TFTomas Fernandez

Tomas Fernandez

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Tomas Fernandez has a total of 76 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Microwave Antenna Sensing for Glucose Monitoring in a Vein Model Mimicking Human Physiology

    by Youness Zaarour, Fatimazahrae El Arroud, Tomas Fernandez, Juan Luis Cano, Rafiq El Alami, Otman El Mrabet, Abdelouheb Benani, Abdessamad Faik, Hafid Griguer

    Non-invasive glucose monitoring has become a critical area of research for diabetes management, offering a less intrusive and more patient-friendly alternative to traditional methods such as finger-prick tests. This study presents a novel approach using a semi-solid tissue-mimicking phantom designed to replicate the dielectric properties of human skin and blood vessels. The phantom was simplified to focus solely on the skin layer, with embedded channels representing veins to achieve realistic glucose monitoring conditions. These channels were filled with D-(+)-Glucose solutions at varying concentrations (60 mg/dL to 200 mg/dL) to simulate physiological changes in blood glucose levels. A miniature patch antenna optimized to operate at 14 GHz with a penetration depth of approximately 1.5 mm was designed and fabricated. The antenna was tested in direct contact with the skin phantom, allowing for precise measurements of the changes in glucose concentration without interference from deeper tissue layers. Simulations and experiments demonstrated the antenna’s sensitivity to variations in glucose concentration, as evidenced by measurable shifts in the dielectric properties of the phantom. Importantly, the system enabled stationary measurements by injecting glucose solutions into the same blood vessels, eliminating the need to reposition the sensor while ensuring reliable and repeatable results. This work highlights the importance of shallow penetration depth in targeting close vessels for noninvasive glucose monitoring, and emphasizes the potential of microwave-based sensing systems as a practical solution for continuous glucose management.


  • Open Access

    Engine Oil Quality Monitoring Using an Additively Manufactured X-Band Microwave Waveguide Sensor

    by Youness Zaarour, Juan Luis Cano, Tomas Fernandez, Fatima Zahrae El Arroud, Abdessamad Faik, Rafiq El Alami, Hafid Griguer

    Maintaining engine oil quality is critical for industrial machinery and transformers to ensure efficient operation and reduce the risk of failure. This paper presents a novel application of an X-band microwave sensor, using a third-order electroformed iris waveguide filter, for real-time, non-invasive engine oil quality monitoring. By detecting shifts in the dielectric properties of engine oil, the sensor accurately tracks oil degradation as it ages. Unlike traditional methods that require oil extraction and laboratory analysis, this sensor enables continuous, in-situ monitoring, providing immediate feedback without disrupting system operations. Any change in oil quality causes a frequency shift, as variations in its dielectric properties affect the waveguide’s resonance. This shift can be measured in real time, enabling accurate monitoring of oil degradation. Additional measurements were conducted using the coaxial probe technique to analyze the changes in the oil’s electrical behavior during various heating periods. Experimental results demonstrate the sensor’s sensitivity, with measurable frequency shifts of up to 10 MHz observed in the most aged oil samples. These shifts clearly correlate with the oil’s aging process, confirming the sensor’s potential for practical use in predictive maintenance. This system, utilizing an electroformed waveguide, offers a cost-effective and efficient solution for enhancing machinery longevity and optimizing maintenance schedules in industrial applications.


  • An Ultra-Compact Full-Band Waveguide Quadrature Hybrid Coupler

    by Juan Luis Cano, Gabriele Ceccato, Tomas Fernandez, Angel Mediavilla, Luca Perregrini

    This work proposes an easily scalable quadrature hybrid coupler (QHC) topology with two symmetric stepped apertures that originate a square coaxial-like mid-section. This new configuration enables an ultra-compact design, three times shorter than equivalent structures, having 40% of fractional bandwidth with 25 dB of matching/isolation and 1 dB of axial ratio (AR). The impedance transformers can be easily redesigned to meet other requirements related to electrical performance or even other desired coupling values. For verification purposes, a prototype at Ku -band was manufactured and measured showing good agreement with simulation results.


  • Open Access

    Compact Low-Cost Filter for 5G Interference Reduction in UHF Broadcasting Band

    by Oscar Fernández, Tomás Fernández, Álvaro Gómez

    The allocation of part of the UHF band to 4G and 5G services has generated the appearance of channel interferences over the digital terrestrial television frequency band. In order to reduce these interferences, this work presents a novel and efficient band-stop filter implemented using microstrip technology. The filter, designed with rectangular split-ring resonators etched in the ground plane, provides a cutoff frequency above channel 48 (694 MHz), a high roll-off rate of 44 dB in 56 MHz and a rejection bandwidth of 250 MHz that covers the upper UHF band occupied by 4G and 5G with rejection levels close to 35 dB. The filter is manufactured entirely over a printed circuit board without lumped elements to reduce production costs, fine tuning after the assembly stage and maintenance. Moreover, it presents a compact subwavelength size of only 0.07 λ × 0.17 λ to facilitate installation, whether at the input of the TV terminal or integrated with the balun at the rooftop antenna.


  • Open Access

    Comparison of Microstrip W-Band Detectors Based on Zero Bias Schottky-Diodes

    by Jéssica Gutiérrez, Kaoutar Zeljami, Juan Pablo Pascual, Tomás Fernández, Antonio Tazón

    This paper presents and discusses three different low-cost microstrip implementations of Schottky-diode detectors in W Band, based on the use of the Zero Bias Diode (ZBD) from VDI (Virginia Diodes, Charlottesville, VA, USA). Designs are based on a previous work of modeling of the ZBD diode. Designs also feature low-cost, easy-to-use tooling substrates (RT Duroid 5880, 5 mils thickness) and even low-cost discrete SMD components such as SOTA resistances (State Of The Art TM miniaturized surface mount resistors), which are modeled to be used well above commercial frequency margins. Intensive use of 3D EM simulation tools such as HFSS TM is done to support microstrip board modeling. Measurements of the three designs fabricated are compared to simulations and discussed.


  • Open Access

    Accurately Modeling of Zero Biased Schottky-Diodes at Millimeter-Wave Frequencies

    by Jéssica Gutiérrez, Kaoutar Zeljami, Tomás Fernández, Juan Pablo Pascual, Antonio Tazón

    This paper presents and discusses the careful modeling of a Zero Biased Diode, including low-frequency noise sources, providing a global model compatible with both wire bonding and flip-chip attachment techniques. The model is intended to cover from DC up to W-band behavior, and is based on DC, capacitance versus voltage, as well as scattering and power sweep harmonics measurements. Intensive use of 3D EM (ElectroMagnetic) simulation tools, such as HFSSTM, was done to support Zero Biased Diode parasitics modeling and microstrip board modeling. Measurements are compared with simulations and discussed. The models will provide useful support for detector designs in the W-band.


  • New shield structure for retrodirective and invisible applications

    by Jorge Caravantes, Paula Mediavilla, Antonio Tazón, Tomás Fernández, Juan Vassal'Lo


  • On the use of HF techniques for biological tissue detection

    by Paula Mediavilla, David Vegas, Antonio Tazon, Tomas Fernandez, Angel Mediavilla, Jose Luis Gutierrez Banos

    The objective of this work is to find a method to distinguish different types of substances with high dielectric constant and high losses, such as is the case of biological tissues, to study the detection of tumors with technologies that enable the accurate identification of the areas to be removed, reducing the loss of healthy tissue. For this a microwave transmission-based sample analysis system has been designed. The biological sample is enclosed in a nylon box whose dielectric constant is much smaller than that of the samples under study. The working frequency is 35 GHz because this frequency maintains a good compromise between the dimensions of the waveguide and the depth of penetration in samples. A study analyzing the system's sensitivity to different biological samples has been done. Then it was verified that the system can distinguish the different separation profiles in a complex sample, yielding very promising results.

  • GNSS microstrip antenna for orbit determination of GEO satellites

    by A. Tazon, T. Fernandez, J. Vassal'Lo, A. Mediavilla

    In this paper we present the design of a low profile antenna for on board GNSS applications in GEO satellites to allow their autonomous orbit determination. The antenna, tuned in two GNSS bands, is based on two stacked microstrip radiators working at TM 2,1 mode to provide a maximum of gain between 10° and 40° of θ, for any value of azimuth (φ). An alternative antenna is also presented to perform a more simple design, with a single microstrip radiator working at TM 2,1 and 3,1 modes.


  • Very-high-frequency methodology for biological tissue discrimination

    by P. Mediavilla, D. Vegas, A. Tazon, A. Mediavilla, T. Fernandez, J. L. Gutierrez

    This paper demonstrates the practical possibilities of a high-frequency setup to discriminate between different types of biological tissues. The final objective is to study the detection of tumors with technologies that enable an accurate identification of the areas to be removed, thus reducing the loss of healthy tissue. For this purpose, a microwave transmission-based antenna sample analysis system has been designed. Moreover, the biological sample is enclosed in a dielectric package, such that its dielectric constant is much lower than that of the biological samples under study. The working frequency is located in the vicinity of the microwave Ka-band. This is because this frequency band maintains a good compromise between the mechanical dimensions of the waveguide and the skin depth of penetration. A complete study on analyzing the system's sensitivity against the versatility of the different biological samples has been done. It was proved that the proposed high frequency measurement system is able to distinguish the different separation profiles in a complex sample of tissue, yielding very promising results.