Philippe Gaucher
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Philippe Gaucher has a total of 65 co-authors. Here are the top co-authors by number of shared publications:
- Hichem Dammak
SPMS, UMR 8580 CNRS, Ecole Centrale Paris, F-92295 Châtenay-Malabry, France
9 shared publications J. Hector
Thomson CSF-LCR, Domaine de Corbeville, 91404 Orsay cedex, France
4 shared publicationsC. Augier
3 shared publications- Catherine Elissalde
ICMCB, University of Bordeaux, France
3 shared publications Gilbert Calvarin
Laboratoire Structures , Propriétés et Modélisation des Solides Unité Mixte de Recherche (UMR) 8580 Centre National de la Recherche Scientifique (CNRS), Ecole Centrale de Paris, 92295 Châtenay–Malabry, France
3 shared publicationsJ. Ravez
3 shared publications
Latest Publications
- 13 December 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 27 (1) , 40-46
Engineering the Structural Nonlinearity Using Multimodal-Shaped Springs in MEMS
The purpose of this paper is to introduce a novel technique to engineer in a precise way the structural nonlinearity in MEMS springs. To perform the adjustment of structural nonlinearity, the idea of using a sine-shaped beam following the combination of the natural bending modes of a straight one is explored to create a multimodal-shaped spring. The basic analytical model of multimodal beam bending is introduced and validated with finite element modeling. Proposed multimodal springs are fabricated by deep reactive ion etching on silicon on insulator wafer and their force-displacement characteristics are extracted using a force probe, with the resulting curves being close to the ones predicted by the theoretical calculations. The presented spring allows the engineering of structural nonlinearity by varying the amplitudes of the different modes used as initial shape. Thus, a straightforward method to create any type of structural nonlinearity starting from fully bistable up to the linear case, without the need to combine springs of several types, reducing the complexity of the targeted systems and their footprint. The proposed methodology was used to successfully design a suspension spring that exhibits flat force-displacement region with the aim to increase the bandwidth of vibrational energy harvesters.
- 13 December 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 27 (1) , 40-46
Engineering the Structural Nonlinearity Using Multimodal-Shaped Springs in MEMS
The purpose of this paper is to introduce a novel technique to engineer in a precise way the structural nonlinearity in MEMS springs. To perform the adjustment of structural nonlinearity, the idea of using a sine-shaped beam following the combination of the natural bending modes of a straight one is explored to create a multimodal-shaped spring. The basic analytical model of multimodal beam bending is introduced and validated with finite element modeling. Proposed multimodal springs are fabricated by deep reactive ion etching on silicon on insulator wafer and their force-displacement characteristics are extracted using a force probe, with the resulting curves being close to the ones predicted by the theoretical calculations. The presented spring allows the engineering of structural nonlinearity by varying the amplitudes of the different modes used as initial shape. Thus, a straightforward method to create any type of structural nonlinearity starting from fully bistable up to the linear case, without the need to combine springs of several types, reducing the complexity of the targeted systems and their footprint. The proposed methodology was used to successfully design a suspension spring that exhibits flat force-displacement region with the aim to increase the bandwidth of vibrational energy harvesters.
- 3 January 2008
- Published by Springer Nature in Journal of Electroceramics
- Vol. 24 (1) , 10-14
Phase transition and piezoelectric response under electric field in PMN-PT crystals
- 3 January 2008
- Published by Springer Nature in Journal of Electroceramics
- Vol. 24 (1) , 10-14
Phase transition and piezoelectric response under electric field in PMN-PT crystals
- 1 December 2006
- Published by Elsevier in Ultrasonics
- Vol. 44, e627-e631
Fine grains ceramics of PIN–PT, PIN–PMN–PT and PMN–PT systems: Drift of the dielectric constant under high electric field
- 1 December 2006
- Published by Elsevier in Ultrasonics
- Vol. 44, e627-e631
Fine grains ceramics of PIN–PT, PIN–PMN–PT and PMN–PT systems: Drift of the dielectric constant under high electric field
- 1 July 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2006 IEEE International Symposium on the Applications of Ferroelectrics
- p. 265-268
Role of Mn Doping on the Electromechanical Properties of [001] Domain Engineered Single crystals
We studied the influence of Mn doping on electromechanical properties of PZN-xPT with x = 7% and 9%. Single crystals oriented along the [111], [011] and [001] directions were poled by a "field cooling" process with an applied electric field of 1 kV/cm. It is shown that Mn doping has a significant influence on the single domain crystals in both cases. It modifies the phase symmetry of single domain PZN-7PT from orthorhombic to rhombohedral. It reduces permittivity perpendicular to polarization direction of single domain PZN-9PT by about 40%. This change in the properties of the bulk material is the main cause for the decrease of permittivity observed in [001] poled PZN-9PT crystals. Further effects of doping on the properties of [001] domain engineered crystals are a decrease of the piezoelectric coefficient, a hardening of the material and an increase of the mechanical quality factor.
- 1 July 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2006 IEEE International Symposium on the Applications of Ferroelectrics
- p. 265-268
Role of Mn Doping on the Electromechanical Properties of [001] Domain Engineered Single crystals
We studied the influence of Mn doping on electromechanical properties of PZN-xPT with x = 7% and 9%. Single crystals oriented along the [111], [011] and [001] directions were poled by a "field cooling" process with an applied electric field of 1 kV/cm. It is shown that Mn doping has a significant influence on the single domain crystals in both cases. It modifies the phase symmetry of single domain PZN-7PT from orthorhombic to rhombohedral. It reduces permittivity perpendicular to polarization direction of single domain PZN-9PT by about 40%. This change in the properties of the bulk material is the main cause for the decrease of permittivity observed in [001] poled PZN-9PT crystals. Further effects of doping on the properties of [001] domain engineered crystals are a decrease of the piezoelectric coefficient, a hardening of the material and an increase of the mechanical quality factor.
- 1 July 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10994734,p. 249-252
Sample Thickness Dependence of Electromechanical Properties of PZN-PT and PMN-PT Single Crystals
We studied the electromechanical properties of PMN-PT and PZN-PT single crystal plates poled along [001] with thickness t ranging from 800 down to 70 mum. In the case of the tetragonal single domain state (IT), the properties of the thickness mode remain stable down to 250 mum. Below 250 mum, an instability of the polarization is shown. The plates exhibit regions where polarization lies in the plane of the plates. The emergence of these regions results in an additional shear mode at a frequency close to that of the thickness mode, an important increase of the dielectric constants epsiv s 33 and epsiv T 33 and a decrease of the coupling-factor k 1 and longitudinal wave velocity v D 33t . In the rhombohedral multidomain state (4R) a moderate variation of k 1 can be observed while epsiv s 33 increases with decreasing thickness. The increase of the dielectric constant in the 4R state is also related to an additional shear mode. When / decreases, the volume ratios of each domain family are not equal, leading to a tilt of the average spontaneous polarization away from the poling electric field. Consequently the modification of the domain structure for thin plates leads to a change of the electromechanical properties.
- 1 July 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10994734,p. 249-252
Sample Thickness Dependence of Electromechanical Properties of PZN-PT and PMN-PT Single Crystals
We studied the electromechanical properties of PMN-PT and PZN-PT single crystal plates poled along [001] with thickness t ranging from 800 down to 70 mum. In the case of the tetragonal single domain state (IT), the properties of the thickness mode remain stable down to 250 mum. Below 250 mum, an instability of the polarization is shown. The plates exhibit regions where polarization lies in the plane of the plates. The emergence of these regions results in an additional shear mode at a frequency close to that of the thickness mode, an important increase of the dielectric constants epsiv s 33 and epsiv T 33 and a decrease of the coupling-factor k 1 and longitudinal wave velocity v D 33t . In the rhombohedral multidomain state (4R) a moderate variation of k 1 can be observed while epsiv s 33 increases with decreasing thickness. The increase of the dielectric constant in the 4R state is also related to an additional shear mode. When / decreases, the volume ratios of each domain family are not equal, leading to a tilt of the average spontaneous polarization away from the poling electric field. Consequently the modification of the domain structure for thin plates leads to a change of the electromechanical properties.
- 1 September 2005
- Published by EDP Sciences in Journal de Physique IV
- Vol. 128, 161-167
Frequency dependance of electromechanical properties of PZN-xPT single crystals
- 1 September 2005
- Published by EDP Sciences in Journal de Physique IV
- Vol. 128, 161-167
Frequency dependance of electromechanical properties of PZN-xPT single crystals
- 25 January 2005
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 97 (4) , 044105
Electric-field-induced orthorhombic phase in Pb[(Zn1∕3Nb2∕3)0.955Ti0.045]O3 single crystals
The ferroelectric phase transitions of -, [001]-, and [111]-oriented (PZN–4.5%PT) single crystals were investigated as a function of temperature ( between 300 and ), and electric field ( field between 0 and ) by dielectric and x-ray diffraction combined measurements. Under null field, PZN–4.5%PT exhibits the following phase transitions: cubic , during cooling. Under field applied on a -oriented single crystal, an intermediate orthorhombic ferroelectric phase is induced at temperatures intermediate between that of the and phases. The temperature range of existence of this phase depends both on the crystal orientation and on the measurement conditions: field cooling (FC), zero-field heating after field cooling (ZFHAFC), or field heating (FH). When field is applied along , the stability range is within in FC and only in ZFHAFC; when field is applied along [001] or [111], this range is still narrower. The phase is not even observed in FH for [001] orientation and in FC for [111] orientation. These observations show that the application of an field favors the transition to an phase, leading to a single-domain structure, when the direction of the field is parallel to the spontaneous polarization direction.- 25 January 2005
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 97 (4) , 044105
Electric-field-induced orthorhombic phase in Pb[(Zn1∕3Nb2∕3)0.955Ti0.045]O3 single crystals
The ferroelectric phase transitions of -, [001]-, and [111]-oriented (PZN–4.5%PT) single crystals were investigated as a function of temperature ( between 300 and ), and electric field ( field between 0 and ) by dielectric and x-ray diffraction combined measurements. Under null field, PZN–4.5%PT exhibits the following phase transitions: cubic , during cooling. Under field applied on a -oriented single crystal, an intermediate orthorhombic ferroelectric phase is induced at temperatures intermediate between that of the and phases. The temperature range of existence of this phase depends both on the crystal orientation and on the measurement conditions: field cooling (FC), zero-field heating after field cooling (ZFHAFC), or field heating (FH). When field is applied along , the stability range is within in FC and only in ZFHAFC; when field is applied along [001] or [111], this range is still narrower. The phase is not even observed in FH for [001] orientation and in FC for [111] orientation. These observations show that the application of an field favors the transition to an phase, leading to a single-domain structure, when the direction of the field is parallel to the spontaneous polarization direction.- 1 January 2005
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 25 (12) , 2429-2432
Phase diagram of high Tc Pb(In1/2Nb1/2)O3–PbTiO3 ceramics
- 1 January 2005
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 25 (12) , 2429-2432
Phase diagram of high Tc Pb(In1/2Nb1/2)O3–PbTiO3 ceramics
- 9 October 2003
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 42 (Part 1, No) , 6477-6482
Origin of the Giant Piezoelectric Properties in the [001] Domain Engineered Relaxor Single Crystals
- 9 October 2003
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 42 (Part 1, No) , 6477-6482
Origin of the Giant Piezoelectric Properties in the [001] Domain Engineered Relaxor Single Crystals
- 14 November 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
PMN-PT transducer: high stress measurements at resonance
- 14 November 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
PMN-PT transducer: high stress measurements at resonance