Glass Process