Zhenglong Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Zhenglong Li has a total of 258 co-authors. Here are the top co-authors by number of shared publications:
Junyan Zhang
Chemical Sciences Division
12 shared publicationsYanran Cui
Institute of Zhejiang University-Quzhou
12 shared publicationsKinga A. Unocic
Department of Materials Science and Engineering NC State University Raleigh NC 27695 USA
7 shared publicationsDennis J. Miller
6 shared publicationsEvan C. Wegener
Chemical Science and Engineering Division Argonne National Laboratory Lemont IL 60439 USA
6 shared publicationsMeijun Li
Manufacturing Science Division Oak Ridge National Laboratory Oak Ridge TN 37830 USA
6 shared publications
Latest Publications
A Flooding‐Resistant Fluorinated Methacrylate Polymer for Enhanced CO 2 Electroreduction to Ethylene
The electrochemical reduction of CO 2 to ethylene offers a sustainable approach for the chemical industry and greenhouse gas mitigation. However, the widely used perfluorosulfonic acid (PFSA) binder is prone to causing catalyst layer flooding due to its excessive hydrophilicity and insufficient electro‐wetting resistance. To address these limitations, we introduced a fluorinated methacrylate polymer (FMP), a low‐cost hydrophobic film‐forming agent commonly used for protective coatings on semiconductors, as a novel hydrophobic binder into the catalyst layer. Through multiple characterizations, we show that FMP, with its high fluorine content and absence of hydrophilic groups, imparts durable hydrophobicity and high electro‐wetting resistance to the catalyst layer, thereby enhancing CO 2 transport while suppressing water accessibility. The incorporation of FMP into the catalyst layer enables enhanced CO 2 electroreduction performance in a membrane electrode assembly system. Compared to the conventional PFSA‐based catalyst layer, the FMP‐modified electrode delivers an enhanced ethylene Faradaic efficiency of 71.2% at a high current density of 400 mA cm −2 . Moreover, the electrode exhibits high operational durability, maintaining stable ethylene selectivity for over 50 h. The introduction of FMP effectively alleviates the long‐standing flooding issue in CO 2 electroreduction.
A Flooding‐Resistant Fluorinated Methacrylate Polymer for Enhanced CO 2 Electroreduction to Ethylene
The electrochemical reduction of CO 2 to ethylene offers a sustainable approach for the chemical industry and greenhouse gas mitigation. However, the widely used perfluorosulfonic acid (PFSA) binder is prone to causing catalyst layer flooding due to its excessive hydrophilicity and insufficient electro‐wetting resistance. To address these limitations, we introduced a fluorinated methacrylate polymer (FMP), a low‐cost hydrophobic film‐forming agent commonly used for protective coatings on semiconductors, as a novel hydrophobic binder into the catalyst layer. Through multiple characterizations, we show that FMP, with its high fluorine content and absence of hydrophilic groups, imparts durable hydrophobicity and high electro‐wetting resistance to the catalyst layer, thereby enhancing CO 2 transport while suppressing water accessibility. The incorporation of FMP into the catalyst layer enables enhanced CO 2 electroreduction performance in a membrane electrode assembly system. Compared to the conventional PFSA‐based catalyst layer, the FMP‐modified electrode delivers an enhanced ethylene Faradaic efficiency of 71.2% at a high current density of 400 mA cm −2 . Moreover, the electrode exhibits high operational durability, maintaining stable ethylene selectivity for over 50 h. The introduction of FMP effectively alleviates the long‐standing flooding issue in CO 2 electroreduction.
- 21 September 2026
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 16 (18) , 5995-6003
Overcoming steric hindrance in furan ring-opening: high-yield 1,5-pentanediol from furfural through rational design of reactant adsorption configuration
Precise introduction of oxygen defects and basic sites on the surface to overcome steric hindrance during the furan ring-opening reaction.
- 21 September 2026
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 16 (18) , 5995-6003
Overcoming steric hindrance in furan ring-opening: high-yield 1,5-pentanediol from furfural through rational design of reactant adsorption configuration
Precise introduction of oxygen defects and basic sites on the surface to overcome steric hindrance during the furan ring-opening reaction.
- Open Access
- 30 June 2026
- Published by Springer Nature in Nature Communications
- Vol. 17 (1)
Scalable ampere-level CO2 electroreduction to ethylene enabled by descriptor-guided oxygen affinity engineering
The electroreduction of CO2 to ethylene using renewable electricity offers a sustainable approach for greenhouse gas mitigation. However, the efficient ethylene production is challenged by sluggish C-C coupling and wide product distribution. Guided the energy changes associated with C-C coupling and C-O cleavage as descriptors for ethylene electrosynthesis, we predict and synthesize unsaturated MgO1-x anchored on Cu via an electrochemical-induced phase separation method. Electrochemical evaluation of this catalyst achieves an ethylene Faradaic efficiency of 78.2% at 300 mA cm-2 in a flow cell. Mechanism studies reveal the bifunctionality of MgO1-x. On one side, chemical interaction of MgO1-x with Cu domain stabilizes Cu+ and gives asymmetric Cu+···Cu0 pairs, facilitating the *CO-CHO coupling. On another side, the MgO1-x with high oxygen affinity strengthens the binding with dual-carbon intermediate and promotes the C-O bond dissociation, accelerating ethylene formation. Ultimately, this catalyst delivers 60.7% ethylene selectivity at 25 A in membrane electrode assembly of 100 cm2, equivalent to a C2H4 production rate of 1.1 L h-1.
- 30 June 2026
- Published by Springer Nature in Nature Communications
- Vol. 17 (1)
Open AccessScalable ampere-level CO2 electroreduction to ethylene enabled by descriptor-guided oxygen affinity engineering
The electroreduction of CO2 to ethylene using renewable electricity offers a sustainable approach for greenhouse gas mitigation. However, the efficient ethylene production is challenged by sluggish C-C coupling and wide product distribution. Guided the energy changes associated with C-C coupling and C-O cleavage as descriptors for ethylene electrosynthesis, we predict and synthesize unsaturated MgO1-x anchored on Cu via an electrochemical-induced phase separation method. Electrochemical evaluation of this catalyst achieves an ethylene Faradaic efficiency of 78.2% at 300 mA cm-2 in a flow cell. Mechanism studies reveal the bifunctionality of MgO1-x. On one side, chemical interaction of MgO1-x with Cu domain stabilizes Cu+ and gives asymmetric Cu+···Cu0 pairs, facilitating the *CO-CHO coupling. On another side, the MgO1-x with high oxygen affinity strengthens the binding with dual-carbon intermediate and promotes the C-O bond dissociation, accelerating ethylene formation. Ultimately, this catalyst delivers 60.7% ethylene selectivity at 25 A in membrane electrode assembly of 100 cm2, equivalent to a C2H4 production rate of 1.1 L h-1.
- 1 June 2026
- Published by Elsevier in Bioresource Technology
- Vol. 458, 134977
The self-reinforcement strategy: upcycling agricultural waste into advanced sustainable cellulose/lignin nanocomposites
- 1 June 2026
- Published by Elsevier in Bioresource Technology
- Vol. 458, 134977
The self-reinforcement strategy: upcycling agricultural waste into advanced sustainable cellulose/lignin nanocomposites
- Open Access
- 1 March 2026
- Published by KEAI Publishing in Green Energy & Environment
- Vol. 11 (3) , 792-804
Selective hydrogenolysis of lignin to alkene-functionalized monomers over ZnO-modified carbon nanotube supported Pd catalysts
- 1 March 2026
- Published by KEAI Publishing in Green Energy & Environment
- Vol. 11 (3) , 792-804
Open AccessSelective hydrogenolysis of lignin to alkene-functionalized monomers over ZnO-modified carbon nanotube supported Pd catalysts
- 25 February 2026
- Published by Elsevier in Chemical Engineering Journal
- Vol. 532
Gradient lignin-modified bamboo nanofiber separators for advanced aqueous zinc-ion batteries
- 25 February 2026
- Published by Elsevier in Chemical Engineering Journal
- Vol. 532
Gradient lignin-modified bamboo nanofiber separators for advanced aqueous zinc-ion batteries
- 2 February 2026
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 14 (6) , 2857-2866
Regulating the Atypical Brønsted Acidity of Zr-SBA-16 Catalysts for Selective Ethanol Conversion to Butene-Rich C 3+ Olefins
- 2 February 2026
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 14 (6) , 2857-2866
Regulating the Atypical Brønsted Acidity of Zr-SBA-16 Catalysts for Selective Ethanol Conversion to Butene-Rich C 3+ Olefins
- 16 December 2025
- Published by Elsevier in Molecular Catalysis
- Vol. 590
Selective cleavage of ether bond in lignin to cyclohexanones over HCl-promoted Pd/ZrO2 catalyst
- 16 December 2025
- Published by Elsevier in Molecular Catalysis
- Vol. 590
Selective cleavage of ether bond in lignin to cyclohexanones over HCl-promoted Pd/ZrO2 catalyst
- Open Access
- 18 November 2025
- Published by Springer Nature in Nature Communications
- Vol. 16 (1) , 10100
Single-atom Ru coupled with AlCl3 to promote asymmetric C-C coupling between CH4 and CO2
Direct synthesis of acetic acid from CH4 and CO2 offers a sustainable strategy to utilize these byproducts co-existed in many anthropogenic scenarios with 100% atom efficiency and mitigate greenhouse effect. But this reaction remains a grand challenge due to chemical inertness of two reactants and sluggish kinetics of C-C coupling. Herein, we propose a bifunctional catalyst design, consisted of metal and Lewis acid, to activate CH4 and CO2 via nucleophilic and electrophilic attacks, respectively, which generating two intermediates with opposite electron properties and promote asymmetric C-C coupling. To achieve this, a rational design with “six-step” screening predicts an efficient catalyst, i.e., Keggin-type phosphotungstic acid supporting equimolar single-atom ruthenium and aluminum chloride. Then we synthesize and demonstrate this catalyst with the activity with TOF of 19.3 h-1 and acetic acid selectivity of 95.7%. In situ infrared spectroscopy and theoretical studies reveal a Langmuir-Hinshelwood mechanism for C-C coupling with a low barrier of 14.03 kcal mol-1. Specifically, CO2 activation by AlCl3 via SE2 process yields a positively charged state, which readily interacts with the negatively charged *CH3 from CH4 activation.
- 18 November 2025
- Published by Springer Nature in Nature Communications
- Vol. 16 (1) , 10100
Open AccessSingle-atom Ru coupled with AlCl3 to promote asymmetric C-C coupling between CH4 and CO2
Direct synthesis of acetic acid from CH4 and CO2 offers a sustainable strategy to utilize these byproducts co-existed in many anthropogenic scenarios with 100% atom efficiency and mitigate greenhouse effect. But this reaction remains a grand challenge due to chemical inertness of two reactants and sluggish kinetics of C-C coupling. Herein, we propose a bifunctional catalyst design, consisted of metal and Lewis acid, to activate CH4 and CO2 via nucleophilic and electrophilic attacks, respectively, which generating two intermediates with opposite electron properties and promote asymmetric C-C coupling. To achieve this, a rational design with “six-step” screening predicts an efficient catalyst, i.e., Keggin-type phosphotungstic acid supporting equimolar single-atom ruthenium and aluminum chloride. Then we synthesize and demonstrate this catalyst with the activity with TOF of 19.3 h-1 and acetic acid selectivity of 95.7%. In situ infrared spectroscopy and theoretical studies reveal a Langmuir-Hinshelwood mechanism for C-C coupling with a low barrier of 14.03 kcal mol-1. Specifically, CO2 activation by AlCl3 via SE2 process yields a positively charged state, which readily interacts with the negatively charged *CH3 from CH4 activation.