Bo Zhao

In the study, a combined numerical simulation and on‐site monitoring method was used to analyze the asymmetric development characteristics of overlying rock fractures in a goaf under the condition of a goaf side entry formed by roof cutting and to explore the gas accumulation area in the goaf, achieving precise gas extraction from the goaf. The results demonstrates that a double‐balanced arch structure is formed under the condition of a goaf side entry formed by roof cutting, achieving safe retention of the roadway and showing the significance of the pressure relief effect of roof cutting. The collapse movement of the overlying rock on the roof‐cutting side is relatively advanced. The heights of the collapse zone on the roof‐cutting side and the uncut roof side are 28 and 24 m, respectively, and the development heights of the fracture zone are 37 and 42 m, respectively. The fault line on the roof‐cutting side gradually shifts toward the direction of the goaf, and the surface settlement and fracture development are relatively small. There is a clear asymmetric structure in terms of time effect, fault line, fracture zone height, and surface settlement compared to the uncut roof side. The gas is distributed throughout the entire goaf in the roof‐cutting and tunneling mode, and a high‐concentration gas accumulation area is formed near the open–off cut and working face on the high side of the fracture zone. Based on an actual situation, a method of drilling high and low positions in a fracture zone is proposed for extraction. Combined with on‐site monitoring, the goaf was no longer filled with gas during extraction, and the proportion of low‐concentration gas space considerably increased.

In order to achieve high-efficiency extraction of coal seams with large-diameter borehole and large flow rates, and to rapidly reduce coal seam gas content and pressure, a large-diameter borehole coal seam pressure relief and permeability enhancement technology is proposed. In this paper, numerical simulation is used to study the mechanism of pressure relief and permeability enhancement in coal seams with large-diameter boreholes, and the evolution of stress, cracks, gas, and permeability of coal bodies around boreholes with different diameters is discussed. The research results show that the stress changes in the coal body around the borehole are symmetrically distributed around the borehole. The stress evolution controls the evolution of the coal bodys cracks. Firstly, damage occurs around the borehole and then extends to the upper left and right corners, like a butterfly spreading its wings. The crushing zone increases with the increase of the hole diameter, and the impact radius of the 100-mm, 200-mm, 300-mm, and 350-mm diameter borehole rupture is 0.375m, 0.65m, 1.0m, and 1.25m, respectively. The rupture radius of the double 350-mm diameter borehole can reach 2.4m. The larger the diameter of the borehole, the more fissures will be produced, and the air permeability of the coal body in the affected coal seam area will obviously increase. The research results provide theoretical support for gas drainage in soft, low-permeability, high-gas coal seams.

Deep mining will increase the likelihood of coal and gas outburst accidents and do harm to the safety of coal mining. In this study, a coal and gas outburst experiment under deep high‐stress conditions was carried out and stress–gas pressure–temperature response laws in coal and rock surrounding the burst hole were evaluated. The experimental results showed that the stress response around the burst hole was intense and stress variation decreased as distance from the position to burst port increased. The gas pressure in the coal decreased sharply and oscillated several times during the burst process. The maximum rebound range was 0.05 MPa during this process. The decreasing rate of gas pressure reduced with the increase of the position‐burst port distance. The temperature response near the burst port was stronger than peripheral area. The gas internal energy was still the main energy source of coal and gas outbursts, accounting for 75% of the total energy, and played a key role in the burst process. The contribution of elastic potential energy was 22% under deep high‐stress conditions in this study. Based on the analysis of burst energy, the gas and stress were key factors of an outburst.

Based on thermal–fluid–solid coupling law in coal and gas outburst, a multi-physical field numerical analysis model is built for the whole outburst process. The response laws of stress, gas pressure, temperature, and seepage in different areas and different time nodes around coal and rock mass in the coal and gas outburst under high stress condition are discussed. Research results show: Firstly, the stress response law of the coal and rock mass around the burst hole is initial vibration–sudden attenuation–late stability. Secondly, the gas pressure response law in different areas is that the gas pressure response rate decreases gradually with the increase of the distance from the outburst. Thirdly, the adsorbed gas contained in the broken coal near the outburst port is desorbed rapidly and expands to do work, and the temperature changes dramatically after outburst occurs. In contrast, with the increase of stress, the proportion of elastic potential in total coal and gas outburst energy increases, and the proportion of elastic potential is positively correlated with stress. The critical gas pressure under the energy condition of coal and gas outburst decreases with the increase of stress. It illustrates that the lower gas pressure can also meet the energy condition of coal and gas outburst under high stress.

Coal and gas outburst is a potentially fatal risk during the mining of gassy coal seams, which seriously threatens the safe mining of collieries. To understand the outburst mechanism and evolution rules, a new apparatus (LSTT) was developed to conduct simulated experiment. In the context of an outburst accident in Dingji coal mine, the authors launched an authentic outburst experiment to replay the outburst accident. Experimental apparatus, similar criterion, coal‐like materials and gas sources, and experimental design were discussed systematically in this paper. Experimentally, the study analyzed the geo‐stress has significant influence on the outburst evolution. At the driving face, the stress concentration possibly caused gas outburst, under the influence of mining‐induced stress. After the outburst occurred, the stress balance of the coal changed, resulting in the instability of the coal. Furthermore, the elastic energy, gas enthalpy, and gravitational potential energy were released rapidly. The experimental result stated that outburst coal has the sorting characteristics, in line with the field outburst law. The intensity prediction model has been built based on the energy model. Moreover, the factors that impact outburst intensity were analyzed. In the process of coal and gas outburst, the gas enthalpy of gas and the elastic potential of coal are the main energy sources. This study provides guidance for the development of the outburst mechanism and outburst mine management.

The permeability of coal reservoirs prominently determines methane flow in reservoirs. A large amount of coal reservoirs containing methane, however, have low permeability because pores in reservoirs are sealed. To solve this issue, we investigated the pore structure and permeability law of coal through contrastive analysis of the microstructure and macrostructure before and after acidizing, using ASAP 2020 and triaxial servo-controlled seepage equipment. An analysis of the experimental data revealed the mechanism and the key parameters of acidizing, such as acid mass fraction and acidizing time. In addition, we hold that the optimal mass fraction for the test specimens is about 12~15%. Furthermore, the acid reaction is divided into three stages according to characteristics of the reaction progress. An analysis of the reaction kinetics of “HCl-HF” states that the significant factors will impact the process of reaction, like the composition of coal, surface area of the acid-coal reaction, mass fraction of acids, and environment of the reaction system. The results provide a new idea and research method for further enhancing permeability and gas extraction.