Hengjun Gai
Research Subjects
Hengjun Gai has a total of 59 co-authors. Here are the top co-authors by number of shared publications:
Meng Xiao
Qingdao Univ Sci & Technol, Coll Chem Engn, Qingdao 266042, Shandong, Peoples R China
7 shared publications- Quanhong Zhu
College of Chemical Engineering, Qingdao University of Science and Technology, Qingdao 266042, Shandong, China
6 shared publications Hongbing Song
College of Chemical Engineering, Qingdao University of Science and Technology, Qingdao 266042, P. R. China
5 shared publications- Hongbing Song
College of Chemical Engineering, Qingdao University of Science and Technology, Qingdao 266042, PR China
5 shared publications - Meng Xiao
College of Chemical Engineering, Qingdao University of Science and Technology, Qingdao 266042, China
4 shared publications Chao Pan
College of Chemical Engineering, Qingdao University of Science and Technology, Qingdao 266042, P. R. China
3 shared publications
Latest Publications
- 27 April 2026
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 71 (5) , 2235-2248
Ternary System of Cyclohexanol + o -/ m -/ p -Cresol + Water: Measurement and Processing of Equilibrium Data at 298.15 and 308.15 K
- 27 April 2026
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 71 (5) , 2235-2248
Ternary System of Cyclohexanol + o -/ m -/ p -Cresol + Water: Measurement and Processing of Equilibrium Data at 298.15 and 308.15 K
- 3 October 2025
- Published by Springer Nature in Journal of Solution Chemistry
- Vol. 55 (2) , 274-289
Liquid–Liquid Equilibrium for Cyclohexanol Extraction of Phenol from Aqueous Solutions at (298.15, 308.15, and 318.15) K
- 3 October 2025
- Published by Springer Nature in Journal of Solution Chemistry
- Vol. 55 (2) , 274-289
Liquid–Liquid Equilibrium for Cyclohexanol Extraction of Phenol from Aqueous Solutions at (298.15, 308.15, and 318.15) K
- Open Access
The Sandwich-Structured PVA/PA/PVA Tri-Layer Nanofiltration Membrane with High Performance for Desalination and Pollutant Removal
Nanofiltration (NF) has become a widely used technology in water treatment due to its environmental friendliness, energy efficiency, cost-effectiveness, and operational simplicity. However, polyamide (PA) NF membranes still face challenges, including low permeate flux, limited resistance to organic pollutants, and inadequate resilience to residual chlorine. To address these issues, this study developed a thin-film composite (TFC) NF membrane featuring a separation layer of sandwich structure. Initially, a single separation layer of polyvinyl alcohol (PVA) NF membrane was prepared, followed by the fabrication of a PA layer on its surface, and ultimately, a second PVA layer was constructed on the PA layer. The experimental results show that the PVA/PA/PVA sandwich structure TFC exhibits high permeability to pure water and robust resistance to both pollution and residual chlorine. The PVA-0.20/PA/PVA-0.20 TFC, prepared with a 0.20%w/v PVA solution, achieved a pure water flux of up to 22.05 L m−2 h−1 bar−1 (LMH/bar), which was 2.92 times higher than that of the control TFC membrane. Additionally, it demonstrated a salt rejection rate exceeding 96% for Na2SO4 and over 99% for Congo Red (CR) and Victoria Blue B (VB). In comparison with the control TFC membrane, the PVA-0.20/PA/PVA-0.20 membrane exhibited significantly enhanced resistance to pollution. Following immersion in a 1000 ppm NaClO solution for 4 h, the rejection rate of the control TFC membrane decreased markedly and that of the PVA-0.20/PA/PVA-0.20 membrane decreased marginally, indicating excellent resistance to residual chlorine. Due to the robust overall performance of the PVA/PA/PVA membrane, it holds potential advantages for application in treating reclaimed water or slightly polluted water.
Open AccessThe Sandwich-Structured PVA/PA/PVA Tri-Layer Nanofiltration Membrane with High Performance for Desalination and Pollutant Removal
Nanofiltration (NF) has become a widely used technology in water treatment due to its environmental friendliness, energy efficiency, cost-effectiveness, and operational simplicity. However, polyamide (PA) NF membranes still face challenges, including low permeate flux, limited resistance to organic pollutants, and inadequate resilience to residual chlorine. To address these issues, this study developed a thin-film composite (TFC) NF membrane featuring a separation layer of sandwich structure. Initially, a single separation layer of polyvinyl alcohol (PVA) NF membrane was prepared, followed by the fabrication of a PA layer on its surface, and ultimately, a second PVA layer was constructed on the PA layer. The experimental results show that the PVA/PA/PVA sandwich structure TFC exhibits high permeability to pure water and robust resistance to both pollution and residual chlorine. The PVA-0.20/PA/PVA-0.20 TFC, prepared with a 0.20%w/v PVA solution, achieved a pure water flux of up to 22.05 L m−2 h−1 bar−1 (LMH/bar), which was 2.92 times higher than that of the control TFC membrane. Additionally, it demonstrated a salt rejection rate exceeding 96% for Na2SO4 and over 99% for Congo Red (CR) and Victoria Blue B (VB). In comparison with the control TFC membrane, the PVA-0.20/PA/PVA-0.20 membrane exhibited significantly enhanced resistance to pollution. Following immersion in a 1000 ppm NaClO solution for 4 h, the rejection rate of the control TFC membrane decreased markedly and that of the PVA-0.20/PA/PVA-0.20 membrane decreased marginally, indicating excellent resistance to residual chlorine. Due to the robust overall performance of the PVA/PA/PVA membrane, it holds potential advantages for application in treating reclaimed water or slightly polluted water.
- 17 September 2023
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 62 (38) , 15553-15562
Conceptual Design and Development of an Environment-Friendly Process for Simultaneous Extraction of Phenol and Naphthalene Compounds from Tar
- 17 September 2023
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 62 (38) , 15553-15562
Conceptual Design and Development of an Environment-Friendly Process for Simultaneous Extraction of Phenol and Naphthalene Compounds from Tar
- 10 May 2023
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 62 (20) , 7877-7888
Selective Hydrogenation of Phenolic Compounds to Cyclohexanols over Nanosheet Ni@Al2O3 Catalysts
- 10 May 2023
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 62 (20) , 7877-7888
Selective Hydrogenation of Phenolic Compounds to Cyclohexanols over Nanosheet Ni@Al2O3 Catalysts
- 20 July 2022
- Published by Elsevier in Chemosphere
- Vol. 307 (Pt 1) , 135784
The metabolism of pyrene by a novel Altererythrobacter sp. with in-situ co-substrates: A mechanistic analysis based on pathway, genomics, and enzyme activity
- 20 July 2022
- Published by Elsevier in Chemosphere
- Vol. 307 (Pt 1) , 135784
The metabolism of pyrene by a novel Altererythrobacter sp. with in-situ co-substrates: A mechanistic analysis based on pathway, genomics, and enzyme activity
- 4 March 2022
- Published by Taylor & Francis in Chemical Engineering Communications
- Vol. 210 (3) , 348-360
Effect of internal friction among unfluidized particles on measuring minimum fluidization velocity and segregation index
The internal friction among unfluidized particles makes them polymorphic, thus confusing measurements of minimum fluidization velocity (Umf) and segregation index (S). Such a polymorphic characteristic of the packed bed caused the ΔPb–Ug↑ curve measured subsequently to be poorly reproducible. The poor reproducibility of determining Umf from this curve resulted eventually from the ambiguity in the traditional definition of Umf. It did not clearly indicate which of the many states the particles should be initially packed into before measuring the ΔPb–Ug↑ curve. The internal friction caused it difficult to accurately measure S for low gas velocities. The corresponding stable fluidization states could not be obtained through reducing the gas flow slowly from complete fluidization to these velocities. Some particles lost the capability to move before reaching their stable equilibrium positions. Only some steady states which could not represent the given Ug were obtained. Many states of the unfluidized particles were demonstrated to be metastable and belong to the amorphous/glass state. They could not recover/restore themselves after relatively large perturbations.
- 4 March 2022
- Published by Taylor & Francis in Chemical Engineering Communications
- Vol. 210 (3) , 348-360
Effect of internal friction among unfluidized particles on measuring minimum fluidization velocity and segregation index
The internal friction among unfluidized particles makes them polymorphic, thus confusing measurements of minimum fluidization velocity (Umf) and segregation index (S). Such a polymorphic characteristic of the packed bed caused the ΔPb–Ug↑ curve measured subsequently to be poorly reproducible. The poor reproducibility of determining Umf from this curve resulted eventually from the ambiguity in the traditional definition of Umf. It did not clearly indicate which of the many states the particles should be initially packed into before measuring the ΔPb–Ug↑ curve. The internal friction caused it difficult to accurately measure S for low gas velocities. The corresponding stable fluidization states could not be obtained through reducing the gas flow slowly from complete fluidization to these velocities. Some particles lost the capability to move before reaching their stable equilibrium positions. Only some steady states which could not represent the given Ug were obtained. Many states of the unfluidized particles were demonstrated to be metastable and belong to the amorphous/glass state. They could not recover/restore themselves after relatively large perturbations.