Irina Baraban
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Irina Baraban has a total of 38 co-authors. Here are the top co-authors by number of shared publications:
- Valeria Rodionova
REC Smart Materials and Biomedical Applications, Immanuel Kant Baltic Federal University, Kaliningrad 236041, Russia
6 shared publications V. Rodionova
4 shared publications- Valeria Kolesnikova
Immanuel Kant Baltic Federal University, Kaliningrad, Russia
4 shared publications A. Litvinova
3 shared publicationsK. Chichay
3 shared publications- Larissa V. Panina
National University of Science and Technology MISiS, 101000 Moscow, Russia
3 shared publications
Latest Publications
- 9 October 2025
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 718
Bimagnetic core/shell microwires with asymmetric external shell
- 9 October 2025
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 718
Bimagnetic core/shell microwires with asymmetric external shell
- Open Access
- 22 October 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (11) , 1284
The Interplay of Core Diameter and Diameter Ratio on the Magnetic Properties of Bistable Glass-Coated Microwires
Glass-coated microwires exhibiting magnetic bistability have garnered significant attention as promising wireless sensing elements, primarily due to their rapid magnetization switching capabilities. These microwires consist of a metallic core with diameter d, encased in a glass coating, with a total diameter D. In this study, we investigated how the dimensions of both components and their ratio (d/D) influence the magnetization reversal behavior of Fe-based microwires. While previous studies have focused on either d or d/D individually, our research uniquely considered the combined effect of both parameters to provide a comprehensive understanding of their impact on magnetic properties. The metallic core diameter d varied from 10 to 19 µm and the d/D ratio was in the range of 0.48–0.68. To assess the magnetic properties of these microwires, including the shape of the hysteresis loop, coercivity, remanent magnetization, and the critical length of bistability, we employed vibrating sample magnetometry in conjunction with FORC-analysis. Additionally, to determine the critical length of bistability, magnetic measurements were conducted on microwires with various lengths, ranging from 1.5 cm down to 0.05 cm. Our findings reveal that coercivity is primarily dependent on the d/D parameter. These observations are effectively explained through an analysis that considers the competition between magnetostatic and magnetoelastic anisotropy energies. This comprehensive study paves the way for the tailored design of glass-coated microwires for diverse wireless sensing applications.
- 22 October 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (11) , 1284
Open AccessThe Interplay of Core Diameter and Diameter Ratio on the Magnetic Properties of Bistable Glass-Coated Microwires
Glass-coated microwires exhibiting magnetic bistability have garnered significant attention as promising wireless sensing elements, primarily due to their rapid magnetization switching capabilities. These microwires consist of a metallic core with diameter d, encased in a glass coating, with a total diameter D. In this study, we investigated how the dimensions of both components and their ratio (d/D) influence the magnetization reversal behavior of Fe-based microwires. While previous studies have focused on either d or d/D individually, our research uniquely considered the combined effect of both parameters to provide a comprehensive understanding of their impact on magnetic properties. The metallic core diameter d varied from 10 to 19 µm and the d/D ratio was in the range of 0.48–0.68. To assess the magnetic properties of these microwires, including the shape of the hysteresis loop, coercivity, remanent magnetization, and the critical length of bistability, we employed vibrating sample magnetometry in conjunction with FORC-analysis. Additionally, to determine the critical length of bistability, magnetic measurements were conducted on microwires with various lengths, ranging from 1.5 cm down to 0.05 cm. Our findings reveal that coercivity is primarily dependent on the d/D parameter. These observations are effectively explained through an analysis that considers the competition between magnetostatic and magnetoelastic anisotropy energies. This comprehensive study paves the way for the tailored design of glass-coated microwires for diverse wireless sensing applications.
- 18 October 2023
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 588
Core/shell bimagnetic microwires with asymmetric shell: MOKE and FMR behavior
- 18 October 2023
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 588
Core/shell bimagnetic microwires with asymmetric shell: MOKE and FMR behavior
- Open Access
Direct Magnetoelectric Effect in a Sandwich Structure of PZT and Magnetostrictive Amorphous Microwires
The magnetoelectric (ME) response in a trilayer structure consisting of magnetostrictive Fe77.5B15Si17.5 amorphous microwires between two piezoelectric PZT (PbZr0.53Ti0.47O3) layers was investigated. Soft magnetic properties of wires make it possible to operate under weak bias magnetic fields below 400 A/m. Enhanced ME voltage coefficients were found when the microwires were excited by ac magnetic field of a frequency of 50–60 kHz, which corresponded to the frequency of electromechanical resonance. The as-prepared microwires were in a glass coat creating a large thermoelastic stress and forming a uniaxial magnetic anisotropy. The effect of glass-coat removal and wire annealing on ME coupling was investigated. The glass coat not only affects the wire magnetic structure but also prevents the interfacial bonding between the electric and magnetic subsystems. However, after its removal, the ME coefficient increased slightly less than 10%. Refining the micromagnetic structure and increasing the magnetostriction by stress release during wire annealing (before or after glass removal) strongly increases the ME response up to 100 mV/(cm × Oe) and reduces the characteristic DC magnetic field down to 240 A/m. Although the achieved ME coefficient is smaller than reported values for multilayered films with layers of PZT and soft magnetic alloys as Metglass, the proposed system is promising considering a small volume proportion of microwires.
Open AccessDirect Magnetoelectric Effect in a Sandwich Structure of PZT and Magnetostrictive Amorphous Microwires
The magnetoelectric (ME) response in a trilayer structure consisting of magnetostrictive Fe77.5B15Si17.5 amorphous microwires between two piezoelectric PZT (PbZr0.53Ti0.47O3) layers was investigated. Soft magnetic properties of wires make it possible to operate under weak bias magnetic fields below 400 A/m. Enhanced ME voltage coefficients were found when the microwires were excited by ac magnetic field of a frequency of 50–60 kHz, which corresponded to the frequency of electromechanical resonance. The as-prepared microwires were in a glass coat creating a large thermoelastic stress and forming a uniaxial magnetic anisotropy. The effect of glass-coat removal and wire annealing on ME coupling was investigated. The glass coat not only affects the wire magnetic structure but also prevents the interfacial bonding between the electric and magnetic subsystems. However, after its removal, the ME coefficient increased slightly less than 10%. Refining the micromagnetic structure and increasing the magnetostriction by stress release during wire annealing (before or after glass removal) strongly increases the ME response up to 100 mV/(cm × Oe) and reduces the characteristic DC magnetic field down to 240 A/m. Although the achieved ME coefficient is smaller than reported values for multilayered films with layers of PZT and soft magnetic alloys as Metglass, the proposed system is promising considering a small volume proportion of microwires.
- Open Access
- 1 February 2020
- Published by AIP Publishing in AIP Advances
- Vol. 10 (2) , 025124
Voltage-induced strain to control the magnetization of bi FeRh/PZT and tri PZT/FeRh/PZT layered magnetoelectric composites
The bi- and tri- layered magnetoelectric composites were fabricated from magnetic Fe49Rh51 and piezoelectric PbZr0.53Ti0.47O3 materials. It was shown the electric field-induced stresses reduce the magnetization around magnetic phase transition temperature of Fe49Rh51: by 5.4% for tri-layer PZT/FeRh/PZT composite and by 3.6% for bi-layer FeRh/PZT composite. The magnetoelectric properties were studied at 320 K, the magnetization rate was estimated for the magnetic field of 0.5 T. The heterogeneous distributions of stresses and magnetization in volume of magnetic layer under applied magnetic and electric fields were demonstrated using COMSOL Multiphysics software. The obtained results demonstrate the tri-layered composite is more effective for tuning the magnetization
- 1 February 2020
- Published by AIP Publishing in AIP Advances
- Vol. 10 (2) , 025124
Open AccessVoltage-induced strain to control the magnetization of bi FeRh/PZT and tri PZT/FeRh/PZT layered magnetoelectric composites
The bi- and tri- layered magnetoelectric composites were fabricated from magnetic Fe49Rh51 and piezoelectric PbZr0.53Ti0.47O3 materials. It was shown the electric field-induced stresses reduce the magnetization around magnetic phase transition temperature of Fe49Rh51: by 5.4% for tri-layer PZT/FeRh/PZT composite and by 3.6% for bi-layer FeRh/PZT composite. The magnetoelectric properties were studied at 320 K, the magnetization rate was estimated for the magnetic field of 0.5 T. The heterogeneous distributions of stresses and magnetization in volume of magnetic layer under applied magnetic and electric fields were demonstrated using COMSOL Multiphysics software. The obtained results demonstrate the tri-layered composite is more effective for tuning the magnetization
- 1 July 2019
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 481, 50-54
Effect of glass-removal on the magnetostriction and magnetic switching properties in amorphous FeSiB microwires
- 1 July 2019
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 481, 50-54
Effect of glass-removal on the magnetostriction and magnetic switching properties in amorphous FeSiB microwires
- 1 May 2019
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 477, 415-419
Control of magneto-static and -dynamic properties by stress tuning in Fe-Si-B amorphous microwires with fixed dimensions
- 1 May 2019
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 477, 415-419
Control of magneto-static and -dynamic properties by stress tuning in Fe-Si-B amorphous microwires with fixed dimensions
- 16 August 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 54 (11) , 1-6
Tunable Magnetic Properties of Glass-Coated Microwires by Initial Technical Parameters
Glass-coated microwires of three different compositions Fe 77.5 Si 7.5 B 15 , Fe 45 Co 30 Si 10 B 15 , and Co 69 Fe 4 Cr 4 Si 12 B 11 were produced by the Taylor–Ulitovsky method under water or air cooling. By changing the technological parameters such as the drawing velocity and cooling environment, the formation of different phases in the microwire metallic core was realized owing to partial crystallization, which was confirmed by X-ray diffraction analysis. A critical correlation of the wire composition, drawing velocity, and hysteresis loops was demonstrated. The combination of air cooling and low drawing velocities create the conditions of partial crystallization which may form a single or multiple crystal phases, depending on composition. On the contrary, the wires quenched in water had an amorphous state irrespectively of the drawing velocity and composition. Then, single-phase, biphase, or multi-phase state microwires could be produced. They demonstrated various types of the magnetization reversal: bistable, stepwise, and S shape with a highly enhanced coercivity. Tailoring the wire microstructure and the magnetization behavior during the fabrication process could be of considerable practical interest.
- 16 August 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 54 (11) , 1-6
Tunable Magnetic Properties of Glass-Coated Microwires by Initial Technical Parameters
Glass-coated microwires of three different compositions Fe 77.5 Si 7.5 B 15 , Fe 45 Co 30 Si 10 B 15 , and Co 69 Fe 4 Cr 4 Si 12 B 11 were produced by the Taylor–Ulitovsky method under water or air cooling. By changing the technological parameters such as the drawing velocity and cooling environment, the formation of different phases in the microwire metallic core was realized owing to partial crystallization, which was confirmed by X-ray diffraction analysis. A critical correlation of the wire composition, drawing velocity, and hysteresis loops was demonstrated. The combination of air cooling and low drawing velocities create the conditions of partial crystallization which may form a single or multiple crystal phases, depending on composition. On the contrary, the wires quenched in water had an amorphous state irrespectively of the drawing velocity and composition. Then, single-phase, biphase, or multi-phase state microwires could be produced. They demonstrated various types of the magnetization reversal: bistable, stepwise, and S shape with a highly enhanced coercivity. Tailoring the wire microstructure and the magnetization behavior during the fabrication process could be of considerable practical interest.
- 1 August 2018
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 459, 61-65
The role of structural properties on magnetic characteristics of glass-coated microwires
- 1 August 2018
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 459, 61-65
The role of structural properties on magnetic characteristics of glass-coated microwires