Naghmeh Sadat Mirbagheri
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Naghmeh Sadat Mirbagheri has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
- Samad Sabbaghi
Department of Nano-Chemical Engineering, Faculty of Advanced Technologies, Shiraz University, Shiraz, Iran
5 shared publications - Shahram Tangestaninejad
University of Isfahan
3 shared publications Valiollah Mirkhani
Chemistry Department, Catalysis Division, University of Isfahan, Isfahan 81746-73441, Iran
3 shared publications- Elena E. Ferapontova
Interdisciplinary Nanoscience Center (iNANO), Faculty of Natural Sciences, Aarhus University, Gustav Wieds Vej 14, 8000, Aarhus C, Denmark
2 shared publications Iraj Mohammadpoor-Baltork
Chemistry Department, Catalysis Division, University of Isfahan, Isfahan 81746-73441, Iran
2 shared publications- Majid Moghadam
University of Isfahan
2 shared publications
Latest Publications
- Open Access
- 10 June 2024
- Published by Royal Society of Chemistry (RSC) in Materials Advances
- Vol. 5 (14) , 5724-5737
Adsorptive and photo-Fenton properties of bimetallic MIL-100(Fe,Sn) and MIL-100(Fe,Ir) MOFs toward removal of tetracycline from aqueous solutions
Novel bimetallic MIL-100(Fe,Sn) MOFs and MIL-100(Fe,Ir) MOFs were synthesized and then utilized for efficient treatment of tetracycline-contaminated wastewater.
- 10 June 2024
- Published by Royal Society of Chemistry (RSC) in Materials Advances
- Vol. 5 (14) , 5724-5737
Open AccessAdsorptive and photo-Fenton properties of bimetallic MIL-100(Fe,Sn) and MIL-100(Fe,Ir) MOFs toward removal of tetracycline from aqueous solutions
Novel bimetallic MIL-100(Fe,Sn) MOFs and MIL-100(Fe,Ir) MOFs were synthesized and then utilized for efficient treatment of tetracycline-contaminated wastewater.
- Open Access
- 1 July 2021
- Published by Elsevier in Desalination and Water Treatment
- Vol. 229, 331-342
Modification of graphitic carbon nitride photocatalyst by Pb-contaminated water for efficient removal of cefixime from aqueous media
- 1 July 2021
- Published by Elsevier in Desalination and Water Treatment
- Vol. 229, 331-342
Open AccessModification of graphitic carbon nitride photocatalyst by Pb-contaminated water for efficient removal of cefixime from aqueous media
- 19 November 2019
- Published by Springer Nature
- p. 165-201
Overview of Nanomaterial-Assisted Technologies for Denitrification Processes
- 19 November 2019
- Published by Springer Nature
- p. 165-201
Overview of Nanomaterial-Assisted Technologies for Denitrification Processes
- 1 May 2018
- Published by Elsevier in Journal of Environmental Management
- Vol. 213, 56-65
A Ti-doped γ-Fe2O3/SDS nano-photocatalyst as an efficient adsorbent for removal of methylene blue from aqueous solutions
- 1 May 2018
- Published by Elsevier in Journal of Environmental Management
- Vol. 213, 56-65
A Ti-doped γ-Fe2O3/SDS nano-photocatalyst as an efficient adsorbent for removal of methylene blue from aqueous solutions
- 1 March 2018
- Published by Elsevier in Microporous and Mesoporous Materials
- Vol. 259, 134-141
A natural kaolin/γ-Fe2O3 composite as an efficient nano-adsorbent for removal of phenol from aqueous solutions
- 1 March 2018
- Published by Elsevier in Microporous and Mesoporous Materials
- Vol. 259, 134-141
A natural kaolin/γ-Fe2O3 composite as an efficient nano-adsorbent for removal of phenol from aqueous solutions
- 8 September 2017
- Published by Springer Nature
- p. 129-174
Nanoporous Nanocomposite Materials for Photocatalysis
- 8 September 2017
- Published by Springer Nature
- p. 129-174
Nanoporous Nanocomposite Materials for Photocatalysis
- 23 March 2016
- Published by IOP Publishing in Nanotechnology
- Vol. 27 (18) , 185603
Synthesis of ligand-free CZTS nanoparticles via a facile hot injection route
Single-phase, ligand-free Cu2ZnSnS4 (CZTS) nanoparticles that can be dispersed in polar solvents are desirable for thin film solar cell fabrication, since water can be used as the solvent for the nanoparticle ink. In this work, ligand-free nanoparticles were synthesized using a simple hot injection method and the precursor concentration in the reaction medium was tuned to control the final product. The as-synthesized nanoparticles were characterized using various techniques, and were found to have a near-stoichiometric composition and a phase-pure kesterite crystal structure. No secondary phases were detected with Raman spectroscopy or scanning transmission electron microscopy energy dispersive x-ray spectroscopy. Furthermore, high resolution transmission electron microscopy showed large-sized nanoparticles with an average diameter of 23 nm ± 11 nm. This approach avoids all organic materials and toxic solvents that otherwise could hinder grain growth and limit the deposition techniques. In addition the synthesis route presented here results in nanoparticles of a large size compared to other ligand-free CZTS nanoparticles, due to the high boiling point of the solvents selected. Large particle size in CZTS nanoparticle solar cells may lead to a promising device performance. The results obtained demonstrate the suitability of the synthesized nanoparticles for application in low cost thin film solar cells.
- 23 March 2016
- Published by IOP Publishing in Nanotechnology
- Vol. 27 (18) , 185603
Synthesis of ligand-free CZTS nanoparticles via a facile hot injection route
Single-phase, ligand-free Cu2ZnSnS4 (CZTS) nanoparticles that can be dispersed in polar solvents are desirable for thin film solar cell fabrication, since water can be used as the solvent for the nanoparticle ink. In this work, ligand-free nanoparticles were synthesized using a simple hot injection method and the precursor concentration in the reaction medium was tuned to control the final product. The as-synthesized nanoparticles were characterized using various techniques, and were found to have a near-stoichiometric composition and a phase-pure kesterite crystal structure. No secondary phases were detected with Raman spectroscopy or scanning transmission electron microscopy energy dispersive x-ray spectroscopy. Furthermore, high resolution transmission electron microscopy showed large-sized nanoparticles with an average diameter of 23 nm ± 11 nm. This approach avoids all organic materials and toxic solvents that otherwise could hinder grain growth and limit the deposition techniques. In addition the synthesis route presented here results in nanoparticles of a large size compared to other ligand-free CZTS nanoparticles, due to the high boiling point of the solvents selected. Large particle size in CZTS nanoparticle solar cells may lead to a promising device performance. The results obtained demonstrate the suitability of the synthesized nanoparticles for application in low cost thin film solar cells.
- 8 July 2014
- Published by Wiley in Chemphyschem
- Vol. 15 (13) , 2844-2850
Electrocatalysis of Water Oxidation by H2O-Capped Iridium-Oxide Nanoparticles Electrodeposited on Spectroscopic Graphite
Electrocatalysis of water oxidation by 1.54 nm IrOx nanoparticles (NPs) immobilized on spectroscopic graphite electrodes was demonstrated to proceed with a higher efficiency than on all other, hitherto reported, electrode supports. IrOx NPs were electrodeposited on the graphite surface, and their electrocatalytic activity for water oxidation was correlated with the surface concentrations of different redox states of IrOx as a function of the deposition time and potential. Under optimal conditions, the overpotential of the reaction was reduced to 0.21 V and the electrocatalytic current density was 43 mA cm−2 at 1 V versus Ag/AgCl (3 M KCl) and pH 7. These results beneficially compete with previously reported electrocatalytic oxidations of water by IrOx NPs electrodeposited onto glassy carbon and indium tin oxide electrodes and provide the basis for the further development of efficient IrOx NP-based electrocatalysts immobilized on high-surface-area carbon electrode materials.
- 8 July 2014
- Published by Wiley in Chemphyschem
- Vol. 15 (13) , 2844-2850
Electrocatalysis of Water Oxidation by H2O-Capped Iridium-Oxide Nanoparticles Electrodeposited on Spectroscopic Graphite
Electrocatalysis of water oxidation by 1.54 nm IrOx nanoparticles (NPs) immobilized on spectroscopic graphite electrodes was demonstrated to proceed with a higher efficiency than on all other, hitherto reported, electrode supports. IrOx NPs were electrodeposited on the graphite surface, and their electrocatalytic activity for water oxidation was correlated with the surface concentrations of different redox states of IrOx as a function of the deposition time and potential. Under optimal conditions, the overpotential of the reaction was reduced to 0.21 V and the electrocatalytic current density was 43 mA cm−2 at 1 V versus Ag/AgCl (3 M KCl) and pH 7. These results beneficially compete with previously reported electrocatalytic oxidations of water by IrOx NPs electrodeposited onto glassy carbon and indium tin oxide electrodes and provide the basis for the further development of efficient IrOx NP-based electrocatalysts immobilized on high-surface-area carbon electrode materials.
- 20 May 2014
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 4 (6) , 2006-2015
Visible Light Driven Photoelectrochemical Water Oxidation by Zn- and Ti-Doped Hematite Nanostructures
- 20 May 2014
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 4 (6) , 2006-2015
Visible Light Driven Photoelectrochemical Water Oxidation by Zn- and Ti-Doped Hematite Nanostructures