Donald J. Weidner
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Donald J. Weidner has a total of 61 co-authors. Here are the top co-authors by number of shared publications:
- Yanbin Wang
Center for Advanced Radiation Sources, The University of Chicago, Chicago, USA
8 shared publications - Michael T. Vaughan
Center for High Pressure Research and Department of Earth And Space Sciences, University at Stony Brookstony Brook, N.Y., 11794, Usa
6 shared publications - Jiuhua Chen
Mineral Physics Institute, Department of Geosciences, State University of New York at Stony Brook, Stony Brook, NY 11794-2100, USA
4 shared publications Li Li
4 shared publications- Yusheng Zhao
Peking University
3 shared publications Jianzhong Zhang
State University of New York at Stony Brook, Stony Brook, New York
2 shared publications
Latest Publications
- Open Access
- 11 December 2023
- Published by Elsevier in Earth and Planetary Science Letters
- Vol. 626
Flow strength of Davemaoite at Mantle P, T conditions using DT25
- 11 December 2023
- Published by Elsevier in Earth and Planetary Science Letters
- Vol. 626
Open AccessFlow strength of Davemaoite at Mantle P, T conditions using DT25
- 1 March 2020
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 91 (3) , 036104
Full waveform analysis for high pressure ultrasonic measurement
We report a data analysis protocol for ultrasonic velocity measurements carried out in a synchrotron x-ray facility based multi-anvil high-pressure apparatus. Synthetic ultrasonic signals for the time period between echoes from the two ends of the sample assembly are created with a few simple parameters as the echo waveform is modeled by the first echo from the anvil-assembly boundary. Each echo is modeled as a delta function with an amplitude and arrival time and convolved with this waveform. The final waveform, fit to the data, enables analysis of signals with overlapped echoes as they are common in small cell assemblies and high pressure.
- 1 March 2020
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 91 (3) , 036104
Full waveform analysis for high pressure ultrasonic measurement
We report a data analysis protocol for ultrasonic velocity measurements carried out in a synchrotron x-ray facility based multi-anvil high-pressure apparatus. Synthetic ultrasonic signals for the time period between echoes from the two ends of the sample assembly are created with a few simple parameters as the echo waveform is modeled by the first echo from the anvil-assembly boundary. Each echo is modeled as a delta function with an amplitude and arrival time and convolved with this waveform. The final waveform, fit to the data, enables analysis of signals with overlapped echoes as they are common in small cell assemblies and high pressure.
- 1 October 2018
- Published by Elsevier in Physics of the Earth and Planetary Interiors
- Vol. 283, 38-42
Ultrasonic acoustic wave velocities of neighborite (NaMgF3) across orthorhombic to cubic phase boundary at high P-T
- 1 October 2018
- Published by Elsevier in Physics of the Earth and Planetary Interiors
- Vol. 283, 38-42
Ultrasonic acoustic wave velocities of neighborite (NaMgF3) across orthorhombic to cubic phase boundary at high P-T
- Open Access
- 17 February 2018
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Solid Earth
- Vol. 123 (2) , 1252-1261
Ultrasonic Acoustic Velocities During Partial Melting of a Mantle Peridotite KLB‐1
Knowledge of the elastic properties of partially molten rocks is crucial for understanding low‐velocity regions in the interior of the Earth. Models of fluid and solid mixtures have demonstrated that significant decreases in seismic velocity are possible with small amounts of melt, but there is very little available data for testing these models, particularly with both P and S waves for mantle compositions. We report ultrasonic measurements of P and S velocities on a partially molten KLB‐1 sample at mantle conditions using a multi‐anvil device at a synchrotron facility. The P, S, and bulk sound velocities decrease as melting occurs. We find that the quantity, ∂lnVS/∂lnVB (where VB is the bulk sound velocity) is lower than mechanical models estimate. Instead, our data, as well as previous data in the literature, are consistent with a dynamic melting model in which melting and solidification interact with the stress field of the acoustic wave.
- 17 February 2018
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Solid Earth
- Vol. 123 (2) , 1252-1261
Open AccessUltrasonic Acoustic Velocities During Partial Melting of a Mantle Peridotite KLB‐1
Knowledge of the elastic properties of partially molten rocks is crucial for understanding low‐velocity regions in the interior of the Earth. Models of fluid and solid mixtures have demonstrated that significant decreases in seismic velocity are possible with small amounts of melt, but there is very little available data for testing these models, particularly with both P and S waves for mantle compositions. We report ultrasonic measurements of P and S velocities on a partially molten KLB‐1 sample at mantle conditions using a multi‐anvil device at a synchrotron facility. The P, S, and bulk sound velocities decrease as melting occurs. We find that the quantity, ∂lnVS/∂lnVB (where VB is the bulk sound velocity) is lower than mechanical models estimate. Instead, our data, as well as previous data in the literature, are consistent with a dynamic melting model in which melting and solidification interact with the stress field of the acoustic wave.
- Open Access
- 18 March 2013
- Published by Wiley
- p. 13-17
Characterization of Stress, Pressure, and Temperature in SAm85, a Dia Type High Pressure Apparatus
- 18 March 2013
- Published by Wiley
- p. 13-17
Open AccessCharacterization of Stress, Pressure, and Temperature in SAm85, a Dia Type High Pressure Apparatus
- 31 March 2012
- Published by Elsevier in Physics of the Earth and Planetary Interiors
- Vol. 194-195, 98-106
Anelasticity and transient creep in NaMgF3 perovskite at high pressure
- 31 March 2012
- Published by Elsevier in Physics of the Earth and Planetary Interiors
- Vol. 194-195, 98-106
Anelasticity and transient creep in NaMgF3 perovskite at high pressure
- 4 April 2011
- Published by Springer Nature in Journal of Earth Science
- Vol. 22 (2) , 169-175
Ab initio molecular dynamic simulation on the elasticity of Mg3Al2Si3O12 pyrope
- 4 April 2011
- Published by Springer Nature in Journal of Earth Science
- Vol. 22 (2) , 169-175
Ab initio molecular dynamic simulation on the elasticity of Mg3Al2Si3O12 pyrope
- 1 June 2008
- Published by Mineralogical Society of America in Elements
- Vol. 4 (3) , 191-196
Laboratory Studies of the Rheological Properties of Minerals under Deep-Mantle Conditions
Most large-scale geological processes, such as mantle convection and plate tectonics, involve plastic deformation of rocks. However, quantitative experimental studies of plastic properties under deep-mantle conditions are challenging, and major progress in this area has often been associated with the development of new techniques. Until very recently, reliable studies have been conducted only at pressures less than ∼0.5 GPa (∼15 km depth in Earth). By combining novel techniques of synchrotron-based in situ stress-strain measurements with newly designed high-pressure apparatuses, a new generation of experimental studies of plastic deformation of minerals under deep-mantle conditions is emerging. These studies constrain the pressure dependence of deformation of minerals such as olivine and the slip systems in high-pressure minerals such as wadsleyite and perovskite. These results have important implications for the depth variation of mantle viscosity and the geodynamic interpretation of seismic anisotropy.
- 1 June 2008
- Published by Mineralogical Society of America in Elements
- Vol. 4 (3) , 191-196
Laboratory Studies of the Rheological Properties of Minerals under Deep-Mantle Conditions
Most large-scale geological processes, such as mantle convection and plate tectonics, involve plastic deformation of rocks. However, quantitative experimental studies of plastic properties under deep-mantle conditions are challenging, and major progress in this area has often been associated with the development of new techniques. Until very recently, reliable studies have been conducted only at pressures less than ∼0.5 GPa (∼15 km depth in Earth). By combining novel techniques of synchrotron-based in situ stress-strain measurements with newly designed high-pressure apparatuses, a new generation of experimental studies of plastic deformation of minerals under deep-mantle conditions is emerging. These studies constrain the pressure dependence of deformation of minerals such as olivine and the slip systems in high-pressure minerals such as wadsleyite and perovskite. These results have important implications for the depth variation of mantle viscosity and the geodynamic interpretation of seismic anisotropy.
- 16 April 2007
- Published by AIP Publishing in Applied Physics Letters
- Vol. 90 (16) , 161903
Elastic properties of yttrium-doped BaCeO3 perovskite
Based on ambient ultrasonic measurements and x-ray diffraction under hydrostatic compression, the authors report here a comparative study of elasticity on oxygen-deficient perovskite, , with and 0.15. The results show that the presence of 2.5% oxygen vacancy has no measurable effect on the elastic bulk modulus. The shear modulus, however, decreases by approximately 5% in perovskite. The differences between -doped cerate and -doped silicate suggest that the effect of oxygen vacancy on the elastic properties could be system dependent and may also be sensitive to distribution of oxygen vacancies within structures of the parent compounds.- 16 April 2007
- Published by AIP Publishing in Applied Physics Letters
- Vol. 90 (16) , 161903
Elastic properties of yttrium-doped BaCeO3 perovskite
Based on ambient ultrasonic measurements and x-ray diffraction under hydrostatic compression, the authors report here a comparative study of elasticity on oxygen-deficient perovskite, , with and 0.15. The results show that the presence of 2.5% oxygen vacancy has no measurable effect on the elastic bulk modulus. The shear modulus, however, decreases by approximately 5% in perovskite. The differences between -doped cerate and -doped silicate suggest that the effect of oxygen vacancy on the elastic properties could be system dependent and may also be sensitive to distribution of oxygen vacancies within structures of the parent compounds.- 27 March 2004
- Published by American Geophysical Union (AGU) in Geophysical Research Letters
- Vol. 31 (6)
Effect of plasticity on elastic modulus measurements
Recent developments in high‐pressure X‐ray studies enable the measurement of the elastic strain anisotropy induced by a macroscopic differential stress in an aggregate sample. Such data are commonly used to constrain the single‐crystal elastic moduli under the assumptions of the Reuss‐Voigt state. We find this procedure is valid only for samples that have not been plastically deformed. Measured elastic strain anisotropy for MgO at stress levels below the yield point agree well with the Reuss elastic model. Plastic deformation effects a change in the stress field for subpopulations of grains that represent different crystallographic orientations with respect to the applied stress field. Our data for the plastically deformed sample are consistent with the predictions of a self‐consistent aggregate model for deforming polycrystals. Such models may be useful as a guide to define the elastic properties in light of the active slip systems.
- 27 March 2004
- Published by American Geophysical Union (AGU) in Geophysical Research Letters
- Vol. 31 (6)
Effect of plasticity on elastic modulus measurements
Recent developments in high‐pressure X‐ray studies enable the measurement of the elastic strain anisotropy induced by a macroscopic differential stress in an aggregate sample. Such data are commonly used to constrain the single‐crystal elastic moduli under the assumptions of the Reuss‐Voigt state. We find this procedure is valid only for samples that have not been plastically deformed. Measured elastic strain anisotropy for MgO at stress levels below the yield point agree well with the Reuss elastic model. Plastic deformation effects a change in the stress field for subpopulations of grains that represent different crystallographic orientations with respect to the applied stress field. Our data for the plastically deformed sample are consistent with the predictions of a self‐consistent aggregate model for deforming polycrystals. Such models may be useful as a guide to define the elastic properties in light of the active slip systems.