Majid Afsahi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Majid Afsahi has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Mohammad Danaie
Faculty of Electrical and Computer Engineering, Semnan University, Semnan, Iran
4 shared publications - Alireza Ghayekhloo
University of Quebec in Outaouais (UQO),Department of Computer Science and Engineering,Gatineau,QC,Canada
3 shared publications - Mohammad Mahdi Ghods
Department of Electrical and Computer Engineering, Semnan University, Semnan, Iran
3 shared publications Abolfazl Vaghayei
Faculty of Electrical and Computer Engineering, Semnan University, Semnan, Iran
2 shared publications- Ali Asghar Orouji
Department of Electrical and Computer Engineering, Semnan University, Semnan 35131-19111, Iran
2 shared publications - Mahdiye Rahmatiyar
Electrical and Computer Engineering Faculty, Semnan University, Semnan, Iran
2 shared publications
Latest Publications
- Open Access
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 151544-151556
Design of 4×4 and 8×8 Ultra-Wideband Butler Matrices Employing Hexagonal-Shaped Couplers and Phase Shifters
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 151544-151556
Open AccessDesign of 4×4 and 8×8 Ultra-Wideband Butler Matrices Employing Hexagonal-Shaped Couplers and Phase Shifters
- 15 October 2025
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 125 (3) , 1-9
Design of miniaturized graphene-based reconfigurable fourth-order quasi-elliptic SIW filter in the THz band
- 15 October 2025
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 125 (3) , 1-9
Design of miniaturized graphene-based reconfigurable fourth-order quasi-elliptic SIW filter in the THz band
- 6 August 2025
- Published by Springer Nature in Plasmonics
- Vol. 20 (12) , 11811-11819
Utilization of a Dual-Layer Graphene Structure for Slow Light Engineering in the Terahertz Band
- 6 August 2025
- Published by Springer Nature in Plasmonics
- Vol. 20 (12) , 11811-11819
Utilization of a Dual-Layer Graphene Structure for Slow Light Engineering in the Terahertz Band
- 4 July 2025
- Published by Springer Nature in Sensing and Imaging
- Vol. 26 (1) , 1-26
Plasmonic Metal–Insulator–Metal Filter and Refractive Index Sensor Based on Semi-Rings Coupled to a Disk Resonator
- 4 July 2025
- Published by Springer Nature in Sensing and Imaging
- Vol. 26 (1) , 1-26
Plasmonic Metal–Insulator–Metal Filter and Refractive Index Sensor Based on Semi-Rings Coupled to a Disk Resonator
- Open Access
- 20 June 2025
- Published by Springer Nature in Research Square
Utilization of a Dual-Layer Graphene Structure for Slow Light Engineering in the Terahertz Band
The proposed structure comprises a unit cell with two dielectric substrates: SiO2 and nine graphene disks, positioned on the lower substrate. Additionally, a square patch of graphene is situated on the upper substrate. The conductive behavior of graphene at terahertz frequencies is described using a specialized model. The impedance and electrical characteristics of this structure are modeled through RLC relationships, and simulations have been conducted to analyze the interaction of terahertz waves with the structure. The results indicate that the Fermi energy of graphene can influence the resonance frequency of the structure, leading to variations in optical properties such as group delay and group velocity. Overall, the findings of this research highlight the potential for optical control and tuning in the terahertz band utilizing graphene and its metamaterials, presenting strategic capabilities for telecommunications and photonic applications.
- 20 June 2025
- Published by Springer Nature in Research Square
Open AccessUtilization of a Dual-Layer Graphene Structure for Slow Light Engineering in the Terahertz Band
The proposed structure comprises a unit cell with two dielectric substrates: SiO2 and nine graphene disks, positioned on the lower substrate. Additionally, a square patch of graphene is situated on the upper substrate. The conductive behavior of graphene at terahertz frequencies is described using a specialized model. The impedance and electrical characteristics of this structure are modeled through RLC relationships, and simulations have been conducted to analyze the interaction of terahertz waves with the structure. The results indicate that the Fermi energy of graphene can influence the resonance frequency of the structure, leading to variations in optical properties such as group delay and group velocity. Overall, the findings of this research highlight the potential for optical control and tuning in the terahertz band utilizing graphene and its metamaterials, presenting strategic capabilities for telecommunications and photonic applications.
- 10 September 2024
- Published by IOP Publishing in Physica Scripta
- Vol. 99 (10) , 105535
A wide angle beam scanning CRLH leaky-wave antenna with non-identical elements per unit-cells
In this research article, a wide-angle scanning leaky-wave antenna (LWA) based on the composite right/left-handed (CRLH) metamaterial (MTM) operating over the C-band spectrum for mobile applications is proposed, investigated, and realized. The proposed LWA includes nine CRLH-MTM-based unit-cells. The properties of CRLH-MTM have been applied using series slots and shunt metallic via-holes. Each unit cell consists of three patches, two external patches, and one smaller middle patch implemented between them. One slot has been etched on each external patch; the width of these two slots is unequal. Moreover, the distance of the middle patch with each side patch is different. The results show that using this method of realizing non-identical elements caused the achievement of proper return-loss at the transition frequency and provided the balanced CRLH metamaterial condition. Additionally, using CRLH-MTM properties by realizing series capacitance (slot) and shunt inductance (via-holes) made the wide-angle scant from backward to forward radiation pattern. The results demonstrate that the LW antenna with small dimensions of 251.5 × 30 × 1.575 mm3 operates over a frequency range of 4.8–6.13 GHz covering a wide beam scanning range from − 63 ° to + 6 5 ° with broadside radiation at the center frequency of 5.46 GHz. The radiation gain of the proposed antenna varies from 6.2–13.1 dB. The achievements confirm the effectiveness of the proposed methods to realize a high-performance LW-antenna with the advantages of simple design, low profile, low cost, and easy of manufacture for mobile applications.
- 10 September 2024
- Published by IOP Publishing in Physica Scripta
- Vol. 99 (10) , 105535
A wide angle beam scanning CRLH leaky-wave antenna with non-identical elements per unit-cells
In this research article, a wide-angle scanning leaky-wave antenna (LWA) based on the composite right/left-handed (CRLH) metamaterial (MTM) operating over the C-band spectrum for mobile applications is proposed, investigated, and realized. The proposed LWA includes nine CRLH-MTM-based unit-cells. The properties of CRLH-MTM have been applied using series slots and shunt metallic via-holes. Each unit cell consists of three patches, two external patches, and one smaller middle patch implemented between them. One slot has been etched on each external patch; the width of these two slots is unequal. Moreover, the distance of the middle patch with each side patch is different. The results show that using this method of realizing non-identical elements caused the achievement of proper return-loss at the transition frequency and provided the balanced CRLH metamaterial condition. Additionally, using CRLH-MTM properties by realizing series capacitance (slot) and shunt inductance (via-holes) made the wide-angle scant from backward to forward radiation pattern. The results demonstrate that the LW antenna with small dimensions of 251.5 × 30 × 1.575 mm3 operates over a frequency range of 4.8–6.13 GHz covering a wide beam scanning range from − 63 ° to + 6 5 ° with broadside radiation at the center frequency of 5.46 GHz. The radiation gain of the proposed antenna varies from 6.2–13.1 dB. The achievements confirm the effectiveness of the proposed methods to realize a high-performance LW-antenna with the advantages of simple design, low profile, low cost, and easy of manufacture for mobile applications.
- 22 October 2023
- Published by Springer Nature in Brazilian Journal of Physics
- Vol. 53 (6) , 1-10
A Narrowband Optical Perfect Absorber and Refractive Index Sensor Based on an Epsilon-Near-Zero Metamaterial Using Ag-Ge-Si Nanowires
- 22 October 2023
- Published by Springer Nature in Brazilian Journal of Physics
- Vol. 53 (6) , 1-10
A Narrowband Optical Perfect Absorber and Refractive Index Sensor Based on an Epsilon-Near-Zero Metamaterial Using Ag-Ge-Si Nanowires
- 4 July 2023
- Published by Springer Nature in Journal of Computational Electronics
- Vol. 22 (4) , 1038-1047
Stepped graphene-covered plasmonic dipole antenna for detecting $\text {NO}_2$ gas at mid-infrared frequencies- 4 July 2023
- Published by Springer Nature in Journal of Computational Electronics
- Vol. 22 (4) , 1038-1047
Stepped graphene-covered plasmonic dipole antenna for detecting $\text {NO}_2$ gas at mid-infrared frequencies- 19 December 2022
- Published by Springer Nature in Plasmonics
- Vol. 18 (1) , 255-270
Optical Refractive Index Sensors Based on Plasmon-Induced Transparency phenomenon in a Plasmonic Waveguide Coupled to Stub and Nano-disk Resonators
- 19 December 2022
- Published by Springer Nature in Plasmonics
- Vol. 18 (1) , 255-270
Optical Refractive Index Sensors Based on Plasmon-Induced Transparency phenomenon in a Plasmonic Waveguide Coupled to Stub and Nano-disk Resonators
- 3 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nanobioscience
- Vol. 22 (1) , 143-148
Ultra-Sensitive Absorption-Based Gas Detecting Using Graphene-Covered Periodic Photonic Crystal Slabs Resonating Under Critical Coupling Condition at Mid-Infrared Frequencies
In this paper, a novel chemical sensor is presented based on graphene deposited on the periodic pattern of the photonic crystal. The sensor structure is very simple to fabricate. Also, the proposed sensor thickness in the order of the nanometer makes it compact and suitable for integrating with optical equipment. The principle of sensing is based on the doping process of graphene due to the adsorption of the chemical molecules that serve as charge carriers. The sensor action under critical coupling results in generating the mid-infrared fano-resonance of the half-absorption band. Then, manipulating the graphene Fermi energy and geometrical parameters, a high quality factor can be attained in the resonance frequency that can provide the sensing possibility through the wavelength interrogation method. The results demonstrate that the proposed sensor can detect the chemicals with spectral shifts of ${10} \textit {pm}$ for steps of 5 charge carriers which is equal to a resolution smaller than ${0}.{1}\textit {ppm}$ . Compared with other types of chemical graphene-based sensors employing optical fibers and plasmonic Fabry-Perot cavity, high resolution and sensitivity as well as the very simple geometry of the proposed sensing structure make it a promising candidate for ultra-sensitive chemical and biochemical detection.
- 3 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nanobioscience
- Vol. 22 (1) , 143-148
Ultra-Sensitive Absorption-Based Gas Detecting Using Graphene-Covered Periodic Photonic Crystal Slabs Resonating Under Critical Coupling Condition at Mid-Infrared Frequencies
In this paper, a novel chemical sensor is presented based on graphene deposited on the periodic pattern of the photonic crystal. The sensor structure is very simple to fabricate. Also, the proposed sensor thickness in the order of the nanometer makes it compact and suitable for integrating with optical equipment. The principle of sensing is based on the doping process of graphene due to the adsorption of the chemical molecules that serve as charge carriers. The sensor action under critical coupling results in generating the mid-infrared fano-resonance of the half-absorption band. Then, manipulating the graphene Fermi energy and geometrical parameters, a high quality factor can be attained in the resonance frequency that can provide the sensing possibility through the wavelength interrogation method. The results demonstrate that the proposed sensor can detect the chemicals with spectral shifts of ${10} \textit {pm}$ for steps of 5 charge carriers which is equal to a resolution smaller than ${0}.{1}\textit {ppm}$ . Compared with other types of chemical graphene-based sensors employing optical fibers and plasmonic Fabry-Perot cavity, high resolution and sensitivity as well as the very simple geometry of the proposed sensing structure make it a promising candidate for ultra-sensitive chemical and biochemical detection.