Ramendra Singh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Interests
Ramendra Singh has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Abhisek Dixit
Department of Electrical Engineering, Indian Institute of Technology Delhi, New Delhi, India
4 shared publications - Anil Kumar Bansal
Department of Electrical Engineering, Indian Institute of Technology Delhi, New Delhi 110 016, India
2 shared publications - Anshul Gupta
Department of Electrical Engineering, IIT Delhi, New Delhi 110016, India
2 shared publications - Charu Gupta
Department of Electrical Engineering, IIT Delhi, New Delhi 110016, India
2 shared publications Terence B. Hook
IBM Research, Albany, NY 12203 USA
2 shared publicationsAnabela Veloso
IMEC, 3001 Leuven, Belgium
1 shared publication
Latest Publications
- 9 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 66 (8) , 3279-3285
Experimental Evaluation of Self-Heating and Analog/RF FOM in GAA-Nanowire FETs
In this paper, we report the characterization and modeling of multi-finger gate all around (GAA) nanowire (NW) FETs (NWFETs) from dc to 14 GHz. The self-heating effect (SHE) in NWFETs is investigated experimentally using the small-signal output conductance (gds) technique. The frequency-dependent complex thermal impedance, Zth(f), is extracted by fitting an nth-order thermal network with the experimental data. We show that the temperature rise Δ T (=85 °C) due to SHE is significant in short-channel silicon on insulator (SOI) NWFETs. Finally, we have evaluated the RF figure of merit (FOM) for these NWFETs as fT (=70 GHz) and fmax (=80 GHz). We also report the RF performance metric sensitivity on temperature, ∂ fmax/∂ Tamb (≈ -0.104 GHz/K). The reported BSIM-CMG compact model shows a good correlation with the measurement data.
- 9 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 66 (8) , 3279-3285
Experimental Evaluation of Self-Heating and Analog/RF FOM in GAA-Nanowire FETs
In this paper, we report the characterization and modeling of multi-finger gate all around (GAA) nanowire (NW) FETs (NWFETs) from dc to 14 GHz. The self-heating effect (SHE) in NWFETs is investigated experimentally using the small-signal output conductance (gds) technique. The frequency-dependent complex thermal impedance, Zth(f), is extracted by fitting an nth-order thermal network with the experimental data. We show that the temperature rise Δ T (=85 °C) due to SHE is significant in short-channel silicon on insulator (SOI) NWFETs. Finally, we have evaluated the RF figure of merit (FOM) for these NWFETs as fT (=70 GHz) and fmax (=80 GHz). We also report the RF performance metric sensitivity on temperature, ∂ fmax/∂ Tamb (≈ -0.104 GHz/K). The reported BSIM-CMG compact model shows a good correlation with the measurement data.
- 11 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 39 (8) , 1246-1249
Evaluation of 10-nm Bulk FinFET RF Performance—Conventional Versus NC-FinFET
In this letter, we have investigated RF performance of a negative capacitance FinFET (NC-FinFET) using BSIM-CMG compact model extracted from DC and RF measured data of 10nm technology node devices. This physics-based RF model is then coupled self-consistently with the Landau-Khalatnikov equation to obtain the RF NC-FinFET model. For the first time, we report here the impact of ferroelectric thickness (tfe) scaling on RF performance of NC-FinFET and find that NC-FinFET’s cut-off frequency (fT) is a function of tfe. We also observe that self-heating effect in NC-FinFET increases with increase in tfe, mainly due to increase in DC current, which can be easily compensated by decreasing supply voltage. Finally, we show that NC-FinFET can achieve similar analog/RF performance as the base FinFET, even at a reduced VDD.
- 11 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 39 (8) , 1246-1249
Evaluation of 10-nm Bulk FinFET RF Performance—Conventional Versus NC-FinFET
In this letter, we have investigated RF performance of a negative capacitance FinFET (NC-FinFET) using BSIM-CMG compact model extracted from DC and RF measured data of 10nm technology node devices. This physics-based RF model is then coupled self-consistently with the Landau-Khalatnikov equation to obtain the RF NC-FinFET model. For the first time, we report here the impact of ferroelectric thickness (tfe) scaling on RF performance of NC-FinFET and find that NC-FinFET’s cut-off frequency (fT) is a function of tfe. We also observe that self-heating effect in NC-FinFET increases with increase in tfe, mainly due to increase in DC current, which can be easily compensated by decreasing supply voltage. Finally, we show that NC-FinFET can achieve similar analog/RF performance as the base FinFET, even at a reduced VDD.
- 7 February 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 65 (3) , 1246-1252
3-D LER and RDF Matching Performance of Nanowire FETs in Inversion, Accumulation, and Junctionless Modes
Nanowire field-effect transistors (NWFETs) have emerged as promising candidates for realization of advanced CMOS technology nodes. Due to small nanowire dimensions, NWFETs are vulnerable to the impact of process-induced random local variations, such as the line edge roughness (LER) and random dopant fluctuation (RDF). NWFETs have three different device modes, namely, the inversion mode (IM), the accumulation mode (AM), and the junctionless (JL) mode. In this paper, a 3-D quasi-atomistic LER model is used for the analysis of LER-induced mismatch in JL, IM, and AM NWFETs. We have also compared the impact of 3-D LER with that of 2-D LER. In addition, another emerging simulation methodology known as statistical impedance field method is utilized to analyze the impact of RDF on the three flavors of NWFETs. We show that JL NWFETs have much higher mismatch due to both LER and RDF than their IM and AM NWFET counterparts with otherwise identical device structure.
- 7 February 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 65 (3) , 1246-1252
3-D LER and RDF Matching Performance of Nanowire FETs in Inversion, Accumulation, and Junctionless Modes
Nanowire field-effect transistors (NWFETs) have emerged as promising candidates for realization of advanced CMOS technology nodes. Due to small nanowire dimensions, NWFETs are vulnerable to the impact of process-induced random local variations, such as the line edge roughness (LER) and random dopant fluctuation (RDF). NWFETs have three different device modes, namely, the inversion mode (IM), the accumulation mode (AM), and the junctionless (JL) mode. In this paper, a 3-D quasi-atomistic LER model is used for the analysis of LER-induced mismatch in JL, IM, and AM NWFETs. We have also compared the impact of 3-D LER with that of 2-D LER. In addition, another emerging simulation methodology known as statistical impedance field method is utilized to analyze the impact of RDF on the three flavors of NWFETs. We show that JL NWFETs have much higher mismatch due to both LER and RDF than their IM and AM NWFET counterparts with otherwise identical device structure.
- 27 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 64 (12) , 5274-5278
Analytical Modeling of Parasitic Capacitance in Inserted-Oxide FinFETs
An analytical model of parasitic capacitance in inserted-oxide FinFETs (iFinFETs) is proposed. A comparative study on the parasitic capacitance of contemporary multigate devices conforming to 7-nm technology node targets is presented. The proposed model is validated against 3-D Technology Computer-Aided Design (TCAD) simulations. Dependence of the iFinFET parasitic capacitance on device design parameters, such as the inserted-oxide thickness (${T}_{\textsf {iox}}$ ) and inserted-oxide recess (${T}_{\textsf {rec}}$ ), is shown using the proposed model and TCAD simulations.- 27 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 64 (12) , 5274-5278
Analytical Modeling of Parasitic Capacitance in Inserted-Oxide FinFETs
An analytical model of parasitic capacitance in inserted-oxide FinFETs (iFinFETs) is proposed. A comparative study on the parasitic capacitance of contemporary multigate devices conforming to 7-nm technology node targets is presented. The proposed model is validated against 3-D Technology Computer-Aided Design (TCAD) simulations. Dependence of the iFinFET parasitic capacitance on device design parameters, such as the inserted-oxide thickness (${T}_{\textsf {iox}}$ ) and inserted-oxide recess (${T}_{\textsf {rec}}$ ), is shown using the proposed model and TCAD simulations.