Joel Heang Kuan Tan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Joel Heang Kuan Tan has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Swee Leong Sing
National University of Singapore
2 shared publications - Wai Yee Yeong
Singapore Centre for 3D Printing (SC3DP), School of Mechanical and Aerospace Engineering, Nanyang Technological University (NTU), 50 Nanyang Avenue, Singapore 639798, Singapore
2 shared publications - Ramasubramanian Lakshmi Narayan
Department of Materials Science and Engineering, Indian Institute of Technology Delhi, New Delhi, India
1 shared publication - Sheng Huang
School of Mechanical and Aerospace Engineering, Nanyang Technological University, Singapore, Singapore
1 shared publication
Latest Publications
- Top Cited Papers
- 1 February 2021
- Published by Elsevier in Acta Materialia
- Vol. 204
Resolving the porosity-unmelted inclusion dilemma during in-situ alloying of Ti34Nb via laser powder bed fusion
- 1 February 2021
- Published by Elsevier in Acta Materialia
- Vol. 204
Top Cited PapersResolving the porosity-unmelted inclusion dilemma during in-situ alloying of Ti34Nb via laser powder bed fusion
- Top Cited Papers
- 23 October 2019
- Published by Taylor & Francis in Virtual and Physical Prototyping
- Vol. 15 (1) , 87-105
Microstructure modelling for metallic additive manufacturing: a review
The microstructure of metals depends on the additive manufacturing (AM) process and the process parameters. However, experimentation on different process parameters for different materials is costly and time-consuming. To overcome these challenges, numerical simulations provide insights that allow prediction of microstructure formed under different process parameters. Microstructure modelling requires coupling of macro-scale thermal model or experimentally measured temperature profiles with either a meso-scale or micro-scale microstructure model. In this review, the commonly used AM techniques for metals are introduced, followed by a discussion on the microstructure of parts fabricated using these processes. This review then presents the latest models used in simulating different microstructural aspects of metal AM parts. In addition, the models were compared and the potential and challenges in microstructure modelling were discussed.
- 23 October 2019
- Published by Taylor & Francis in Virtual and Physical Prototyping
- Vol. 15 (1) , 87-105
Top Cited PapersMicrostructure modelling for metallic additive manufacturing: a review
The microstructure of metals depends on the additive manufacturing (AM) process and the process parameters. However, experimentation on different process parameters for different materials is costly and time-consuming. To overcome these challenges, numerical simulations provide insights that allow prediction of microstructure formed under different process parameters. Microstructure modelling requires coupling of macro-scale thermal model or experimentally measured temperature profiles with either a meso-scale or micro-scale microstructure model. In this review, the commonly used AM techniques for metals are introduced, followed by a discussion on the microstructure of parts fabricated using these processes. This review then presents the latest models used in simulating different microstructural aspects of metal AM parts. In addition, the models were compared and the potential and challenges in microstructure modelling were discussed.